• Journal of the Korean Ceramic Society
• /
• v.42 no.2 s.273
• /
• pp.99-103
• /
• 2005

Nowadays, large amount of waste pottery and porcelain annually are produced. It is needed that they are used as recycled materials in order to prevent environmental pollution and gain economic profits. Therefore, the purpose of this study is to present the method of utilizing the recycled aggregates that are obtained from waste pottery and porcelain as the concrete aggregate. The qualities of the recycled aggregate were compared with those of the crushed aggregate through measuring their physical properties. The test results showed that the replacement of crushed aggregate by recycled aggregate at the levels $10\%,\;20\%$, and $30\%$ had little effect on the compressive strength of the concretes, but higher levels of replacement reduced the compressive strength. Increment of the replacement of recycled aggregate caused increase in absorption ratio. As a conclusion, norman strength recycled aggregate concretes can be produced using less than $30\%$ of recycled aggregate.

• Journal of the Korean Wood Science and Technology
• /
• v.37 no.4
• /
• pp.340-348
• /
• 2009

The recycled polyethylene was used for making wood-plastic composite panels. In this experiment, the sizes of wood particles used were 1/32", 1/4" and 1/2" in mesh number, and the contents of the recycled polyethylene were 10%, 30% and 50%. The physical and mechanical properties of the composite panels were investigated. At a given content of recycled polyethylene, the density of composite panel decreases with the increase of wood particle size. The thickness swelling and water adsorption decrease with the increase of recycled polyethylene, where significantly lower at 10%, compared with at 30%. In the water soaking experiment for 14 days, the dimensional stability of composite panel appeared good in the composite panel with recycled polyethylene content of 30% or higher. As the content of recycled polyethylene increases, the internal bonding strength and the modulus of rupture in bending strength increases. In SEM, the molten recycled polyethylene showed interlocking action through its penetration into tracheid openings including pits as well as binder between wood particles as the matrix material, thus increasing bonding strength and improving the physical and mechanical properties of composite panel.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.6 no.1
• /
• pp.95-102
• /
• 2011

Vicker's hardness and pore size distribution of mortar adhered to the recycled coarse aggregate were tested according to the strength level of original concrete of recycled coarse aggregate to find the change of mortar adhered to the recycled coarse aggregate in cement paste. The strength levels of original concrete of recycled coarse aggregate were 25.5MPa, 41.7MPa and 60.1MPa and the aggregates were used at the state of saturated surface dry condition and oven dry condition. The results of this experimentation indicated that the mean value of Vicker's hardness was increased according to age and strength of original concrete of recycled aggregate. Porosity of $100nm{\sim}10{\mu}m$ size was reduced and porosity of 6nm~100nm size was increased in cement paste.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.6 no.3
• /
• pp.199-206
• /
• 2018

Due to the advantages of less raw materials and fossil fuel consumption, lower carbon footprint, and the capability of pavement performance improvement, the recycling technology of asphalt is developed and applied for road rehabilitation and construction in the western countries over the past two decades. Cold recycled asphalt mixtures are bituminous materials normally made by mixing recycled aggregate from wasted asphalt with an asphalt emulsion and water at room temperature. This paper aims at investigating the properties of cold recycled asphalt mixture with alkali-activated filler according to wasted asphalt aggregate content. As a result, as the content of wasted asphalt aggregate increased, the marshall stability of cold recycled asphalt mixture decreased and void ratio increased. Also, grading curves for cold recycled asphalt mixture as specified in GR criteria were satisfied in all aggregate mixing conditions regardless of the wasted asphalt aggregate content.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.04a
• /
• pp.473-476
• /
• 2008

The use of the recycled fine aggregate to the material of structural concrete is not easy currently because there are some problems, such as the difficulty of quality control and the badness of chemical and physical property other than river sand, crushed fine aggregate. To use of recycled fine aggregate, many researches on the recycling of recycled fine aggregate have been studying until today. However, the result of the research is little except for some results. Therefore, the purpose of this study is to confirm the possibility of use of recycled fine aggregate for raw material of plaster mortar. In this study, various tests were performed such as flow, air content, unit weight, bond strength, and compressive strength test to evaluate the effect according to the substitution of recycled concrete aggregate. The results of strength test showed that the concrete strength improved with the increase of replacement ratio of recycled fine aggregate. In the other side, flow and air content are decreased according to replacement ratio of recycled fine aggregate. The result of this study could be used as the basic data for the recycling of recycled fine aggregate.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.04a
• /
• pp.205-208
• /
• 2008

Using the recycled aggregate can reduces the landfill space, the demand for natural raw material for new construction. Some investigations have been carried out to study the shear behaviors of RC beams with recycled aggregates. But these have some limitation due to the use of low quality recycled aggregates and small-scale specimens in the laboratory. In this study, four full-scaled RC beams were tested to evaluate the effects of replacement level (0,30, 60, and 100%) of recycled fine aggregate on shear behavior of RC beams. The results showed that the beams with recycled fine aggregates show similar crack pattern and failure mode compared with the beam with natural aggregate. Also, the beams with recycled fine aggregates present the similar shear strength except the one with the replacement level of 100% recycled fine aggregates. Shear strength were compared with the provisions in current code (KCI2007) and the equation proposed by Zsutty. The KCI equations were conservative and subsequently can be used for the shear design of recycled aggregate concrete beam.

• Resources Recycling
• /
• v.18 no.3
• /
• pp.20-26
• /
• 2009

The objective of this study is to investigate the properties of fresh concrete with recycled coarse and fine aggregates. Four different kinds of aggregate with natural, recycled aggregates were prepared. The concrete mixtures were produced with test parameters of replacement ratio of recycled aggregate. The properties of the fresh concrete were measured by means of slump and air content according to elapsed time. Quality control method to maintain the constant total mixing water for recycled aggregate concrete was suggested. The all concrete mixtures were produced with approximately the same slump on the job site after an hour. Test results indicated that compressive strength of concrete with constant slump is not affected by the replacement ratio of recycled aggregate. Also the practical way for the quality control of recycled aggregate concrete is to maintain the constant total mixing water.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.9 no.3
• /
• pp.246-252
• /
• 2021

The basic properties and volume stability of the ultra-rapid setting cement mortar containing low-quality recycled aggregate with a higher water absorption and lower specific gravity than relavent Korea Standard were experimentally confirmed. The mix proportion without recycled aggregate followed that of the general repair mortar used in the fields. 15% and 30% of the fine aggregate was substituted by the recycled aggregate in the mixtures with and without latex emulsion, and properties and characteristics of the mortar including mortar flow, setting time, compressive and flexural strength, and linear deformation under sealed and unsealed conditions were evaluated. It was confirmed that when low-quality recycled aggregate was used by 30%, there were risks of decrease in the early-age strength by up to 50% within 24h and increases in drying shrinkage by up to 2 times for 2 weeks compared to the the mixtures without the recycled aggregate.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.39 no.4
• /
• pp.485-492
• /
• 2019

In this study, the effect of moisture conditions of recycled coarse aggregates on the compressive strength of concrete was evaluated with the water/binder ratios and the curing conditions. The saturated recycled aggregates seemed to have the negative effect on the strength development of concrete. This is the because of the decrease in bond strength between aggregate and cement paste due to the increase of surface water according to the high absorption of recycled aggregates. The effect of types and moisture conditions of aggregates according to the change of water/binder ratio was similar. However, the curing conditions had a significant effect on the compressive strength of the concrete with the different types of aggregates. In the case of curing in air, the recycled aggregates with high absorption reduced the moisture required for hydration and increased the rate of vaporizing, and these result in interfering strength development. The moisture conditions of the recycled aggregates have a considerable effect on the compressive strength of the concrete, and it is necessary to control the moisture conditions of aggregates in the production of concrete with recycled coarse aggregate. And the control of the curing condition is very important for the concrete with recycled aggregate.

• Advances in concrete construction
• /
• v.17 no.1
• /
• pp.13-26
• /
• 2024

Due to its capacity to address urgent environmental challenges connected to urbanization and stormwater management, pervious concrete, a sustainable and innovative material, has attracted a lot of attention recently. The aim of this study was to find the engineering characteristics of pervious concrete made from recycled aggregate (RA) at various aggregate-to-cement ratios (A/C) and the addition of 5% (by weight of total aggregate) of both natural and recycled fine aggregate to produce a very sustainable concrete product for a variety of applications. The three distinct aggregate-to-cement ratios, 6, 5, and 4, were used to produce pervious concrete using recycled aggregate in the research approach. The ratio of water to cement (w/c) was maintained at 0.3. Pervious concrete was created using single-sized recycled aggregate that passed through a 12.5 mm sieve and was held on a 9.5 mm sieve, as well as natural and recycled sand that passed through a 4 mm sieve. The production of twelve distinct concrete mixtures resulted in the testing of each concrete sample for dry density, abrasion resistance, compressive and splitting tensile strengths, porosity, and water permeability. A statistical method called GLM-ANOVA was also used to assess the characteristics of pervious concrete made using recycled aggregate. According to the experimental results, lowering the aggregate-to-cement ratio enhances the pervious concrete's overall performance. Additionally, a modest amount of fine aggregate boosts mechanical strength while lowering void content and water permeability. However, it was noted that such concretes' mechanical qualities were adversely affected to some extent. The results of this study offer insight into the viability of using recycled aggregates in order to achieve both structural integrity and environmental friendliness, which helps to optimize pervious concrete compositions.