• Korean Chemical Engineering Research
• /
• v.47 no.3
• /
• pp.281-286
• /
• 2009

Bitumen extraction and sulfur removal from Athabasca oil sand were conducted using water in sub- and supercritical condition. Bitumen yield in micro reactor was investigated in the pressure range of 15~30 MPa, the temperature of 360 and $380^{\circ}C$ and water density $0.074{\sim}0.61g/cm^3$ for 0~120 min. Bitumen yield increased with reaction pressure irrespective of temperature and dramatically increased in especially supercritical region due to hydrogen formed from water gas shift reaction. Total amount of gas product decreased with reaction pressure but the portion of sulfur and hydrogen increased a little with increasing pressure to 25 and 30 MPa. It is seen that supercritical condition was favourable to the hydrogen formation and sulfur removal. Bitumen yield and sulfur removal from original oil sand reached a maximum 22% and 40% respectively in supercritical condition(the reaction time of 60 min at $380^{\circ}C$ and 25 or 30 MPa).

• Korean Journal of Food Science and Technology
• /
• v.25 no.3
• /
• pp.288-294
• /
• 1993

Solubilities of urea-crystallized tuna oil methyl esters in supercritical carbon dioxide were determined by a flow through extraction reactor. Experimental results obtained under a quasi-equlibrium condition showed that at 150 bar, solubilities of the esters in supercritical $CO_2$ were 0.075, 0.028 and 0.006(w/w) at $40^{\circ}C,\;60^{\circ}C\;and\;80^{\circ}C$, respectively. In the pressure and temperature ranges $(100{\sim}200bar\;and\;40{\sim}80^{\circ}C)$, the solubility increased with the density of $CO_2$. However, selectivity of supercritical carbon dioxide on the extracted compounds was much better at low density than at high density. Supercritical fractionation with a temperature gradient $(50{\sim}75^{\circ}C)$ resulted in concentrates of EPA and DHA in purities of 12% and 85%, respectively.

• KEPCO Journal on Electric Power and Energy
• /
• v.2 no.2
• /
• pp.211-221
• /
• 2016

The increase of world's population and economic development are the keys drivers behind growing demand for energy. Especially the demand for electricity would eventually result in an increase of coal usage. Therefore ultra supercritical circulating fluidized bed boiler has been developed as solutions of economic eco-friendly technologies for coal and of increasing supplies of low grade fuels. Ultra supercritical circulating fluidized bed boiler has an once through type of steam cycle different from drum type in subcritical circulating fluidized bed boiler. Also, the duplication of a proven commercial module with 100-300 MWe subcritical circulating fluidized bed might be the key for design of 500~800 MWe ultra supercritical circulating fluidized bed boiler. After 2017, ultra supercritical circulating fluidized bed boiler might become standard model over subcritical circulating fluidized bed boiler. Therefore, this paper will help you to understand ultra super critical circulating fluidized bed (USC-CFB) through describing the background, status and prospect of the CFB technology.

• Korean Chemical Engineering Research
• /
• v.55 no.2
• /
• pp.220-224
• /
• 2017

In this study, we investigated a new recycling method of phenol resin, which is widely used to make electric insulation boards and adhesives, into carbon particles by using supercritical fluids. Because phenol resin is insoluble and infusible, most of the phenol resin wastes are buried in the ground or incinerated, which leads to environmental pollution. Therefore, development of a new method to recycle phenol resin waste is an urgent issue. In this study, phenol resin waste was treated with four sub/supercritical solvents: ethanol, acetone, water, and methanol. For all the sub/supercritical solvents, the phenol resin wastes were broken down into carbon nano particles at much lower temperatures than that required in the existing carbon particle manufacturing processes. We investigated the difference of morphologies and physical properties of recycled carbon particles according to the use of various solvents. As a result, carbon nano particles with the same amorphous structure were obtained from phenol resin waste with the usage of various sub/supercritical solvents at much lower temperature.

• Journal of the Korean Applied Science and Technology
• /
• v.27 no.3
• /
• pp.233-239
• /
• 2010

Supercritical carbondioxide is very effective in removing oils from a variety of seed matrices, devoid of any appreciable amount of phospholipid content. However, the limited solubility of phosphalipids in supercritical carbondioxide leaves behind a potentially valuable by-product in spent seed matrix. Any phospholipid extraction process from the spent matrix must maintain the structure and the quality of phospholipids and must be compatible with the end use of the seed protein meal an animal feed or for human consumption. An initial supercritical carbondioxide extraction of soybean flakes was performed at 32 MPa and $80^{\circ}C$ to extract the oils, leaving the phospholipids in the deflatted soybean flakes, A second step was performed on the defatted soybean flake using $X_{eth}$=0.10, Varying the pressure from 175 MPa to 70.6 MPa and temperature from $60^{\circ}C$ to $80^{\circ}C$. For all supercritical carbon dioxide/ethanol mixture extractions, a fraction rich in phospholipids was obtained. The fractions extracted from defatted soybean flakes were dried and them redissolved in chloroform before HPLC-ELSD analysis. Quantitative and qualitative analysis of phospholipids on soybean seeds, defatted soybean flake, and different extracted phospholipid fractions was carried out, to ascertain the effect of extraction pressure and temperature.

• Journal of Ginseng Research
• /
• v.37 no.4
• /
• pp.468-474
• /
• 2013

Ginseng seed oil was prepared using compressed, solvent, and supercritical fluid extraction methods of ginseng seeds, and the extraction yield, color, phenolic compounds, fatty acid contents, and phytosterol contents of the ginseng seed oil were analyzed. Yields were different depending on the roasting pretreatment and extraction method. Among the extraction methods, the yield of ginseng seed oil from supercritical fluid extraction under the conditions of 500 bar and $65^{\circ}C$ was the highest, at 17.48%. Color was not different based on the extraction method, but the b-value increased as the roasting time for compression extraction was increased. The b-values of ginseng seed oil following supercritical fluid extraction were 3.54 to 15.6 and those following compression extraction after roasting treatment at $200^{\circ}C$ for 30 min, were 20.49, which was the highest value. The result of the phenolic compounds composition showed the presence of gentisic acid, vanillic acid, ferulic acid, and cinnamic acid in the ginseng seed oil. No differences were detected in phenolic acid levels in ginseng seed oil extracted by compression extraction or solvent extraction, but vanillic acid tended to decrease as extraction pressure and temperature were increased for seed oil extracted by a supercritical fluid extraction method. The fatty acid composition of ginseng seed oil was not different based on the extraction method, and unsaturated fatty acids were >90% of all fatty acids, among which, oleic acid was the highest at 80%. Phytosterol analysis showed that ${\beta}$-sitosterol and stigmasterol were detected. The phytosterol content of ginseng seed oil following supercritical fluid extraction was 100.4 to 135.5 mg/100 g, and the phytosterol content following compression extraction and solvent extraction was 71.8 to 80.9 mg/100 g.

• Food Science and Preservation
• /
• v.16 no.4
• /
• pp.482-489
• /
• 2009

We investigated how supercritical $CO_2$ affected sterilization and enzyme inactivation in dongchimi, a conventional Korean fermented food. The growth of bacteria, including lactic acid bacteria, in dongchimi juice tended to decrease with increased pressure and temperature during treatment with supercritical $CO_2$. D values were affected by pressure more than by temperature. The lowest total number of cells and D values of lactic acid bacteria were observed after treatment with supercritical $CO_2$ at 25 MPa and $25^{\circ}C$; these conditions also reduced polygalacturonase activity in radishes by approximately 40.3%. Supercritical $CO_2$ can be used as an alternative method of sterilization and enzyme inactivation, minimizing sensory loss and textural changes in vegetable materials.

• Composites Research
• /
• v.34 no.5
• /
• pp.277-282
• /
• 2021

Graphene oxide can be reduced to graphene under supercritical fluid condition even without using a specific reducing agent or applying a high thermal process. In this study, a process for converting graphene oxide into graphene was studied under supercritical fluid conditions in methanol and ethanol solvents. When the structure of asprepared graphene was analyzed by using FE-SEM and XRD, the reduction of graphene oxide in supercritical fluid condition was more affected by the change of solvent than other variables such as concentration of graphene oxide and reaction time. The use of ethanol showed better results for the reduction than the use of methanol. The graphene prepared in this study was mixed with epoxy resin up to 20 wt.% to make composites, and the thermal conductivity of the composites were analyzed. Thermal conductivity of the composite increased proportionally with graphene loadings. The graphene prepared in supercritical ethanol condition was more effective on the thermal conductivity of the composite.

• Journal of Convergence for Information Technology
• /
• v.11 no.6
• /
• pp.206-212
• /
• 2021

This study aimed to maximize the efficacy of Angelica gigas by finding a more effective way to extract active compounds from Angelica gigas. After extracting Angelica gigas by hydrothermal, ethanol, and supercritical carbon dioxide extraction methods, analysis of decursin and decursinol angelate content, quantification of total polyphenol content, and evaluation of efficacy of antioxidant, whitening, and antibacterial were conducted. The content of decursin and decursinol angelate was very high at 38.65% of the supercritical carbon dioxide extract, and the total polyphenol content was high in the order of hydrothermal extract, ethanol extract and supercritical carbon dioxide extract, but the difference was relatively small. The antioxidant effects were consistent with the total polyphenol content, and the antibacterial effects were consistent with the decursin and decursinol angelate content. In other words, through this study, we found that the optimal method for extracting active compounds from Angelica gigas is the supercritical carbon dioxide extraction method.

• Journal of the Korean Wood Science and Technology
• /
• v.28 no.4
• /
• pp.41-50
• /
• 2000

Cement-bonded particleboard is being used as outdoor siding material all over the world, because this composite particularly bears a light weight, high resistance against fire, decay, and crack by cyclic freezing and thawing, anti-shock property, and strength enhancement. Construction systems are currently changing into a frame-building style and wooden houses are being constructed with prefabrication type. Therefore, they require a more durability at outdoor-exposed sides. In this study, the cement hydration property for Korean pine particle, Japanese larch particle and face- and middle layer particles (designated as PB particle below) used in Korean particleboard-manufacturing company was investigated, and the rapid manufacturing characteristics of cement-bonded particleboard by supercritical $CO_2$ curing was evaluated. Korean pine flour showed a good hydration property, however, larch flour showed a bad one. PB particle had a better hydration property than larch flour. The addition of $Na_2SiO_3$ indicated a negative effect on hydration, however, $MgCl_2$ had a positive one. Curing by supercritical $CO_2$ fluid gave a conspicuous enhancement in the performances of cement-bonded particleboards compared to conventional curing. $MgCl_2$ 3%-added PB particle had the highest properties, and $MgCl_2$ 1%-added Korean pine particle had the second class with the conditions of cement/wood ratio of 2.7, a small fraction-screened particle and supercritical curing. On the contrary, the composition of non-hammermilled or large fraction-screened particle at cement/wood ratio of 2.2 was poorer. Also, the feasibility for actual use of 3%-added, small PB particle-screened fraction was greatest of all the conventional curing treatments. Relative superiority of supercritical curing vs. conventional curing at dimensional stability was not so apparent as in strength properties. Through the thermogravimetric analysis, it was ascertained that the peak of a component $CaCO_3$ was highest, and the two weak peaks of calcium silicate hydrate and ettringite and $Ca(OH)_2$ were present in supercritical treatment. Accordingly, it was inferred that the increased formation of carbonates in board contributes to strength enhancement.