• Journal of Korea Soil Environment Society
• /
• v.5 no.1
• /
• pp.75-83
• /
• 2000

Recently, many landfills are constructed by using geosynthetics with earth materials. Geotextiles in geosynthetics are applied for the various purposes such as filters of the leachate collection and removal system and protectors of geomembrane liner. However geotextiles can be exposed to direct sunlight during the construction of landfill for several months. As you know the exposure of polymers to sunlight can be a major source of degradation of them. This study is to suggest a criteria on the installation of heavy weight geotextiles at the landfill. For this purpose, several different geotextiles were evaluated by outdoor exposure at two different locations and under the different seasons for one and half years. As the results of outdoor exposure, polypropylene geotextiles with 500g/$m^2$ and 700g/$\textrm{m}^2$were maintained around 40% of the initial strength during for one and half years. However, the polypropylene geotextile of 1000g/$\textrm{m}^2$showed 65% of the retained strength for the same duration of exposure. The retained strength of all polypropylene geotextile reduced dramatically with the cumulative sunshine radiation on a horizontal surface of around 1500MJ/$\textrm{m}^2$.

• The Journal of Engineering Geology
• /
• v.15 no.2 s.42
• /
• pp.123-132
• /
• 2005

This study presents the results of a laboratory investigation performed to study physical properties of soil-bentonite mixtures through the vertical permeation test and dielectric measurement test using Frequency Domain Reflectometry system for the liner of waste landfill. For the laboratory experiments, geotechnical testing was conducted on pre-mixed soil-bentonite which is consisted of standard sand, weathered granite soil and bentonite for estimating physical parameters such as a volumetric water content, void ratio and dielectric constant. In experiment results, initial soil-bentonite mixing rate has an effect of change of volumetric water content. Also change of volumetric water content of a soil-bentonite mixture is clearly detected to measure a response of dielectric constant. In order to estimate an unsaturated permeable property of soil-bentonite mixtures, equations between volumetric water content and dielectric constant were derived from this study.

• Journal of the Korean Geotechnical Society
• /
• v.20 no.6
• /
• pp.11-17
• /
• 2004

This study focused on the protection effects of geosynthetics installed on HDPE to resist against puncture loads. The study was conducted by a model test with various types of puncture loads created by different shapes of tools. The puncture resistance of geosynthetics installed as a protective material on HDPE is varied depending on the sizes of geosynthetics and types of puncture loads. In this study, it was found that the protection effect far all kinds of geosynthetics when a truncated cylindrical shape of puncture tool is used is lower than others. Also, geocomposite has the most excellent protection effect against all types of puncture loads.

• Journal of the Korean Geosynthetics Society
• /
• v.10 no.2
• /
• pp.67-72
• /
• 2011

CMDS (Coal Mine Drainage Sludge) is mainly generated from acid mine drainage during physicochemical treatment or electrical purification. CMDS is well worth considering on recycling possibilities in various areas. This research applies the liner and cover materials using waste disposal landfill generally to treat acid mine drainage sludge. In this Part I of the two parts paper, physico-chemical characteristics of CMDS, bentonite and cement to prepare the liner have been identified using XRD, XRF, FESEM. In addition, combining their physicochemical characteristics, the optimum mixing ratio has been determined to be 1: 0.5: 0.3 for CMDS: bentonite: cement by the batch tests. Initial permeability of CMDS was $7.10{\times}10^{-7}cm/s$. Through the leaching test, it was confirmed that its mixture was environmentally safe. In the Part 2, a large-scale Lysimeter was used to simulate the effects of the layer on the freeze/thaw for evaluation on field applicability and stability.

• Journal of the Korean GEO-environmental Society
• /
• v.1 no.1
• /
• pp.19-26
• /
• 2000

This study is and experimental study to investigate the possibility of the utilization of paper ash as the cover and liner materials in the waste disposal landfill and other construction materials. A series of tests were performed to evaluate basic properties, compaction, compressive strength, consolidation, permeability, and CBR of paper ash. The sample used in these tests was obtained from four paper mills which are located in near Ch$\hat{o}$ngju. Bentonite and lime were used as addictives to improve permeability properties of paper ash. It was found that the maximum dry unit weight increases with the increase of the bentonite and lime contents. The results of unconfined compression tests show that paper ash meets the criteria of the unconfined compression strength. It is recognized that the permeability coefficient decreases as increasing bentonite content and the percentage of bentonite needed to make the permeability coefficient below $1{\times}10^{-7}cm/sec$ was 30%.

• Journal of the Korean Geosynthetics Society
• /
• v.12 no.4
• /
• pp.67-76
• /
• 2013

Landfill require special care due to the dangers of nearby surface water and underground water pollution caused by leakage of leachate. The leachate does not leak due to the installation of the geomembrane but sharp wastes or landfill equipment can damage the geomembrane and therefore a means of protecting the geomembrane is required. In Korea, in accordance with the waste control act being modified in 1999, protecting the geosynthetics liner on top of the slope of landfill and installing a drainage layer to fluently drain leachate became mandatory, and technologies are being researched to both protect the geomembrane and quickly drain leachate simultaneously. Therefore, this research has its purpose in studying the drainage functions of leachate and protection functions of the geomembrane in order to examine the application possibilities of Geo-Multicell-Composite (GMC) as a Leachate Collection Removal and Protection System (LCRPs) at the slope on top of the geomembrane of landfill by observing methods of inserting filler with high-quality water permeability at the drainage net. GMC's horizontal permeability coefficient is $8.0{\times}10^{-4}m^2/s$ to legal standards satisfeid. Also crash gravel used as filler respected by vertical permeability is 5.0 cm/s, embroidering puncture strength 140.2 kgf. A result of storm drain using artificial rain in GMC model facility, maxinum flow rate of 1,120 L/hr even spray without surface runoff was about 92~97% penetration. Further study, instead of crash gravel used as a filler, such as using recycled aggregate utilization increases and the resulting construction cost is expected to savings.

• Journal of the Korean GEO-environmental Society
• /
• v.4 no.4
• /
• pp.25-34
• /
• 2003

This paper is focused on an experimental study in order to investigate the utilization of sewage sludge ash as the cover and liner materials for the waste disposal landfill or as construction materials. A series of tests were performed to evaluate the basic properties, compaction, compressive strength, consolidation, permeability, and CBR of sewage ash. Specially, clay bricks were made as increasing replacement ratio of sewage ash (such as 5, 10, 15, 20, 25, 30%). And tests were fulfilled for its quality. Bentonite and lime were used as the additives to improve permeability properties of sewage sludge ash. As a result of tests, it was shown that the permeability coefficient decreases as increasing bentonite content and the percentage of bentonite was roughly needed 20% to keep the permeability coefficient below $1{\times}10^{-7}cm/sec$. The results of unconfined compression tests show that sewage ash meets the criteria of the unconfined compression strength for cover material. It was shown that the compressive strength decreases as increasing the replacement ratio of sewage sludge ash and the maximum replacement ratio of sewage sludge ash to satisfy the quality standards of the third degree bricks was about 15%.

• Journal of the Korean Geotechnical Society
• /
• v.21 no.4
• /
• pp.115-122
• /
• 2005

In this paper, a new method composed of discrete element method and genetic algorithm has been introduced to estimate the safety factor and search critical slip surface on slope stability analysis. In case of estimating the safety factor, conventional methods of slope analysis based on the limit equilibrium do not satisfy the overall equilibrium condition; they must make assumptions regarding the inclination and location of the interstice forces. An alternative slope analysis method based on the discrete element method, which can consider the compatibility condition between force and displacement, is presented. Real-coded genetic algorithm is applied to the search for the minimum factor of safety in proposed analysis method. This search method is shown to be more robust than simple optimization routines, which are apt to find local minimum. Examples are also shown to demonstrate the applicability of the proposed method.