• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.31 no.1
• /
• pp.31-38
• /
• 1999

Adsorption of polymeric flocculants and dry strength agents onto the surface of papermaking fibers is critical for their effective utilization since the polymeric substances not adsorbed on fibers or fines keep recirculating in the papermaking system to cause various operational difficulties and loss of raw materials. Problems associated with the unadsorbed polymeric substances generate great attention because unprecedent interests in utilization of recycled papers and papermaking system closure. In this study, to understand the effects of recycling on the adsorption propensity of cationic polyacryamide (PAM) dry strength resin onto hardwood bleached kraft pulp fibers and fines a systematic approach was followed. Never dried bleached hardwood kraft pulp was recycled in two different ways. In mode one recycling experiment never dried pulp was beaten then recycled three times by employing simple drying and disintegrating steps. In mode two recycling experiment beating of the recycled pulp was carried out after each recycling step. Adsorption of cationic PAM on fibers and fines was evaluated employing Kjeldahl nitrogen analysis method. The influence of recycling on water retention value, carboxyl content, sheet density and tensile strength of the pulp was examined. As the number of recycling increased, water retention value of the fiber was reduced due to hornification and this in turn caused a decrease in adsorption of cationic PAM. On the other hand, the carboxyl content of the recycled fibers increased because of the oxidation of fibers occurred during drying, and this caused an increase in adsorption of cationic PAM. Because of these two opposing factors the adsorption of the cationic PAM on the recycled fibers decreased and then increased slightly at third recycling step. Increase of PAM adsorption, however, did not provide did not provide and strength improvement for the recycled pulp fibers indicating greater influence of the honification on interfiber bonding.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.33 no.2
• /
• pp.32-40
• /
• 2001

It is desirable to reduce the amounts of fresh water and reuse the recycled water in papermaking process. In an attempt to improve the efficiency of recycling water refining treatment and to enhance the productivity of OCC recycling mill, up flow anaerobic sludge blanket(UASB) reactor was developed and introduced to Korea recently. In order to maximize the operating efficiency and minimize the adverse side effects it is imperative to estimate and evaluate the total effects of new system, UASB on the whole OCC recycling process. This study was carried out with a view to investigate the effects of the high temperature and alkalinity of process water on the quality ad productivity of testliner of OCC recycling mill which is equipped with UASB reactor and almost closed. Another object of this study was searching for the best available use of UASB treated process water. The results were as follows; Reuse of UASB treated water characterized with high temp and alkalinity was useful to improve the strength and drainage properties of recycled OCC owing to its good points of promoting OCC disintegration and reducing the calcium hardness of process water. However, it might not be avoidable to induce the increase of dissolved solids in process water in accordance with direct introducing of UASB treated water into the former stage of OCC stock preparation. So it would be advisable to adopt the UASB treated water in the stage of clean, screened OCC stock.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1995.10a
• /
• pp.256-261
• /
• 1995

Large-scaling recycling of demolished concrete will concrete will contribute not only to the solution of a growing waste disposal problem, it will also help to consweve natural resoures of sand and gravel and to secure future supply of reasonly priced aggregates for building and other construction purposes within large urban areas. Because recycled aggregate particles consits of substantial amount of relatively soft cement paste component, it is less resistant to mechanical actions. With this view in mind, to obtain a reference data for the development of recycling system and to a basic data the guiedline of recycled aggregate concrete construction and engineering properties of recycled aggregate concrete according to the factors, such as blending ratio of recyced aggregete with the natural aggregate, addition to the factors, such as blending ratio of recycled aggregete with the natural aggregate, addition of flyash, water coment ratio.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.14 no.4
• /
• pp.289-295
• /
• 2008

The disposal of constructive waste is emerging as a national and social issue and the recycled powder generated by the production of reproductive aggregate is all being abolished or buried Analysis on the harmful effect of recycled powder indicated that because it contained massive cytotoxicity, it could derive secondary pollution to soil and subterranean water. This study set on an idea that one way to recycle recycled powder was to use it as a compound of concrete. In order to study that prospect, recycled powder, instead of cement, was mixed and a comparative analysis was conducted on the mechanical properties and workability. From experimental results, it was judged that application of recycled powder of cement replacement ratio below 20% was available with chemical admixtures. Also application of recycled powder was available to high strength concrete.

• Journal of the Korea Institute of Building Construction
• /
• v.6 no.2 s.20
• /
• pp.65-72
• /
• 2006

The amount of water demand at large buildings is increasing with the concentration of population to city and a rise in the standard of living in the city area. In this reason the Water Shortage is expected and a problem of water pollution by the city sewerage is increasing. One of method of saving city water demand and city sewer is applying recycling water system witch make used water reuse by purification of water. The application of recycling water system witch make used performed since the application of Lotte World Complex. But the popularization of this system is not activated because of cost problem and feeling of people to the water recycled. So in this study, provide application method for recycling water system by propose the estimation method of optimal sizing of recycling water system.

• Journal of the Korean Geosynthetics Society
• /
• v.10 no.1
• /
• pp.37-42
• /
• 2011

In this study, it is analyzed that mechanical properties and required strength of porous concrete according to the mixing ratio of cement, fine aggregate, and water/cement ratio in order to evaluate mechanical properties of porous concrete using recycled asphalt aggregate. Recycled asphalt aggregates of 13 mm were used without modification of aggregate grading to extend porous concrete application. The water/concrete ratio was poor mix and the range of compressive strength was 18.2 to 19.5 MPa. The average value of permeability showed 8.0E-02 cm/sec.

• Journal of the Korean Society of Safety
• /
• v.29 no.4
• /
• pp.123-131
• /
• 2014

Whole amount of waste water, approximately 921.6 liter, for cleaning a ready mixed concrete truck should be used to produce concrete as a mixing water or cleaning water. Recycling water for concrete mixing contains solids, which cause decrease in slump, air and compressive strengths, so it may influence on poor concrete quality. Therefore, it has been maintained to use recycling water with less than 3 percent of solids. Since no evaluation system has been constructed to directly reflect on variability of recycling water from ready mixed concrete plants, it is necessary to develop "Automatic recycling solid measuring system" for quality controls in real time. In this research, sensors measuring waste water concentration in ultrasonic and inductance methods were developed, and automatic system using the sensors were established. The accuracy of measurement sensors developed for recycling water based on various conditions of concentration was proved, and application limits were evaluated. Also, concentration of recycling water using sensors developed from ready mixed concrete plant was measured, and curing method verified the accuracy of the sensors. Moreover, measurement sensors for recycling water in various locations were installed to evaluate the effects on measuring method and spots. The automatic measuring system for recycling water concentration, which is developed in the research, will contribute to improve concrete quality safety through reliable solids maintenance.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1995.04a
• /
• pp.177-182
• /
• 1995

Large-scaling recycling of demolished concrete will contribute not only to the solution of a growing waste disposal problem. it will also help to conserve natural resoures of sand and gravel and to secure future supply of reasonly priced aggregates for builiding and other construction purposes within large urban areas. because recycled aggregate particles consist of substaintial amount of relatively soft cement paste component, it is less resistant to mechanical actions. With this view in mind, to obtain a reference data for the development of recycling system and to a basic data the guideline of recycled aggregate concrete construction and mix design, this study deals with the comparative analysis of the workability and engineering properties of recycled aggregate concrete according to the factors, such as blending ratio of recycled aggregate with the natural aggregate, addition of flyash, water cement ration.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.6 no.3
• /
• pp.53-60
• /
• 2011

As Construction & Demolition(C&D) debris increase every year, a system has enforced for recycled aggregate made out of C&D debris, then recycled aggregate usage increased in construction field. But as environmental problem by alkalinity of recycled aggregate occurred, the study for lowering alkalinity of recycled aggregate is needed. In this study we made alkalinity reducing facility and installed in the C&D debris midterm-treat field. Then we certified effect of lowering alkalinity and quality of recycled aggregates before and after carbonation. As a result, the most effective carbonation condition is 30seconds in carbonation time, -50~100 kPa of reaction pressure with change of 3cycles. This condition made pH 9.33~9.8 of recycled aggregate possible. The quality of recycled aggregate after carbonation was better than before carbonation in terms of plasticity index, modified CBR, abrasion loss, sand equivalent, liquid limit, size distribution, density and water absorption.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.48 no.2
• /
• pp.56-60
• /
• 2016

Neutral or alkaline papermaking provides many advantages in paper strength and processing conditions. It also provides the opportunity of using calcium carbonate fillers in papermaking. These diverse advantages have made almost all paper machines of printing and writing papers run under neutral and alkaline conditions. On the other hand, linerboard machines, which use recycled papers as a raw material, are running under acid conditions using a rosin sizing system. Because the recycled raw materials used by the linerboard industry contain significant amounts of alkaline papers, the linerboard industry has an interest in the possibility of using the neutral or alkaline papermaking opportunity. In this study, the compatibility of the recycled linerboards under neutral or alkaline papermaking conditions was examined by recycling them under various pH conditions. The sizing degree of the papers recycled under neutral or alkaline was significantly lower than that of acid formed papers indicating that during the neutral or alkaline recycling process the rosin sized papers lost their sizing efficiency. Recycling of acid formed linerboards under neutral or alkaline conditions increased the amount of foam, and the foam contained substantial amount of solid materials derived from the acid sizing systems. Use of cationic polyelectrolytes including PEI and poly-DADMAC improved the sizing degree of the recycled papers under neutral and alkaline conditions. PEI decreased the foam generation as well while poly-DADMAC did not show any reducing effect of the foam. These results suggest that PEI forms coordinate bonds with rosin acid and precipitate them onto the surface of recycled fibers, while the reaction products between poly-DADMAC and rosin acid ions still remain water soluble under neutral or alkaline conditions.