• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2016.11a
• /
• pp.201.2-201.2
• /
• 2016

$Mg_xNi_yZn_{1-x-y}Fe_2O_4$ ferrite powders were prepared by self-propagating high temperature synthesis followed by classified by ultrasonic wet-magnetic separation method to get nano-sized particles with high purity. The $Mg_xNi_yZn_{1-x-y}Fe_2O_4$ ferrites were well formed by using several powders like iron, nickel oxide, zinc oxide and magnesium oxide at 0.1 MPa of oxygen pressure. The ultrasonic wet-magnetic separation of pre-mechanical milled ferrite powders produced the powders with average size of $3.7-0.8{\mu}m$. The addition of a surfactant during the separation process improved productivity more than twice. The coercive force, maximum magnetization and residual magnetization of the $Mg_xNi_yZn_{1-x-y}Fe_2O_4$ nano-powders with 810 nm size were 45.89 Oe, 53.92 emu/gOe, 0.4 emu/Oe, respectively.

• Elastomers and Composites
• /
• v.38 no.2
• /
• pp.147-156
• /
• 2003

Synthesis of fullerene oxides by fullerenes [$C_{60},\;C_{70}$] and several oxidants such as benzoylperoxide, trichloroisocyanuric acid, methyltrioxorhenium(VII), iodosobenzene, phosphorous pentoxide take place under ultrasonic condition at room temperature. The MALDI-TOF MS,UV-visible spectra and HPLC analysis confirmed that the products of fullerenes oxidation are [$C_{60}(O)_n$], ($n=1{\sim}3$ or n=1) and [$C_{70}(O)_n$], ($n=1{\sim}2$ or n=1). As compared with the reactivity of epoxidation of fullerenes [$C_{60},\;C_{70}$], the reaction rate of $C_{70}$ was lower than that of $C_{60}$ under same reaction condition.

• Journal of the Korean Ceramic Society
• /
• v.44 no.5 s.300
• /
• pp.148-150
• /
• 2007

A process to synthesize $La_{0.8}Sr_{0.2}CrO_3$ (LSC), which is a promising material for use as a separator in a soild oxide fuel cell, is investigated in this study. LSC powders without secondary Phases could be synthesized with ultrasonic spray pyrolysis and a heat treatment at $1200^{\circ}C$ for 20 h; however, it showed an average diameter of $0.6{\mu}m$ with a wide particle size distribution. On the other hand, LSC powders synthesized with spray pyrolysis at $800^{\circ}C$, heat-treated at $900^{\circ}C$ for 5 h, ball-milled and finally heat-treated again at $1200^{\circ}C$ for 20 h showed a smaller average diameter of $0.3{\mu}m$ and narrower size distribution. Very few particles above $0.5{\mu}m$ were found. Thus, a proper combination of the heat treatment and milling process after spray pyrolysis it determined to be very important in synthesizing fine and uniform LSC perovskite powders.

• Korean Journal of Medicinal Crop Science
• /
• v.23 no.2
• /
• pp.155-160
• /
• 2015

This research evaluate antioxidant and skin-whitening effect of Abeliophyllum distichum Nakai by extraction processes. First, antioxidant effects were follows: EE (70% ethanol extract) showed higher DPPH scavenging activity of 69.66% than WE (hot water exract) 59.13% at $0.3mg/m{\ell}$, also UE's (70% ethanol extract by sonication process) higher than EE. Reducing power was that also EE showed higher than WE, and it was the highest value with UE's because of ultrasonic pretreatment. Next, the whitening effect tyrosinase inhibition activity was measured that EE was 23.88%, WE's was 16.69%, and UE was 23.34%. Ultrasonic pretreatment did not influence to tyrosinase inhibition activity. Cell viability showed low cell toxicity in all groups. UE's inhibited melanin synthesis, 55.1%, that is higher than EE and WE, 52.7% and 39.5%, respectively. As a result, we confirmed that antioxidant activities and skin-whitening effect by extraction process. Also, this results confirmed that the Abeliophyllum distichum Nakai extracts worth as cosmetic materials.

• Journal of Powder Materials
• /
• v.25 no.6
• /
• pp.482-486
• /
• 2018

Despite numerous advances in the preparation and use of GaN, and many leading-edge applications in lighting technologies, the preparation of high-quality GaN powder remains a challenge. Ammonolytic preparations of polycrystalline GaN have been studied using various precursors, but all were time-consuming and required high temperatures. In this study, an efficient and low-temperature method to synthesize high-purity hexagonal GaN powder is developed using sub-micron $Ga_2O_3$ powder as a starting material. The sub-micron $Ga_2O_3$ powder was prepared by an ultrasonic spray pyrolysis process. The GaN powder is synthesized from the sub-micron $Ga_2O_3$ powder through a nitridation treatment in an $NH_3$ flow at $800^{\circ}C$. The characteristics of the synthesized powder are systematically examined by X-ray diffraction, scanning and transmission electron microscopy, and UV-vis spectrophotometer.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.1 no.1
• /
• pp.107-116
• /
• 1991

Fine $PbTiO_3$ Particles were synthesized from the $Pb(NO_3)_2$and $TiO(NO_3)_2$ solution by the spray pyrolysis method using the ultrasonic vibrator as a mist generator. The obtained particles were characterized. The mechanisms of particle formation were discussed in comparison with those if other particles, such as $BaTiO_3$, $ZnO_2$, ZnO ....., in the same spray pyrolysis process.

• Journal of the Korean Ceramic Society
• /
• v.29 no.12
• /
• pp.919-925
• /
• 1992

Continuous synthesis process for monodispersed zirconia powders with ultrasonic wave mixing was developed. Reactant solutions were flowed through a T-tube with small diameter and then mixed in a microscale with ultrasonification. Reaction and aging were followed during the mixed solution of reactants is in plug flowing through a narrow long teflon tubing. Zr(n-OC4H9)4 in ethanol and H2O in ethanol were used as reactants. From this process monodispersed, spherical, non-agglomerated, singlet hydrated zirconia powders with 0.6 $\mu\textrm{m}$ average size were obtained. Geometrical standard deviation of the particle size distribution was less than 1.2 with ultrasonic mixing, and the geometrical standard deviation was not affected by the flow rate of the reactants.

• Journal of the Korean Ceramic Society
• /
• v.26 no.5
• /
• pp.691-697
• /
• 1989

Fine TiO2 and BaTiO3 powders having spherical particles were synthesized by ultrasonic spray pyrolysis of alcoholic solution of metal alkoxide in an electric furnace heated at 400-90$0^{\circ}C$. Microstructure and composition of particles synthesized were observed by TEM and XRD respectively. Spectific surface area of powders synthesized was examined through BET specific surface area measurement. TEM observation revealed that the particle size did not change irrespective of pyrolysis temperature but decreased according to the increase of concentration and spherical particle was consisted of primary particles of about 0.02${\mu}{\textrm}{m}$. As for BaTiO3 powder, the ratio of Ti/Ba was 0.987 by EDX analysis.

• Journal of the Korean Applied Science and Technology
• /
• v.18 no.2
• /
• pp.127-135
• /
• 2001

Alkyl polyglucosides were synthesized by solvent-free glycosidation using ultrasonic emulsification. We examined glycosidation conditions of fatty alcohol with glucose hydrate and anhydrous glucose in the presence of p-toluenesulfonic acid. Glucose was emulsified in a molar excess of fatty alcohol for 20 minutes with a ultra-sonicator at room temperature and converted in a stirred reactor to more than 95% polyglucoside within $2.5{\sim}3.5$ hr under $20{\sim}30$ mmHg at $110^{\circ}C$ with a three-fold molar ratio of fatty alcohol to glucose in the presence of 1mol% p-toluenesulfonic acid. It was possible to obtain a polyglucoside mixture of HLB 13 consisting of 65% monoglucoside and 35% oligoglucoside with less than 1% of fatty alcohol.

• Elastomers and Composites
• /
• v.54 no.3
• /
• pp.252-256
• /
• 2019

Fullerene oxide[$C_{60}(O)_n$, ($n{\geq}1$)] was synthesized by dissolving fullerene[$C_{60}$] and 3-chloroperoxybenzoic acid in toluene under refluxing condition for 5 h. Hybrid fullerene oxide-silver nanoparticle composites were synthesized by dissolving fullerene oxide and silver nitrate[$AgNO_3$] in diethylene glycol under ultrasonic irradiation for 3 h. The synthesized hybrid nanocomposites were characterized by X-ray diffraction, scanning electron microscopy, and ultraviolet-visible[UV-vis] spectroscopy. The catalytic activity for the reduction of various nitroanilines[NAs] was identified by UV-vis spectrophotometer. The efficiency of the catalytic reduction by the synthesized hybrid nanocomposites has an order of 4-NA > 2-NA > 3-NA.