• Current Optics and Photonics
• /
• v.3 no.6
• /
• pp.531-540
• /
• 2019

Spectral Amplitude Coding Optical Code Division Multiple Access (SAC OCDMA) is an advanced technique in asynchronous environments. This paper proposes design and implementation of a novel quantum logic gate (QLG) code, with code construction algorithm generated without following any code mapping procedures for SAC system. The proposed code has a unitary matrices property with maximum overlap of one chip for various clients and no overlaps in spectra for the rest of the subscribers. Results indicate that a single algorithm produces the same length increment for codes with weight greater than two and follows the same signal to noise ratio (SNR) and bit error rate (BER) calculations for a higher number of users. This paper further examines the performance of a QLG code based SAC-OCDMA system with NAND and direct detection techniques. BER analysis was carried out for the proposed code and results were compared with existing MDW, RD and GMP codes. We demonstrate that the QLG code based system performs better in terms of cardinality, which is followed by improved BER. Numerical analysis reveals that for error free transmission (10^-9), the suggested code supports approximately 170 users with code weight 4. Our results also conclude that the proposed code provides improvement in the code construction, cross-correlation and minimization of noises.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.9 no.12
• /
• pp.5150-5169
• /
• 2015

Mobile Ad hoc NETworks (MANETs) are the best choice when mobility, scalability, and decentralized network infrastructure are needed. Because of critical mission applications of MANETs, network security is the vital requirement. Most routing protocols in MANETs assume that every node in the network is trustworthy. However, due to the open medium, the wide distribution, and the lack of nodes' physical protection, attackers can easily compromise MANETs by inserting misbehaving nodes into the network that make blackhole attacks. Previous research to detect the misbehaving nodes in MANETs used the overhearing methods, or additional ACKnowledgement (ACK) packets to confirm the reception of data packets. In this paper a special lightweight acknowledgement-based method is developed that, contrary to existing methods, it uses ACK packets of MAC layer instead of adding new ACK packets to the network layer for confirmations. In fact, this novel method, named PIGACK, uses ACK packets of MAC 802.11 to piggyback confirmations from a receiver to a sender in the same transmission duration that the sender sends a data packet to the receiver. Analytical and simulation results show that the proposed method considerably decreases the network overhead and increases the packet delivery ratio compared to the well-known method (2ACK).

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.12 no.3
• /
• pp.1136-1151
• /
• 2018

This paper proposes a new hybrid scheme to decrease the high peak to average power ratio (PAPR) of optical orthogonal frequency division multiplexing (OFDM) signals in visible light communication (VLC) systems. The PAPR causes nonlinear signal distortions and high power requirements for the VLC transmitter (light emitting diode, LED). The proposed method is applicable for both direct current-biased optical OFDM (DCO-OFDM) and asymmetrically clipped optical OFDM (ACO-OFDM). In the proposed scheme, the PTS method is firstly modified to fit both optical OFDM approaches transmission and then combined with signal clipping method for further PAPR reduction and bit error rate (BER) improvement of the VLC system. The performance of hybrid scheme has been evaluated and compared with the original OFDM based VLC system, conventional PTS and clipping methods. The results show that the hybrid scheme outperforms other methods in terms of both the PAPR reduction and BER performance.

• 한국신재생에너지학회:학술대회논문집
• /
• 2007.11a
• /
• pp.201-204
• /
• 2007

A novel self-humidifying composite membrane for the proton exchange membrane fuel cell (PEMFC) at low humidity condition was developed. The $Pt/TiO_2 catalyst particles were synthesized via supercritical impregnation methods. Pt precursor was dissolved in supercritical carbon dioxide and impregnated onto $TiO_2$ particles. Pt precursors were platinum(II) acetylacetonate, Dimethyl(1,5-cyclooctadiene) platinum(II) and we controlled the ratio of Pt to $TiO_2$ The impregnated Pt precursor was converted to $TiO_2$ supported Pt nanoparticle under various reducing conditions. $TiO_2$ catalyst particles were dispersed uniformly into the Nafion solution, and then $Pt/TiO_2/Nafion$composite membrane was prepared using solution-cast method. The size, dispersion and content of the platinum had been characterized with Transmission Electron Micrograph (TEM), X-ray diffract ion (XRD) and Inductively Coupled Plasma - Atomic Emission Spectrometer (ICP-AES). The cell performance with the self-humidifying composite membrane was compared with a recast Nafion membrane under both humidified and dry conditions at 65 $^{\circ}C$.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.8 no.5
• /
• pp.13-19
• /
• 2008

A mobile ad-hoc network routing protocols for transmission of multimedia contents need to have low delay time and to maintain the established route because it should secure quality of service(QoS) of the network. In this paper, the proposed protocol, termed HODMRP (History-based On-Demand Multicast Routing Protocol), is enhanced On-Demand Multicast Routing Protocol (ODMRP) by adding the criterion which is the session history for establishing route. The characteristic of this protocol is that data can be transmitted using the redundant route which is already selected by session history, if it occurs that the route is broken, HODMRP have better Packet Delivery Ratio (PDR) value and lower delay time than ODMRP by the simulation results.

• Carbon letters
• /
• v.16 no.4
• /
• pp.233-240
• /
• 2015

Electrochemical synthesis was employed to prepare a novel hydroxyapatite/graphene (HAP/Gr) composite powder suitable for medical applications as a hard tissue implant (scaffold). The synthesis was performed in a homogeneous dispersion containing Na₂H₂EDTA·2H₂O, NaH₂PO₄ and CaCl₂ with a Ca/EDTA/PO₄³⁻ concentration ratio of 0.25/0.25/0.15M, along with 0.01 wt% added graphene nanosheets, at a current density of 137 mA cm⁻² and pH value of 9.0. The field emission scanning electron microscopy and transmission electron microscopy observations of the composite HAP/Gr powder indicated that nanosized hydroxyapatite particles were uniformly placed in the graphene overlay. Raman spectroscopy, Fourier transform infrared spectroscopy and X-ray diffraction confirmed graphene incorporation in the HAP/Gr powder. The electrochemically prepared HAP/Gr composite powder exhibited slight antibacterial effect against the growth of the bacterial strain Staphylococcus aureus.

• Carbon letters
• /
• v.13 no.4
• /
• pp.205-211
• /
• 2012

Methanol as a carbon source in chemical vapor deposition (CVD) graphene has an advantage over methane and hydrogen in that we can avoid optimizing an etching reagent condition. Since methanol itself can easily decompose into hydrocarbon and water (an etching reagent) at high temperatures [1], the pressure and the temperature of methanol are the only parameters we have to handle. In this study, synthetic conditions for highly crystalline and large area graphene have been optimized by adjusting pressure and temperature; the effect of each parameter was analyzed systematically by Raman, scanning electron microscope, transmission electron microscope, atomic force microscope, four-point-probe measurement, and UV-Vis. Defect density of graphene, represented by D/G ratio in Raman, decreased with increasing temperature and decreasing pressure; it negatively affected electrical conductivity. From our process and various analyses, methanol CVD growth for graphene has been found to be a safe, cheap, easy, and simple method to produce high quality, large area, and continuous graphene films.

• Proceedings of the KIEE Conference
• /
• 2005.11a
• /
• pp.217-219
• /
• 2005

To detect partial discharge of 154kV joint box, we have made experiment by using the HFCT sensor. Generally the signals which are detected in partial discharge test of underground power transmission cable are accompanied with both noises of high voltage and noises of surrounding power cable. The most noise in near to end part of joint box is corona, beside other noises flowed from surrounding area. Partial discharge test is difficulty due to these noises. First, we test reliability on both injection of calibration signal in NJB and removal of low frequency. After that, we had analyzed frequencies by measuring signals in IJB with 300[m] distance from NJB. Also we had measured S/N ratio by using the indirected injection method of calibration signal in IJB. In this experiment, two measurement methods were difference of detection acquisition, but these had the equal frequency properties.

• Transactions on Electrical and Electronic Materials
• /
• v.8 no.5
• /
• pp.206-210
• /
• 2007

Carbon nanotubes(CNTs) are largely synthesized on Fe catalysts by catalytic chemical vapor deposition. The various shapes and compositions of these nanostructure CNTs were obtained by controlled parameters such as the reaction temperature, gas-mixing ratio. The influence of these parameters is investigated, together with observations of the produced materials after the purification processes. A diameter of CNTs, range from 2 to 10 nm, closely correlated with the size of the catalyst particle found attached to the tube end. The yield of CNTs was estimated to be 88.5 % and the purities of CNTs thus obtained were more than 80 %. The experimental results were documented with field emission scanning electron microscopy and raman spectroscopy and transmission electron microscopy, both before and after the purification.

• Journal of Korean Library and Information Science Society
• /
• v.28
• /
• pp.61-91
• /
• 1998

In contemporary education, a school library is considered and valued as a vital and integral component of a school's instructional program. Especially, school library materials should contribute to execution of school curriculums through wide provision of resources. The results of the study are as follows. 1. The term 'library materials' should be changed into 'library resources' with a broad meaning. And, the scope of school library materials should include printed materials, audio-visual materials, electronic materials, associated equipment and other library resources. 2. It is desirable that the minimal standards of total collection is 5 books and 3 AV for a student in elementary schools, 7 books and 5 AV for a student in middle schools, 10 books and 7 AV for a student in high schools. 3. Annual growth is 0.5 for a student in elementary schools, 1 for a student in middle schools and 1.5 copy for a student in high schools. And, the number of minimal serials is 20 titles in elementary schools, 30 titles in middle schools and 50 tides in high schools. 4. Besides, basic collection, with the advances of technology, the school library collection should include new formats and delivery systems such as CD, video discs, videotex, computer software, satellite transmission etc. 5. The recommendable annual ratio of withdrawl is 3 to 5% for update and functional materials.