• Journal of Wetlands Research
• /
• v.9 no.1
• /
• pp.107-114
• /
• 2007

This study aimed to investigate the hexachlorobenzene (HCB) dechlorinating ability of sediment microbes collected from a natural canal receiving secondary effluents from an industrial estate and nearby factories. Nine sites along the stream and one in the estuary in the Gulf of Thailand into which the canal spills were specified and sampling for sediment and water. Preliminary analysis of the sediments showed that the first four sites nearest to the discharging location were contaminated by HCB within the range of 0.18 to 1.25 ppm. Apart from that, 1,3,5-trichlorobenzene which has never been commercially produced or used in any manufacturing processes except for the transformation from higher chlorinated benzene was also identified in the range of 0.16 to 0.24 ppm. This suggested a possibility of sporadically HCB contamination in this stream. Of more important, people in the community along this canal earn their living by coastal fishery; hence, posing a risk of spreading HCB and its less chlorinated congeners via food chain from caught marine creatures to human. As a result, there is an urgent need to understand the behavior of HCB dechlorination in this stream sediment which can lead to a clean-up action in the future. Serum bottles with sediment slurries (sediment to water ratio of 1:1 (v/v) and filtered to remove particles larger than 0.7 mm) from each site were inoculated with 2 mg/l of HCB, kept anaerobically in the dark at room temperature without any nourishment, and analyzed for HCB and its less-chlorinated congeners every 6 days. Total chemical oxygen demand, suspended solids, and volatile suspended solids were in the range of 21,492-73,584, 158,100-518,100 and 6,000-32,700 mg/l, respectively. It was found that all sediment slurries began to dechlorinate HCB in 12 to 30 days and the HCB was completely removed within 42 to 60 days or so. On the other hand, there was no HCB dechlorination occurred in the controlled set which was sterilized by autoclaving prior to the addition of HCB. This implies that the HCB transformation was solely due to microorganisms' activities. HCB was dechlorinated principally via pentachlolobenzene to 1,2,3,5-tetrachlorobenzene and terminated at 1,3,5-trichlorobenzene which is the major pathway as reported by many researchers. Dichlorobenzene has not been detected in any samples within the dechlorination period of 60 days. The results indicate that the microbial matrix in the sediment of this stream has an outstanding capability to dechlorinate HCB. Existing substrates and nutrients which mainly sorbed onto the solid phase and the typical temperature in Thailand were sufficient and suitable to promote the activities of these HCB-dechlorinating microbes.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.9 no.2
• /
• pp.113-119
• /
• 2011

Safe operation and maintenance of engineered dry storage systems for spent fuel from nuclear power plants basically depends on adequately adopted design requirements. The most important design target of the system are those which provide the necessary assurances that spent fuel can be received, handled, stored and retrieved without undue risk to health and safety of workers and the public. To achieve these objectives, the design of the system incorporates features to remove spent fuel residual heat, to provide for radiation protection, and to maintain containment over the lifespan of the system as specified in the design specifications. The features also provide for all possible anticipated operational occurrences and design basis events in accordance with the design basis as guided by the designated regulations. The general performance requirements of a projected storage system are introduced in this paper. The storage system is designed to store fuel assemblies in associated with designated regulatory requirements. Small increases/decreases in maximum burnup can be adjusted with cooling time. These variations are compensated for by a corresponding small site-specific increase/decrease in the design basis-cooling period, as long as the maximum heat load and radioactivity of loaded fuel assemblies are met. Generic design basis events considered for the storage system are summarized. Shielding and radiological requirements along with mechanical and structural are derived in this study.

• Journal of Korean Society of Environmental Engineers
• /
• v.38 no.4
• /
• pp.210-218
• /
• 2016

The pollutant removal efficiencies of stormwater runoff by settling were analyzed using field samples collected in 4 different raining events in a test bed installed in the Gwanpyung-Cheon stream in Daejeon. A 1.8 m high with 30 cm diameter cylindrical settling device was used for the settling test by measuring concentration of TSS, TP and TN for time and height. The pollutants removal rate was relatively high in the first 4 hours while 24 hours seem to be necessary to reach steady state in pollutant concentrations. However, there were no considerable differences in concentrations for height at a given time. This indicates most of particulate pollutant in the test seems to show independent settling with no interference to each other. Much part of particle sizes were distributed in the range of $10{\sim}100{\mu}m$. Average particulate fractions of TP and TN were estimated as 52.4% and 23.5%, respectively. This results explain why TN is difficult to remove by simple settling. This study indicates that a simple settling can provide effective method to remove significant amount of TSS and TP effectively and this can be used to protect urban river water quality.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.15 no.1
• /
• pp.38-46
• /
• 2012

This study carried out current status, characteristics, and problems of coastal environment management on semi-enclosed Masan Bay in Korea and suggests cost-effective and eco-friendly water quality management policy. The pollutants from terrestrial sources into the Bay have apparently environmental pollution problems, such as eutrophication, red tide, and hypoxia. The carrying capacity of the Bay is estimated by hydrodynamic model and ecosystem model, material circulation including bivalve in ecosystem is analyzed by the growth model of bivalve. The resulting reduction in the input load was found to be 50~90%, which is unrealistic. When the efficiency of water quality improvement through bivalve farming was assessed based on the autochthonous COD, 30.7% of the total COD was allochthonous COD and 69.3% was autochthonous COD. The overall autochthonous COD reduction rate by bivalve aquaculture farm was found to be about 6.7%. This study indicate that bivalve farming is about 31% less expensive than advanced treatment facilities that remove both nitrogen and phosphorous.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.21 no.4
• /
• pp.33-43
• /
• 2013

That occur in the ocean and the efficient management of marine litter on marine pollution oil spill response one step further strategies are needed. Marine pollution accidents occurred in 2011, a total of 287 and was found in runoff 369 kL, respectively compared to the previous year decreased by 13% and 39%. Average amount of marine materials during 5-years represent the oil flow of 310.5 kL (heavy fuel oil of 106.0 kL, diesel of 178.9 kL, oily bilge water of 22.3 kL, other oil of 7.7 kL) and the waste of 62.3 tons, the hazardous and noxious substances (HNS) was 510.6 kL. Marine emissions in 2011 by type of waste that a total amount of dumping 3,972 $m^3$, and livestock manure 795 $m^3$(20%), waste water 1,431 $m^3$(36%), sewage sludge 887 $m^3$(22%), wastewater sludge, 813 $m^3$(21%), manure 5 $m^3$(0.1%), other 41 $m^3$(0.9%), respectively. The concept of marine waste and needs to be more clearly defined. Integrated management of hazardous chemicals according to the incident management system should be established. To remove of coastal pollution, response officer needs korean coast response system. Like the marine pollution response, coastal pollution response systems also require step response.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.27 no.1
• /
• pp.146-150
• /
• 2000

Dental caries and periodontal disease continue to present unique problems in the dental management of the persons with disabilities because the chronicity of oral diseases complicates the primary physical or mental disability. The increased prevalence of dental disease in most persons with disabilities is probably not due to any inherent proclivity for dental disease but more likely evolves because dental care receives less attention. Prosthetic dentistry procedures are not contraindicated for most patients with physical and mental disabilities. Fixed bridges may be feasible if the patient or care provider can maintain adequate oral hygiene and the patient's disability dose not preclude this type of prosthesis. Removable partial or full dentures may be indicated if the patient or care provider can easily remove the prosthesis and care for it. Although most persons with disabilities need no additional behavior management modalities to complete dental care, some persons require professionally recognized behavior management techniques during treatment, such as physical restraint, pharmacologic agents, or general anesthesia. Hospitalization and the use of general anesthesia are sometimes required to deal effectively with the extreme management problem patient. This patient with mild mental retardation was fearful of dental treatment. Routine restorative, surgical and prosthetic dentistry procedures were performed under general anesthesia.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.46 no.3
• /
• pp.64-76
• /
• 2009

Adaptive Random Testing through Iterative Partitioning(IP-ART) is one of Adaptive Random Testing(ART) techniques. IP-ART uses an iterative partitioning method for input domain to improve the performances of early-versions of ART that have significant drawbacks in computation time. Another version of IP-ART, named with EIP-ART(IP-ART with Enlarged Input Domain), uses virtually enlarged input domain to remove the unevenly distributed parts near the boundary of the domain. EIP-ART could mitigate non-uniform test case distribution of IP-ART and achieve relatively high performances in a variety of input domain environments. The EIP-ART algorithm, however, have the drawback of higher computation time to generate test cases mainly due to the additional workload from enlarged input domain. For this reason, a revised version of IP-ART without input domain enlargement needs to improve the distribution of test cases to remove the additional time cost. We explore three smoothing algorithms which influence the distribution of test cases, and analyze to check if any performance improvements take place by them. The simulation results show that the algorithm of a restriction area management achieves better performance than other ones.

• Journal of Korean Society of Environmental Engineers
• /
• v.31 no.9
• /
• pp.793-802
• /
• 2009

Adsorption properties were estimated for the organic silicon compounds (siloxanes) in an actual landfill gas (LFG) using adsorbents such as coconut activated carbon, coal activated carbon, silica gel, sulfur adsorbent, carbonized sludge, and molecular sieve 13X. Coconut activated carbon showed the highest removal efficiency of more than 95%. The desorption of hexamethyldisiloxane (L2) from the adsorbent, however, resulted in the remarkable concentration variation of the compound in the treated gas. Silica gel, which had high adsorption capacity for L2 in single substance adsorption experiment in the other study, could not remove the component in the actual landfill gas while it adsorbed well octamethylcyclotetrasiloxane (D4) and decamethylcyclopentasiloxane (D5) in the LFG. Therefore the elimination of hexamethyldisiloxane is an important factor to determine the level of total organosilicon compound in pretreated landfill gas. Moreover, the L2 from the actual landfill gas was effectively adsorbed by the serial adsorption test using two columns packed with coconut activated carbon which has the great capacity of siloxanes removal among others. In order to utilize efficiently LFG as a renewable energy, the emission and adsorptive characteristics of the substance to be treated should be considered for the organization, operation, and management of pretreatment process.

• KIPS Transactions on Software and Data Engineering
• /
• v.8 no.12
• /
• pp.499-506
• /
• 2019

An intelligent robot should decide its behavior accordingly to the dynamic changes in the environment and user's requirements by evaluating options to choose the best one for the current situation. Many intelligent robot systems that use the Procedural Reasoning System (PRS) accomplishes such task management functions by defining the priority functions in the task model and evaluating the priority functions of the applicable tasks in the current situation. The priority functions, however, are defined locally inside of the plan, which exhibits limitation for the tasks for multi-domain services because global contexts for overall prioritization are hard to be expressed in the local priority functions. Furthermore, since the prioritization functions are not defined as an explicit module, reuse or extension of the them for general context is limited. In order to remove such limitations, we propose a policy-based meta-planning for general task management for multi-domain services, which provides the ability to explicitly define the utility of a task in the meta-planning process and thus the ability to evaluate task priorities for general context combining the modular priority functions. The ontological specification of the model also enhances the scalability of the policy model. In the experiments, adaptive behavior of a robot according to the policy model are confirmed by observing the appropriate tasks are selected in dynamic service environments.

• Journal of Animal Environmental Science
• /
• v.15 no.2
• /
• pp.171-182
• /
• 2009

Conventionally, many pig producers have utilized a continual sow managements system that the matings, farrowings and weanings are done weekly basis. But this transitional method is not able to cut the cycle of diseases and fully apply all-in/all-out system because of the continuous flow of sows and pigs. Conventional weekly management system is currently limiting in small farm to work efficiently both for workers and pigs. Therefore, pig producers have found novel management methods for applying all-in/all-out system, improving pig health, leading to better growth, lowering mortality and reducing medication costs nowadays. Moreover, all-in/all-out pig management system has known as a strategy for improving productivity in swine farm. The batch system is one of the best management methods to adopt all-in/all-out pig management system that prevent spreading diseases in pig and remove cycle of diseases. Batch farrowing system is a concept for providing a group of sows that delivery within a specific farrowing interval and inducing a large enough scale of piglets to fill the weaner facilities. There are different types of batch farrowing system with batch size and interval of farrowing when several factors at the swine farm are considered such as total number of sows, available facilities in the farm, and the efficiency of workforce. Sow managements such as farrowing, weaning and breeding, every 3 weeks rather than weekly, 2 or 5-week interval have advantages for workers and reproductive cycle of sows as well as pig flow. Because there are several pros and cons both in weekly and batch management system, various factors should be considered to apply the most suitable management system in each individual farm. To improve poor swine productivity in Korea compared to ED, batch system for sows will be an alternative choice which is able to prevent high incidence of diseases in swine farm such as PMWS, PRRS, PRDC and PED because all-in/all-out pig management can be also applied automatically by using this management system.