• Journal of Advanced Marine Engineering and Technology
• /
• v.31 no.8
• /
• pp.1028-1034
• /
• 2007

In order to establish a criteria of solid particle separation performance test on marine centrifugal purifier at factory acceptance test, an investigation had been done on criteria of test standards, regulations and test specifications of purifier manufactures. KS V 7836, fuel oil and lubricating oil purifiers for marine use-centrifugal type, the criteria of solid particle separation is studied in the point of reality, restricts and analysis method. It is proposed that a reasonable criteria and analysis method should be adopted, and the current criteria shall be revised to adequate levels considering reasonable basis and industrial technology levels. Also, the test analysis conceptions, separation efficiency method and particle size restriction method, are reviewed to fulfil separation performance test for marine centrifugal purifiers.

• Journal of Advanced Marine Engineering and Technology
• /
• v.31 no.6
• /
• pp.804-809
• /
• 2007

In order to provide reliability. reproducibility. objectivity of solid particle separation performance test on marine centrifugal purifier, an investigation had been done on solid test dusts. test standards and designation of a definite standard test dust In test specifications or standards. ISO 121031-1 A2 test dust is the best test particle to meet commercial and military fuel oil and lube oil requirements on marine standards.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.16 no.2
• /
• pp.261-270
• /
• 2018

In this study, to replace the 'J-slot joint', a joint device between a disposal canister and an emplacement jig in Deep Borehole Disposal process, a novel joint device was designed and tested. The novel joint device was composed of a wedge on top of a disposal canister and a hook box at the end of a winch system. The designed joint device had merits in that it can recombine an emplaced canister freely without the replacement of the joint component. Moreover, it can be applied to various emplacement jigs such as drill pipes, wire-lines, and coiled tubing. To demonstrate the designed joint device, the joint device (${\Phi}110mm$, H 148 mm), a twin canister string (${\Phi}140mm$, H 1,105 mm), and a water tube (${\Phi}150mm$, H 1,500 mm) as a borehole model were manufactured at 1/3 scale. As deployment muds, Na-type bentonite (MX-80) and Ca-type (GJ II) bentonite muds were prepared at solid contents of 7wt% and 28wt%, respectively. The manufactured joint device showed good performance in pure water and viscous muds, with an operation speed of $10m{\cdot}min^{-1}$. It was concluded that the newly developed joint device can be used for the emplacement and retrieval of a deep disposal canister, below 3~5 km, in the future.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.24 no.2
• /
• pp.67-74
• /
• 2016

This study was purposed to evaluate the characteristic changes of the solidified livestock manure fuel(SLMF) through the application of compression treatment process. The compression process led to an increase of VS/TS ratio (Volatile solids/Total solids ratio) and moisture removal effect of SLMF. The amount of leachate withdrawn from dairy cattle manure and Hanwoo manure by compression were 21~26%(w/w) and 15~20%(w/w), respectively. The specific gravity of the leachate of dairy cattle manure and Hanwoo manure were 1.01 and 0.99, respectively. The dehydrated cow manure was easily processed into ball-shaped solidified fuel. The drying time of the SLMF was proportional to the diameter of the solidified fuel. The highest heating value was observed in diameter range of 10~15mm SLMF. It is concluded that the higher heating value of 10~15mm SLMF was related with the amount of fibrous matter contained in the SLMF.

• Korean Journal of Food Science and Technology
• /
• v.15 no.4
• /
• pp.414-420
• /
• 1983

Heating characteristics for retort pouches of Kimchi heated in hot water were determined as a function of various parameters for processing. Processing conditions in laboratory and commercial retort were also evaluated on the basis of storage test. D values for Lactobacillus plantarum isolated from test sample ranged from $D^{1.08}\;to\;D^{0.18}$ and z value was $10.5^{\circ}C$. Thermal diffusivity of Kimchi increased from 1.15 to $1.44{\times}10^{-3}cm/s$ by blanching for 15 min at $80^{\circ}C$. The rate of heat penetration was significantly decreased with increasing the thickness of the pouch although the decreases was less significant below 1.0cm thickness. Increasing in the ratio of solid to syrup up to 90:10 proportionately decreased $f_h$ value, but above the ratio $f_h$ values were nearly constant.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.35 no.2
• /
• pp.199-204
• /
• 2006

This study was conducted to investigate the quality characteristics of noodles prepared with the addition of nanofiltered (NF) powder of sunmul. Noodles were prepared with different levels $(0\%,\;1.5\%,\;3\%\;and\;5\%,\;w/w)$ of NF powder and physico-chemical properties were examined. Results of rapid visco analyzer showed that peak, trough, final viscosity and set back decreased as the NF powder level increased. The weight and volume of cooked noodles increased with the addition of NF powder. Turbidity of soup also increased as the amount of NF powder increased, indicating higher cooking loss. The color of wet and cooked noodles became greenish yellow as the NF powder level increased. Hardness, springiness, gumminess and brittleness of cooked noodles decreased with the increasing amount of NF powder. Results of sensory evaluation showed that noodles prepared with up to $3\%$ addition of NF powder was considered to be as acceptable as noodles prepared without NF powder.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.34 no.4
• /
• pp.519-523
• /
• 2005

Soybean paste (Doenjang) was prepared by adding Lotus root powder (LRP) at $5\~15\%$ (w/w) to improve quality of the Doenjang and to give some functional properties. Moisture content was ranged about $50.05\~54.04\%$ and amino nitrogen content was $635\~648\;mg\%$ following the LRP contents. Crude protein amounts were $11.55\~12.56\%$ that was no difference between test samples. Carbohydrates contents increased $1.5\~2$ times in the test samples than the control depending on the LRP contents. However, contents of crude lipid $(6.99\~8.55\%)$ and ash $(13.99\~15.17\%)$ were decreased as increased the amounts of LRP. The pH of the product was decreased until 45 days during aging period and then slightly increased without significantly differences among test samples. The values of acidity were $1.85\~2.18\%$ at the early stage of aging but slightly increased with further aging. The total phenolic content in the Doenjang adding $15\%$ LRP was $461.8\;mg\%$ which is higher than $368.6\;mg\%$ in the control. Doenjang prepared with LRP showed an anti-browning effect of the product itself.

• Journal of Animal Environmental Science
• /
• v.13 no.1
• /
• pp.13-20
• /
• 2007

Sawdust biofiltration is an emerging bio-technology for control of ammonia emissions including compost odors from composting of biological wastes. Although sawdust is widely used as a medium for bulking agent in composting system and for microbial attachment in biofiltration systems, the performance of agitated bed composting and sawdust biofiltration are not well established. A pilot-scale composting of hog manure amended with sawdust and sawdust biofiltration systems for practical operation were investigated using aerated and agitated rectangular reactor with compost turner and sawdust biofilter operated under controlled conditions, each with a working capacity of approximately $40m^3\;and\;4.5m^3$ respectively. These were used to investigate the effect of compost temperature, seed germination rate and the C/N ratio of the compost on ammonia emissions, compost maturity and sawdust biofiltration performance. Temperature profiles showed that the material in three runs had been reached to temperature of 55 to $65^{\circ}C$ and above. The ammonia concentration in the exhaust gas of the sawdust biofilter media was below the maximum average value as 45 ppm. Seed germination rate levels of final compost was maintained from 70 to 93% and EC values of the finished compost varied between 2.8 and 4.8 ds/m, providing adequate conditions for plant growth.