• Proceedings of the Korea Air Pollution Research Association Conference
• /
• 1999.10a
• /
• pp.355-356
• /
• 1999

대기오염물질의 침적에 의해 호소나 연안해수의 조성이 변화하여 수서 생태계에 영향을 미칠 가능성에 대해서는 여러 논의가 있었다. 특히 질소화합물의 대기로부터의 유입에 의한 부영양화는 적조 등의 현상을 일으켜, 연안 생태계에 큰 영향을 미칠 수 있다. 따라서, 연안에서 침적되는 대기오염물질의 양을 추산하기 위해 에어로솔상의 이온성분을 측정하는 것은 침적 현상이해에 매우 중요하다.(중략)

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1999.11a
• /
• pp.51-54
• /
• 1999

In this paper, the relativities, and the properties of various contaminants, which could give significant decrease in electrical insulation strength were investigated. For this investigation, the contamination degree was manually measured with brush-wiping method, and the ingredient of some specific sample was analyzed with ICP/MS. With the result, the influence of distance from sea, climatic condition contamination was investigated. And the difference in electrical properties of various salts in aquous solution was determined. Finally, we could get several significant result on the relativity and properties of contamination in various conditions

• Analytical Science and Technology
• /
• v.32 no.6
• /
• pp.243-251
• /
• 2019

Microplastics (MP) are found in large quantities in the oceans, posing a major threat to the ecosystem. In Korea, MPs have been reported to be detected in sea salts. In order to analyze MPs, information on their composition, size, and shape is required. FT-IR microscopy is used frequently to measure sizes larger than 20 ㎛. Recently, however, Raman microscopy, which can analyze ultrafine plastics below 20 ㎛, has been applied extensively. In this study, 10.0 g samples of commercially available salts were dissolved and filtered through a 45 ㎛ mesh filter with a size of 25.4 mm × 25.4 mm. These filtered samples were then analyzed by both FT-IR microscopy and Raman microscopy. A total of four MPs, including three polyethylene (PE) of size 70-100 ㎛ and a polypropylene (PP) of size 170 ㎛, were detected by FT-IR microscopy, while 10 MPs, including nine PE of size 10-120 ㎛ and one polystyrene (PS) of size 40 ㎛, were detected by Raman microscopy. Approximately, 1,000 MPs/kg was estimated, which was almost two times higher than the previous reported levels (~550-681 particles/kg in sea salts); this is because Raman microscopy can detect much smaller MPs than FT-IR microscopy. A total of 113 particles were found using Raman microscopy: Carbon (35, 31.5 %), minerals (28, 25 %), and glass (16, 14.4 %) were dominant, forming around 70% of the total, but MPs (10, 8.8 %) and cellulose (5, 4.5 %) were also found. Raman microscopy has great potential as an accurate method for measuring MPs, as it can measure smaller size MPs than FT-IR microscopy. It also has a reduced sample preparation time.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.41 no.1
• /
• pp.129-135
• /
• 2012

This study was to investigate the heavy metal content of 55 commercial salts in the Seoul area. There were 22 types of solar sea salt, 17 types of processed salt and 16 types of reworked salt. Looked at another way, there were 22 types of domestic salt and 33 types of salt imported from France, the U.S., Japan, Australia, New Zealand, and Argentina. The samples were measured using both a mercury analyzer and an Inductively-Coupled Plasma Optical Emission Spectrometer (ICP-OES). The average heavy metal contents for commercial salts were Pb $0.281{\pm}0.344$, Cd $0.035{\pm}0.221$, Cr $0.364{\pm}0.635$, Cu $0.182{\pm}0.313$, As $0.046{\pm}0.062$, Ni $0.155{\pm}0.247$, Al $5.753{\pm}10.746$, Co $0.028{\pm}0.211$ and Hg $0.001{\pm}0.001$ mg/kg. The leads were detected highly in solar sea salt rather than in processed salt or reworked salt. Also chrome, arsenic and nickel were found more in processed salt. There were large differences in aluminum content between imported solar sea salt and processed salt. Aluminum was highly detected in French products, showing that salt can be affected by regional differences. The weekly average intakes of Pb, Cd, Cr, Cu, and Hg from commercial salt were 1.652% (0.000~6.754), 0.372% (0.000~7.214), 3.177% (0.000~26.279), 0.008% (0.001~0.049), and 0.031% (0.000~0.094) respectively compared with Provisional Tolerable Weekly Intakes established by the Joint FAO/WHO Expert Committee for the evaluation of food safety. The content of heavy metals from commercial salts was determined to be at safe levels.

• Journal of Environmental Science International
• /
• v.25 no.5
• /
• pp.715-726
• /
• 2016

This study investigates the characteristics of metallic and ionic elements concentration, concentration according to transport path, and factor analysis in $PM_{10}$ at Guducsan in Busan in the springtime of 2015. $PM_{10}$ concentration in Guducsan and Gwaebeopdong were $59.5{\pm}9.04{\mu}g/m^3$ and $87.5{\pm}20.2{\mu}g/m^3$, respectively. Contribution rate of water-soluble ions and secondary ion in $PM_{10}$ concentration in Guducsan were 37.0% and 27.8% respectively. [$NO_3{^-}/SO{_4}^{2-}$] ratio and contribution rate of sea salt of $PM_{10}$ in Guducsan and Gwaebeopdong were 0.91 and 1.12, 7.0% and 5.3%, respectively. The results of the backward trajectory analysis indicates that $PM_{10}$ concentration, total inorganic water-soluble ions and total secondary ions were high when the air parcels moved from Sandong region in China than non-Sandong and northen China to Busan area. The results of the factor analysis at Guducsan indicates that factor 1 was anthropogenic source effects such as automobile emissions and industrial combustion processes, factor 2 was marine sources such as sea salts from sea, and factor 3 was soil component sources.

• Advances in concrete construction
• /
• v.5 no.6
• /
• pp.671-683
• /
• 2017

Commonly used concrete in general, consists of cement, fine aggregate, coarse aggregate and water. Natural river sand is the most commonly used material as fine aggregate in concrete. One of the important requirements of concrete is that it should be durable under certain conditions of exposure. The durability of concrete is defined as its ability to resist weathering action, chemical attack or any other process of deterioration. Durable concrete will retain its original form, quality and serviceability when exposed to its environment. Deterioration can occur in various forms such as alkali aggregate expansion, freeze-thaw expansion, salt scaling by de-icing salts, shrinkage, attack on the reinforcement due to carbonation, sulphate attack on exposure to ground water, sea water attack and corrosion caused by salts. Addition of admixtures may control these effects. In this paper, an attempt has been made to replace part of fine aggregate by tailing material and part of cement by fly ash to improve the durability of concrete. The various durability tests performed were chemical attack tests such as sulphate attack, chloride attack and acid attack test and water absorption test. The concrete blend with 35% Tailing Material (TM) in place of river sand and 20% Fly Ash (FA) in place of OPC, has exhibited higher durability characteristics.

• Journal of the East Asian Society of Dietary Life
• /
• v.11 no.5
• /
• pp.393-399
• /
• 2001

Effects of various types of salts (commercial low salt, sea salt, refined salt, and bamboo salt) and concentrations (0, 3.0 and 5.0% ) on the growth of yeasts isolated from Kimchi were investigated. The isolated yeasts used in the study are as follows : Saccharomyces cerevisia, Sporobolomyces albo-rubescens, Issatchenkia orientalis Cryptococcus luteolous, Ustilago maydis, Candida humilis, Pichia onychis, Cadida nitratophila, and Pichia jadinii. The growths of the yeasts were inhibited against each salt concentration. The growths of Candida sp. isolated from the later stage of fermentation was strongly inhibited against 5% concentration of salt. On the other hand the induction phase of Issatchenkia orientalis isolated at the early stage of fermentation was the quickest among all the tested yeasts. Among the salts, bamoo salt was found to be strongest inhibitor of the growth of yeasts.

• Fire Science and Engineering
• /
• v.30 no.5
• /
• pp.93-99
• /
• 2016

This study tested the combustion characteristics of veneer specimens coated with four kinds of ammonium salts. Each veneer specimen was coated three times with 20 wt.% ammonium salt solutions at room temperature. After drying, the combustion characteristics of the specimens coated with chemicals, were investigated using the cone calorimeter (ISO 5660-1, 2). The specimens coated with monoammonium phosphate (MAPP) and, diammonium phosphate (DMPP) showed a 6.7% and, 10.0%, lower mean heat release rate ($HRR_{mean}$), respectively, than that of the uncoated specimen. On the other hand, the specimens coated with MAPP showed a 15.7% higher $CO_{peak}$ production rate and the specimens coated with DAPP showed by 8.2% lower rate than that of the uncoated specimen. The veneer coated with ammonium sulfate (AMSF) and DAPP showed a 9.6% and 33.3% lower the peak smoke production rate ($SPR_{peak}$) than that of the uncoated specimen. In addition, the time to the peak smoke extinction area ($SEA_{peak}$) was delayed by 38.4% in the specimens coated with DAPP than the uncoated specimen. Therefore, DAPP inhibited the combustion properties of the veneer and showed a tendency to reduce smoke production.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.19 no.1
• /
• pp.18-24
• /
• 2016

Mineral carbonation is a technology for permanently storing carbon dioxide by reacting with metal oxides containing calcium and magnesium. In this study, we used sea water and alkaline industrial by-product such as paper sludge ash (PSA) for the storage of carbon dioxide through direct carbonation. We found the optimum conditions of both sea water content (mixing ratio of sea water and PSA) and reaction time required in the direct carbonation through various experiments using sea water and PSA. In addition, we compared the amounts of carbon dioxide storage with the cases when sea water and ultra-pure water were separately used as solvents in the direct carbonation with PSA. The amount of carbon dioxide storage was calculated by using both solid weight increase through the carbonation reaction and the contents of carbonate salts from thermal gravimetric analysis. PSA particle used in this study contained 67.2% of calcium. The optimum sea water content and reaction time in the carbonation reaction using sea water and PSA were 5 mL/g and 2 hours, respectively, under the conditions of 0.05 L/min flow rate of carbon dioxide injected at $25^{\circ}C$ and 1 atm. The amounts of carbon dioxide stored when sea water and ultra-pure water were separately used as solvents in the direct carbonation with PSA were 113 and $101kg\;CO_2/(ton\;PSA)$, respectively. The solid obtained through the carbonation reaction using sea water and PSA was composed of mainly calcium carbonate in the form of calcite and a small amount of magnesium carbonate. The solid obtained by using ultra-pure water, also, was found to be carbonate salt in the form of calcite.

• Journal of Food Hygiene and Safety
• /
• v.33 no.6
• /
• pp.460-465
• /
• 2018

Deep sea water is deeper than 200 m in depth and maintains cool temperatures. It is clean seawater not contaminated by E. coli and other general bacteria. Because deep sea water is a recyclable resource with high industrial value, activities for commercial use are vigorously developing. We investigated safety, quality characteristics, and mineral contents of prototype products using deep sea water as a substitute for a curing agent and compared it with existing commercially processed products. This study examined the potential of deep sea water as an alternative to curing agent solution. As a result, safety and quality characteristics of processed meat products with deep sea water were not different from commercially processed meat products, but mineral contents were higher in processed meat products with deep sea water. Deep sea water could be widely used as purity salt and purity minerals that can replace chemical substances such as chemical salts. A new, active food market using deep sea water will emerge in the near future.