• Proceedings of the KWS Conference
• /
• 2002.05a
• /
• pp.285-287
• /
• 2002

This study is investigated in variations of micro-structures and mechanical properties of Ti/SUS321L joint with bonding temperature and time using brazing method. According to increasing bonding temperature and time, it was observed the thickness of their reaction layer increased. In tensile test, it was examined that the tensile strength had maximum value at the bonding time of 5min and decreased after bonding time over 5min because of increasing their oxides and intermetallic compounds.

• Journal of Soil and Groundwater Environment
• /
• v.20 no.5
• /
• pp.16-25
• /
• 2015

The City of Boulder is located at an average elevation of 1,655 m (5,430 feet), the foothills of the Rocky Mountains in Colorado. Its daily air temperature is much varying and snow is very frequent and heavy even in spring. This paper examines characteristics of shallow (surface and depth = 10 cm) soil temperatures measured from January to May 2015 in the high elevation city Boulder, Colorado. The surface soil temperature quickly responded to the air temperature with the strongest periodicity of 1 day while the subsurface soil temperatures showed a less correlation and delayed response with that. The short-time Fourier of the soil temperatures uncovered their very low frequencies characteristics in heavy snow days while it revealed high frequencies of their variations in warm spring season. The daily minimum air temperature exhibited high cross-correlations with the soil temperatures without lags unlike the maximum air temperature, which is derived from its higher and longer auto-correlation and stronger spectrums of low frequencies than the maximum air temperature. The snow depth showed an inverse relationship with the soil temperature variations due to snow's low thermal conductivity and high albedo. Multiple regression for the soil temperatures using the air temperature and snow depth presented its predicting possibility of them even though the multiple r² of the regression is not that much satisfactory (r² = 0.35-0.64).

• Ocean Science Journal
• /
• v.43 no.1
• /
• pp.1-7
• /
• 2008

Physical and biological environmental variations in the East Sea were investigated by analysing time-series of oceanographic data and meteorological indices. From 1971 to 2000, dominant periodicity in water temperature variations had two apparent periods of 3 to 4 years and of decades, especially in the southwestern part of the East Sea affected by the influence of inflowing Tsushima warm current. Fluctuating water temperature within a certain period appears to respond to El $Ni{\tilde{n}}o$ events with a time lag. It was found that there was a strong correlation between water temperature and El $Ni{\tilde{n}}o$ events with a time lag of 1.5 and 5.5 years for periods of 3 to 6 years and of decades, respectively. Corresponding with El $Ni{\tilde{n}}o$ events, water temperature variability also showed strong correlation with shift and/or changes in biological and chemical environments of nutrient concentrations, zooplankton biomass, and fisheries. However, there also occurred a short-term periodicity of water temperature variations. Within a period of 1 to 4 years, a relatively short-term cycle of water temperature variation had strong correlation with other climate indices such as Pacific Decadal Oscillation and monsoon index. After comparing coherence and phase spectrum between water temperature and different climate indices, we found that there was a shift of coherent periods to another climate index during the years when climate regime shift was reported.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.31 no.3
• /
• pp.260-270
• /
• 2011

The electromechanical impedance(E/M)-based method detects local structural damages based on variations of electrical impedance signatures which are obtained from piezoelectric sensors bonded to the structure and excited in high frequency band. In this method, temperature changes may result in significant impedance variations and lead to erroneous diagnostic results of the structure. To tackle this problem, a new technique providing a 2-dimensional damage feature related to the temperature information is proposed to distinguish the structural damage from the undesirable temperature variation. For experimental tests to validate the proposed method, damages are introduced by bolt loosening to a bolt-jointed steel beam, and impedance signals are measured under varying temperature conditions through a piezoelectric sensor attached on the beam. A freely suspended piezoelectric sensor is additionally utilized to obtain temperature information indirectly from resistance signatures. From a relationship between the damage index (from a constrained sensor) and the temperature (from a freely suspended sensor or a temperature sensor), damages can be detected more clearly under varying temperature compared to other conventional approaches.

• Journal of the korean Society of Automotive Engineers
• /
• v.13 no.4
• /
• pp.62-75
• /
• 1991

The purpose of this study is to perform modelings and experiments to measure air flow rate using hot-wires and a CTA(Constant Temperature Anemometer). The flow rate can be obtained by measuring the heat loss of the hot-wire due to the variations of flow velocity when the hot-wire is maintained at uniform temperature. But the defect of this method is that the output signal changes not only by the flow rate but also by the ambient temperature. Thus, in the present study, a method which compensates the variations of the ambient temperature has been introduced to measure exact flow rate. To be more specific, the bridge circuit of the usual hot-wire anemometer system has been modified in such a way that a temperature resistance sensor and a variable resistance are placed in one of the legs to compensate the different temperature coefficients of both the hot-wire and the temperature compensating resistance for flow velocity or for flow mass up to the flow temperature of 50 .deg.C. Comparing the modeling and experimental results, it has been shown that the compensating point differs as the flow rate varies. Therefore, optimum compensation points are sought to construct the circuit. The present modeling and experimental results may be applied to the design of actual air flow meters for automobiles.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.6
• /
• pp.728-735
• /
• 2016

A 70 MHz temperature-compensated on-chip CMOS relaxation oscillator for mobile display driver ICs is proposed to reduce frequency variations. The proposed oscillator compensates for frequency variation with respect to temperature by adjusting the bias currents to control the change in delay of comparators with temperature. A bandgap reference (BGR) is used to stabilize the bias currents with respect to temperature and supply voltages. Additional temperature compensation for the generated frequency is achieved by optimizing the resistance in the BGR after measuring the output frequency. In addition, a trimming circuit is implemented to reduce frequency variation with respect to process. The proposed relaxation oscillator is fabricated using 45 nm CMOS technology and occupies an active area of $0.15mm^2$. The measured frequency variations with respect to temperature and supply voltages are as follows: (i) ${\pm}0.23%$ for changes in temperature from -30 to $75^{\circ}C$, (ii) ${\pm}0.14%$ for changes in $V_{DD1}$ from 2.2 to 2.8 V, and (iii) ${\pm}1.88%$ for changes in $V_{DD2}$ from 1.05 to 1.15 V.

• Journal of Environmental Science International
• /
• v.23 no.6
• /
• pp.1131-1142
• /
• 2014

In this study, the variations of the carbon dioxide fluxes were investigated with soil temperatures in the grassplot and seasonal variations of carbon dioxide concentrations and fluxes were analysed. Soil temperatures, carbon dioxide concentrations and fluxes were measured on the grassplot in Pukyong National University. Field measurements were carried out 25 times from March in 2010 to March in 2011 with nine points on the grassplot. Seasonal variations of carbon dioxide concentrations and fluxes showed an inverse relation. In summer, carbon dioxide concentrations are lower and carbon dioxide fluxes are higher. In winter, carbon dioxide concentrations are higher and carbon dioxide fluxes are lower. On the grassplot, carbon dioxide emission rate increase when the soil temperature is more than $20^{\circ}C$ and the emission rate decrease when the soil temperatures are less than $10^{\circ}C$. When the accumulated rainfall for five days before measurement day is 20~100 mm, it is showed that the more rainfall, the more carbon dioxide emissions. Carbon dioxide emission rate from the grassplot to the upper atmosphere was increased or decreased by the factors such as soil temperature, growth and wither of grass and rainfall. The results of this study showed that the emission of carbon dioxide in the grassplot is dominantly controlled by seasonal factors (especially soil temperature and rainfall).

• Geomechanics and Engineering
• /
• v.22 no.4
• /
• pp.339-348
• /
• 2020

The uncertain geotechnical properties of frozen soil are important evidence for the design, operation and maintenance of the frozen ground. The complex geological, environmental and physical effects can lead to the spatial variations of the frozen soil, and the uncertain mechanical properties are the key factors for the uncertain analysis of frozen soil engineering. In this study, the elastic modulus, strength and Poisson ratio of warm frozen soil were measured, and the statistical characteristics under different temperature conditions are obtained. The autocorrelation distance (ACD) and autocorrelation function (ACF) of uncertain mechanical properties are estimated by random field (RF) method. The results show that the mean elastic modulus and mean strength decrease with the increase of temperature while the mean Poisson ratio increases with the increase of temperature. The average values of the ACD for the elastic modulus, strength and Poisson ratio are 0.64m, 0.53m and 0.48m, respectively. The standard deviation of the ACD for the elastic modulus, strength and Poisson ratio are 0.03m, 0.07m and 0.03m, respectively. The ACFs of elastic modulus, strength and Poisson ratio decrease with the increase of ratio of local average distance and scale of fluctuation. The ACF of uncertain mechanical properties is different when the temperature is different. This study can improve our understanding of the spatial autocorrelation variations of uncertain geotechnical properties and provide a basis and reference for the uncertain settlement analysis of frozen soil foundation.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.11 no.4
• /
• pp.185-191
• /
• 2009

Few studies have attempted to analyze variations of daily maximum temperature in the summer whereas many studies have analyzed warming trends in other seasons with respect to greenhouse gases or urban heat islands. We analyzed daily maximum temperature data for the summer season (June to August) at 18 locations in South Korea from 1983 to 2007. Compared to the climatic normal (from 1971 to 2000), an average increase of $0.1^{\circ}C$ was found for the summer daily maximum temperature along with an increase of $0.61MJ\;m^{-2}$ in daily solar radiation. Approximately 65% of the annual variations of the summer daily maximum temperature could be explained by the solar radiance alone. Higher atmospheric transmittance due to lower aerosol concentration (especially of sulfur dioxide) is believed to have caused the recent increase in solar irradiance. Daily maximum temperature of the summer is expected to keep rising if the clean air activities are maintained in the future.

• The Korean Journal of Zoology
• /
• v.8 no.2
• /
• pp.51-54
• /
• 1965

Present author observed the variation in color and pattern and also those of geographical distribution of Graphosoma rubrolineatum WESTWOOD.And the variations were also studied in relation to the temperature and the humidity . The results are as follows . 1. The variations in color and pattern of G.rubrolineatum were gradually changed into black ones, and so they showed polymorphic. 2. Their colors and patterns were not variated in inland at all, while those variations in island increased according to the distance from the inland. 3. The red color of the patterns appeared the yellowish-red in inland, the blackish -red in island. 4. The variation in color and pattern of G.rubrolineatum occure in the region of the temperature below 22.8$^{\circ}C$ (mean temperaturrre of June, July and August)and the humidity above 72%(yearly average).