• Journal of Korean Society of Environmental Engineers
• /
• v.31 no.1
• /
• pp.1-8
• /
• 2009

This research was performed to assess a Fenton-like oxidation using naturally present iron in the field to treat remained oils throughout silty clay residues which finally resided even after a series of soil washing process. Biodegradability was thus tested for reaction products to investigate a possible treatment of the Fenton-like oxidation coupled with a biological treatment process. For those purposes, two types of field soil samples (e.g., dewatered cake after conditioning with a polymer and not-dewatered residue) were tested to remove TPH by adding the various concentration of hydrogen peroxide ($H_2O_2$). Moreover the biodegradability of treated samples was observed based on the ratio of $BOD_5/COD_{Cr}$ after Fenton-like oxidation. The Highest removal of TPH was at 1% of hydrogen peroxide ($H_2O_2$) when hydrogen peroxide ($H_2O_2$) was continuously injected for a period of time rather than that of spot introduction with the same amount of it. For the dewatered cake, TPH was effectively treated when the ratio of solid and water was mixed at 1 : 2. Employing cooking oil could increase solubility of TPH due to enhanced surface-active escalating TPH desorption from silty clay. Nonetheless, the biodegradability was decreased as long as the oxidation duration being extended regardless of operational conditions. It was therefore proved that Fenton-like oxidation using $H_2O_2$ and natural iron minerals was able to remove adsorbed oils in silty clay but the removal efficiency of TPH was low. And if a biological treatment process followed after Fenton-like oxidation, microorganisms would need enough time for acclimation.

• Korean Journal of Food Science and Technology
• /
• v.40 no.2
• /
• pp.123-128
• /
• 2008

The MRLs (maximum residue limits) of DDT (DDD and DDE) in fresh ginseng, dried ginseng, and steamed red ginseng are set as low as 0.01 mg/kg, 0.05 mg/kg, and 0.05 mg/kg, respectively. Therefore, this study was undertaken to develop a simple and highly sensitive analysis method, as well as to reduce interfering ginseng matrix peaks, for the determination of DDT isomers (o,p'-DDE, p,p'-DDE, o,p'-DDD, p,p'-DDD, o,p'-DDT, and p,p'-DDT) in fresh ginseng, dried ginseng, and steamed red ginseng at the 0.01 mg/kg level. The method used acetonitrile extraction according to simultaneous analysis, followed by normal-phase Florisil solid-phase extraction column clean-up. The purification method entailed the following steps: (1) dissolve the concentrated sample extract in 7 mL hexane; (2) add 3 mL of $H_2SO_4$; (3) vigorously shake on avortex mixer; (4) cetrifuge at 2000 rpm for 5 min; (5) transfer 3.5 mL of the supernatant to the Florisil-SPE (500 mg/6 mL);and (6) elute the SPE column with 1.5 mL of hexane and 10 mL of ether/hexane (6:94). The determination of DDT isomers was carried out by a gas chromatography-electron capture detector (GC-${\mu}$ECD). The hexane and ether/hexane (6:94) eluate significantly removed chromatographic interferences, and the addition of 30% $H_2SO_4$ to the acetonitrile extract effectively reduced many interfering ginseng matrix peaks, to allow for the determination of the DDT isomers at the 0.01 mg/kg level. The recoveries of the 6 fortified (most at 0.01 mg/kg) DDT isomers from fresh ginseng, dried ginseng, and steamed red ginseng ranged from 87.9 to 99.6%. The MDLs (method detection limits) ranged from 0.003 to 0.009 mg/kg. Finally, the application of this method for the determination of DDT isomers is sensitive, rapid, simple, and inexpensive.

• Journal of Food Hygiene and Safety
• /
• v.29 no.2
• /
• pp.131-140
• /
• 2014

The objective of this study was to develop a simultaneous method of 8 penicillin antibiotics including amoxicillin, ampicillin, cloxacillin, dicloxacillin, nafcillin, oxacillin, penicillin G and penicillin V in meat using LC-MS/MS. The procedure involves solid phase extraction with HLB cartridge and subsequent analysis by LC-MS/MS. To optimize MS analytical condition of 8 compounds, each parameter was established by multiple reaction monitoring in positive ion mode. The chromatographic separation was achieved on a $C_{18}$ column with a mobile phase of 0.05% formic acid and 0.05% formic acid in acetonitrile at a flow rate of 0.2 mL/min for 20 min with a gradient elution. The developed method was validated for specificity, linearity, accuracy and precision in beef, pork and chicken. The recoveries were 71.0~106%, and relative standard deviations (RSD) were 4.0~11.2%. The limit of detection (LOD) and the limit of quantification (LOQ) were 0.003~0.008 mg/kg and 0.01~0.03 mg/kg, respectively, that are below maximum residue limit (MRL) of the penicillins. This study also performed survey of residual penicillin antibiotics for 193 samples of beef, pork and chicken collected from 9 cities in Korea. Penicillins were not found in all the samples except a sample of pork which contained cloxacillin (concentration of 0.08 mg/kg) below the MRL (0.3 mg/kg).

• Resources Recycling
• /
• v.30 no.6
• /
• pp.43-52
• /
• 2021

In this study, the optimal nitration process for selective lithium leaching from powder of a spent battery cell (LiNi_xCo_yMn_zO₂, LiCoO₂) was studied using Taguchi method. The nitration process is a method of selective lithium leaching that involves converting non-lithium nitric compounds into oxides via nitric acid leaching and roasting. The influence of pretreatment temperature, nitric acid concentration, amount of nitric acid, and roasting temperature were evaluated. The signal-to-noise ratio and analysis of variance of the results were determined using L₁₆(4⁴) orthogonal arrays. The findings indicated that the roasting temperature followed by the nitric acid concentration, pretreatment temperature, and amount of nitric acid used had the greatest impact on the lithium leaching ratio. Following detailed experiments, the optimal conditions were found to be 10 h of pretreatment at 700℃ with 2 ml/g of 10 M nitric acid leaching followed by 10 h of roasting at 275℃. Under these conditions, the overall recovery of lithium exceeded 80%. X-ray diffraction (XRD) analysis of the leaching residue in deionized water after roasting of lithium nitrate and other nitrate compounds was performed. This was done to determine the cause of rapid decrease in lithium leaching rate above a roasting temperature of 400℃. The results confirmed that lithium manganese oxide was formed from lithium nitrate and manganese nitrate at these temperatures, and that it did not leach in deionized water. XRD analysis was also used to confirm the recovery of pure LiNO₃ from the solution that was leached during the nitration process. This was carried out by evaporating and concentrating the leached solution through solid-liquid separation.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.22 no.1
• /
• pp.468-476
• /
• 2021

This study examined the effects of a hydrothermal pretreatment (HP) on the nutritional values and in vitro fermentation characteristics of tall fescue and corn silage. This study was conducted through a factorial design of 2 (control or HP) × 2 (hay; tall fescue or silage; corn). For the HP, forage was placed into a glass bottle with 20% w/v of water, and the glass bottle was sealed and heated to reach a temperature of 121℃ (0.12 MPa). The solid residue and liquid were collected and oven-dried at 65℃ for three days. The dried materials were tested for in vitro fermentation at 39℃ for 24 and 48 h. The content of ADF increased significantly regardless of the forage type. After in vitro incubation for 24 h, the total VFA content was significantly lower after HP, regardless of the forage type (p ≤ 0.05), and the propionate concentration was increased in corn silage with HP (p ≤ 0.05). After 48 hours of in vitro incubation, the propionate content increased significantly (p ≤ 0.03) in corn silage with HP (p ≤ 0.05), but the butyrate content decreased significantly (p ≤ 0.05). There was no change in the in vitro dry matter and neutral detergent fiber digestibility by HP regardless of the forage type. Therefore, the use of hydrothermally pretreated corn silage could be advantageous for the supply of energy for ruminants.

• Journal of the Korean Chemical Society
• /
• v.67 no.2
• /
• pp.81-88
• /
• 2023

The contribution of hydrophobic residues to the protein folding reaction was studied by using HubWA variant proteins with I and L to V mutation. Folding kinetics of all V variant proteins was observed to be satisfied by a three-state on-pathway mechanism, U ⇌ I ⇌ N, where U, I, and N represent unfolded, intermediate, and native state, respectively. Three-state folding reaction was quantitatively analyzed and the free energy of folding of each elementary reactions and overall folding reaction, ΔG^o_UI, ΔG^o_IN, and ΔG^o_UN, were obtained. From the ratio of free energy difference between the variant protein and HubWA, ΔΔG^o_UI/ΔΔG^o_UN (ΔΔG^o_UI = ΔG^o_UI (variant protein) - ΔG^o_UI (HubWA) and ΔΔG^o_UN = ΔG^o_UN (variant protein) - ΔG^o_UN(HubWA)), the contribution of hydrophobic residues to HubWA folding was analyzed. The residues which are located in the hydrophobic core between α-helix and β-sheet, I3, I13, L15, I30, L43, I61 and L67, showed ΔΔG^o_UI/ΔΔG^o_UN value of ~0.5 when each of these residues was mutated to V, indicating that these residues form relatively solid hydrophobic core in the intermediate state. Residues located at the end of secondary structures and loop, I23, L69 and I36 showed ΔΔG^o_UI/ΔΔG^o_UN value below 0.4 when each of these residues was mutated to V, indicating that the region containing these residues are loosely formed in the intermediate state. V17A, L50V and L56V showed fairly high ΔΔG^o_UI/ΔΔG^o_UN value of ~0.8. Since L50 and L56 are located in the region containing long loop (residue 46 to 62), it is suggested that the high ΔΔG^o_UI/ΔΔG^o_UN value of these residues prevents the formation of aggregate at the early stage of folding reaction.