• Journal of the Korean Magnetics Society
• /
• v.20 no.1
• /
• pp.1-7
• /
• 2010

We investigate the spin dynamics of the magnetic domain wall using the magnetic noise in the magnetic nanowire structure by employing micromagnetic simulations. Magnetic noise due to the thermal fluctuations in ferromagnetic materials is related to magnetic susceptibility and resonance frequency, which are important physical quantities in the study of the spin dynamics. In this study, we present the magnetic noise of the single domain without magnetic domain wall, and with the magnetic domain wall between two magnetic domains in ferromagnetic nanowires. It is confirmed that the Kittel equation with simple ellipsoid model with demagnetizing factor well describe the resonance frequency due to magnetic noise of the single domain. Besides, we find that there is a distinguishable additional resonance frequency, when a magnetic domain wall exists. It is verified that the additional resonance frequency is originated from the magnetic domain wall, and it is lower than one of the single domain. It implies that the spins inside the domain wall have a different effective field.

• Journal of the Korea Society for Simulation
• /
• v.17 no.4
• /
• pp.199-208
• /
• 2008

Lately, since Complementary Metal Oxide Semiconductor(CMOS) image sensor system has low power, low cost and been miniaturized, hardware and applied software studies using these strengths are being carrying on actively. However, the products equipped with CMOS image sensor based polling method yet has several problems in degree of completeness of applied software and firmware, compared with hardware’s. CMOS image sensor system has an ineffective synchronous problem due to superfluous message exchange. Also when a sending of data is delayed continually, overhead of re-sending is large. So because of these, it has a problem in structural stability according to Polling Method. In this study, polling cycle was subdivided in high-speed synchronization method of firmware -based through MCU and synchronization method of Stepwise was proposed. Also, re-connection and data sending were advanced more efficiently by using interrupt way. In conclusion, the proposed method showed more than 20 times better performance in synchronization time and error connection. Also, a board was created by using C328R board of CMOS image sensor-based and ATmega128L which has low power, MCU and camera modules of proposed firmware were compared with provided software and analyzed in synchronization time and error connection.

• Journal of the Korean Chemical Society
• /
• v.46 no.4
• /
• pp.317-323
• /
• 2002

The composition of trace materials in domestic circulated LPG are determined. The sampling points are two cylinders of LPG cylinder re-inspection center, six vaporizer of LPG-supplying group facilities, and the compressed oil from one LPG station. In the trace materials from cylinder of LPG cylinder-reinspection center, alkene and diene derivative (No. of carbon ${\leq}9),$ aromatic compounds, and tarry chemicals(No. of carbon ${\geq}10)$ are 1.5~39.9%, 0.7%, 57.8~96.0%, respectively. While in the trace materials from LPG-supplying group facilities and in the oil from LPG station, tarry chemicals(No. of carbon>10) exceed 96.6%. Nine samples are classified into three clusters. One cluster is the sample of SE company cylinder-reinspection center(Euclidian distance between S company LPG cylinder-reinspection center and SE company cylinder-reinspection center=2.11), the other is the sample of SE company LPG cylinder-reinspection center(Euclidian distance between from samples of LPG-supplying group facilities including compressed oil from LPG station=0.110) the third is the samples of LPG-supplying group facilities(Euclidian distances among them<0.075). The compositions of samples from LPG-supplying group facilities are similar to those of oil from LPG station. Furthermore densities of samples from LPG-supplying group facilities and compressed oil in LPG station are 0.873, 0.873 [0.00798 (99% confidence limits) respectively. It was presumed that tarry chemicals had been leached from the compressed oil of LPG supplying facilities.

• Clean Technology
• /
• v.17 no.3
• /
• pp.259-265
• /
• 2011

The textile industry is suffered from air pollution problems which must be resolved. In particular, white smoke and odor after the tenter process require abatement. The major air pollution problem in the textile industry occurs during the finishing stages, where various chemicals are used for coating the fabrics. Lubricating oils, plasticizers, and water repellent chemicals are the fabric treatment chemicals. The coated fabrics are cured by heating in tenter facility. In this process, most of air pollutants emitted into the air. White smoke is basically made up of tiny solid or liquid particles of VOCs less than one micron in size. The oil mist can be carried over long distance from their point of origin. The most effective method of removing odor from tenter process is to get rid of tiny oil mist at the emitted gas. For this reason, the full-scale EFC (Electric Fume Collector) of 700 CMM was tested for removing odorous substances emitted from tenter facility. As a result of this study, odor and white smoke can be eliminated effectively and quite large amounts of oil can be recovered.

• The Journal of the Korea Contents Association
• /
• v.19 no.12
• /
• pp.129-140
• /
• 2019

This study investigated cyber university students' motivation and demotivation in learning English. Data was collected from a survey of 498 students in a general English course at a cyber university located in Seoul. The survey inquired into participants' English learning motivation and demotivation. To analyze the data, frequency analysis, descriptive statistics, t-test, and ANOVA were used. The findings reveal that among the motivation factors ideal L2 self was the main cause of motivation followed by promotion-based instrumentality. Among the demotivation factors the anxiety factor was found to have the highest mean followed by negative investment value for learning English. The statistical analysis of English learning motivation and demotivation according to the participants' characteristics indicates that, in terms of English learning motivation factors, the male participants' ought-to L2 self was significantly higher than that of the females' and the promotion-based instrumentality of the students who are unemployed was higher than those who are employed. Moreover, the younger the students' age, the higher their competitive motivation and promotion-based instrumentality. In terms of English learning demotivation, the female respondents achieved higher scores in the factors of anxiety, passive learning style, and negative investment value for learning English than their male counterparts. In addition, employed students showed higher demotivation in negative investment value for learning English than those without employment. The findings of this research can be used in developing online English programs for cyber university students who possess diverse learning goals.

• Journal of the Korean Applied Science and Technology
• /
• v.33 no.4
• /
• pp.836-847
• /
• 2016

Water soluble oil was obtained by pyrolysis of biomass. The characteristics of emulsified fuel by mixing water soluble oil and MDO(marine diesel oil) and engine emissions were studied with engine dynamometer. Saw dust was used as biomass. Water soluble oil was obtained by condensing of water and carbon content with pyrolysis of saw dust at $500^{\circ}C$. Emulsion fuel was obtained by emulsifying MDO and water soluble oil by the water soluble oil mixing ratio of 10 to 20% of MDO. Exhaust gas detection was performed with engine dynamometer. While combustion, micro-explosion took place in the combustion chamber by water in the emulsion fuel, emulsion fuel scattered to micro particles and it caused to smoke reduction. The heat produced from water vapour reduce the temperature of internal combustion chamber and it caused to inhibition of NOx production. It can be verified by the lower exhaust temperature of each ND-13 mode using emulsion fuel than that of MDO fuel. The NOx and smoke concentration were reduced by increasing water soluble oil content in the emulsion fuel. The power also decreased according to the increment of water soluble oil content of emulsion fuel because emulsion fuel has low calorific value due to high water content than MDO. As a result of ND-13 mode test with 20% bio oil content, it was achieved 25% reduction in NOx production, 60% reduction in smoke density, and 15% reduction in power loss.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.49 no.1
• /
• pp.12-19
• /
• 2012

Recently, the market of skin-care device has been steadily growing up. In this paper, we tried to develop a personal compound stimulus device more competitive than existing products. As the compound stimulus, biochemical stimulus of herbal extraction fluid, thermal stimulus of plate-shaped carbon fiber heater, and optical stimulus of near infrared LED were selected. By some evaluation tests, the thermal stimulation part and the optical stimulation part were found to be developed properly. Additionally, the efficacy of the mixed stimulus of thermal and optical stimulation was tested in C2C12 mouse myoblast. Through RT-PCR analysis, it was found that, by the developed compound stimulus, the expression of collagen I mRNA and collagen III mRNA increased by 4.9 and 1.3 times respectively.

• Journal of Environmental Policy
• /
• v.6 no.3
• /
• pp.33-56
• /
• 2007

Use of chemicals has greatly increased along with development of human civilization. Concerns about potential effects of chemicals on human health and environment have also grown accordingly. Due to the enormous number of chemicals being used, however, it is neither practical nor feasible to regulate all the chemicals. Therefore, it is necessary to identify chemicals that deserve more immediate attention, based on the effects on receptors to be protected. This study was initiated by the need for developing management policies for Shihwa-Banwol Techno Valley and its vicinities of korea, where complaints and concerns on environmental contamination have been raised for long time. This study to identifies major chemicals that deserve most immediate attention in environmental health management in this area. For this purpose, the study employed CHEMS-1(Chemical Hazard Evaluation for Management Strategies), and used chemical data from Toxics Release Inventory(TRI) and environmental contamination data from the environmental pollution monitoring network. Top priority pollutants identified in Shihwa-Banwol Techno Valley area were metals and volatile organic compounds, such as dichloromethane, trichloroethylene, diazinon, tetrachloroethylene, chromium compounds, tin compounds, chloroacetic acid, ethyl acetate, and zinc compounds, in an order of decreasing importance. An evaluation of physicochemical properties of the priority chemicals and the environmental pollution monitoring network database in Shihwa-Banwol Techno Valley suggested that the media that are of potential concern would be the atmosphere and aquatic environment.

• Journal of Advanced Marine Engineering and Technology
• /
• v.39 no.4
• /
• pp.425-431
• /
• 2015

LNG (liquefied natural gas) is considered the best alternative eco-fuel, and many studies on the LNG fuel system have been performed to use LNG as the fuel for ships. For the LNG fuel supply system, natural gas transfers from the vaporizer to the engine in the gaseous state with a temperature of $50^{\circ}C$ and a pressure of 35MPa. Therefore, a structural safety evaluation of the double-walled pipelines considering thermal load is essential. In this article, an uniaxial tensile test for super duplex stainless steel, material for double-walled pipe, according to the annealing time was carried out to analyze the thermal effect. In addition, thermo-structural analysis of the high temperature-high pressure double-walled pipe with fixed supports that are now used widely was carried out to evaluate the structural safety. To minimize stress concentration of the connection point between the support and inner pipe, the shapes of the new type support that can slip through inner pipe were proposed, and the supports which has best structural performance was selected using the results from the thermo-structural analyses of new supports and an analysis of the whole double-walled pipeline was performed to ensure structural safety. These results can be used as a database for the design of double-walled pipelines and sliding support.

• YAKHAK HOEJI
• /
• v.55 no.4
• /
• pp.284-288
• /
• 2011

The test method for biologics of lot release system is based on 'Test procedure and specification for biological products,' generally, thimerosal content is measured by chemical analysis using O.D. In this study, the comparative analysis was carried out using the gold amalgamation method for thimerosal content was compared to the existing methods, which are described above. The gold amalgamation method, which uses atomic absorption spectrophotometry, was meets all the method validation acceptance criteria. It is considered to be proper as the assay and identification test for thimerosal. In this study, the comparative analysis was performed three times. As a result, gold amalgamation method is more convenient and easy to perform as this assay doesn't have pre-treatment procedure. Also this assay showed good precision and reproducibility compared to the conventional method. Therefore, it is appropriate to alternate the assay method of thimerosal from the conventional chemical analysis to gold amalgamation method to improve the credibility of lot release system and the quality control of biologics, by standardizing test method.