• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.49 no.1
• /
• pp.15-24
• /
• 2012

In this paper, we suggest the dynamic-response-free SMPS using a new high-resolution DPWM generator based on switched-capacitor delay technique. In the proposed system, duty ratio of DPWM is controlled by voltage slope of an internal capacitor using switched-capacitor delay technique. In the proposed circuit, it is possible to track output voltage by controlling current of the internal capacitor of the DPWM generator through comparison between the feedback voltage and the reference voltage. Therefore the proposed circuit is not restricted by the dynamic-response characteristic which is a problem in the existing SMPS using the closed-loop control method. In addition, it has great advantage that ringing phenomenon due to overshoot/undershoot does not appear on output voltage. The proposed circuit can operate at switching frequencies of 1MHz~10MHz using internal operating frequency of 100 MHz. The maximum current of the core circuit is 2.7 mA and the total current of the entire circuit including output buffer is 15 mA at the switching frequency of 10 MHz. The proposed circuit has DPWM duty ratio resolution of 0.125 %. It can accommodate load current up to 1 A. The maximum ripple of output voltage is 8 mV. To verify operation of the proposed circuit, we carried out simulation with Dongbu Hitek BCD $0.35{\mu}m$ technology parameter.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.43 no.5 s.347
• /
• pp.54-63
• /
• 2006

This work proposes a 14b 100MS/s 0.18um CMOS ADC with optimized resolution, conversion speed, die area, and power dissipation to obtain the performance required in the fourth-generation mobile communication systems. The 3-stage pipeline ADC, whose optimized architecture is analyzed and verified with behavioral model simulations, employs a wide-band low-noise SHA to achieve a 14b level ENOB at the Nyquist input frequency, 3-D fully symmetric layout techniques to minimize capacitor mismatch in two MDACs, and a back-end 6b flash ADC based on open-loop offset sampling and interpolation to obtain 6b accuracy and small chip area at 100MS/s. The prototype ADC implemented in a 0.18um CMOS process shows the measured DNL and INL of maximum 1.03LSB and 5.47LSB, respectively. The ADC demonstrates a maximum SNDR and SFDR of 59dB and 72dB, respectively, and a power consumption of 145mW at 100MS/s and 1.8V. The occupied active die area is $3.4mm^2$.

• Journal of the Society of Disaster Information
• /
• v.15 no.4
• /
• pp.548-559
• /
• 2019

Purpose: Analysis method of V2I data driven motorway service area usage behavior to cope with manpower survey. Method: Segmentation of traveling state group and boundary using the distribution characteristics of traveling speed data of individual vehicles. Result: As a result of the verification, the use rate of resting places in lunchtime surged, and the boundary between the distribution status of the traffic speed data was clearly or unclear. Conclusion: The effect of the cost reduction is big because it can cope with the use of rest area survey by manpower and there is no limit in the time and space range of investigation. The dynamic utilization rate of each time sequence, such as a service area/drowsiness shelter/simple service area, with a V2I system, can be calculated. Identify illegal parking on highway section. Identify the unexpected situation in the road section. Identify the real-time service area utilization rate and congestion information.

• Journal of Korean Society of Transportation
• /
• v.27 no.5
• /
• pp.209-221
• /
• 2009

Travel time estimation under given traffic conditions is important for providing drivers with travel time prediction information. But the present expressway travel time estimation process cannot calculate a reliable travel time. The objective of this study is to estimate the path travel time spent in a through lane between origin tollgates and destination tollgates on an expressway as a prerequisite result to offer reliable prediction information. Useful and abundant toll collection system (TCS) data were used. When estimating the path travel time, the path travel time is estimated combining the link travel time obtained through a preprocessing process. In the case of a lack of TCS data, the TCS travel time for previous intervals is referenced using the linear interpolation method after analyzing the increase pattern for the travel time. When the TCS data are absent over a long-term period, the dynamic travel time using the VDS time space diagram is estimated. The travel time estimated by the model proposed can be validated statistically when compared to the travel time obtained from vehicles traveling the path directly. The results show that the proposed model can be utilized for estimating a reliable travel time for a long-distance path in which there are a variaty of travel times from the same departure time, the intervals are large and the change in the representative travel time is irregular for a short period.

• 한국사회정책
• /
• v.24 no.4
• /
• pp.185-222
• /
• 2017

The purpose of this study is to investigate the effect of labor market policy on fiscal soundness of welfare state. The analysis was carried out using cross-sectional panel data regression analysis, stepwise mediating effect analysis and system GMM designed by Baron and Kenny(1986) based on the data from 1985 to 2015 for 20 OECD countries. In setting up the analysis model, this study considers the interaction effect between active and passive labor market policies as well as the time sequence of the outcomes which have been overlooked in the previous studies. The result shows that labor market policies have significant impacts on the fiscal condition of welfare states, which is measured as the levels of national debt in this study. Especially the expenditure on active labor market programs has a positive effect on improving the fiscal soundness of welfare states by promoting the employment rate. In contrast, passive labor market programs expenditure is negatively associated with employment rate growth and it exacerbates the burden of national debt in the short-term. However, when active labor market programs and passive labor market programs are combined, the negative impacts by passive pabor market policies on the fiscal soundness of welfare states are off-set. Therefore this study addresses that although the expansion of the labor market policies can be inimical to the fiscal soundness of welfare states in the short-term, in the long run, they can have effective roles in securing and promoting the fiscal soundness of the welfare states by promoting the employment rate.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.17 no.1
• /
• pp.59-70
• /
• 2022

In this paper, we proposed an active fault tolerant control (AFTC) method for the position control of a quadrotor with complete loss of effectiveness of one motor. We obtained the dynamics of a quadrotor using Lagrangian equation without small angle assumption. For detecting the fault on a motor, we designed a fault detection module, which consists of the fault detection and diagnosis (FDD) module and the fault detection and isolation (FDI) module. For the FDD module, we designed a nonlinear observer that observes the states of a quadrotor based on the obtained dynamics. Using the observed states of a quadrotor, we designed residual signals and set the appropriate threshold values of residual signals to detect the fault. Also, we designed an FDI module to identify the fault location using the designed additional conditions. To make a quadrotor track the desired path after detecting the fault of a motor, we designed a fault tolerant controller based on the multiple sliding surface control (MSSC) technique. Finally, through simulations, we verified the effectiveness of the proposed AFTC method for a quadrotor with complete loss of effectiveness of one motor.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.26 no.1
• /
• pp.49-57
• /
• 2022

In order to efficiently analysis the stability of a slope, measuring the shear strength of soil is needed. The Standard Penetration Test (SPT) is not appropriate for a slope inspection due to cost and weights. One of the ways to effectively measure the N-value is the Dynamic Cone Penetration Test (DCPT). This study was performed to develop a minimized multi-function sensors that can easily estimate CPT values and Volumetric Water Content. N value with multi-fuction sensor DCPT showed -2.5 ~ +3.9% error compared with the SPT N value (reference value) in the field tests. Also, the developed multi-fuction sensor system was tested the correlation between the CPT test and the portable tester with indoor test. The test result showed 0.85 R2 value in soil, 0.83 in weathered soil, and 0.98 in mixed soil. As a result of the field test, the multi-function sensor shows the excellent field applicability of the proposed sensor system. After further research, it is expected that the portable multi-function sensor will be useful for general slope inspection.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.16 no.4
• /
• pp.771-782
• /
• 2021

Regular or irregular situations such as traffic accidents, damage to road facilities, maintenance or repair work, and vehicle breakdowns occur frequently on highways. It is required to provide traffic services to drivers by promptly recognizing these regular or irregular situations, various techniques have been developed for rapidly collecting data and detecting abnormal traffic conditions to solve the problem. We propose a method that can be used for verification and demonstration of unexpected situation algorithms by establishing a system and developing algorithms for detecting unexpected situations on highways. For the detection of emergencies on expressways, a system was established by defining the expressway contingency and algorithm development, and a test bed was operated to suggest a method that can be used for verification and demonstration of contingency algorithms. In this study, a system was established by defining the unexpected situation and developing an algorithm to detect the unexpected situation on the highway, and a method that can be used verifying and demonstrating unexpected situations. It is expected to secure golden time for the injured by reducing the effectiveness of secondary accidents. Also predictable accidents can be reduced in case of unexpected situations and the detection time of unpredictable accidents.

• Journal of the Korean Geotechnical Society
• /
• v.22 no.5
• /
• pp.59-67
• /
• 2006

The centrifuge and 1-g shaking table tests were performed simultaneously to compare the dynamic behaviors of loose sands of the same geotechnical properties. The prototype soils were 10 m thick liquefiable loose sands. The geometric scaling factors were 20 for 1-g and 40 for centrifuge tests. The excess pore pressure, surface settlement, and acceleration in the soil were measured at the same locations in the 1-g and centrifuge tests. The total excess pore pressure from development to dissipation was measured. In the centrifuge test, viscous fluid was used as the pore water to eliminate the time scaling difference between dynamic time and dissipation time. In the 1-g tests, the steady state concept was applied to determine the unit weight of the model soil, and two different time scaling factors were applied for the dynamic time and the dissipation time. It is concluded that the 1-g tests can simulate the excess pore pressure of the prototype soil if the permeability of the model soil is small enough to prevent dissipation of excess pore pressure during shaking and the dissipation time scaling factor is properly determined.

• Asia-Pacific Journal of Business Venturing and Entrepreneurship
• /
• v.15 no.4
• /
• pp.245-261
• /
• 2020

The aim of this study is to investigate the correlation between the support activities provided by the franchiser and how they affect the intention of the contract renewal and business performances made by franchisees, developing dynamic trust between these transactional partners. Various supportive activities between franchiser and franchisees were divided into financial and non-financial activities and dynamic trust into Transitional-based trust, Calculative-based trust, Relational-based trust, and Balanced-based trust. These trust types, which are variable and adjustable based on the opportunistic behaviors of business parties, were applied to define the impact of the support activities on the contract renewal intention and the performances. This study was developed around domestic franchisees. An investigator visited business owners and manager level-employees, explained the purpose of the survey prior to the response, and the answers were directly written by hands. A total of 348 copies were used for the analysis. As the results of the analysis, first, financial support activities were found to have a positive(+) effect on transitional-based trust, calculative-based trust, and balanced-based trust. On the other hand, non-financial support activities were found to have a positive(+) effect on calculative-based trust, relational-based trust, and balanced-based trust, and there was no significant relationship on transitional-based trust. Second, the dynamic trust had a statistically significant positive(+) effect on inducing the contract renewal. Lastly, in the relationship between the dynamic trust and its impact on business performances, only transitional-based trust, and relational-based trust were found to have a positive(+) effect on the financial performances. In addition, relational-based trust showed a meaningful positive(+) relationship on the non-financial performances, and non-financial performace showed a meaningful positive(+) relationship on the re-contract intention. From the results, it can be concluded that the financial and non-financial activities for a win-win partnership between franchiser and franchisees are essential in not only forming dynamic trust but also boosting business performances as well as maintaining the business relationship. Thus, it suggests that building a win-win partnership can be promoted more efficiently by specifying activities best suitable for a particular relationship. In addition, a specific set of activities could be presented for establishing the level of trust that is formed in situations that vary depending on transaction risks and interdependency arising from having the transactional relationship based on the contract as the franchise industry features. Eventually, it is expected that this study can provide a way to promote the qualitative improvement of the franchise industry by identifying factors essential to establishing a sustainable win-win system and relationships that can improve the business performance of franchisees.