• Journal of the Korea Concrete Institute
• /
• v.25 no.3
• /
• pp.339-345
• /
• 2013

This study is to derive from the required performances and the optimum mix proportion of the roof concrete placed in the in-ground LNG storage tank with a capacity of 200000 $m^3$, and propose the actual data for site concrete work. The concrete placing work without sliding and segregation in the fresh concrete condition is very important because the slope of domed roof is varied in the large range by its curvature. Also the control of hydration heat and the strength development at test ages are classified with massive section about 1.4 m thick and considered to the pre-stressing work and removal of air support after concrete placing work. Considering above condition, slump range is selected $100{\pm}25$ mm under the slope $20^{\circ}$ and $150{\pm}25$ mm over the slope $20^{\circ}$ s until 60 minutes of elapsed time. Also, the roof concrete is satisfied with compressive strength range including design strength at 91 days (30 MPa), pre-stressing work at 7 days (10 MPa), air support removal work at 21 days (14 MPa). Replacement ratio of limestone powder is determined by confined water ratio test and main design factors include water-cement ratio (W/C), sand-aggregate ratio and dosage of admixture. As test results, the optimum mix proportion of the roof concrete used low heat cement is as followings. 1) Replacement ratio of limestone powder 25% by confined water ratio test 2) Water-cement ratio 57.8% 3) Sand-aggregate ratio 42.0%. Also, test results for the adiabatic temperature rising test is satisfied with its criteria and shown the lower value compared to preceding storage tank (TK-13, 14). These required performances and the optimum mix proportion is to apply the actual construction work.

• Journal of Korea Water Resources Association
• /
• v.45 no.2
• /
• pp.127-136
• /
• 2012

River is able to change by various environmental factors. In order to conduct river restoration design, it is necessary to evaluate the stable channel through the analysis of past and present river channels. River evaluation requires various data, such as geometry, hydraulic and hydrology, but there is a lot of difficulty to understand topographical information of river change on time and space due to a lack of past data by domestic conditions. This study was analyzed abandoned channel formation, changes in the vertical-section and cross-section length of rivers, and micro-landform changes etc using an image analysis technique. Purpose of this research is to evaluates the stable channel through a river channel morphology change from past and present river channels image. Mangyoung river was conducted artificial river maintenance through straight channel consolidation form 1920 to 1930 year. In the result river maintenance, mangyoung river length was decreased by 15 km and abandoned channels of six points were made. Since then, weir was continuously increased to control bed slope and use water. Install of weir was to be the reason of changes on channel width, thalweg, vegetated bar, sand bar, water area. Present Mangyoung river show that water area was temporary increased in upper and middle reach because of weir installation. Total sand bar was only decreased in upper channel. The change of vegetated bar and sand bar was slight recently. In this result, Mangyoung river is inferred to reach stabilized channel although there is some difference to the lower reach.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.19 no.3
• /
• pp.218-226
• /
• 2016

Field observations were used to study the characteristics and influence of groundwater level fluctuations on vegetation development on the natural beach of a sandy barrier island, in the Nakdong River estuary. The spatial/temporal fluctuations of the groundwater level and the interactions with the external forces (weather, ocean wave and tide) were analyzed. The results indicated that when it rains the groundwater level rises. During summer, when precipitation intensity is greater than 20 mm/hour, it rose rapidly over 20 cm. Subsequently, it fell gradually during periods of no precipitation. Seasonal characteristics indicated that the groundwater level was high during the summer rainy season and tended to fall in the winter dry season. The time-averaged groundwater level, observed from the four observations over 3 years (2012-2014), was about 1.47 m, higher than mean sea level (M.S.L.). It was shown that the average annual groundwater level rises toward the land rather than showing intertidal patterns observation. Differences in the presence or absence of a coastal sand dunes affected the progress of vegetation. In other words, in environments of saltwater intrusion where the groundwater level varies, dependent on the distance from the shoreline and bottom slope, sand dunes can be provided to affect soil conditions and groundwater, so that vegetation can be grown reliably.

• Journal of the Korean association of regional geographers
• /
• v.13 no.1
• /
• pp.32-42
• /
• 2007

In Sagye coast of Andeok-myeon, southwestern Jeju, shore platform of noncohesive Hamori Formation, marine terrace deposit of round gravels, coastal dune composed of shell sand and volcanic sand, and back lake are linked closely with each other. In this paper, the formation process of Sagye coastal geomorphic system analysed by using OSL dating method is as follows: Firstly, Hamori Formation is a horizontal stratum filed up of tuff reworked by submarine volcanic eruption during 3$\sim$7.6 ka BP. Hollow at the boundary between Hamori Formation' flat and Kwangheak Basalt's gentle slope become a back lake when block is appeared over the sea level by uplift. Secondly, while Hamori Formation was laid below sea level, gravels which had been broken and abraded at southwestern rocky coast composed of Kwangheak basalt or been transported through the small stream from adjacent hillslope were deposited in rapid flow environment. Thirdly, deposition of round gravels was ceased by earth uplift, and shore platform was constructed by abrasion process of energy of swash moving forward. As altitude of shore platform is equal to high tidal level of spring tide, compared it with present high tidal level of study area, earth is uplifted about 105m since shore platform was formed. Fourthly, much sandy sediments transported from offshore bottom covered shore platforms and marine terrace deposits. Lighter sediments among sandy sediments was blown to back, formed secondary sand dune since about 500 year.

• Geotechnical Engineering
• /
• v.12 no.3
• /
• pp.109-126
• /
• 1996

In this study, the chemical fluid considered is sodium chloride sloutions. The concentrations for the sodium chloride solutions are varied from 0 to 20%. A series of lab oratory triaxial tests are performed on the cylindrical specimens of sand bentonite mixture with different (5, 10, 15%) sodium chloride content solutions. Deformation(elastic modulus, E) and strength (cohesion, c', and angle of friction, f') parameters are obtained from the triaxial tests and they are expressed as functions of conf'ming pressure and sodium chloride solution concentrations. The stress-strain-strength behavior based on the above strength parameters is introduced to the finite element method with a residual flow procedure (RFP). By integrating a slope stability (limit equilibrium) procedure in the finite element method, factors of safety with time are computed.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.3 no.2
• /
• pp.108-115
• /
• 1991

This paper aims at the elucidation of the characteristics of longshore current profile after wave breaking. Wave breakers are always accompanied by complex turbulent process, wave energy losess occur and the mean water level also varies due to the gradient of radiation stress. These with other factors result in the development of longshore currents. Longshore currents have relations to the alongshore sand transport and to the diffusion of contaminants in nearshore region, thus the understanding and elucidation of them are very important from the engineering point of view. Using the calculated results, the factors such as lateral mixing cofficients, bed shear stress. wave angle. wave steepness and bottom slope. which are influencing the longshore current profile. are examined. Also, by comparing the results of longshore currents with the experimental data obtained by other investigators, the procedure proposed in the present study is shown to be valid.

• Journal of Microbiology and Biotechnology
• /
• v.23 no.5
• /
• pp.602-613
• /
• 2013

This paper aims at an investigation of the features of bacterial communities in surface sediments of the South China Sea (SCS). In particular, biogeographical distribution patterns and the phylogenetic diversity of bacteria found in sediments collected from a coral reef platform, a continental slope, and a deep-sea basin were determined. Bacterial diversity was measured by an observation of 16S rRNA genes, and 18 phylogenetic groups were identified in the bacterial clone library. Planctomycetes, Deltaproteobacteria, candidate division OP11, and Alphaproteobacteria made up the majority of the bacteria in the samples, with their mean bacterial clones being 16%, 15%, 12%, and 9%, respectively. By comparison, the bacterial communities found in the SCS surface sediments were significantly different from other previously observed deep-sea bacterial communities. This research also emphasizes the fact that geographical factors have an impact on the biogeographical distribution patterns of bacterial communities. For instance, canonical correspondence analyses illustrated that the percentage of sand weight and water depth are important factors affecting the bacterial community composition. Therefore, this study highlights the importance of adequately determining the relationship between geographical factors and the distribution of bacteria in the world's seas and oceans.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.35 no.3
• /
• pp.130-139
• /
• 1993

In order to evaluate the long-term permeability performace of the geotextiles, for five different combination of geotextiles and soils the long-term column test method The results obtained are as follows; 1.The gradient range of the initial stage of the long-term permeability curves varied with respect to the soil types, while that of the final stage varied according to the interaction of the soil/geotextile system. 2.The time required for a given soil/geotextile system to reach a interactive stable stage was measured ahout 100 hours for the standard sand and 150 to 600 hours for the silty content soils, respectively. 3.There were no differences between the plain woven geotextile and the non-geotextile in the long-term permeability performance. 4.As the silt content increased, the long-term performance of the geotextiles decreased, and the limiting silt content was about 15%. 5.The thickness and area density of the geotextiles did not influence on the variation of the seepage quantities. 6.The ayerage slope and the transition time of the long-time flow curve were calculated. 7.In order to evaluate the mechanism of soil/geotextile system more perfectly, the gradient ratio test or the hydraulic conductivity test is required.

• Journal of the Korean GEO-environmental Society
• /
• v.3 no.2
• /
• pp.71-79
• /
• 2002

A numerical simulation has been performed on the generation of the coastal cliff which lies as the distinct boundary between the beach and the hinterland. As a result of storm surge, it is known that the steeper the initial beach slope, the larger the generation of the coastal cliff. The rise of water level added the mean water level accelerates the generation of the coastal cliff. In addition, the longshore distribution of the incident wave height is one factor that bring about the generation of the non-uniform coastal cliff in longshore direction. Therefore this study will be able to use for expecting the formation and erosion of coastal cliff in sand beach.

• Journal of the Korean GEO-environmental Society
• /
• v.19 no.4
• /
• pp.17-26
• /
• 2018

This study systematically examines the changes in the compressive and tensile strength of soil cement reinforced by natural hair fiber, which is regularly produced from human. Extensive experimental tests of various test specimens have been carried out in a laboratory. Several factors are considered, including the soil type, amount of cement, amount of fiber, fiber length, loading type, and curing age. The test results indicate that both the compressive and tensile strengths are significantly affected by the fiber, either increasing or decreasing depending on the conditions. The increase in tensile strength is significant in the sand-based soil cement due to the tensile resistance of the fiber which is interlocked with the surrounding soil or cement particles. The natural fiber provides a larger strain to failure due to its extensibility, which allows greater deformation. Based on the test results, natural hair fibers can be an effective and environmentally friendly way to improve soil ground subjected to tensile loading, such as an embankment slope, road subgrade, or landfill, thus reducing the cost for cement and waste treatment. The study results provide a useful information of better understanding the mechanical behavior of natural hair fiber in soil cement and the practical use of waste materials in civil engineering. The findings can be practically applied for improving earth structures under tensile loading.