• Magazine of the Korea Concrete Institute
• /
• v.10 no.6
• /
• pp.169-178
• /
• 1998

Bond strength of reinforcing bar to high-perfomance concrete using belite cement is explored using beam end test specimens. The key parameters for the bond test are slump of concrete, top bar effect, and strength of concrete in addition to concrete cover. The test results show that the specimens with belite cement concrete show approximately 10% higer bond strength than those with portland cement concrete. The results also show that the bond strength from the high strength concrete is function of the square root of concrete compressive strength. Bond strength of the top bar is less than bond strength of bottom bar, but the ratios of the bond strength of bottom-cast bars to those for top-cast bars are much less than the modification factor for top reinforcement found in the ACI 318-95 code. Comparisons with other reported tests identified that belite cement increased bond strength while silica fume or flyash used in high strength concrete decreased bond strength. The high-strength and high-slump concrete with belite cement performs well in terms of bond strength to reinforcing steel.

• Journal of Biomedical Engineering Research
• /
• v.33 no.4
• /
• pp.194-201
• /
• 2012

This study was designed to investigate the effect of a combined stimulus which was composed of chiropractic massage and thermotherapy on the relief of mental and physical stress. Fifteen healthy male subjects were treated with three type of stimuli; control (without any stimulus), a single stimulus (only chiropractic) and a combined stimulus. To evaluate the effects of stimuli, visual analogue scale (VAS), trunk extension, electromyogram (EMG) on erector spinae muscle and electrocardiogram (ECG) were measured and analyzed before and after stimuli. In the control group, there were no significant changes in EMG root mean square (RMS) value and low Frequency/high Frequency (LF/HF) ratio (p > 0.05, p > 0.05). However, both stimulus groups showed significant increases in trunk extension and EMG RMS values (p < 0.05, p < 0.05), but significant decreases in LF/HF ratios (p < 0.05). Particularly the decrement rate in LF/HF ratio was significantly higher in the combined stimulus group than that in the single stimulus group (p < 0.05). Also, a significantly lower VAS was recorded after combined stimulus. Our findings indicate that the combined stimulus might not only improve flexibility and strength of muscle, but also active parasympathetic nerve activity. The combined stimulus may thus contribute to relieve the stress and to enhance the muscle function.

• Korean Journal of Remote Sensing
• /
• v.33 no.1
• /
• pp.69-77
• /
• 2017

S The need for an automated geo-positioning approach for near real-time results and to boost cost-effectiveness has become increasingly urgent. Following this trend, a new approach to automatically compensate for the bias of the rational function model (RFM) was proposed. The core idea of this approach is to remove the bias of RFM only using tie points, which are corrected by matching with the digital elevation model (DEM) without any additional ground control points (GCPs). However, there has to be a additional evaluation according to the quality of DEM because DEM is used as a core element in this approach. To address this issue, this paper compared the quality effects of DEM in the conduct of the this approach using the Shuttle Radar Topographic Mission (SRTM) DEM with the spatial resolution of 90m. and the National Geographic Information Institute (NGII) DEM with the spatial resolution of 5m. One KOMPSAT-2 stereo-pair image acquired at Busan, Korea was used as experimental data. The accuracy was compared to 29 check points acquired by GPS surveying. After bias-compensation using the two DEMs, the Root Mean Square (RMS) errors were less than 6 m in all coordinate components. When SRTM DEM was used, the RMSE vector was about 11.2m. On the other hand, when NGII DEM was used, the RMSE vector was about 7.8 m. The experimental results showed that automated geo-positioning approach can be accomplished more effectively by using NGII DEM with higher resolution than SRTM DEM.

• Journal of the Korean Ceramic Society
• /
• v.41 no.4
• /
• pp.340-343
• /
• 2004

SrA1$_2$O$_4$was prepared by polymerized complex method and crystalline growth was investigated. Precursors was annealed at temperatures form 900 to 100$0^{\circ}C$, for different time(between 0 and 10 h), and that was determined by Transmittance Electron Microscopy (TEM) and X-Ray Diffractometer (XRD). Crystalline size was calculated by Scherrer's equation and its variation was studied. It increased rapidly in the primary stage and then slowly as a function of square root of time. so, It was grown to 32, 45 and 59nm after heating treatment at 900, 980, and 100$0^{\circ}C$ for 10 h respectively. Cstalline growth rates were 4.5, 9.6, and 18.6 nm/h$^{1}$2/ as a addition of heating temperature.

• Korean Journal of Acupuncture
• /
• v.30 no.4
• /
• pp.305-318
• /
• 2013

Objectives : The aim of this study was to examine the effect of electroacupuncture(EA) at an acupoint, HT8(Sobu), on normal humans by using power spectral analysis. We examined the effect on the Heart Rate Variability(HRV), and the balance of the autonomic nervous system. Methods : Thirty-two healthy volunteers participated in this study. EEG(Electroencephalogram) power spectrum exhibits site-specific and state-related differences in specific frequency bands. A thirty-two channel EEG study was carried out on thirty-two subjects(14 males; mean age=23.5 years old, 18 females; mean age=21.5 years old). HRV and EEG were simultaneously recorded before and after acupuncture. Results : In the ${\alpha}$(alpha) band, during the HT8-acupoint treatment, the power values in the ${\alpha}$(alpha) band significantly decreased(p<0.05) at 28 channels. In the ${\beta}$(beta) band significantly decreased(p<0.05) at 26 channels. In ${\delta}$(delta) band significantly decreased(p<0.05) at 18 channels. In ${\theta}$(theta) band significantly decreased(p<0.05) at 20 channels. ${\alpha}/{\beta}$ values were increased at 6 channels and decreased at 10 channels.${\beta}/{\theta}$ values were increased at 10 channels and decreased at 19 channels. Mean-RR(RR-interval), Complexity, RMSSD(Root mean square of successive differences), SDSD(Standard deviations differences between adjacent normal R-R intervals), norm HF showed a significantly increased and mean-HRV, norm LF, LHR(LF/HF Ratio) showed a significantly decreased after HT8-acupoint treatment(p<0.05). Conclusions : These results suggest that EA at the HT8 mostly causes significant changes on alpha(28 channels), beta(26 channels), delta(18 channels), theta(20 channels) bands and mean-HRV, mean-RR, complexity, RMSSD, SDSD, norm LF, norm HF and LHR. If practicing EA at the HT8, it will regulate the function of the cerebral cortex, decrease activity of the sympathetic and increase parasympathetic nervous activity.

• Progress in Superconductivity
• /
• v.6 no.2
• /
• pp.133-137
• /
• 2005

We fabricated the Au/Ni template for YBCO coated conductors and evaluated texture formation and the microstructural evolution. The cube textured Ni substrate was fabricated by rolling and recrystallization annealing, and subsequently Au layer formed on the substrate by electroless-plating method. The texture was evaluated by pole-figure with x-ray goniometer with orientation distribution function (ODF) analysis. The surface roughness and grain boundary morphology of template were characterized by atomic force microscopy (AFM) We observed that Au layer deposited epitaxially on Ni substrate and formed a strong cube texture when plating time was optimized. The full-width at half-maximum (FWHM) was $8.4^{\circ}$ for out-of-plane and $9.98^{\circ}$ for in-plane texture for plating time of 30 min. Microstructural observation showed that the Au layer was homogeneous and dense without formation of crack/microcrack. In addition, we observed that root-mean-square (RMS) and depth of grain boundary were 14.6 nm and 160 $\AA$ for the Au layer, respectively, while those were 27.0 nm and 800 $\AA$ for the Ni substrate, indicating that the electoless-plated Au layer had relatively smooth surface and effectively mollified grain groove.

• Food Science of Animal Resources
• /
• v.30 no.5
• /
• pp.730-738
• /
• 2010

We developed predictive growth models for Staphylococcus aureus and Bacillus cereus on various food matrices consisting primarily of ready-to-eat (RTE) foods. A cocktail of three S. aureus strains, producing enterotoxins A, C, and D, or a B. cereus strain, were inoculated on sliced bread, cooked rice, boiled Chinese noodles, boiled bean sprouts, tofu, baked fish, smoked chicken, and baked hamburger patties at an initial concentration of 3 log CFU/g and stored at 8, 10, 13, 17, 24, and $30^{\circ}C$. Growth kinetic parameters were determined by the Gompertz equation. The square-root and Davey models were used to determine specific growth rate and lag time values, respectively, as a function of temperature. Model performance was evaluated based on bias and accuracy factors. S. aureus and B. cereus growth were most delayed on sliced bread. Overall, S. aureus growth was significantly (p<0.05) more rapid on animal protein foods than carbohydrate-based foods and vegetable protein foods. The fastest growth of S. aureus was observed on smoked chicken. B. cereus growth was not observed at 8 and $10^{\circ}C$. B. cereus growth was significantly (p<0.05) more rapid on vegetable protein foods than on carbohydrate-based foods. The secondary models developed in this study showed suitable performance for predicting the growth of S. aureus and B. cereus on various food matrices consisting of RTE foods.

• The Korean Journal of Pain
• /
• v.22 no.1
• /
• pp.39-46
• /
• 2009

Background: Ketamine has an indirect sympathetic stimulation effect. We investigated heart rate variability (HRV) as a marker of cardiac autonomic function after a target controlled infusion (TCI) of ketamine with a plasma concentration of 30 or 60 ng/ml. Methods: In 20 adult volunteers, the mean of the R wave to the adjacent R wave interval (RRI), the range of RRI, the root mean square successive difference of intervals (RMSSD), the total power, the low frequency (LF, 0.04-0.15 Hz) power, the high frequency (HF, 0.15-0.4 Hz) power, the normal unit HF (nuHF), the normal unit LF (nuLF), the LF/HF ratio and the SD1 and the SD2 in the Poincare plot were measured before and after a TCI of ketamine. We observed for any psychedelic symptoms or sedation. Results: There were no differences in the mean and range of the RRI, RMSSD, total power, LF power, HF power, nuHF, nuLF, LF/HF ratio, SD1 and SD2 between before and after ketamine administration. The OAA/S score was higher and there were more psychedelic symptoms with a 60 ng/ml plasma concentration than with a 30 ng/ml plasma concentration. Conclusions: This study did not show any effect of a low plasma concentration of ketamine on the autonomic nervous system.

• Journal of Biomedical Engineering Research
• /
• v.36 no.4
• /
• pp.103-108
• /
• 2015

Discrimination of Parkinson's disease (PD) from Essential tremor (ET) is often misdiagnosed in clinical practice. Since tremor is time-varying signal, and dominant and harmonic frequencies are shown in tremor only with moderate or severe symptom, there are some limitations to use frequency related features. Moreover, patients with PD or ET can suffer from both resting tremor and postural tremor. In this study, 28 patients with PD and 17 patients with ET were enrolled. Tremor was measured with accelerations on the more affected hand during resting and postural conditions. The ratio of root mean square (RMS) of resting tremor to RMS of postural tremor, the mean coefficients of autocorrelation function (ACF), and the mean of differences of two adjacent coefficients of ACF at resting and postural were calculated and compared between PD and ET. The performance showed 98% accuracy with support vector machine and leave-one-out cross validation. In addition, the method accurately differentiated the patients with tremor-dominant PD from patients with ET, with 100% accuracy. Therefore, the developed algorithm can assist clinicians in diagnosing and categorizing patients with tremor, especially, patients with mild symptom or the early stage of a disease, for proper treatment.

• Journal of Sensor Science and Technology
• /
• v.9 no.4
• /
• pp.316-326
• /
• 2000

A new signal processing algorithm for white light interferometry has been proposed and investigated theoretically. The goal of the algorithm is to determine the absolute optical path length of an interferometer with very high precision (<< one optical wavelength). The algorithm features cross-correlation of interferometer fringe scans and hypothesis testing. The hypothesis test looks for a zero order fringe peak candidate about which the cross-correlation is symmetric minimizing the uncertainty of misidentification. The shot noise limited performance of the proposed signal processing algorithm has been analyzed using computer simulations. Simulation results were extrapolated to predict the misidentification rate at Signal to-Shot noise ratio (SNR) higher than 31 dB. Root-mean-square phase error between the computer-generated zero order fringe peak and the estimated zero order fringe peak has been calculated for the changes of three different parameters (SNR, fringe scan sampling rate, coherence length of light source). Results of computer simulations showed the ability of the proposed signal processing algorithm to identify the zero order fringe peak correctly. The proposed signal processing algorithm uses a software approach, which is potentially inexpensive, simple and fast.