• Journal of the Korean Ceramic Society
• /
• v.48 no.4
• /
• pp.323-327
• /
• 2011

The effects of $Dy_2O_3$ and $Er_2O_3$ co-doping on electrical properties and temperature stability of barium titanate ($BaTiO_3$) ceramics were investigated in terms of microstructure and structural analysis. The dielectric constant and the insulation resistance (IR) of 0.7 mol% $Dy_2O_3$ and 0.3 mol% $Er_2O_3$ co-doped dielectrics had about 60% and 20% higher than the values of undoped one, respectively, and the temperature coefficient of capacitance (TCC) met the X7R specification. The addition of $Dy_2O_3$ contributed to electrical properties caused by increase of tetragonality; however, preferential diffusion of $Dy^{3+}$ ions toward A site in $BaTiO_3$ grain exhibited an adverse effect on temperature stability by grain growth. On the other hand, The $Er_2O_3$ addition in $BaTiO_3$ could affect the TCC behavior and the IR with suppression of grain growth caused by reinforcement of grain boundary and electrical compensation. Therefore, the enhanced electrical properties and temperature stability through the co-doping could be deduced from the increase of tetragonality and the suppression of grain growth.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.17 no.3
• /
• pp.289-293
• /
• 2004

PNW-PMN-PZT ceramics were fabricated with the variations of Nb$_2$O$_{5}$ addition and their microstructural and piezoelectric characteristics were investigated. When the amount of Nb$_2$O$_{5}$ increased, grain size decreased gradually. At 0.3wt％ Nb$_2$O$_{5}$ which is the same weight percent with Fe$_2$O$_3$, maximum tetragonality(c/a) and density were shown due to the complexed doping effects. Also, this composition that showed Qm of 2,041, kp of 0.55, grain size of 2.5${\mu}{\textrm}{m}$ and $\varepsilon$r of 1704 were proper for high power application. Using this composition, Rosen-type piezoelectric transformer was fabricated as the size of 1 ${\times}$ 16 ${\times}$ 5㎣ and its electrical characteristics were investigated with the variations of load resistance and driving frequency. At the resistance of 200㏀, maximum step-up ratio of 13.68 was shown. After driving PDA CCFL for 25 min using the inverter circuit, at driving frequency of 214.4KHz, input voltage of 31.78 V and input current of 21.1mA were measured at the input part of piezoelectric transformer. And then, output voltage of 293.2 V and output current of 2.2mA were shown at the output part of piezoelectric transformer. At the same time, efficiency of 96.2％ and temperature rise of 3.5$^{\circ}C$ were appeared at the piezoelectric transformer.ormer.

• Journal of the Korean Magnetics Society
• /
• v.27 no.4
• /
• pp.129-134
• /
• 2017

Bulk-type body-centered-tetragonal Fe-Co alloy was synthesised by utilising a conventional alloy preparation technologies, such as melting, solidification, and homogenising treatments, and its magnetic properties were investigated. In the $(Fe_{100-x}Co_x)_{1-y}C_y$ alloy, the composition range, from which single phase body-centered-tetragonal alloy (martensite phase) was obtained, was severely limited: Co content x = 2.5, and C content y = 0.062. Tetragonality(c/a) of the synthesised body-centered-tetragonal $(Fe_{97.5}Co_{2.5})_{0.938}C_{0.062}$ alloy was 1.05. Magnetocrystalline anisotropy constant ($K_1$) of the body-centered-tetragonal $(Fe_{97.5}Co_{2.5})_{0.938}C_{0.062}$ alloy was measured to be $9.8{\times}10^5J/m^3$), which was 3.1 time as high as the pure iron (${\alpha}-Fe$).

• Journal of the Korean Ceramic Society
• /
• v.31 no.8
• /
• pp.841-848
• /
• 1994

The sintering behavior of La-modified PbTiO3 ceramics was investigated in order to improve the poor sinterability of PbTiO3. Addition of La improved the sinterability. It was confirmed that this improvement was due to the decrease in tetragonality ratio c/a of crystal lattice. The variations of dielectric constant and pyroelectric coefficient were measured with temperature. It was observed that with the increase of La content, Curie temperature decreased and dielectric constant at room temperature increased. La-modified PbTiO3 ceramics had smaller pyroelectric figure of merits than those of pyroelectric materials in use. The effects of grain size on dielectric and pyroelectric properties were also investigated. The change of grain size had effect on maximum dielectric constant and pyroelectric coefficient, but is had little effect on pyroelectric figure of merit at room temperature. The closer examination near ferro-paraelectric phase transition temperature revealed that the behavior of phase transition approached a more relaxor character with the increase of La content and the decrease of grain size.

• Journal of Surface Science and Engineering
• /
• v.35 no.3
• /
• pp.127-132
• /
• 2002

High speed performance of ferroelectric Pb(Zr,Ti)$O_3$ (PZT) based capacitors is reported. La substitution up to 10% was performed to systematically lower the coercive and saturation voltages of epitaxial ferroelectric capacitors grown on Si using a ($Ti_{0.9}$ /$Al_{0.1}$ )N/Pt conducting barrier composite. Ferroelectric capacitors substituted with 10% La show significantly lower coercive voltage compared to capacitors with 0% and 3% La. This is attributed to a systematic decrease in the tetragonality (i.e., c/a ratio) of the ferroelectric phase. Furthermore, the samples doped with 10% La showed dramatically better retention and pulse width dependent polarization compared to the capacitors with 0% and 3% La. These capacitors show promise as storage elements in low power high density memory architectures.

• Journal of the Korean Ceramic Society
• /
• v.25 no.4
• /
• pp.321-328
• /
• 1988

The sintering phenomena, electrical resistivity, dielectric and piezoelectric properties of lead titanate ceramics modified by the partial substitution of La for Pb and Mn for Ti, (Pb1-1.5xLax)(Ti1-yMny)O3 ceramics, have been investigated. In (Pb1-1.5xLax)(Ti1-yMny)O3 system, with increasing lanthanum content, the realtive bulk density increased, but the Curie point and tetragonality (c/a) decreased. The tetragonal-to-cubic phase transition boundary existed in the range of 0.20

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2003.11a
• /
• pp.142-142
• /
• 2003

The effects of film thickness on the dipolar relaxation of ferroelectric PbTiO$_3$ films were investigated in the microwave-frequency range. The dielectric constants ($\varepsilon$) and the dielectric losses (tan $\delta$) were successfully measured up to 30 ㎓ using interdigital capacitors. The PbTiO$_3$ thin films were deposited on the quartz substrate at room temperature and postannealed in oxygen atmosphere. As the film thickness increased, its grain size and tetragonality were enhanced. And the dipolar relaxation behavior began to appear in the thin films with approximately 20 nm thickness, since ferroelectric domains could not be formed hi small grains. The observed relaxation frequency (above 10 ㎓) was higher than the previous values reported in bulk ceramics. It can be correlated with the extremely small domain size of the thinfilms as shown by TEM. And, the Rayleigh constant [1] from domain wall motions was alsoinvestigated by LCR meter at 100 KHz.

• Journal of the Korean Society for Heat Treatment
• /
• v.15 no.3
• /
• pp.113-117
• /
• 2002

Fatigue characteristics of ferroelectric $Pb(Zr,Ti)O_3$ (PZT) based capacitors through donor doping is reported in this paper. La substitution up to 10% were carried out to study systematically the fatigue behaviors of epitaxial ferroelectric capacitors grown on Si using $(Ti_{0.9}Al_{0.1})N/Pt$ conducting barrier composite. Ferroelectric capacitors substituted with 10% La show sufficient low voltage switched polarization and fatigue free performance. Systematic decrease in the tetragonality of the ferroelectric phase (i.e., c/a ratio) results in the corresponding reduction in coercive voltage, sufficient remnant polarization at 1.5-3V, and good fatigue property.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.07b
• /
• pp.749-751
• /
• 2002

$(Pb_{1-x}Sr_x)TiO_3$ $(0.6{\leq}x{\leq}0.8)$ thin films were prepared by the MOD method for tunable microwave device application and their characteristics were investigated as a function of Sr content(x) and applied field. Thin films showed a homogeneous microstructure and the tetragonality(c/a) was slightly decreased with increasing Sr content. With increasing Sr content, Curie temperature of the thin films showed a decreasing tendency. For the PST thin films, the dielectric constant at room temperature, Tc, and $tan{\delta}$ were 750~1900, $-70^{\circ}{\sim}-30^{\circ}C$ and 0.025~0.04, respectively.

• Journal of the Korean Ceramic Society
• /
• v.24 no.6
• /
• pp.586-592
• /
• 1987

The role of the strain energy and phase stability in the diffuse phase transition have been investigated in the highly disordered solid solution, (Pb1-xBax)(Zr0.4Ti0.6)O3 (0.2 x 0.4). X-ray diffraction analysis indicates that tetragonality (c/a) decreases with the increasing Ba content. Also as the Ba content increases, phase transition becomes more diffuse and at the same time dielectric relaxation as a function of measured frequencies in the 1KHz-10MHz range occurs very pronouncedly. In the Ba content range, 0.2 x 0.35, hysteresis loops are routinely observed and the loop is observed to narrow shape as the Ba content increases but becomes very slim at 40mol% Ba content. Moreover thermal analysis shows that there is no abrupt change in the thermal expansion coefficient below the apparent transition temperature at which dielectric constant becomes maximum. From the above results, it has been concluded that creation of the strain energy due to the distorthion that occurred during the phase transition suppresses diffuse phase transition.