• 한국구조물진단유지관리공학회 논문집
• /
• 제14권3호
• /
• pp.131-137
• /
• 2010

개구부의 여러가지 형상을 고려한 축하중에 대한 철근 콘크리트 벽체의 극한 강도를 연구하기 위하여 12개의 1/3축소벽체 실험을 수행하고 분석하였다. 벽체실험은 기존의 설계식을 수정하기 위하여 구성되었다. 유효좌굴길이가 고려된 실험결과를 이용하여 새로운 실험식이 산출되었다. 이 새로운 설계식은 기존의 실험설계식과 비교하여 제안한다.

• Structural Engineering and Mechanics
• /
• 제71권5호
• /
• pp.563-576
• /
• 2019

According to The Concrete Centre, in the UK shear walls have become an inseparable part of almost every reinforced concrete frame building. Recently, the construction industry has questioned the need for shear walls in low to mid-rise RC frame buildings. This study tried to address the issue in two stages: The first stage, the feasibility of removing shear walls in an existing design for a residential building where ETABS and CONCEPT software were used to investigate the structural performance and cost-effectiveness respectively. The second stage, the same structure was examined in various locations in the UK to investigate regional effects. This study demonstrated that the building without shear wall could provide adequate serviceability and strength within the safe range defined by Eurocodes. As a result, construction time, overall cost and required concrete volume are reduced which in turn enhance the sustainability of concrete construction.

• Structural Engineering and Mechanics
• /
• 제72권4호
• /
• pp.443-454
• /
• 2019

In order to reduce the residual drift of a structure in structural engineering field, a combined structural system (dual) consisting of steel buckling-restrained braced frame (BRBF) along with shear wall is proposed. In this paper, BRBFs are used with special reinforced concrete shear walls as combined systems. Some prototype models of the proposed combined systems as well as steel BRBF-only systems (without walls) are designed according to the code recommendations. Then, the nonlinear model of the systems is prepared using fiber elements for the reinforced concrete wall and appropriate elements for the BRBs. Seismic responses of the combined systems subjected to ground motions at maximum considered earthquake level are investigated and compared to those obtained from BRBFs. Results showed that the maximum residual inter-story drift from the combined systems is, on average, less than half of the corresponding value of the BRBFs. In this research, mean of absolute values of the maximum inter-story drift ratio demand obtained from combined systems is less than the 3% limitation, while this criterion has not been fulfilled by BRBF systems.

• Structural Engineering and Mechanics
• /
• 제42권3호
• /
• pp.383-407
• /
• 2012

A numerical approach to simulate the behaviour of timber shear walls under both static and dynamic loading is proposed. Because the behaviour of timber shear walls hinges on the behaviour of the nail connections, the force-displacement behaviour of sheathing-to-framing nail connections are first determined and then used to define the hysteretic properties of finite elements representing these connections. The model nails are subsequently implemented into model walls. The model walls are verified using experimental results for both monotonic and cyclic loading. It is demonstrated that the complex hysteretic behaviour of timber shear walls can be reasonably represented using model shear walls in which nonlinear material failure is concentrated only at the sheathing-to-framing nail connections.

• Structural Engineering and Mechanics
• /
• 제31권3호
• /
• pp.367-369
• /
• 2009

The aim of this discussion is to expose incorrect formulations and terms in the aforementioned paper.

• 콘크리트학회논문집
• /
• 제15권2호
• /
• pp.323-334
• /
• 2003

비선형정적해석과 같은 성능기초설계를 위해서는 부재의 비선형거동을 정확하게 예측하여야 한다. 본 연구에서는 단부횡보강된 구조벽의 휨모멘트-곡률관계를 구하는 방법을 개발하기 위하여 해석연구를 실시하였다. 비선형해석을 수행하여 수직방향 철근의 배치형태와 단부횡보강 길이의 변화에 따른 구조벽체의 거동특성과 파괴 메카니즘의 변화를 연구하였다. 분석결과, 적절하게 횡보강된 벽체의 최대강도는 비횡보강 콘크리트가 극한 압축변형율에 도달하는 경우에 발생한다. 단부집중배근을 갖는 벽체에서는 취성파괴가 일어나며, 웨브의 수직철근은 연성파괴를 유도하는 역할을 한다. 이러한 연구결과에 근거하여 다양한 배근형태를 갖는 벽체에 대한 모멘트-곡률관계를 정의하였다. 이 제안된 관계에 따르면 단부횡보강된 구조벽체의 변형능력은 재하된 압축력에 비하여 횡보강 콘크리트의 압축재하능력이 증가할수록 증가한다.

• 한국구조물진단유지관리공학회 논문집
• /
• 제22권5호
• /
• pp.72-81
• /
• 2018

방화구획 내 벽체에는 콘크리트, 조립식 패널, 건식벽체 등을 사용한 내화구조가 주로 적용되고 있으나 근래에 들어 시야 확보 및 미적 관점에 대한 관심이 증가하여 유리로 구성된 벽체의 수요가 발생하고 있다. 본 연구에서는 차열 유리를 적용한 스틸 내화벽체에 관한 것으로써 내부 방화구획에 적용 가능한 60분 내화벽체와 외부 벽체 및 커튼월에 적용 가능한 90분 내화벽체에 대하여 내화시험 및 성능분석을 수행하였다. 시험 결과, 각 시험체의 요구 내화성능을 충족하는 것으로 나타났으며, 추가적으로 유한요소해석을 통한 유리벽체의 내화성능을 평가하였으며 그 결과 1차적으로 시험체의 내화성능을 예측하는 것이 가능한 것으로 판단되었다.

• Structural Engineering and Mechanics
• /
• 제65권3호
• /
• pp.303-314
• /
• 2018

Shear walls are a typical member under a complex stress state and have complicated mechanical properties and failure modes. The separated-elements model Genetic Evolutionary Structural Optimization (GESO), which is a combination of an elastic-plastic stress method and an optimization method, has been introduced in the literature for designing such members. Although the separated-elements model GESO method is well recognized due to its stability, feasibility, and economy, its adequacy has not been experimentally verified. This paper seeks to validate the adequacy of the separated-elements model GESO method against experimental data and demonstrate its feasibility and advantages over the traditional elastic stress method. Two types of reinforced concrete shear wall specimens, which had the location of an opening in the middle bottom and the center region, respectively, were utilized for this study. For each type, two specimens were designed using the separated-elements model GESO method and elastic stress method, respectively. All specimens were subjected to a constant vertical load and an incremental lateral load until failure. Test results indicated that the ultimate bearing capacity, failure modes, and main crack types of the shear walls designed using the two methods were similar, but the ductility indexes including the stiffness degradation, deformability, reinforcement yielding, and crack development of the specimens designed using the separated-elements model GESO method were superior to those using the elastic stress method. Additionally, the shear walls designed using the separated-elements model GESO method, had a reinforcement layout which could closely resist the actual critical stress, and thus a reduced amount of steel bars were required for such shear walls.

• 한국구조물진단유지관리공학회 논문집
• /
• 제16권3호
• /
• pp.128-137
• /
• 2012

복합 병렬 전단벽(Coupled shear walls)은 커플링 보와 철근콘크리트 벽체로 구성되어 바람이나 지진 등의 횡하중으로부터 유발된 전도모멘트의 상당 부분을 철골 연결보의 커플링 작용에 의하여 골조 작용(Frame action)을 의하여 횡력에 효율적으로 저항하게 된다. 본 연구에서는 접합부 상세에 따른 복합병렬 전단벽의 접합부 강도에 대한 규준식을 정립하기 위한 선행연구로서 병렬 전단벽 접합부에서 커플링 보의 매립길이 및 벽체 두께를 주변수로 실험적 연구를 수행하여 접합부 상세에 따른 복합 병렬 전단벽 시스템의 거동특성을 규명하고자 하였다. 본 실험결과, 실험체의 거동 및 내력은 매립길이 및 접합부 상세에 많은 영향을 받는 것으로 나타났으며 향후 설계시 이에 대한 영향을 반영해야 할 것으로 판단된다.

• 한국지진공학회논문집
• /
• 제17권5호
• /
• pp.197-207
• /
• 2013

The seismic performance of school buildings has been a matter of common interest socially and academically. The structural system of the school buildings is representative of the domestic low-rise reinforced concrete moment resisting frames, which apply extensively infills in their masonry walls. The masonry infilled walls are divided into full masonry infill in the transverse direction and partial masonry infill in the longitudinal direction. The masonry infilled walls are usually not included in structural analysis during the design process, but affect significantly the seismic performance because they behave with surrounding frames simultaneously during earthquakes. Many researchers have studied the effect of the masonry infilled walls, but several issues have been missed such as the increase of asymmetry by adding the full masonry infill, the size of the mean strength of the full masonry infill, and short column effect by the partial masonry infill. The issues were analytically investigated and the results showed that they should be checked at least by nonlinear pushover analysis in the seismic performance evaluation process. The results also confirm the weakness of the guideline of Korean Educational Development Institute where the seismic performance is basically assessed without structural analysis.