• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.6 no.12
• /
• pp.3081-3099
• /
• 2012

We propose a new multipath-based reliable routing protocol on MANETs, Multipath-based Reliable routing protocol with Fast-Recovery of failures (MRFR). For reliable message transmission, MRFR tries to find the most reliable path between a source and a destination considering the end-to-end packet reception reliability of the routes. The established path consists of a primary path that is used to transmit messages, and the secondary paths that are used to recover the path when detecting failures on the primary path. After establishing the path, the source transmits messages through the primary path. If a node detects a link failure during message transmission, it can recover the path locally by switching from the primary to the secondary path. By allowing the intermediate nodes to locally recover the route failure, the proposed protocol can handle the dynamic topological change of the MANETs efficiently. The simulation result using the QualNet simulator shows that the MRFR protocol performs better than other protocols in terms of the end-to-end message delivery ratio and fault-tolerance capability.

• ETRI Journal
• /
• v.21 no.3
• /
• pp.1-5
• /
• 1999

A clock and data recovery circuit with a phase-locked loop for 10 Gb/s optical transmission system was realized in a hybrid IC form. The quadri-correlation architecture is used for frequency-and phase-locked loop. A NRZ-to-PRZ converter and a 360 degree analogue phase shifter are included in the circuit. The jitter characteristics satisfy the recommendations of ITU-T. The capture range of 150 MHz and input voltage sensitivity of 100 mVp-p were showed. The temperature compensation characteristics were tested for the operating temperature from -10 to $60^{\circ}C$ and showed no increase of error. This circuit was adopted for the 10 Gb/s transmission system through a normal single-mode fiber with the length of 400 km and operated successfully.

• Smart Structures and Systems
• /
• v.20 no.1
• /
• pp.35-42
• /
• 2017

Recently, compressive sensing based data loss recovery techniques have become popular for Structural Health Monitoring (SHM) applications. These techniques involve an encoding process which is onerous to sensor node because of random sensing matrices used in compressive sensing. In this paper, we are presenting a model where the sampled raw acceleration data is directly transmitted to base station/receiver without performing any type of encoding at transmitter. The received incomplete acceleration data after data losses can be reconstructed faithfully using compressive sensing based reconstruction techniques. An in-depth simulated analysis is presented on how random losses and continuous losses affects the reconstruction of acceleration signals (obtained from a real bridge). Along with performance analysis for different simulated data losses (from 10 to 50%), advantages of performing interleaving before transmission are also presented.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.2
• /
• pp.417-426
• /
• 1996

The end-to-end service clock recovery is a critical issue in providing constandt bit rate service through ATM network. The Synchronous Residual Time Stamp(SRTS) algorithm is used to recovery the source clock using time stamp of transmitter. In thispaper, we propose a Differential Residual Time Stamp (DRTS) transmission mechanism to effectively deliver the timing information of source clock in SRTS algorithm. The RTS transmission method simple in its hardware. From the results of field trial of DS3 rate interactive video communication system through B-ISDN testbed, it can be identified that DRTS method is superior to the RTS method.

• Journal of Industrial Technology
• /
• v.28 no.A
• /
• pp.113-117
• /
• 2008

Wireless carrier sense multiple access (CSMA) systems are widely used but show extremely different transmission efficiency according to the operation environment. Simulation or prototype deployment is needed to see the transmission efficiency of a wireless CSMA system with the partial packet retransmission scheme. The lower bound for the transmission efficiency of such a system is found mathematically in this work. This shows how much the partial packet retransmission scheme improves the transmission efficiency quantitatively. It also shows that the maximum throughput is obtained at higher offered load compared to the conventional CSMA system without the partial packet transmission. The result of this work can be applied to IEEE 802.11 networks or wireless mesh networks.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.64 no.4
• /
• pp.291-296
• /
• 2015

Transmission line is exposed to a large area, and then faults are likely to occur than the other component of power system. When a fault occurs on a transmission line, fault locator helps fast recovery of power supply on power system. This paper deals with the design of a digital fault locator for improvement accuracy of the fault distance estimation and a fault occurrence position for transmission line. The algorithm of a fault locator uses a DC offset removal filter and DFT filter. The algorithm utilizes a fault data of GPS time synchronized. The computed fault information is transmitted to the other side substation through communication. The digital fault locator includes MPU module, ADPU module, SIU module, and a power module. The MMI firmware and software of the fault locator was implemented.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.65 no.1
• /
• pp.1-6
• /
• 2016

Recently, proportion of the induction motor load is gradually increased. When a contingency in the power systems, it has been discovered phenomenon that the voltage is delayed recover caused mechanical characteristics of the induction motor load. It can be a serious impact on the voltage stability of the power system considering induction motor load. The scheme to mitigate this phenomenon tripping off the motors to prevent voltage drop and delayed voltage recovery on the load demand side. Fault induced delayed voltage recovery phenomenon is caused by stalling of small induction motor load in transmission level contingencies. In this paper, fault induced delayed voltage recovery phenomenon mitigation method implementation under voltage load shedding on the korean power system considering induction motor load.

• Proceedings of the IEEK Conference
• /
• 2006.06a
• /
• pp.329-330
• /
• 2006

This paper presents a recovery technique for images with block-based corruption by transmission losses. Conventional methods that do not consider edge directions can cause blocked blurring artifacts. In this paper, we present a block recovery scheme using Haar wavelet features. The adaptive selection of neighboring blocks is performed based on the energy ratio f wavelet subbands. The lost blocks are recovered by linear interpolation in the spatial domain using selected block pairs. The proposed directional recovery method is effective for the strong edge because it exploits the varying neighboring blocks adaptively according to the edges and the directional information in the image. The proposed method outperforms the previous methods that used only a predefined set of neighboring blocks.

• KIISE Transactions on Computing Practices
• /
• v.20 no.12
• /
• pp.694-699
• /
• 2014

In mobile ad-hoc networks (MANET), the network topology and neighboring nodes change frequently, since MANET is composed of nodes that have mobility without a fixed network infrastructure. The AODV routing protocol is advantageous for MANET, but AODV has a delay in the transmission of data packets because AODV can not transmit data during route recovery. This paper proposes solving the above problem of AODV by using a bypass generation mechanism for data transmission during route recovery. For further improvement, additional mechanisms that coordinate the reception threshold of a hello packet are proposed in order to improve the accuracy of the information obtained from the neighboring nodes when the bypass is generated due to a link failure and the immediacy of the route recovery. Simulation results show that the proposed technique improves the performance in terms of the delay in transmission compared to traditional AODV.

• Journal of KIISE:Computer Systems and Theory
• /
• v.26 no.8
• /
• pp.957-965
• /
• 1999

그룹간 공동 작업이나 화상 회의와 같은 그룹 통신의 수요가 늘어나면서 멀티캐스팅을 이용한 효율적인 데이타 전송에 대한 요구가 증가하고 있다. 특히 오디오나 비디오 데이타와는 달리 공동 문서 작업이나 그룹간 문서 전송을 위한 데이타 처리를 위해서는 어느 정도의 시간 손실이 있더라도 신뢰성을 보장할 수 있는 멀티캐스트 프로토콜이 요구된다. 그러나 멀티캐스트 전송에서의 신뢰성을 보장하기 위하여 손실 패킷에 대한 재전송 패킷이 전체 그룹으로 멀티캐스트 되는 것은 네트워크 상에 트래픽을 폭증시키는 요인이 된다. 이에 본 논문에서는 지역 그룹에서의 오류 회복을 위한 재전송 제한 기법을 제안하여 손실 패킷의 재전송 과정에서 발생하는 트래픽의 폭주를 제어하고자 한다. 이것은 재전송 패킷이 중복없이 다중 수신자에게 전송될 수 있도록 하여 그룹 내의 재전송 패킷의 양을 줄이고 필요없는 중복 패킷이 네트워크의 효율을 저하시키는 것을 방지하고자 하는 데 그 목적이 있다. Abstract As the size and the geographic span of communication groups increases, efficient data transmission schemes using Multicast service become more and more essential. Especially, unlike audio and video applications, for some collaborative applications and other data delivery components which require ordered and lossless delivery of data, Reliable Multicast Service is needed to ensure consistent presentation across multiple views. Thus error recovery by retransmission of loss data is provided in order to guarantee the reliability of multicast transmission protocol. However, redundant retransmission packets by multicast may cause traffic implosion on the Internet and it can be aggravated with continuous retransmission.This paper describes a Restricted Retransmission Mechanism as an error recovery method of multicast service in a local group, which can handle traffic implosion in retransmission process. It reduces redundant retransmission packets flowing into a local group and supports reliable multicast transmission. The goal of this mechanism is to reduce retransmission packets and decrease the load for group members and networks.