• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 1999년도 하계종합학술대회 논문집
• /
• pp.183-186
• /
• 1999

The Ultra-miniature and low phase noise Colpitts VCO of 0.06㏄ in size has been developed using the high Q resonator and phase compensation technique. This type is one transistor VCO without a buffer. To design and simulate the VCO accurately, nolinear model parameters of a bipolar transistor are extracted using the measured I-V data and S parameters based on the Gummel-Poon model. Design and simulation have been done by Serenade 7.5 design tool using the extracted nonlinear model parameters. The wideband VCO has been designed using two varactor diodes and open loop gain compensation technique to improve the operating frequency range. The ultra-miniature VCO has shown the phase noise of -91㏈c/Hz at 10KHz offset and output power of -3㏈m The wideband VCO has shown the tuning frequency bandwidth of 150MHz phase noise of -95㏈c/Hz at 10KHz offset and output power of 5㏈m.

• 전기학회논문지
• /
• 제56권2호
• /
• pp.424-427
• /
• 2007

A fully differential transconductor using the series composite transistor is proposed. Simulation results show that THD is less than 1.2% for the differential input signal of up to $1.5V_{p-p}$ when the input signal frequency is 10MHz. i he proposed transconductor is used to design a third-order elliptic Gm-C lowpass filter with 138kHz cutoff frequency for ADSL Tx filter. The design procedure is based on signal flow graph(SFG) of a doubly-terminated LC ladder filter by means of fully differential transconductors and capacitors. The filter is fabricated and measured with a $0.35{\mu}m$ CMOS process.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1987년도 전기.전자공학 학술대회 논문집(II)
• /
• pp.1512-1515
• /
• 1987

The buffer circuit having minimum delay time is designed and analyzed in this paper. Considering the parasitic components of the MOS transistor, the optimal transistor size ratio between the individual buffer stages is presented. This paper's result is better than that of the Mead and Conway's analysis [1] with respect to both delay time and total area that buffer occupies.

• 한국산업정보학회:학술대회논문집
• /
• 한국산업정보학회 2002년도 춘계학술대회 논문집
• /
• pp.195-199
• /
• 2002

This paper describes the effect of substrate back bias of CMOS Inverter. When the substrate back bias applied in body, the MOS transistor threshold voltage increased and drain saturation current decreased. The back gate reverse bias or substrate bias has been widely utilized and the following advantage has suppressing subthreshold leakage, lowering parasitic junction capacitance, preventing latch up or parasitic bipolar transistor, etc. When the reverse voltage applied substrate, this paper stimulated the propagation delay time CMOS inverter.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2007년도 하계종합학술대회 논문집
• /
• pp.475-476
• /
• 2007

The stress induced leakage currents will affect data retention in synapse transistors and the stress current, transient current is used to estimate to fundamental limitations on oxide thicknesses. The synapse transistor made by thin silicon oxides has represented the neural states and the manipulation which gaves unipolar weights. The weight value of synapse transistor was caused by the bias conditions. Excitatory state and inhibitory state according to weighted values affected the channel current. The stress induced leakage currents affected excitatory state and inhibitory state.

• 정보처리학회논문지A
• /
• 제17A권3호
• /
• pp.121-126
• /
• 2010

본 논문에서는 저 전압 스윙 기술을 적용하여 저 전력 회로를 구현하고, 슬립 트랜지스터 (sleep-transistor)를 이용하여 누설전류를 최소화하는 새로운 저 전력 MOS 전류모드 논리회로 (MOS current-mode logic circuit)를 제안하였다. 제안한 회로는 저 전압 스윙 기술을 적용하여 저 전력 특성을 갖도록 설계하였고 고 문턱전압 PMOS 트랜지스터 (high-threshold voltage PMOS transistor)를 슬립 트랜지스터로 사용하여 누설전류를 최소화하였다. 제안한 회로는 $16\;{\times}\;16$ 비트 병렬 곱셈기에 적용하여 타당성을 입증하였다. 이 회로는 슬립모드에서 기존 MOS 전류 모드 논리회로 구조에 비해 대기전력소모가 1/104로 감소하였으며, 정상 동작모드에서 11.7 %의 전력소모 감소효과가 있었으며 전력소모와 지연시간의 곱에서 15.1 %의 성능향상이 있었다. 이 회로는 삼성 $0.18\;{\mu}m$ CMOS 공정을 이용하여 설계하였으며, HSPICE를 통하여 검증하였다.

• 한국정보전자통신기술학회논문지
• /
• 제9권1호
• /
• pp.120-131
• /
• 2016

본 논문에서는 back-gate bias 전압인 VNN (Negative Voltage)을 이용하여 5V의 MV (Medium Voltage) 소자만 이용하여 FN (Fowler-Nordheim) tunneling 방식으로 write하는 MTP cell을 사용하여 512비트 MTP IP를 설계하였다. 사용된 MTP cell은 CG(Control Gate) capacitor, TG(Tunnel Gate) transistor와 select transistor로 구성되어 있다. MTP cell size를 줄이기 위해 TG transistor와 select transistor를 위한 PW(P-Well)과 CG capacitor를 위한 PW 2개만 사용하였으며, DNW(Deep N-Well)은 512bit MTP cell array에 하나만 사용하였다. 512비트 MTP IP 설계에서는 BGR을 이용한 voltage regulator에 의해 regulation된 V1V (=1V)의 전압을 이용하여 VPP와 VNN level detector를 설계하므로 PVT variation에 둔감한 ${\pm}8V$의 pumping 전압을 공급할 수 있는 VPP와 VNN 발생회로를 제안하였다.

• 설비공학논문집
• /
• 제30권1호
• /
• pp.1-9
• /
• 2018

Thermal performance of a heat sink for an inverter power stack was analyzed in terms of array and installation location of an Insulated Gate Bipolar Transistor (IGBT). Thermal flow around the heat sink was calculated with a numerical model that could simulate forced convection. Thermal performance was calculated depending on the array and location of high- and low-power IGBTs considering the maximum temperature of IGBT. The optimum array and installation location were found and causes were analyzed based on results of numerical analysis. For the numerical analysis, experiment design considered the installation location of IGBT, ratio of heat generation rates of high- and low-power IGBTs, and velocity of the inlet air as design variables. Based on numerical results, a correlation that could calculate thermal performance of the heat sink was suggested and the maximum temperature of the IGBT could be predicted depending on the installation method.

• 정보처리학회논문지A
• /
• 제15A권5호
• /
• pp.243-248
• /
• 2008

본 논문은 다중 문턱전압 CMOS를 이용하여 저 전력 특성을 갖는 캐리 예측 가산기 (carry look-ahead adder)를 설계하였으며, 이를 일반적인 CMOS 가산기와 특성을 비교하였다. 전파 지연시간이 긴 임계경로에 낮은 문턱전압 트랜지스터를 사용하여 전파 지연시간을 감소시켰다. 전파 지연시간이 짧은 최단경로에는 높은 문턱전압 트랜지스터를 사용하여 회로전체의 소비전력을 감소시켰으며, 그 외의 논리블럭들은 정상 문턱전압의 트랜지스터를 사용하였다. 설계한 가산기는 일반적인 CMOS 회로와 비교하여 소비전력에서 14.71% 감소하였으며, 소비전력과 지연 시간의 곱에서 16.11%의 성능향상이 있었다. 이 회로는 삼성 $0.35{\mu}m$ CMOS 공정을 이용하여 설계하였으며, HSPICE를 통하여 검증하였다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2009년도 추계학술대회 논문집
• /
• pp.52-52
• /
• 2009

In this work, we demonstrate the modelling and simulation of the AlGaAs/GaAs quantum-well based light emitting transistor(LET). Based on the experimental and theoretical model, we have compared between a heterojunction bipolar transistor(HBT) structure with quantum wells in the base region and a HBT without quantum wells in the base region. For the purpose of optimizing device design, several analytic and numerical studies have been presented.