• 대한전자공학회논문지TC
• /
• 제49권2호
• /
• pp.23-31
• /
• 2012

고 대역폭을 지원하는 네트워크 인프라가 급격히 발전하면서 이를 활용한 대용량의 데이터를 사용하는 원거리 사용자 사이에 협업에 대한 요구가 증가하고 있다. 하지만 현재까지 주로 사용되는 TCP 기반의 전송프로토콜은 RTT가 큰 네트워크 환경에서 대용량 데이터 전송 시 충분한 성능을 얻지 못하고 있다. 이로 인해 최근 효율적인 대역폭 활용을 위한 새로운 전송기법들이 시도되고 있다. UDT(UDP-based Data Transfer protocol)는 UDP를 기반으로 응용계층에서 TCP와 같은 데이터 전송의 신뢰성과 안정성을 보장하기 위해 개발된 대표적인 대용량 데이터 전송프로토콜이다. 본 논문에서는 UDT를 기반으로 대용량 데이터 전송을 위한 병렬, 압축 전송기법을 적용한 전송도구를 설계, 구현한다. 실험은 실제 환경을 구성하여 병렬, 압축 전송기법의 성능향상 효과를 분석하고, 이를 기준으로 다른 대용량 데이터 전송 도구와 성능을 비교한다. 실험결과 제안기법이 UDT보다 RTT가 큰 구간에서 안정적이며 큰 성능향상을 보인다. 특히, 손실 없는 RTT 400ms 구간에서 UDT 대비 244%, 손실률 0.005%의 RTT 250ms 구간에서 229%의 성능향상을 확인하였다.

• Structural Engineering and Mechanics
• /
• 제73권3호
• /
• pp.339-351
• /
• 2020

Earthquakes are natural disasters that cause serious social disruptions and economic losses. In particular, they have a significant impact on critical lifeline infrastructure such as urban water transmission networks. Therefore, it is important to predict network performance and provide an alternative that minimizes the damage by considering the factors affecting lifeline structures. This paper proposes a probabilistic reliability approach for post-hazard flow analysis of a water transmission network according to earthquake magnitude, pipeline deterioration, and interdependency between pumping plants and 154 kV substations. The model is composed of the following three phases: (1) generation of input ground motion considering spatial correlation, (2) updating the revised nodal demands, and (3) calculation of available nodal demands. Accordingly, a computer code was developed to perform the hydraulic analysis and numerical modelling of water facilities. For numerical simulation, an actual water transmission network was considered and the epicenter was determined from historical earthquake data. To evaluate the network performance, flow-based performance indicators such as system serviceability, nodal serviceability, and mean normal status rate were introduced. The results from the proposed approach quantitatively show that the water network is significantly affected by not only the magnitude of the earthquake but the interdependency and pipeline deterioration.

• 한국초전도ㆍ저온공학회논문지
• /
• 제5권2호
• /
• pp.8-15
• /
• 2003

Nowadays, As power demand increases gradually, the call for underground transmission system increases. But it is very difficult and high in cost to construct new ducts and/or tunnels for power cables in metropolitan areas. HTS cable has the several useful characteristics such as increased power density, stronger magnetic fields and/or reduced losses. Therefore HTS cable can allow more power to be moved in existing ducts, which means very large economical and environmental benefits. In this paper, we investigate the status of korean power system and underground transmission system. Based on this, the feasibility study on applying HTS cable to korean power system is carried out and then we propose the new power system configuration of metropolitan area with HTS cable. Finally, we can get a conclusion that applying HTS cable to 154kV underground transmission line in metropolitan area such as seoul is very available. In addition, detail applicable cases are investigated; a)replace old conventional cable with HTS cable; b) apply HTS cable to constructing new underground transmission line; c)use HTS cable to resolve overload problem in conventional power system configuration.

• 대한조선학회논문집
• /
• 제29권1호
• /
• pp.113-122
• /
• 1992

선박소음을 예측하는 과정중에서 고체소음 전달해석은 직접적으로 예측결과의 정도에 영향을 미치고 있다. 이에 대한 계산 방법으로서 경험식이 그 간편성 때문에 자주 사용되고 있지만 자체의 한계성 때문에 이론적 해석방법(Wave guide theory, SEA등)들에 대한 연구가 선박음향학 분야에서 꾸준히 수행되어 왔다. 본 연구에서는 SEA를 이용하여 22개의 plate로 구성된 선체구조의 단순모델을 대상으로 고체소음 전달손실에 대한 이론적 계산 및 실험적 산정을 수행하였다. 계산치와 실험치의 비교결과는 3 dB이내의 좋은 일치를 보여 주었다.

• Journal of Electrical Engineering and Technology
• /
• 제7권6호
• /
• pp.814-823
• /
• 2012

Electric power transmission utilities make an effort to maximize profit by reducing their electricity supply and operation costs while maintaining their reliability. The development of maintenance strategies for aged components is one of the more effective ways to achieve this goal. The reliability centered approach is a key method in providing optimal maintenance strategies. It considers the tradeoffs between the upfront maintenance costs and the potential costs incurred by reliability losses. This paper discusses the application of the Particle Swarm Optimization (PSO) technique used to find the optimal maintenance strategy for a transmission component in order to achieve the minimum total expected cost composed of Generation Cost (GC), Maintenance Cost (MC), Repair Cost (RC) and Outage Cost (OC). Three components of a transmission system are considered: overhead lines, underground cables and insulators are considered. In regards to aged and aging component, a component state model that uses a modified Markov chain is proposed. A simulation has been performed on an IEEE 9-bus system. The results from this simulation are quite encouraging, and then the proposed approach will be useful in practical maintenance scheduling.

• 전자공학회논문지D
• /
• 제36D2호
• /
• pp.11-19
• /
• 1999

본 논문에서는 저가의 상용 제품용 이동체 위성방송 수신 안테나 레이돔의 설계 절차를 실험 결과들과 함께 제시한다. 우선 레이돔으로 사용될 재료 선정을 위한 유전체의 복소유전율 측정 방법과 함께 국내에서 생산되는 몇몇 저가의 플라스틱에 대한 측정 결과를 제시하였다. 그리고 측정된 플라스틱들을 레이돔을 사용했을 경우의 투과 손실을 해석하고, 플라스틱 박판을 통한 전자파 투과 시험으로 해석 결과를 검증하였다. ABS 단일층 레이돔 및 A-샌드위치(PET-FOAM-ABS) 레이돔의 두 가지 레이돔을 실제 제작하여 시험하였다. 최대 전자파 입사 각도인 57도에서 투과손실은 ABS 단일층 레이돔은 1.5dB이나, A-샌드위치 구조는 투과 손실이 0.6dB 이하이다. 또한 A-샌드위치 구조 레이돔의 교차편파 발생은 20dB이다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2006년도 제37회 하계학술대회 논문집 A
• /
• pp.93-94
• /
• 2006

The sheath of a single-conductor cable for ac service acts as a secondary of a transformer, the current in the conductor induces a voltage in the sheath. When the sheaths of single-conductor cables are bonded to each other, as is common practice for multi-conductor cables, the induced voltage causes current to flow in the completed circuit. This current causes losses in the sheath. Various methods of bonding may be used for the purpose of minimizing sheath losses. In korea, sheath cross bonding system was employed for the prevention of sheath losses, the sheaths wire subjected to at voltages, and the bonding was designed to keep the magnitude of the induced voltages within small limits so as to prevent the possibility of sheath corrosion. But, sheath cross bonding system without transposition of cable can not achieve an exact balance of induced sheath voltages unless the cables are lain in trefoil. This paper describes a transposition system with sheath cross bonding using EMTP(Electromagnetic Transient Program). The transposition system with cross bonding can be extended to longer cable circuits for laid in flat as wall as trefoil by the methods described in this paper.

• Journal of Power Electronics
• /
• 제17권1호
• /
• pp.200-211
• /
• 2017

Conventional boost-full-bridge and boost-hybrid-bridge two-stage inverters are widely applied in order to adapt to the wide dc input voltage range of photovoltaic arrays. However, the efficiency of the conventional topology is not fully optimized because additional switching losses are generated in the voltage conversion so that the input voltage rises and then falls. Moreover, the electrolytic capacitors in a dc-link lead to a larger volume combined with increases in both weight and cost. This paper proposes a higher efficiency inverter with time-sharing synchronous modulation. The energy transmission paths, wheeling branches and switching losses for the high-frequency switches are optimized so that the overall efficiency is greatly improved. In this paper, a contrastive analysis of the component losses for the conventional and proposed inverter topologies is carried out in MATLAB. Finally, the high-efficiency under different switching frequencies and different input voltages is verified by a 3 kW prototype.

• 한국전자파학회논문지
• /
• 제10권1호
• /
• pp.133-141
• /
• 1999

본 논문에서는 광선추적기법에 근거한 3차원 실내 전파전파 예측모델을 제시한다. 본 모텔은 건물 실내에 산재되어 있는 가구, 집기 등의 모든 장애물을 고려하는 것 대선에 벽과 천장, 바닥 등의 대표적인 전파 장애 불만을 유한 두께와 유한 전도도를 갖는 슬랩으로 모댈링하여, 주요 전파현상을 고려함으로써 간결하면서도 정확하게 전파손실을 예측할 수 있는 모텔이다. 전파 광선들은 장애물과 부딪히면 거울 같은 반사와 투과를 하고 또 모서리에서는 회절되어 전파하는 것으로 고려되었다. 평연 장애물에서의 반사 및 투과 손실은 광선 추적기법을 사용하여 계산하였으며, 모서리에서의 회절손실은 유한 전도도 매질에 대한 UTD를 사용하여 계 산하였다 본 예측모델을 사용한 몇 경우에 대한 경로손실의 시율레이션 결과는 실측치와 잘 일치하는 것을 보여준다.

• Journal of Electrical Engineering and Technology
• /
• 제8권1호
• /
• pp.168-175
• /
• 2013

This paper presents compact dual-band WLAN filter and filter module. They were developed by embedding all of the passive lumped elements into a LTCC substrate. In order to reduce the size/volume of the filter and avoid EM parasitic couplings between the passive elements, the proposed filter was designed using a 3rd order Chebyshev circuit topology and J-inverter transformation technology. The 3rd order Chebyshev bandpass filter was firstly designed for the band-selection of the 802.11b and was then transformed using finite transmission zeros technologies. Finally, the dual-band filter was realized by adding two notch resonators to the 802.11b filter circuit for the band-selection of the 802.11a/g. The maximum insertion losses in the lower and higher passbands were better than 2.0 and 1.3 dB with minimum return losses of 15 and 14 dB, respectively. Furthermore, the filter was integrated with a diplexer to clearly split the signals between 2 and 5 GHz. The maximum insertion and minimum return losses of the fabricated module were 2.2 and 14 dB at 2.4 - 2.5 GHz, and 1.6 and 19 dB at 5.15 - 5.85 GHz, respectively. The overall volume of the fabricated filter was $2.7{\times}2.3{\times}0.59mm^3$.