• 대한의용생체공학회:의공학회지
• /
• 제13권4호
• /
• pp.285-298
• /
• 1992

An analysis of the dynamics in the closing phase of the occluder of a mechanical monoleaflet heart valve prosthesis is presented. The dynamic analysis of the fluid in the vicinity of the occluder was based on the control vo]use approach. The backflow velocity of the fluid was computed by applying the continuity, Bernoulli's and momentum equations in the unsteady state. By considering the fluid pressure and gravity as external forces acting on the occluder, the moment equilibrium on fine occluder was employed to analyze the motion of the occluder during closing and the force of impact between the occluder and the guiding struts. Occluder comes to rest after several oscillations in about 10-18 msec after the Inltiaton of closing. As the aortic pressure increases, the occludes closes faster and comes to the final resting position earlier and the impact force increases also. But backflow is not af footed by the variation of the aortic pressure. With decreasing time delay of the ventricle pressure, the occluder closes faster and impact force Increases. The computed magnitudes of the occluder tiP velocities as well as the backflow of the fluid during the closing phase using this model were in agreement with previously reported experimental measurements.

• 대한의용생체공학회:의공학회지
• /
• 제28권1호
• /
• pp.1-7
• /
• 2007

To determine the effect of posture change on autonomic activity and to investigate valid parameters to reflex the autonomic activity from time-series pupil size data, a posture-related experiment was performed with 15 subjects, which involved measuring their electrocardiograms and pupil sizes. The experimental procedure consisted of three-sequence postures-supine, sitting and upright-for 5 minutes each, with rest sessions between postures. The subjects were notified of the entire experimental procedure. The parameters of the subjects' heart rate variability showed significant differences between the postures (heart rate: 63-70-80 beat, normalized low frequency power: 28-50-75, normalized high frequency power: 72-49-25 and ratio: 0.5-1.2-4.4 in supine-sitting-upright position respectively) as did the parameters of their mean pupil sizes (41300-53900-53700 pixels respectively) and the major frequencies (the third trend: 0.23-0.2-0.18 Hz respectively) of their pupil size variability according to changes in their autonomic activities induced by posture change. The experiment thus proved that posture change affects autonomic activity and that such activity can be estimated by the parameters of pupil size as similar as heart rate variability.

• 한국잡초학회지
• /
• 제17권1호
• /
• pp.94-111
• /
• 1997

A relatively wide range of weed technology concerning sound herbicide development, its formulation exploitation, and application techniques was extensively reviewed in accordance with least inputted sustainable agriculture. Herbicide plays an integral part of farmers' cultural practices in Korean agriculture like rest of world over. Weeds are more obstacle to the adaptation of more sustainable agriculture system. Because weeds dictate most of the crop production practices, weed scientists must become the leaders of collaborative integrated approaches to agriculture systems research. Feasible ways to minimize herbicide input involve the positive introduction of low-rate selective chemistries, innovative formulations, biological herbicides and newly developed application technology. Since herbicide will remain to be a core position in weed management for the foreseeable future, research is needed to optimize herbicide application technology and to minimize their impact on the environment. Public concerns and regulatory pressures on agricultural chemicals are likely to strengthen throughout this decade and coming. Researchers, pesticide manufacturing industries and regulatory authorities have to work together more closely, leading to understand each other better, as well as the needs of our customers and those of society. To be taken extensively, weed control management practices in the future have to be accepted such a way the respective demands of environment, society and economics are entirely matched.

• 제어로봇시스템학회논문지
• /
• 제5권5호
• /
• pp.577-584
• /
• 1999

In this paper, the double inverted pendulum having a single actuator is built and the controller for the system is proposed. The lower link of the target pendulum system is hinged on the plate to free for rotation in the specified range($10^{\cire}$) on the x-z plane. The upper link is connected to the lower link through a DC motor. The double inverted pendulum built can be kept upright posture by controlling the position of the upper link even though it has no actuator in lower hinge. The algorithm to control the inverted pendulum consists of a state feedback controller within a linearizable range and a fuzzy logic controller coupled with a nonlinear feedback compensator for the rest of the range. Conventional state feedback control is employed, and the fuzzy controller is responsible for generating the reference joint angle of the upper link for the nonlinear feedback compensator which drives a DC motor to generate an indirect torque to the lower joint. As a result, we can get the upright posture of the proposed pendulum system. Simulations and experiments are conducted to show the validity of the proposed controller.

• 건축역사연구
• /
• 제9권2호
• /
• pp.33-48
• /
• 2000

This study aims to analyze the construction of Kyungsang KAMYOUNG in the late Chosun dynasty by restoring its constructive system and relating it with the office organization. followings are the summary of this study. 1. Government office of Daegu consists of inn(KAEGSA), Kyungsang KAMYOUNG, and Daegu city hall(BUA), and JINYOUNG. 2. The layout of virtual placement is shown in the in the text. Even though it had been newly constructed due to three times of fire, the fundamental scheme of space is found out not to have been changed since mid-eighteen century at the latest. 3. Followings are the result of analyzing the space of KAMYOUNG, after dividing its space into entry area, main business area and police military business area in the aspect of business. First, entry area consists of 2 door system with external door(UOISAMMUN) and internal door(NAESAMMUN). Second, main business area consists of facilities for inspector, public officials, and low grade employee respectively This space is divided into SUNHWADANG area and JINGCHONGKAK area, and the former consists of active business facilities, and the latter consists of passive business facilities focusing on the rest facilities. Third, business support area consists of facilities for low grade employee and minor assistant respectively, which are placed to the left and right of POJONGMUN and KWANPUNGRU. Fourth, police military business space is in middle(JUNGYOUNG) and forms separate areas to the east of SUNHWADANG. Accordingly, It is certain that the space of Kyungsang KAMYOUNG had been placed in accordance with the nature of business per position.

• International journal of advanced smart convergence
• /
• 제6권1호
• /
• pp.57-67
• /
• 2017

In this paper, propose an algorithm to improve network lifetime by equally consuming energy of LEACH - Mobile sensor nodes. LEACH is one of energy efficient protocols. However, we did not consider the mobility of nodes. Therefore, the transmission reception success rate of the moving data is reduced. LEACH-Mobile is a protocol that has improved the drawbacks of these LEACH. However, since LEACH-Mobile has a larger number of data packets and consumes more energy than LEACH, it has a disadvantage that the lifetime of the network is short. In order to improvement these disadvantage, Based on the average of the remaining energy of the node, cluster heads are elected with a number of nodes whose energies are larger than the average of the remaining energy from the member nodes. After that, by trying to increase the lifetime of the network by equalizing the remaining energy. In to confirm whether improve the lifetime of the network, In this paper, the number of nodes and the position of all nodes are varied for each specific round, the rest energy is equalized, and the algorithm which uniformly selected the cluster head is compared with LEACH.

• 대한기계학회논문집
• /
• 제19권2호
• /
• pp.443-450
• /
• 1995

An analysis of the dynamics of a mechanical monoleaflet heart valve prosthesis in the closing phase is presented. Employing the moment equilibrium principles on the occluder motion and the squeeze film dynamics of the fluid between the occluder and the guiding strut at the instant of impact, the velocity of the occluder tip and the impact force were computed. The dynamics of fluid being squeezed between the occluder and the guiding struts is accounted for by Reynold's equation. The effect of the fluid being squeezed between the occluder and the guiding strut was to reduce the velocity of the occluder tip at the instant of valve closure as well as dampen the fluttering of the occluder before coming to rest in the fully closed position. The squeeze film fluid pressure changed rapidly from a high positive value to a relatively large negative value in less than 1 msec. The results of this study may be extended for the analysis of cavitation inception, mechanical stresses on the formed elements and valve components as well as to estimate the endurance limits of the prosthetic valves.

• 제어로봇시스템학회논문지
• /
• 제13권9호
• /
• pp.868-874
• /
• 2007

This paper proposes an efficient partial matching system and representation by using a region-based method for 2D image, and we applied to an extraction of the ROI(Region of Interest) according to its matching score. The matching templates consist of the global pattern and the local one. The global pattern can make it by using region-based relation between center region and its rest regions in an object. And, the local pattern can be obtained appling to the same method as global, except relation between objects. As the templates can be normalized, we use this templates for extraction of ROI with invariant to size and position. And, our system operates only one try to match, due to normalizing of region size. To use our system for searching and examining if it's the ROI by evaluating the matching function, at first, we are searching to find candidate regions with the global template. Then, we try to find the ROI among the candidates, and it works this time by using the local template. We experimented to the binary and the color image respectively, they showed that the proposed system can be used efficiently for representing of the template and the useful applications, such as partially retrievals of 2D image.

• Advances in Automotive Engineering
• /
• 제1권1호
• /
• pp.61-77
• /
• 2018

In this study, the effects of sitting position of the driver on the whiplash neck injury have been analyzed experimentally by using hybrid III series 50 percentile male crash test dummy. A testing platform consisting of vehicle ground, driver foot rest, driver seat and a 3-point seatbelt has been prepared. This testing platform and the instrumented crash test dummy are prepared for tests according to the Euro NCAP whiplash testing protocol. The prepared test set-up has been exposed to 3 different acceleration-time loading curves defined in the Euro NCAP whiplash testing protocol by performing sled tests. 9 different sled tests have been performed with the combinations of 3 different seating positions of the crash test dummy and 3 different acceleration-time loading curves. The sensor data obtained from the crash test dummy and high-speed videos taken are analyzed according to the injury assessments criteria defined in the Euro NCAP whiplash testing protocol and the criticality of the whiplash injury is defined. It is seen that the backset distance of the driver head with the headrest and the height difference of the top of the head of the driver with the headrest have a great importance on whiplash injuries.

• 한국소음진동공학회논문집
• /
• 제18권2호
• /
• pp.177-184
• /
• 2008

The dynamic stability of elastically restrained cantilever pipe conveying fluid with crack is investigated in this paper. The pipe, which is fixed at one end, is assumed to rest on an intermediate spring support. Based on the Euler-Bernoulli beam theory, the equation of motion is derived by the energy expressions using extended Hamilton's Principle. The crack section is represented by a local flexibility matrix connecting two undamaged pipe segments. The influence of a crack severity and position, mass ratio and the velocity of fluid flow on the stability of a cantilever pipe by the numerical method are studied. Also, the critical flow velocity for the flutter and divergence due to variation in the support location and the stiffness of the spring support is presented. The stability maps of the pipe system are obtained as a function of mass ratios and effect of crack.