• Journal of the Korean Geographical Society
• /
• v.39 no.1
• /
• pp.45-55
• /
• 2004

The paper describes the rainfall-runoff. soil moisture distribution and subsurface flow of 'U-shaped Goll' valley head slope to evaluate quantitatively the interaction between the water circulation system and geomorphic development. The findings are as follows: The fissure and the pipe entrance in front of 'U-shaped Goll' introduce a lot of direct runoff into either the soil pipe or the soil layer to accelerate the erosion of the soil layer, so that they are likely to contribute to the expansion and development of the soil pipe. Most of soil water is to be drained in pipe flow, while some of remaining soil water is to be fed into groundwater. Therefore, low rainfall intensity is thought to let both the groundwater level and the pipe flow react sensitively by the effects of the precedent rainfall even at events: As a result, the soil pipe is said to be an important factor having influence upon the material balance of 'U-shaped Goll' valley head slope. On the other hand, the groundwater shows greater specific flux at the top than at the bottom, and relatively larger specific flux is applied to the top to make 'U-shaped Goll' valley head slope go back to the top.

• Journal of the Korea Concrete Institute
• /
• v.18 no.2 s.92
• /
• pp.283-290
• /
• 2006

The paper describes m experimental study on the shear strengthening of concrete beams with exposed wire rope. The strengthening method is using the mechanical bolting of wire rope tensioned on the exterior of beam section. There are two shear strengthening types. The first is closed type wrapped beam section with wire rope like as closed stirrup. The second is U type tensioned at the anchor located in the side of beam section. The main parameters of specimens are strengthening spacings of wire rope with 150, 200, and 250mm for the closed and U type respectively. The shear span ratio of specimens applied by 3-point loading is 4. The results showed that the ultimate shear strength and ductility of strengthened beams increased significantly compared with non-strengthened beams. Especially, the strengthening effect of closed type was very preferable to U type. Therefore, the shear strengthening method with wire rope is very reasonable in view of repair and rehabilitation of beams.

• Korean Journal of Optics and Photonics
• /
• v.17 no.1
• /
• pp.60-67
• /
• 2006

We constructed a TEA $N_2$ laser which consists of spark gap, pulse type high voltage power supply, Blumlein transmission line circuit, laser tube with Ernst electrode. We observed the self-preionization with an optical fiber in the spark gap and laser tube. The higher voltage power supplied to the Blumlein transmission line circuit, the better preionization was. An U-type transformer yielded better stability and output power than an I-type transformer. The discharge time after triggering a spark gap for the U-type transformer was also short. We obtained the stability of $2.7\%$ and output power of $36{\mu}J$ when the optimum conditions of the laser operation were spark gap distance of 6.0 mm, electrode distance in laser tube of 5.0 mm, $N_2$ gas flow rate in spark gap of 1500 cc/min, $N_2$ gas flow rate in laser tube of 4 ${\iota}$/min, output window reflectivity of $40\%$ and repetition rate of 10 Hz.

• International Area Studies Review
• /
• v.17 no.4
• /
• pp.67-88
• /
• 2013

The purpose of this study empirically examines the pattern of regional disparities on the level of development in China's eastern, central, western and northeast regions for the period 1978-2012. To do this, it test Williamson's inverted-U hypothesis and Amos' augmented inverted-U hypothesis, focusing on polarization, polarization reversal, and spatial restructuring. Results of study are as follows: In the absolute economic disparity(AED) models of per capita income within a region, the Williamson's inverted-U hypothesis was supported in the eastern region, central region and inter-region model. The central region and the western region supports Williamson's hypothesis in the case of the relative economic disparity(RED). On the other hand, The inter-region model and the western region supports Amos' augmented inverted-U hypothesis in model of per capita income. In the urban-rural income economic disparity model, the inter-region model of AED and the central region of RED supports Amos' augmented inverted-U hypothesis. But the Williamson's inverted-U hypothesis was supported in the inter-region model and the western region in RED.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.11 no.1
• /
• pp.85-91
• /
• 2010

In this paper, a new microstrip antenna using asymmetric U-shaped slotted ground is proposed for a switchable circular polarization sense. The proposed antenna is achieved a circularly polarization from orthogonal E-field distributions with 90 degree phase difference due to the asymmetrical U-shaped slot. Moreover, the circular polarization sense of the proposed antenna can be easily switchable with changing the symmetric plane of the U-shaped slots. As a result, the proposed antenna is implemented by two PIN diodes with two different bias condition for ON/OFF states. The measured axial ratios are about 1.5 dB without the dependence of the polarization sense and 3-dB axial ratio bandwidth are achieved 29 MHz with respect to about 1.2 % at 2.46 GHz operating frequency.

• Journal of Bio-Environment Control
• /
• v.22 no.4
• /
• pp.408-412
• /
• 2013

This study was carried out to investigate damp injury caused by tomato coir bag culture and prevent that. The tomato variety was used 'Minichal', and tomatoes were grown in greenhouse. The nutrient solution based on Yamazaki Tomato Standard Solution was irrigated from one hour after sunrise to two hour before sunset. The slits for darainage were made in three types; I, L, and bottom slit type. The coir bag of I and L type had six slits of 15cm length, that of bottom slit type had three slits of 15 cm length. The weight of coir bag in 24 hours after saturation was 14.2 kg in I type, 13.8 kg in L type, and 12.8 kg in bottom slit type, but there was not significant difference. The weight of coir bag after one day irrigation was 14.5 kg, 14.2 kg, and 13.3 kg at L, I, and bottm slit type, respectively. This means that the moisture content of coir bag during cultivation was lowest in bottom slit type. The number of adventitious root on stem was 160, 170, and 53 at I, L, and bottom slit type, respectively. The dry weight of root and root length were highest at bottom slit type, compared to other treatment. The marketable yield was highest 26.5 kg/20 plant in bottom slit type. For increasing yield and preventing damp injury, bottom slit type was most effective at U type bed coir bag culture.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.36 no.11
• /
• pp.1447-1453
• /
• 2012

For an electromagnetic suspension (EMS)-type urban Maglev train using U-shaped electromagnets, both the vertical and the lateral air gaps for levitation are maintained only by the electromagnet. The train can run over curved rails without active lateral air gap control because the U-shaped electromagnet simultaneously produces both a levitation force and a guidance force, which is dependent on the levitation force. Owing to the passive control of the lateral air gap, the lateral vibration could exceed the limits of the lateral air gap and acceleration. In this study, dynamic analysis of a Maglev train is carried out, and the effectiveness of a lateral damper for vibration reduction is investigated. To more accurately predict the lateral vibration, a Maglev vehicle multibody model including air-sparing, guideway irregularities, electromagnets, and their controls is developed.

• Journal of the Korean Society for Precision Engineering
• /
• v.23 no.12 s.189
• /
• pp.80-87
• /
• 2006

Seals are usually made from elastomer, a kind of rubber, and it has the non-linearity and hyper-elasticity. U-type seals are used to prevent the leakage of internal fluid sealed in hydraulic actuator because they have more excellent performance than O-rings or rectangular seals. As a core part of hydraulic actuator, U-type seal gives much effect on performance and reliability of actuator. This study considers an NBR U-type seal under high pressure of a hydraulic actuator, and provides its deformation, stress-strain characteristic and contact force using the non-linear finite element analysis. Analysis results are compared with the experimental ones performed by the self-developed testing equipment. Verification result shows that this study presents a good application process for the effective design of U-type seals under high operation pressure.

• Journal of the Korean Society of Manufacturing Process Engineers
• /
• v.7 no.1
• /
• pp.53-61
• /
• 2008

In this research, the layout and geometry of U-type ribs in the part, including significant process conditions, are automatically optimized to reduce part warpage with robustness in consideration. The optimization procedure are based on an iterative redesign methodology integrated with computer aided injection molding simulation, Taguchi's Design of Experiment(DOE), and a direct search-based optimization method. The robustness of a design alternative is efficiently measured by introducing composite noise factor and Taguchi's signal-to-noise ratio. As a solution search methodology, the modified design space reduction method based on orthogonal arrays is employed to exploit an optimal robust design alternative. To illustrate the proposed methodology, a case study is performed on simulation results, where an optimal robust design alternative is obtained with a moderate number of iterations.

• 도로교통
• /
• s.93
• /
• pp.141-157
• /
• 2003