• 폴리머
• /
• 제29권5호
• /
• pp.508-517
• /
• 2005

가전제품용 플라스틱 재료의 열화 거동과 신뢰성을 고찰하기 위해 열분해에 따른 동역학적 매개변수를 결정하기 위하여 동역학적 열중량 분석기법을 사용하였고, 촉진 열화시험을 수행하였다. 또한, 플라스틱 재료의 내후성을 고찰하고자 제논 아크 광원을 사용하여 촉진 열화시험을 하였고, 가속 열화시험후 시료의 색차를 컬러 아이 3010 색차분석기를 이용하여 측정하였다. 재료는 중량감소율이 증가함에 따라 열분해 활성화 에너지도 증가하는 경향을 보였다. 플라스틱 재료의 열분해에 관한 기술은 Kim-Park법이 가장 효과적인 분석법으로 나타났다. 플라스틱 재료는 빠른 열화를 진행시키는 자외선에 아주 민감하게 반응하였다.

• 한국재료학회지
• /
• 제25권3호
• /
• pp.144-148
• /
• 2015

Cubic mesocrystal $CeO_2$ was synthesized via a hydrothermal method with glutamic acid ($C_5H_9NO_4$) as a template. The XRD pattern of a calcined sample shows the face-centered cubic fluorite structure of ceria. Transmission electron microscopy (TEM) and the selected-area electron diffraction (SAED) pattern revealed that the submicron cubic mesocrystals were composed of many small crystals attached to each other with the same orientation. The UV-visible adsorption spectrum exhibited the red-shift phenomenon of mesocrystal $CeO_2$ compared to commercial $CeO_2$ particles; thus, the prepared materials show tremendous potential to degrade organic dyes under visible light illumination. With a concentration of a rhodamine B solution of 20 mg/L and a catalyst amount of 0.1 g/L, the reaction showed higher photocatalytic performance following irradiation with a xenon lamp (${\geq}380nm$). The decoloring rate can exceed 100% after 300 min.

• 한국산학기술학회논문지
• /
• 제12권9호
• /
• pp.3795-3801
• /
• 2011

자동차 방전 램프의 전압과 전류에 대한 수학적 해석은 고전압 안정기 해석 및 설계에 유용하게 활용된다. 본 논문에서는 자동차 방전 램프에서 발생되는 램프 전력과 음극 전압 강하 현상에 대한 수학적 모델을 제안하였다. 제안된 모델에 적용된 수치해석 알고리즘을 구현하였고 여기에서 발생된 해석결과는 실험과 비교 검토하였다. 또한, 본 논문에서는 설계 기반의 해석방법을 적용하여 자동차용 고전압 안정기 핵심 부품에 대한 설계 인자를 도출하였다.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2008년 영문 학술대회
• /
• pp.557-560
• /
• 2008

A two-dimensional particle-in-cell(PIC) simulation with a Monte-Carlo Collision(MCC) has been developed to investigate the discharge characteristics of the acceleration channel of a HET. The dynamics of electrons and ions are treated with PIC method at the time scale of electrons in order to investigate the particle transport. The densities of charged particles are coupled with Poisson's equation. Xenon neutrals are injected from the anode and experience elastic, excitation, and ionization collisions with electrons, and are scattered by ions. These collisions are simulated by using an MCC model. The effects of control parameters such as magnetic field profile, electron current density, and the applied voltage have been investigated. The secondary electron emission on the dielectric surface is also considered.

• Macromolecular Research
• /
• 제17권3호
• /
• pp.149-155
• /
• 2009

The thermal decomposition behavior and degradation characteristics off our different thermotropic liquid crystalline polymers (TLCPs) were studied. The thermal decomposition behavior was determined by means of thermogravimetric analysis (TGA) at different heating rates in nitrogen and air. The order of the thermal stability was as follows: multi-aromatic polyester > hydroxybenzoic acid (HBA)/hydroxynaphthoic acid (HNA) copolyester > HNA/hydroxyl acetaniline (HAA)/terephthalic acid (TA) copolyester > HBA/Poly(ethylene terephthalate) (PET) copolyester. The activation energies of the thermal degradation were calculated by four multiple heating rate methods: Flynn-Wall, Friedman, Kissinger, and Kim-Park. The Flynn-Wall and Kim-Park methods were the most suitable methods to calculate the activation energy. Samples were exposed to an accelerated degradation test (ADT), under fixed conditions of heat ($63{\pm}3^{\circ}C$), humidity ($30{\pm}4%$) and Xenon arc radiation ($1.10\;W/m^2$), and the changes in surface morphology and color difference with time were determined. The TLCPs decomposed, discolored and cracked upon exposure to ultraviolet radiation.

• International Journal of Precision Engineering and Manufacturing-Green Technology
• /
• 제5권5호
• /
• pp.643-650
• /
• 2018

A self-powered electrochromic device was fabricated on an indium tin oxide-polyethylene naphthalate flexible substrate using a dye-sensitized solar cell (DSSC) as a self-harvesting source; the electrochromic device was naturally bleached and operated under outdoor light conditions. The color of the organic electrochromic polymer, poly(3,4-ethylenedioxythiophene) polystyrene sulfonate, was shifted from pale blue to deep blue with an antimony tin oxide film as a charge-balanced material. Electrochromic performance was enhanced by secondary doping using dimethyl sulfoxide. As a result, the device showed stable switching behavior with a high transmittance change difference of 40% at its specific wavelength of 630 nm for 6 hrs. To improve the efficiency of the solar cell, 1.0 wt.% of Ag NWs in the photoanode was applied to the $TiO_2$ photoanode. It resulted in an efficiency of 3.3%, leading to an operating voltage of 0.7 V under xenon lamp conditions. As a result, we built a standalone self-harvesting electrochromic system with the performance of transmittance switching of 29% at 630 nm, by connecting with two solar cells in a device. Thus, a self-harvesting and flexible device was fabricated to operate automatically under the irradiated/dark conditions.

• Journal of Photoscience
• /
• 제9권2호
• /
• pp.197-200
• /
• 2002

UVR-induced immunosuppression contributes to skin cancer. The aim was to construct accurate dose response curves for primary and secondary contact sensitivity for solar-simulated UVR (ssUVR; 290-400nm), UVA and UVB as the role of UVA in immunosuppression is controversial. We used a xenon arc source. The mice were immobilised, enabling accurate dosing. C57BL/6 mice were immunosuppressed at half the dose of ssUVR required to cause sunburn but not by higher doses (up to the sunburn dose). Thus, ssUVR causes systemic immunosuppression only over a narrow, low dose range. UVA caused suppression at low but not high doses whereas UVB induced immunosuppression at all doses tested. 8 weeks later the mice were resensitised to assess tolerance. Mice exposed to the minimum immunosuppressive dose of ssUVR prior to primary sensitisation were tolerant to re-sensitisation. However, at higher doses of ssUVR, these mice were protected from tolerance. Interestingly, while low doses of UV A caused immunosuppression, even lower doses enhanced the response to the second sensitisation. Higher doses of UVA had no affect. UVB induced tolerance in a dose related manner. Thus, ssUVR only induces immunosuppression and tolerance over a narrow dose range. Both UVA and UVB are immunosuppressive at this dose, while higher doses of UVA protect from the suppressive effects of UVB. Surprisingly very low doses of UVA enhanced memory development. Thus UVR has complex effects on the immune system depending on dose and spectrum.

• 한국결정성장학회지
• /
• 제14권3호
• /
• pp.123-128
• /
• 2004

융제(flux)로서 $B_2O_3$의 농도를 0-10 wt%까지 변화시킨 $SrAl_2O_4$ : $Eu^{+2}$, $Dy^{+3}$계 장잔광 형광체를 고상반응법으로 합성한 후, $B_2O_3$의 첨가량에 따른 결정특성과 장잔광 축광재료로서 가장 중요한 발광 및 장잔광 특성을 조사하였다. $SrAl_2O_4$ : Eu$^{+2}$, $Dy^{+3}$계 형광체는 $B_2O_3$의 농도에 관계없이 520nm 파장을 최대 발광파장으로 하는 발광스펙트럼을 나타내었고, 3wt%의 $B_2O_3$ 농도에서 최대 발광강도를 나타내었다. 그리고 $SrAl_2O_4$ : Eu$^{+2}$, $Dy^{+3}$ 형광체의 잔광강도 역시 $B_2O_3$의 농도에 무관하게 시간에 따라 모든 시료에서 지수 함수적으로 감소하였으나, $B_2O_3$의 농도가 3wt%인 경우에 발광의 감쇠속도가 작은 뛰어난 장잔광특성을 나타내었다.

• 한국분말재료학회지
• /
• 제25권3호
• /
• pp.226-231
• /
• 2018

F-containing $TiO_2$ nanopowders are synthesized using simple wet processes (precipitation-based and hydrothermal) from ammonium hexafluorotitanate (AHFT, $(NH_4)_2TiF_6$) as a precursor to apply as a photocatalyst for the degradation of rhodamine B (RhB). The surface properties of the prepared samples are evaluated using X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), field-emission scanning electron microscopy (FESEM), and transmission electron microscopy (TEM). The results confirm that the synthesized anatase $TiO_2$ has sphere-like shapes, with numerous small nanoparticles containing fluorine on the surface. The photocatalytic activity of F-containing $TiO_2$ compared with F-free $TiO_2$ is characterized by measuring the degradation of RhB using a xenon lamp. The photocatalytic degradation of F-containing $TiO_2$ exhibits improved photocatalytic activity, based on the positive effects of adsorbed F ions on the surface.

• 한국전산유체공학회지
• /
• 제21권2호
• /
• pp.112-119
• /
• 2016

NEXTSat-1 is the next-generation small-size artificial satellite system planed by the Satellite Technology Research Center(SatTReC) in Korea Advanced Institute of Science and Technology(KAIST). For the control of attitude and transition of the orbit, the system has adopted a RHM(Resisto-jet Head Module), which has a very simple geometry with a reasonable efficiency. An axisymmetric model is devised with two coil-resistance heaters using xenon(Xe) gas, and the minimum required specific impulse is 60 seconds under the thrust more than 30 milli-Newton. To design the module, seven basic parameters should be decided: the nozzle shape, the power distribution of heater, the pressure drop of filter, the diameter of nozzle throat, the slant length and the angle of nozzle, and the size of reservoir, etc. After quasi one-dimensional analysis, a theoretical value of specific impulse is calculated, and the optima of parameters are found out from the baseline with a series of multi-physical numerical simulations based on the compressible Navier-Stokes equations for gas and the heat conduction energy equation for solid. A commercial code, COMSOL Multiphysics is used for the computation with a FEM (finite element method) based numerical scheme. The final values of design parameters indicate 5.8% better performance than those of baseline design after the verification with all the tuned parameters. The present method should be effective to reduce the time cost of trial and error in the development of RHM, the thruster of NEXTSat-1.