• Proceedings of the Korea Contents Association Conference
• /
• 2003.11a
• /
• pp.276-280
• /
• 2003

Somani and Peleg proposed t/k-diagnosable system to diagonse more faults than t(dimension) by allowing upper bounded few number of units to be diagnosed incorrectly. Kranakis and Pelc showed that their adaptive diagnosis algorithm was more efficient than that of any previous ones, assuming that the number of faults does not exceed the hypercube dimension. We propose an adaptive diagnosis algorithm using the idea of t/k-diagnosable system on the basis of that of Kranakis and Pelc's. When the number of faults exceeds t, we allow a fault(k=1, 2, 3) to be diagnosed incorrectly. Based on this idea, we find that the performance of the proposed algorithm is nearly as efficient as any previously known strategies and detect above about double faults.

• Geomechanics and Engineering
• /
• v.14 no.1
• /
• pp.51-60
• /
• 2018

The foundations are classified into shallow and deep, which have important differences: in terms of geometry, the behavior of the soil, its structural functionality, and its constructive systems. The shallow foundations may be of various types according to their function; isolated footings, combined footings, strip footings, and slabs foundation. The isolated footings are of the type rectangular, square and circular. The combined footing may be rectangular, trapezoidal or T-shaped in plan. This paper presents a new model for T-shaped combined footings to obtain the most economical contact surface on the soil (optimal dimensioning) to support an axial load and moment in two directions to each column. The new model considers the soil real pressure, i.e., the pressure varies linearly. The classical model uses the technique of test and error, i.e., a dimension is proposed, and subsequently, the equation of the biaxial bending is used to obtain the stresses acting on each vertex of the T-shaped combined footing, which must meet the conditions following: The minimum stress should be equal or greater than zero, and maximum stress must be equal or less than the allowable capacity that can withstand the soil. To illustrate the validity of the new model, numerical examples are presented to obtain the minimum area of the contact surface on the soil for T-shaped combined footings subjected to an axial load and moments in two directions applied to each column.

• Korean Journal of Mathematics
• /
• v.7 no.2
• /
• pp.167-169
• /
• 1999

Let R be a Noetherian domain. It is proved that $t$-dimR = 1 if and only if each (proper if R is not a valuation domain) $t$-linked overring D of R is of $t$-dimD = 1 if and only if each integrally closed $t$-linked overring of R is a Krull domain.

• Journal of the Korean Society of Costume
• /
• v.39
• /
• pp.283-299
• /
• 1998

The present study is to analyze the dimensions of affective responses according to the types of appeal in underwear advertisements and to find out the influences of affective res-ponses on the attitudes toward advertisement and brands. The research has been made by normative-descriptive survey method with the sample of 654 consumers residing in Seoul and Incheon. The data gaathered was analyzed by the methods of means, standard deviation, ANOVA, factor analysis and regression. The result are as follows : 1. There are 4 dimensions of affective responses ; Emotional dimension, Negative dimen-sion, Upbeat-activation dimension and Sexual activation dimension. 2. Affective responses to the advertising were different according to the characteristics of the consumers. According to the consumer's sex, there are significant differences in each dimension of their affective responses. To the sex appeal advertisement, man show higher degree of affective responses in Emotional, Upbeat-activation and Sexual-activation dim-ensions, while women show higher degree of affective responses in Negative dimension. 3. In case of female consumers, there are significant differences in affective responses to the both appeal type of advertisements according to consumer's age. As the age is increasing. Emotional dimension and Sexual-activation dimension are increasing, but Negative dimension is decreasing in the Ads with sex appeal. In particular, the 19∼24s age group shows strong responses in the Emotional dimension, Upbeat-activation dimension and Sexual-activation dimension to Ads with sex appeal, while it shows the lowest affective responses in Negative dimension. It represents the 19-24s age group is the most positive one to the under-wear advertisements with sex appeal. Consequently, it is proved that the Ads with sex appeal focusing on this age group can be one of the most effective advertising plans. 4. The involvement gets higher, Upbeat-ac-tivation dimension and Sexual-activation dimension are increasing both in males and female groups. But Negative dimension is in-creasing in the female consumer group of low involvement. 5. The attitudes toward advertisements and brands are comparatively stronger in the advertisements using sex appeal type. Regardless of types of appeal in the advertisements, there is a significant difference in their attitudes tow-ard Ads between male and female consumer groups. When Ads are sexual, attitudes toward Ads and Brands are stronger in the female consumer group. But males consumers show com-paratively strong attitudes toward the advertis-ements and brands in both types of appeal. 6. The age of consumers doesn't make any significant difference in their attitudes toward advertisements and brands in both types of appeal. 7. According to the involvement level of the consumers, there are significant differences in their attitudes toward advertisements. In the groups of low involvement, the female consumers show more favorite attitudes toward the advertisements with sex appeal, while the male group show more favorite attitudes toward the non-sex appeal advertisement. But there is no significant difference in consumer's attitude toward brands according to the types of appeal of the advertisement. 8. The affective responses of the consumers caused by the underwear advertisements have a respectable influence on their attitudes toward the advertisements and brands. This research represents that the advertisers should try to arise consumer's positive affective responses such as pleasant, happy, cheerful and warm-hearted emotions by the advertisements. Based on the above results of the research, it can be said that the consumer's affective responses have a strong effect not only on their attitudes toward adver-tisements but on those toward attitude toward the brands.

• Journal of the Korean Wood Science and Technology
• /
• v.17 no.3
• /
• pp.67-81
• /
• 1989

This experiment was carried out to know the mothod of changing the step of moisture content schedule with time in conventional kiln drying. For the purpose of this object. we made drying model by applying the moisture diffusion model by J.FSiau(1984) to average moisture content equation by J.Crank(1956) derived it from Fick's second law. And to verify this method of drying model. 2.5cm-thick boards and 5.0cm-thick dimension lumbers of Pinus densiflora were kiln-dried with the schedule of T11-C3 and T10-C4, respectively. And then the drying rates were investigated and compared with those calculated from drying model. The results obtained were as follows 1. Average drying rate and total drying time of board to dry to 6.5% moisture content were 0.64%/hr and 109hr., and those of dimension lumber to dry to 8.3% moisture content were 0.4%/hr. and 162hr., respectively. 2. The moisture content of shell and core decreased by equalizing treatment and increased by conditioning treatment both on board and dimension lumber. But the moisture gradient was lower after conditioning than after equalizing. 3. As the drying was proceeded, the transverse bound water diffusion coefficient all but linearly decreased, the water vapor diffusion coefficient abruptly curvilinearly increased, while the transverse diffusion coefficient curvilinearly decreased both on board and dimension lumber. But each of diffusion coefficients on board was larger than that on dimension lumber. 4. Compared to experimential drying rate of board. theoretical drying rate was larger at 30.0%-21.8% moisture content range and was similiar at 21.8%-5.4% moisture content. And in case of dimension lumber, the drying rate was similiar at 30.0%-16.1% moisture content range but theoretical drying rate was much lower at 16.1%-8.3% moisture content range. 5. The possibility of adapting this drying model to changing the moisture content schedule step with time was in the range of 21.8%-5.4% moisture content on board. And in the case of dimension lumber that was in the range of 30.0%-16.1% moisture content.

• Communications of the Korean Mathematical Society
• /
• v.21 no.1
• /
• pp.11-16
• /
• 2006

In this article we show that if R is a Noetherian ring with the global dimension at most one, then every S-torsion free R-module T has a divisible envelope of the form $T{\hookrightarrow}S^{-1}T$

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2003.10b
• /
• pp.26-30
• /
• 2003

Since the dimension of cold forged part is larger than the cavity size of forging die, the difference results from the various features, such as, the elastic characteristics of die and workpiece, thermal influences, and machine-elasticity. All of these factors should be considered to get more accurate prediction of the dimension of forged part. In this paper, severe FE techniques are proposed to improve the prediction accuracy of dimension for cold forged part. To validate the importance of the above mentioned factors, and the estimated results are compared with the experimental results. The used model is a closed die upsetting of cylindrical billet. The calculated dimensions are well coincided with .the measured values based on the proposed techniques. The proposed techniques have put two simple but important points into Fe simulation. One is the separation of forging stages into 3 steps, from a loading through punch retraction to ejecting stage. The other is the dimensional change, according to the temperature changes due to the deformation. The FE analysis could predict the dimension of cold forged part within the $10{\mu}m$, based on the more realistic consideration.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.26 no.1
• /
• pp.18-26
• /
• 2002

With the introduction of Fractal notation, various fields of engineering adopted fractal notation to express characteristics of geometry involved and one of the most frequently applied areas was turbulence. With research on turbulence regarding the surface as fractal geometry, attempts to analyze turbulent premised flame as fractal geometry also attracted attention as a tool for modeling, for the flame surface can be viewed as fractal geometry. Experiments focused on disclosure of flame characteristics by measuring fractal parameters were done by researchers. But robust principle or theory can't be extracted. Only reported modeling efforts using fractal dimension is flame speed model by Gouldin. This model gives good predictions of flame speed in unstrained case but not in highly strained flame condition. In this research, approaches regarding fractal dimension of flame as one representative value is pointed out as a reason for the absence of robust model. And as an extort to establish robust modeling, Presents methods treating fractal dimension as statistical variable. From this approach flame characteristics reported by experiments such as Da effect on flame structure can be seen quantitatively and shows possibility of flame modeling using fractal parameters with statistical method. From this result more quantitative model can be derived.

• The Journal of the Society of Korean Medicine Diagnostics
• /
• v.11 no.2
• /
• pp.84-95
• /
• 2007

Background and Purpose: We have studied the trends of EEG signals in the voluntary breathing condition by applying the fractal analysis. According to chaos theory, irregularity of EEG signals can result from low dimensional deterministic chaos. A principal parameter to quantify the degree of Chaotic nonlinear dynamics is correlation dimension. The aim of this study was to analyze correlation between the correlation dimension of EEG and HRV(heart rate variability). We have studied the trends of EEG signals in the voluntary breathing condition by applying the fractal analysis. Methods: EEG raw data were measured by moving windows during 15 minutes. Then, the correlation dimension(D2) was calculated by each 40-seconds-segment in 15 minutes data, totally 36 segments. 8 channels EEG study on the Fp, F, T, P was carried out in 30 subjects. Results and Conclusion: Correlation analysis of HRV was calculated with deterministic non-linear data and stochastic non-linear data. 1. Ch1(Fp1), Ch4(F3), Ch4(F4) is positive correlated with In LF. 2. Ch1(Fp1), Ch3(F3) is positive correlated with In TF.

• Ocean and Polar Research
• /
• v.28 no.4
• /
• pp.459-465
• /
• 2006

Ambient noise as a background noise in the ocean has been well known for its the various and irregular signal characteristics. Generally, these signals we treated as noise and they are analyzed through stochastical level if they don't include definite sinusoidal signals. This study is to see how ocean ambient noise can be analyzed by the chaotic analysis technique. The chaotic analysis is carried out with underwater ambient noise obtained in areas near the Korean Peninsula. The calculated physical parameters of time series signal are as follows: histogram, self-correlation coefficient, delay time, frequency spectrum, sonogram, return map, embedding dimension, correlation dimension, Lyapunov exponent, etc. We investigate the chaotic pattern of noises from these parameters. From the embedding dimensions of underwater noises, the assesment of underwater noise by chaotic analysis shows similar results if they don't include a definite sinusoidal signal. However, the values of Lyapunov exponent (divergence exponent) are smaller than that of random noise signal. As a result we confirm the possibility of classification of underwater noise using Lyapunov analysis.