• 조명전기설비학회논문지
• /
• 제26권1호
• /
• pp.75-81
• /
• 2012

In this paper, the wireless power transfer system using the magnetic resonance was designed, analyzed by circuit analysis methode and the calculated transfer function was compared with the measured one. The self-resonant coil was made up of the commonly used capacitor which had the lumped capacitance and it enabled the stable magnetic resonance not to be affected by the circumstance. The transmission efficiency of this system was 70[%] at the 15[cm] between the transmission and receiving coil and the measured transfer function was similar to the calculated one, which means the circuit analysis methode is valid in this system. When the intermediate coils were added between the transmission and receiving coil, the transmission efficiency was increased, which produced the increase of transfer distance. In the case of the five intermediate coils adding, the 35[%] transmission efficiency was achived at the 90[cm] distance.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2003년도 하계학술대회 논문집 A
• /
• pp.172-174
• /
• 2003

Power system restoration following a large black-out starts with charging of primary transmission lines. As the power systems are gradually enlarged and become more complex, the power plant and transmission of electricity units are being expanded continuously. Accordingly, evaluation and reconfiguration of the primary transmission system is needed. So far it has been decided to analyze and evaluate with the knowledge and experience of the corresponding expert. This paper presents an expert system for configuring the optimum primary transmission system based on expert knowledge, static analysis and configuration data.

• 전기학회논문지
• /
• 제58권2호
• /
• pp.349-355
• /
• 2009

As electrical power demand is gradually increasing, the construction of power transmission facility is unavoidable. However difficulties which resulted from increasing of complaints and NYMBY make power transmission tower to be more environmentally friendly. As an alternative proposal, a new method which is changing conventional iron arm for insulation arm which is made of FRP(Fiber Glass Reinforced Plastics) is in progress. In this paper, we discussed environmentally friendly characteristic of domestic 154 kV testing transmission tower whose insulation arms have same mechanical and excellent electrical properties compare to conventional heavy iron arm.

• Journal of Electrical Engineering and Technology
• /
• 제9권3호
• /
• pp.1002-1008
• /
• 2014

This paper describes insulation design and its reliability evaluation of ${\pm}80kV$ HVDC XLPE cable. Recently, the construction of HVDC transmission system, which is combined overhead line with underground cable, has been completed. This system is installed with existing 154 kV AC transmission line on the same tower. In this paper, the lightning transient analysis is firstly reviewed for selection of basic impulse insulation level and nominal insulation thickness. Then the electrical performance tests including load cycle test and superimposed impulse test based on CIGRE TB 496 are performed to evaluate the reliability of newly designed HVDC cable. There is no breakdown for ${\pm}80kV$ HVDC XLPE cable during electrical performance test. Finally, this system is installed in Jeju island based on successful electrical performance test (Type test). After installation tests are also successfully completed.

• 반도체디스플레이기술학회지
• /
• 제20권4호
• /
• pp.102-107
• /
• 2021

In this paper, the measurements of received power was shown and compared in two developed 5.8GHz 25W wireless charging systems. One is the system using commercial transmission antenna, and the other is the system using transmission antenna combined with metamaterial. The system combined with metamaterial shows higher received power due to negative reflective index of metamaterial. In addition, a comparative analysis of the systems shows that the transmission efficiency in the systems can decrease the real gain of transmission antenna due to higher side robe of beam pattern. The side robe beams of transmitting antenna interferes transmitted beam with the reflected beams from the bottom region due to the side robes. The failure problems of the RF wireless charging systems are discussed and proposed in order to charge mobile devices through the RF wireless charging system.

• 대한전기학회논문지
• /
• 제41권5호
• /
• pp.445-458
• /
• 1992

As one of the forced cooling method of the underground power transmission system, external water cooled system with trough in tunnel was investigated. This study is performed on thermal analysis for a standard condition to determine the cable transmission current of the underground power transmission system about the cooling facility. A parametric study was performed for the inlet water temperatures, flow rates, the inlet air velocities, flow rates and the cooling spans. This study shows that the cable transmission current varies within the allowable limitation in compliance with the variation of inlet water temperatures and flow rates. It exhibits little variations for the most intervals in compliance with the variation of inlet air temperatures and flows. But, the cable transmission current fast reduces for a specified interval and consequently affects the underground transmission system. As a result, when the actual forced cooling system is designed, the design conditions of inlet air have to be considered as the most important parameters in determination of the cable transmission current.

• 대한전기학회논문지:전력기술부문A
• /
• 제54권12호
• /
• pp.597-602
• /
• 2005

The introduction of competition in electricity market emphasizes the importance of sufficient transmission capacities to guarantee various electricity transactions. Therefore, when dispatch scheduling, transmission security constraints should be considered for the economic and stable electric power system operation. In this paper, we propose an optimal dispatch scheduling algorithm incorporating transmission security constraints. For solving these constraints, the dispatch scheduling problem is decomposed into a master problem to calculate a general optimal power flow (OPF) without transmission security constraints and several subproblems to inspect the feasibility of OPF solution under various transmission line contingencies. If a dispatch schedule given by the master problem violates transmission security constraints, then an additional constraint is imposed to the master problem. Through these iteration processes between the master problem and subproblems, an optimal dispatch schedule reflecting the post-contingency rescheduling is derived. Moreover, since interruptible loads can positively participate as generators in the competitive electricity market, we consider these interruptible loads active control variables. Numerical example demonstrates efficiency of the proposed algorithm.

• 한국인터넷방송통신학회논문지
• /
• 제11권4호
• /
• pp.53-60
• /
• 2011

무선 센서 네트워크에서, IEEE 802.11은 센서노드간에 최대전력을 사용하여 패킷을 전송하기 때문에, 불필요한 에너지 소모가 발생한다. BASIC구조는 RTS-CTS패킷 전송에 최대 전송전력을 사용하며, 에너지 효율을 높이기 위해서 DATA-ACK전송에 최소한으로 필요한 전송전력을 사용한다. 그러나 BASIC구조는 반송파 감지지역의 노드에 의한 ACK패킷의 충돌로 인해 네트워크 수율이 떨어지며, 전력제어를 하지 않는 IEEE 802.11을 사용할 때 보다 더 높은 에너지 소모를 가진다. 기존에 제안된 PCM(Power Control MAC)구조는 ACK패킷의 충돌을 피하기 위해, 반송파 감지지역에서 DATA패킷의 전송을 감지하기 위해 주기적으로 최대 전력레벨로 DATA패킷 전송방법을 이용하였다. 본 논문에서는 기존의 PCM구조의 에너지 효율에 대한 문제점을 제시하고, 보다 높은 에너지 효율을 가진 개선된 PCM구조를 제안하였다.

• 한국생산제조학회지
• /
• 제4권2호
• /
• pp.25-30
• /
• 1995

The shifting and steering performance of the tracked vehicle with the hydromechanical continuous variable transmission is analyzed. The simulation results are closely similar to both the vehicle test result, As a result of hydromechanical transmission simulation, power circulation in 2nd and 3rd range is maximum 142% And power flow of mechanical part has the relationship with the effeciency of the vehicle and transmission.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제12권4호
• /
• pp.1854-1868
• /
• 2018

A wireless body-sensor network (WBSN) refers to a network-configured environment in which sensors are placed on both the inside and outside of the human body. The sensors are much smaller and the energy is more constrained when compared to traditional wireless sensor network (WSN) environments. The critical nature of the energy-constraint issue in WBSN environments has led to numerous studies on the reduction of energy consumption of WBSN sensors. The transmission-power-control (TPC) technique adjusts the transmission-power level (TPL) of sensors in the WBSN and reduces the energy consumption that occurs during communications. To elaborate, when transmission sensors and reception sensors are placed in various parts of the human body, the transmission sensors regularly send sensor data to the reception sensors. As the reception sensors receive data from the transmission sensors, real-time measurements of the received signal-strength indication (RSSI), which is the value that indicates the channel status, are taken to determine the TPL that suits the current-channel status. This TPL information is then sent back to the transmission sensors. The transmission sensors adjust their current TPL based on the TPL that they receive from the reception sensors. The initial TPC algorithm made linear or binary adjustments using only the information of the current-channel status. However, because various data in the WBSN environment can be utilized to create a more efficient TPC algorithm, many different types of TPC algorithms that combine human movements or fuse TPC with other algorithms have emerged. This paper defines and discusses the design and development process of an efficient TPC algorithm for WBSNs. We will describe the WBSN characteristics, model, and closed-loop mechanism, followed by an examination of recent TPC studies.