• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.23 no.5
• /
• pp.394-400
• /
• 2013

Underwater radiated noise is one of the important performances related to stealth of the naval vessel. However, the evaluation can't be performed frequently due to the cost. Therefore, the estimation method of the underwater radiated noise with average hull vibration is suggested in this paper assuming that the hull of the ship is infinite plate which consists of various unit plates. Through the experiment, the estimated noise is verified from the comparison to the measured data. In addition the difference of underwater radiated noise according to the operating equipments is estimated with measured vibration velocity.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.15 no.1
• /
• pp.33-40
• /
• 2011

In this paper, underwater acoustic communication experiment was carried out to test a performance of single carrier digital modulation schemes. The communication experiment was performed at real sea and tested modulation schemes are ASK, FSK with non-coherent detection and QPSK with coherent detection. A modulated image data was transmitted with data rates of 600bps~3Kbps. From the results of BER of the demodulated signal, ASK and FSK show the achievable BER of $10^{-3}{\sim}10^{-4}$ without compensation techniques and QPSK show that of $10^{-4}$ with linear equalizer.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.10 no.5
• /
• pp.645-652
• /
• 2015

In underwater, such as fish farm and sea, turbidity is increased by water droplets and various suspended, therefore light attenuation occurs depending on the depth also caused by the scattering effect of light float. In this paper, in order to improve the visibility of underwater images obtained from these aquatic environment, we propose a visibility enhancement method using a haze removal method based on dark channel prior and a trained color transform model. In order to train a color transform model, we used underwater pattern images captured from Pohang and Yeosu, and to measure the performance of the proposed method, we carried out experiment of visibility enhancement using underwater images collected from Yeosu, Geomundo and Philippines. The results show that the proposed method can improve the visibility of underwater images of various locations.

• Proceedings of the IEEK Conference
• /
• 2003.07e
• /
• pp.2259-2262
• /
• 2003

This paper describes visual tracking procedure of the underwater mobile robot for nuclear reactor vessel inspection, which is required to find the foreign objects such as loose parts. The yellowish underwater robot body tend to present a big contrast to boron solute cold water of nuclear reactor vessel, tinged with indigo by Cerenkov effect. In this paper, we have found and tracked the positions of underwater mobile robot using the two color informations, yellow and indigo. The center coordinates extraction procedures is as follows. The first step is to segment the underwater robot body to cold water with indigo background. From the RGB color components of the entire monitoring image taken with the color CCD camera, we have selected the red color component. In the selected red image, we extracted the positions of the underwater mobile robot using the following process sequences: binarization labelling, and centroid extraction techniques. In the experiment carried out at the Youngkwang unit 5 nuclear reactor vessel, we have tracked the center positions of the underwater robot submerged near the cold leg and the hot leg way, which is fathomed to 10m deep in depth.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.17 no.1
• /
• pp.119-124
• /
• 2022

Successful underwater localization requires a large-scale, parallel computing environment that can be mounted on various underwater robots. Accordingly, we propose a design method for an artificial intelligence computing platform for underwater localization. The proposed platform consists of a total of four hardware modules. Transponder and hydrophone modules transmit and receive sound waves, and the FPGA module rapidly pre-processes the transmitted and received sound wave signals in parallel. Jetson module processes artificial intelligence based algorithms. We performed a sound wave transmission/reception experiment for underwater localization according to distance in an actual underwater environment. As a result, the designed platform was verified.

• Journal of the Society of Naval Architects of Korea
• /
• v.61 no.1
• /
• pp.1-7
• /
• 2024

Underwater sound speed is an important analysis parameter on an estimation of the underwater radiated noise (URN) emitted from vessels. This paper aims to present an underwater sound speed measurement procedure using a cross-correlation of time-domain acoustic signals and validate the procedure through an experiment in a reverberant water tank. For the purpose, time-domain acoustic signals transmitted by a Gaussian pulse excitation from an acoustic projector have been measured at 20 hydrophone positions in the reverberant water tank. Then, the sound speed in water has been calculated by a linear regression using 190 cross-correlation cases of distances and time lags between the received signals and the result has been compared with those estimated by the existing empirical formulae. From the result, it is regarded that the presented experimental procedure to measure an underwater sound speed is reliably applicable if the time resolution is sufficiently high in the measurement.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39C no.6
• /
• pp.457-465
• /
• 2014

This paper introduces a test bed for communication protocol schemes of underwater acoustic sensor network, and also shows experimental results obtained from the test bed. As a testing protocol, carrier sense multiple access/collision avoidance (CSMA/CA) is evaluated on underwater acoustic channel. A sensor node is equipped with a DSP control board of ATmega2560 and a commercial underwater modem produced by Benthos. The control board not only manipulates a GPS signal to acquire the information of location and time, but also controls the underwater modem to operate according to the procedure designed for a given testing protocol. Whenever any event takes place such as exchanging control/data packets between underwater modems and acquiring location and timing information, each sensor node reports them through radio frequency (RF) air interface to a central station located on the ground. The four kinds of packets for CSMA/CA, RTS(Request To Send), CTS(Clear to Send), DATA, ACK(Acknowledgement) are designed according to the underwater communication environment and are analyzed through the lake experiment from the point of feasibility of CSMA/CA in underwater acoustic communications.

• Journal of Navigation and Port Research
• /
• v.42 no.1
• /
• pp.1-8
• /
• 2018

This study covers the selection of systems measuring the behaviour of the slender structure in the underwater environment and its performance assessment. From a comparison of an instrumentation system that can measure the continuous behaviour along the entire length of the slender structure, the underwater camera system is finally selected as the most appropriate semi-permanent measurement system for Deep-sea Ocean Engineering Basin of KRISO. An experiment on the rigid pipes for a basic performance evaluation of the underwater camera is conducted in this study. The motion of a top excited rigid pipe is measured with the utilization of the underwater camera system. The performance of the underwater camera is evaluated by comparing the movement of a pipe measured by the underwater camera with the measured input signals. Through the top excitation experiment for the slender structure, the real-time three-dimensional measurement of the underwater camera system is qualitatively evaluated in this case. The developed underwater camera system can apply to the system to measure dynamic behaviour of a slender structure and mooring line in Deep Ocean Engineering Basin.

• Nuclear Engineering and Technology
• /
• v.55 no.10
• /
• pp.3709-3715
• /
• 2023

It is an important work to measure the dimensions of underwater spent fuel assemblies in the nuclear power industry during the overhaul, to judging whether the spent fuel assemblies can continue to be used. In this paper, a three dimensional reconstruction method for underwater spent fuel assemblies of nuclear reactor based on linear structured light is proposed, and the topography and size measurement was carried out based on the reconstructed 3D model. Multiple linear structured light sensors are used to obtain contour size data, and the shape data of the whole spent fuel assembly can be collected by one-dimensional scanning motion. In this paper, we also presented a corrected model to correct the measurement error introduced by lead-glass and water is corrected. Then, we set up an underwater measurement system for spent fuel assembly based on this method. Finally, an underwater measurement experiment is carried out to verify the 3D reconstruction ability and measurement ability of the system, and the measurement error is less than ±0.05 mm.

• The Journal of the Acoustical Society of Korea
• /
• v.37 no.1
• /
• pp.21-30
• /
• 2018

A passive time-reversal technique can improve error performance of the underwater communication system by reducing influence of inter-symbol interferences, which is caused by a multipath channel response. The passive time-reversal communication system equipped with numerous receivers generally can obtain superior error performance since larger diversity gain can be obtained as the number of available received signal increased. In this paper, we analyze the optimal number and combination of receivers that can approximately achieve the best error performance when using the limited number of receivers. For this analysis, we use communication data collected during SAVEX15 (Shallow-water Acoustic Variability Experiment 2015) carried out in the south-western part of Jeju Island from May 14 to May 28, 2015. Analysis results show that there are depths of energy concentration due to the channel characteristics in which the underwater sound channel are present, and the passive time-reversal technique using the limited number of the receivers can derive near-optimal communication performance if the receivers for time-reversal processing are located at the depths where energy is concentrated.