• Journal of Broadcast Engineering
• /
• v.7 no.4
• /
• pp.300-309
• /
• 2002

The object of this paper is to make temporal direct mode clear by providing a solution to the following problem : if the co-located block in the list 1 reference picture for direct mode has only the 1ist 1 motion vector or both the 1ist 0 and list 1 motion vectors, then which motion vector will be used for the direct mode motion vector calculation\ulcorner This paper also shows how to derive reference picture index and direct mode motion vector for each list in order to guarantee the high coding efficiency. when the co-located macroblock is in intra mode. Furthermore, the reasonable calculation methods for the direct mode motion vectors in the various cases are presented. Finally, experimental results show that the proposed temporal direct mode provides the comparable performance against the spatial direct mode. Therefore, the simulation proves that the proposed temporal direct mode is acceptable.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.16 no.3
• /
• pp.429-436
• /
• 2021

The wind profilers operated by the Korea Meteorological Administration observe in a low mode for intensive observation of the low levels and a high mode for intensive observation of the high levels. The LAP-3000 wind profiler installed in Bukgangneung and Changwon is characterized by the same sampling frequency of the low mode and the high mode, allowing to compare winds observed in both modes at the same altitude. As a result of analyzing the wind speed of the two points for one year in 2020, the correlation between the two modes was up to 0.2 lower than the correlation with radiosonde. The T-test for the wind speed of the two modes showed a particularly significant difference in October, where the temperature and specific humidity fluctuate frequently. The difference in the development of the atmospheric boundary layer affects the accuracy of the wind speed depending on the observation mode.

• Korean Journal of Optics and Photonics
• /
• v.14 no.2
• /
• pp.184-188
• /
• 2003

We fabricated a P-I-i-I-N $GaAs/Al_{0.35}Ga_{0.65}As$waveguide phase modulator with significant phase shift for the TE mode but negligible for the TM mode. We selected the P-I-i-I-N structure to cause a phase shift about the TM mode. The wavelength of $\lambda=1.55$\mu\textrm{m}$ was measured for both the TE and TM modes, respectively. As a result, the measured phase shift efficiency ($\Delta\phi$) by using the Fabry-Perot resonance method was $7.9^{\circ}/V.mm$ for TE-polarized light. Also, no modulation was observed for TM-polarized light.

• Journal of the Korean Magnetics Society
• /
• v.12 no.5
• /
• pp.163-167
• /
• 2002

In order to study the temperature dependence of the magnetostatic wave modes for an YIG thin film, grown by a liquid phase epitaxy method, The ferromagnetic resonance was performed by an FMR spectrometer in the temperature range -140$\^{C}$∼200$\^{C}$. The magnetostatic surface wave and backward volume wave modes show periodic excitations in parallel configuration. The resonance fields of all modes and intensities decreased with decreasing the temperature. All magnetostatic modes can be well explained by the Walker and Damon-Eshbach theory. The calculated saturation magnetization Ms of the YIG thin film was increased with decreasing the temperature. The line widths of magnetostatic modes changed in various trends with decreasing the temperature.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.6
• /
• pp.492-503
• /
• 2013

H.264/AVC has shown high coding efficiency by using various coding tools, including intra and inter prediction. However, there are still many more redundancy components in intra prediction than in inter prediction. In this paper, a novel intra prediction method is proposed with adaptive mode selection. The combined intra prediction modes and simplified gradient modes are added in order to refine the directional feature and gradation region. Suitable modes are selected according to the neighboring blocks that provide a high compression rate and lower computational complexity. The improvement of the proposed method is 1.96% in terms of the bitrate, 0.25 dB in PSNR, and 1.72 times in terms of the computational complexity.

• Korean Journal of Optics and Photonics
• /
• v.14 no.3
• /
• pp.298-305
• /
• 2003

We have calculated the single mode yield of index-coupled (IC) DFB lasers above threshold for several kL, and facet reflectivity combinations, and investigated the correlation between those results and the single mode yield as a function of f number at the threshold. As a result, there is little correlation between the single mode yield above threshold and the single mode yield as a function of f number at the threshold. The single mode yields above threshold for kL of 0.8 and 1.25 is larger than those for kL, of 2 and 3 due to the spatial hole burning effect. Also, we have investigated the effect of the reflectivity of the AR facet on the single mode yield for AR-HR and AR-CL combinations. For AR-HR combinations, the single mode yield increases as the reflectivity of the AR facet decreases. However, for AR-CL combinations, the reflectivity of the AR facet for the largest single mode yield exists. In the single mode yield calculations for IC DFB lasers in this paper, the single mode yield for kL of 0.8 with AR(1％)-HR combination is largest above threshold.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.41 no.9
• /
• pp.853-860
• /
• 2017

To evaluate the effects of mode II on the crack initiation and propagation stages, the effects in the fatigue threshold region under a mixed-mode I+II loading state was experimentally investigated. In the case of mixed-mode I + II, during the crack initiation stage, as the loading application angle (${\theta}$) increased, cracks occurred in the lower load owing to the effects of mode II, while the crack propagation rate decreased. The effects of mode II were experimentally investigated in the crack propagation stage by means of multilevel loading direction variation. Following mixed-mode I+II ($0^{\circ}{\rightarrow}{\theta}{\rightarrow}60^{\circ}$), as the load application angle increased, the fatigue crack propagation rate decreased, as did the fatigue crack propagation rate, which occurred later. Following mixed-mode I + II in case of(${\theta}{\geq}75^{\circ}$), the fatigue crack propagation rate was found to increase, while the fatigue life decreased.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.49 no.4
• /
• pp.34-42
• /
• 2012

In this paper, a wide-input range CMOS multi-mode rectifier for wireless power transfer system is presented. The output voltage of multi-mode rectifier is sensed by comparator and switches are controlled based on it. The mode of multi-mode rectifier is automatically selected by the switches among full-wave rectifier, 1-stage voltage multiplier and 2-stage voltage multiplier. In full-wave rectifier mode, the rectified output DC voltage ranges from 9 V to 19 V for a input AC voltage from 10 V to 20 V. However, the input-range of the multi-mode rectifier is more improved than that of the conventional full-wave rectifier by 5V, so the rectified output DC voltage ranges from 7.5 V to 19 V for a input AC voltage from 5 V to 20 V. The power conversion efficiency of the multi-mode rectifier is 94 % in full-wave rectifier mode. The proposed multi-mode rectifier is fabricated in a $0.35{\mu}m$ CMOS process with an active area of $2500{\mu}m{\times}1750{\mu}m$.

• Korean Journal of Optics and Photonics
• /
• v.5 no.2
• /
• pp.278-285
• /
• 1994

We investigated the spectral characteristics for temperature and driving current change in visible laser diode. As a result of spectrum analysis, the ratio of frequency change for temperature and driving current change were about $33 GHz/^{\circ}C$, 6.6 GHz/mA in the region which was not mode hopping range. Compared to the sharp mode hopping in the near IR single mode AlGaAs lasers, the visible laser diode showed relatively broad multimode operation in the mode hopping region. We performed the experiment of injection-locking characteristics analysis for visible laser diode. Locking half bandwidth(LHBW) was measured 0~5.0 GHz for $0~25\muW$ input power and it was dependent on the input power. Also, LHBW for polarization angle was dependent on the difference of polarization angle between master laser and slave laser. The phase change of injection-locked output beam of the slave laser diode as a function of the drive current was measured in the interferometer which was composed of master laser and slave laser. The ratio of phase change with the slope of 5.0~1.3 rad/mA was obtained within injection-locking range for the change of $2~25\muW$ input power. power.

• The Journal of the Korea Contents Association
• /
• v.9 no.3
• /
• pp.20-27
• /
• 2009

H.264/AVC video coding standard adapting a rate-distortion optimization technique to select the best coding mode with multi reference frames for each macroblock gets a higher coding efficiency than those of previous video coding standards but the computational complexity increases drastically. Therefore, many fast mode decision algorithms are proposed to reduce the computational complexity. Among them, we propose a fast intra mode decision algorithm based on directional information of I4MB. The proposed algorithm achieves consistent time saving about 15% in IPPP sequences and 44% in all I frame sequences with negligible loss in PSNR and small increment of bit rate compared with that of JM11.0.