Alternating current (AC) losses of two Bi-2223 ([Bi, Pb] : Sr : Ca : Cu :O = 2:2:2:3) tapes [one untwisted (Tape I, twist-pitch of $\infty$ mm) and the other with a twist-pitch of 8mm (Tape II) ] were measured and compared. These samples, produced by the powder-in-tube (PIT) method, are multi-filamentary and have a Ag/Au and Ag matrix, respectively. Susceptibility measurements were conducted while cooling in a magnetic field. Flux loss measurements were conducted as a function of ramping rate, frequency and field direction. The AC flux loss increases as the twist-pitch of the tapes decreased, in agreement with the Norris Equation.

A new class of carbosiloxane dendrimer (G4-48PyP) terminated with 4-pyridylpropano I was synthesized and its possible application to functional thin films was examined through metal complexation and Langmuir-Blodgett (LB) technique. The highly concentrated periphery pyridyl groups of G4-48PyP were exposed on aq. aluminum ions at the air-water interface. The monolayers showed stability up to ca. 50 mN/m of surface pressure. When the subphase became acidic or alkaline, the monolayers changed to condensed phase. The presence of aluminum ions also caused reduction of the molecular area. The macroscopic images of the monolayers were monitored by Brewster angle microscopy (BAM) and only the images of dendrimer aggregates could be observed after the monolayer collapse. The surface images of the monolayer LB film were scanned by atomic force microscopy (AFM). The convex structures of single and aggregate molecules were directly observed. The structures of Langmuir-Blodgett (LB) films were characterized by FT-IR, UV-Vis, and X-ray photoelectron spectroscopy (XPS). The UV-Vis spectrum of the aluminum ion-complexed LB film showed additional band around 670nm, which was not found in the spectra of dendrimer itself or aq. aluminum ions. XPS spectra also supported the incorporation of aluminum ions into the LB films.

In this paper, a new frequency-to-digital converter without an analog element is proposed. The proposed circuit consists of pulse-shrinking elements, latches and D flip-flops, and the operation is based on frequency comparison by the pulse-shrinking element. In the proposed circuit, the resolution of digital output can be easily improved by increasing the number of the pulse-shrinking elements. The FDC performance is improved in viewpoints of operating speed and chip area. In designed FDC, error of frequency-to-digital conversion is less than 0.1 %.

An ultra high frequency (UHF) coupler possessing ultra wide band (UWB) characteristics ranging from hundreds of MHz to several GHz is desirable for the detection of the partial discharge (PD) pulses because the pulses propagate with rise time shorter than one nanosecond in a gas-insulated substation (GIS). Thus, the authors have proposed a log-periodic antenna for GIS PD detection. Various parameters of the coupler such as frequency bandwidth, coupler gain, radiation pattern, and coupler geometry were considered throughout the simulations. The experiments for the detection characteristics of the coupler were carried out in the mock-up GIS chamber. The results indicated that the detection characteristics of the coupler are dependent on the installation angle of the coupler, the position of the coupler in the hand hole and the existence of the spacer.

In this paper, a superposed discharge type ozonizer with an internal dielectric that can be made into a vacuum tube has been designed and fabricated. Ozone generation and discharge characteristics have been investigated in accordance with output voltage of power supply, flow-rate, discharge power and vacuum of inside internal dielectric. Pure oxygen was used as the supply gas of the ozonizer. Ozone concentration and ozone generation are gradually increased when discharge power is increased at the same flow-rate and they are both proportional to the vacuum level. As such, the maximum ozone concentration of 8840 ppm was obtained at vacuum 0.1 Torr and flow-rate 0.5 $\ell$/min.

The UWB UHF coupler for GIS PD detection requires a balun (balance to unbalance transformer) to show its inherent UWB characteristics. In order to reduce the size of the balun and to make it practical in the conventional GIS, a novel tapered coaxial balun with a dielectric was proposed for the UWB UHF coupler. The performance of the proposed balun was verified through a series of simulations, measurements and experiments. As a result, both the conventional balun and the proposed balun, which has a length equal to one third of that of the conventional balun, demonstrated good S11 characteristics, whereas the efficiency of the proposed balun increased as much as about 30% in comparison to the conventional one.

ZnO thin films on (l00) p-type Si and sapphire substrates have been deposited by a pulsed laser deposition technique using an Nd:YAG laser with a wavelength of 266 nm. The influence of the deposition parameters such as oxygen pressure, substrate temperature and laser energy density on the properties of the grown films was studied. The experiments were performed for substrate temperatures in the range of 200∼50$0^{\circ}C$ and oxygen pressure in the range of 100∼700 sccm. All of the films grown in this experiment show strong c-axis orientation with (002) textured ZnO peak. With increasing substrate temperature, the FWHM (full width at half maximum) and surface roughness were decreased. In the case of using sapphire substrate, the intensity of PL spectra increased with increasing ambient oxygen flow rate. We investigated the structural and morphological properties of ZnO thin films using X-ray diffraction (XRD), scanning electron microscopy (SEM) and atomic force microscopy (AFM).

We report the theory of thin-sample Z -scan for materials, viz. diffusion-dominated photorefractives, having a nonlinearly induced phase that may be proportional to the spatial derivative of the intensity profile. The on-axis far-field intensity is approximately an even function of the scan distance on different positive and negative values for phase shift $\Delta$$\Phi$$_{o}$. In case of positive phase shift, the Z -scan graph shows a minimum and two maxima, while for the negative value, only one minimum is observed. The fact is that far-field beam profiles display beam distortion and shift of the peak as compared with Kerr-type or photovoltaic nonlinearities.s.