The water treatment by electrochemical method was performed to increase the yield of production. Continuous plug flow reactor was operated to treat poultry and domestic wastewaters. Experimental results were compared with experimental results of the wastewater treatment by chemical coagulation, they were increased over 10% in the removal efficiency of COD and the production rate of sludge was reduced by 30%. Ozone utilized to degrade or change the organic chemical structures, which removal efficiency increased to 20% in the electro-coagulation reactor. Economic evaluation was performed to estimate total cost of electro-coagulation reactor in comparison with that of chemical coagulation method. The total cost to treat 1000 ton/day of domestic wastewater was reduced by 50%.

If a pollutant invade at liguid and gas, it will be use ozone in order to remove or sterilize. Ozone excessively supply in order to receive satisfactory efficiency. If excessive ozone leave like that, second-problem will be occur. This study used high heater in order to treat occurred ozone. ; the results were as follow : 1. As initial ozone os supplied with $1.789{\;}g/m^3$ : For the 40, 50, 60, 70(V) of electric potential $O_3$ removal efficiency was treated 34.41, 73.78, 98.60, 98.97%(time of operation ; after 5min.). 2. As initial ozone is supplied with $3.645{\;}g/m^3$ : For the 40, 50, 60, 70(V) of electric potential, $O_3$ removal efficiency was treated 1.78, 69.27, 99.18, 98.68%(time of operation ; after 5min.). 3. As initial ozone is supplied with $4.759{\;}g/m^3$ : For the 50, 60, 70(V) of electric potential, $O_3$ removal efficiency was treated 61.29, 99.29, 99.18%(Time of operation ; after 5min.). 4. Used electric power is 15.38, 24.00, 35.29, 46.15(w/hr) at the 40, 50, 60, 70(V) of the electric potential. 5. Regarding electric power and $O_3$ removal efficiency, Used electric pote-ntial economized at 60(V).

The objective of this study was to investigate the component ratio of gas generated at closed GD landfill site in MY city and the decomposition status of landfill gas, and was to examine and analyze the properties of the landfill gas. In addition, to provide basic data required to stabilize landfill earlier in the future, the study was to measure gas by landfill gas gauge and to analyze the properties of landfill gas based on documents. As a result of analyzing the properties, acquired follow results. 1. The main elements of landfill gas, $CH_4$ and $CO_2$ were respectively 25.02% and 22.325 on the average. 2. $NH_3$ and $H_2S$ were respectively 1.07 4.97 and 0.75 1.15 on the average. 3. Generated gas was different depending on water, pH properties of MSW(Munticipal Solid Wastes) and their decomposition rate. Furthermore, when measured the temperature of room to inspect landfill gas, the temperature was $22{\;}-{\;}30^{\circ}C$ in the average.

This study was aimed to evaluate biodegradability for various food waste using anaerobic batch digestion. In the anaerobic biodegradability study of each food waste according to occurrence source, the cumulative methane productions of water melon and melon were 375, and 354ml and that of cucumber, fresh cabbage, radish, sprouted bean were 366, 364, 374, 384, 355ml and that of noodle, boiled rice and fish were 432, 409 and 477ml $CH_{4/g}$ VS add, respectively. And methane yield rate was about 84.1~97.2%. The reaction rate coefficiency(k) was $0.00495~0.2022day^{-1}$.

The purpose of this study was to investigate the created liquid post-acid fermentation of usability of denitrification as exterior carbon sources by pH control. The time of acid fermentation of food waste, the slower loading capacity of organic matter, the faster decomposition rate, but the density of generation Volatile Fermentation Acids(VFAs), was weak and, $SBOD_{5}$ : ST-N rate and $SBOD_{5}/SCOD_{Cr}$ rate was low. Between TS and VS, VS was decreased to 4.5th day fast, and then was decreased slowly. 1.5 days after stating the experiments, $SCOD_{Cr}$, $SBOD_{5}$, STOC and $VFA_{s}$ was decreased of increased slowly, and then increased fast. And after showing the highest density, it was tended to decreased fast. At the time of $SBOD_{5}$ with the highest density, at $SBOD_{5}$ : ST-N ratio, $R_1$ was 303:1, $R_2$ was 319:1, $R_3$was the highest. After studying $SBOD_{5}$ : ST-N ratio and $SBOD_{5}/SCOD_{Cr}$ ratio, as a carbon source of biological denitrification it was profitable composition ratio.

In this work, the heterogeneous ion exchange membrane was used in a electrodialysis apparatus to treat a Ni planting rinse water because the heterogeneous ion exchange membrane was excellent efficiency as compared with low manufacturing cost, was easy to make, and had a good mechanical properties. For a regeneration of membrane and to obtain the optimal condition for a scale-up of apparatus after treating Ni plating rinse water, we would find about the limiting current density and the concentration polarization. When the Ni plating rinse water 150mg/L was treated with the electrodialysis apparatus using the heterogeneous ion exchange membrane, the limiting current density was about $1.49{\;}mA/\textrm{cm}^2$. And the limiting current density increased with the flow rate and concentration of Ni plating rinse water. We recognized that the used membrane could be reused by periodic backwashing because efficiency was constant when the membrane was backwashed after treating wastewater.

We investigated to find the optimum operation condition of electrolysis which have an influence on removal efficiency of heavy metals. When we experimented the testing wastewaters containing each 250mg/L of Cu and Ni ions, we got the variables like as pH, amount of electrolyte(NaCl), different species of electrode, electrode gap, electric strength, the number of electrodes, after fastening positive electrode plate with Al, Fe, Ti and negative electrode plate with Stainless Steel plate.

This study is carried out to investigate the water quality changes in Busan Metropolitan streams, The results are as follows. The level of organic contaminants($BOD_{5}$ and $COD_{Mn}$) is found to be low and does not show seasonal variation in domestic waste water streams. But, the level of organic contaminants in industrial waste water streams is relatively high and seems to be seasonally variable, which is affected by other factors. The nutrient materials, such as nitrogen(as T-N, about 20mg/L) and phosphorus(as T-P about 2.0mg/L), are abundant than Nak Dong River and the general trends of contaminants level are similar to those of organic contaminants. The chronic water qualities, including organic, nutrient contaminants levels, show that the loading rates in 1998 are smaller than the past(1983, 1992). And this trend is more evident in industrial waste water streams than domestic waste water streams.

This study was initiated to evaluate and resolve the potential problems caused as the MSWI(Municipal Solid Waste Incinerator) fly ash were stabilized and solidified into the cement. The physical and chemical properties of fly ashes (K and M) used in this study were fixed according to the operating conditions of the incineration plant. The compressible strength of the solidified matrix used in this study were measured at 7, 28, and 56 curing days, respectively, to evaluate the stability of the solidified matrix, which were further analyzed by XRD and SEM. The experimental results obtained in this study showed that the relatively long hours of curing periods were needed to solidify the fly ash. The solidified matrix containing K ash had the high and excellent compressible strength of $200{\;}kg/\textrm{cm}^2$, after 56 curing days, but was not good enough in appearance. The analytical data by SEM confirmed that the alkaline Na and K, which are highly dissolved in water, were included in the fly ash and evenly distributed into the exterior surface of the solidified matrix. Whereas, the solidified matrix containing M ash never showed such a compressible strength as shown in the K ash due to the severe fracture, even as early as 7 curing days. Based on its XRD analysis, it appeared that both $C_2S$ and $C_3S$ highly related to the compressible strength were not crystallyzed into the solidified matrix. However, the compressible strength of the solidified and cemented M ash was remarkably improved by 100 times, after the alkalinity was washed out, which indicated that it is equivalent to 30 to 40g per one kg of fly ash.

본 연구는 폐수 중 함유된 고농도의 LAS를 제거하기 위해 $FeSO_4$를 이용한 응집, 펜톤산화, 펜톤 공정 전.후에 응집공정을 조합시킨 Coagu-oxidation 및 Renton's Coagulation을 이용하여, 처리 시 최적 조건을 도출하고, 효율적인 화학적 처리방법을 검토하기 위해 수행되었다. 연구로부터 얻어진 결론은 다음과 같다. 응집공정은 pH 8, 응집제의 주입량 200mg/L인 조건에서, 펜톤산화는 pH 3, $H_2$$O_2$에 대한 ${Fe^2}^{+}$의 비가 1:1인 조건에서 최적효율을 보였다. Fenton's Coagulation 처리 시 LAS의 개환율은 높아졌고, 주입된 LAS농도의 73~96%가 제거되어 4가지 처리 방법 중 가 장 좋은 처리효율을 보였다. 따라서, LAS의 생물학적 처리 시 거품 및 부산물 생성 등에 의해 저해작용을 감안한다면, LAS가 다량으로 함유한 산업 폐수에서 화학적 처리방법의 도 입이 적절할 것으로 생각되며, 이들 중 Fenton's Coagulation을 유용하게 적용될 수 있을 것으로 판단된다.

Commercial liquid seeds are used for supplying active microbial flora to organic wastewater treatment plants of high feed-to-microorganism ratio and to maintain optimal microbial condition during unsteady state operation of the biological wastewater treatment plant. In addition to bacterial cells, the liquid weeds contain various additives for special purposes as well as organic substrates for energy supply. The additives give physical stability for the maintenance of microbial decomposition activity and ability to control the overgrowth of seed strains. In this work, the effects of addition of two kinds of typical substrate additives, poly aluminum chloride(PAC) and poly aluminum sulfate(PAS) on the consitutional total cell counts(CFU/ml) of four kinds of reorganization liquid seeds(RLS I, RLS II, RLS III and RLS IV) were studied experimentally. The addition of PAC and PAS gave negative effect on TCC constitution for the four seeds studied.

Cross linked chitosan beads showed high selective adsorption abilities in order of $Au^{3+}$ > $Hg^{2+}$ > $Cu^{2+}$ > $Cd^{2+}$ > $Pt^{4+}$ > ${UO_2}^{2+}$ ions in mixed solution of various metal ions at pH 4.5. N-methyltyiobenzylated chitosan beads(MTB-chitosan beads) were prepared treating with p-(methylthio) benzaldehyde after cross linking of chitosan beads to give them a high selectivity in adsorption of metal ions. The MTB-chitosan beads demonstrated their selectivity on precious metals among various metal ions distinctively. Particularly, the MTB-chitosan had a peculiar selective adsorption on $Pd^{2+}$, $Au^{2+}$, and $Hg^{2+}$ions whilst the cross linked chitosan beads showed its high adsorption on $Pd^{2+}$ at pH 1.1. On the other hand, the cross linked chitosan beads showed its superiority in selective adsorption on $Au^{2+}$, $Cu^{2+}$, and $Hg^{2+}$ions to the MTB-chitosan at pH 4.5 of the test solution. Thus metal selectivities were given to chitosan beads through chemical modifications.