• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.10
• /
• pp.2373-2379
• /
• 2015

COMS(Communication, Ocean and Meteorological Satellite), the first Korean geostationary meteorological satellite, provides free meteorological information through HRIT/LRIT(High/Low Rate Information Transmission) service. This work presents the development of data receiver circuit that is essential to the implementation of a low-cost meteorological information receiver system. The data receiver circuit processes the data units according to the specification of physical layer and data link layer of HRIT/LRIT service. For this purpose, the circuit consists of a Viterbi decoder, a sync. word detector, a derandomizer, a Reed-Solomon decoder and so on. The circuit also supports PCI express interface to pass the information data on to the host PC. The circuit was implemented on an FPGA(field programmable gate array) and its function was verified through simulations and hardware implementation.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.9A
• /
• pp.991-997
• /
• 2004

In this paper, we propose the architecture of modem receiver to fabricate HomePNA 2.0 chip. HomePNA suffers from inferior channel because of bridge tap, the effect of amateur HAM band and so on. To transfer data over such channel, HomePNA 2.0 uses training sequence to equalize channel and uses FD-QAM optionally as modulation method. So modem receiver demodulate QAM based signal and needs optimum architecture that fully uses these transmission feature. As a result of research, we define 2 mode function of modem receiver depending on TX/RX state. In this paper, particularly, we show the algorithm of equalizer, carrier phase recovery and frame synchromzationblock and propose architecture that improve the performance of channel equalization and is stable in operation. In the end, we estimate the performance of proposed HomePNA2.0 modem receiver over HomePNA TEST LOOP using SPW program.

• Journal of Korea Society of Industrial Information Systems
• /
• v.18 no.2
• /
• pp.35-40
• /
• 2013

In this paper, we propose a new image rejection receiver architecture using simultaneously the high-side and low-side injected LO signals. The proposed architecture has a lower noise figure (NF) performance and a higher linearity characteristic than the previous receiver architecture using a single LO signal. Also, the proposed receiver shows a higher IRR performance about 6dB than that of the previous Weaver image rejection architecture even though the same gain and phase errors between I-path and Q-path exist. To verify these characteristics, we derive an IRR formular of the proposed architecture as a function of mismatch parameters. And we demonstrate its formular's usefulness through the system simulation. Therefore, the proposed architecture will be widely used to implement the image rejection receiver due to its higher IRR performance.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.9
• /
• pp.2433-2443
• /
• 1996

In this paper, a new technique is proposed for obtaining the error probabilities of the VSB(vestigial sideband modulation) signal in the presence of the cochannel interference and frequency-selective fading channel. For the receivers, a suboptimal matched filter receiver and the MLSE(maximum likelihood sequence estimation) receiver, which is known to be optimal on the fading channel, are considered. First, for the matched filter receiver, the distributions of the random variables, which determine the SER(symbol error rate) are obtained by decomposing the multi-path fading channel into Rayleigh distributed main path and Gaussian distributed remained path channels. the random variables mean the energy of the main path and subpath respecitively, and SER can be calculated from the distribution of them. Next, for the case of the MLSE receover, it is found that the random variables are expressed as a function of integrals. In order to obtain the distribution for the random variables, we expanded each element of integrals with the KL(Karhunen-Loeve) transformation. And it is derived that the distributions for the transformed random variables are given by a sum of chi-square distributions. Finally, we calculated the error rate derived formula on the two-ray fading channel, which is one of widely used models for the frequency-selective fading channel. From the numerical results, it is found that for the matched filer receiver, performance degradation is significant, while the performance degradation at the MLSE receiver is insignificant on the frequency-selective fading channel. However, in case of cochannel interference environment, the error rateis found to increase significantly both at the matched filter and at the MLSE receiver.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.7A
• /
• pp.724-729
• /
• 2007

In this paper, we consider a joint optimization of transmitter and receiver in additive cyclostationary noise with zero forcing criterion. We assume that the period of the cyclostationary noise is the same as the inverse of the symbol transmission rate and that the noise has a positive-definite autocorrelation function. The data sequence is modeled as a wide-sense stationary colored random process and the channel is modeled as a linear time-invariant system with a frequency selective impulse response. Under these assumptions and a constraint on the average power of the transmitted signal, we derive the optimum transmitter and receiver waveforms that jointly minimizes the mean square error with no intersymbol interference. The simulation results show that the proposed system has a better BER performance than the systems with receiver only optimization and the systems with no transmitter and receiver optimization.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.23 no.6
• /
• pp.563-573
• /
• 2013

The ship radiated noise level fluctuates by the interference between direct and reflected paths. The effect of sea surface reflection path on interference depends strongly on sea surface roughness. This paper describes error characteristics of ship acoustic signature estimation by sea surface scattering effect. The coherent reflection coefficient which explains a magnitude of sea surface scattering and its resultant interference acoustic field is analyzed quantitatively as a function of a grazing angle, effective surface height, frequency, source-receiver range and depths of source and receiver. Theoretical interference acoustic field is compared with experimental result for two different sea surfaces and five different frequencies by changing source-receiver range. It is found that both matches well each other and a magnitude of interference acoustic field is decreasing by increasing a grazing angle, effective surface height, frequency, and depths of source and receiver and decreasing source-receiver range. For given experimental conditions, the transmission anomaly which is a bias error of ship acoustic signature estimation, is about a range of 1~3 dB. The bias error of an existing ship radiated noise measurement system is also analyzed considering wind speed, source depth and frequency.

• Journal of Korea Multimedia Society
• /
• v.8 no.3
• /
• pp.362-371
• /
• 2005

This paper presents a digital video broadcasting - terrestrial (DVB-T) receiver system based on the orthogonal frequency division multiplexing (OFDM) modulation method, which has exhibited a good reception performance even with obstacles and a mobile reception. As such, an improved OFDM receiver is developed for a DVB-T system that also considers function expansion for further development. After manufacturing the DVB-T receiver system, the performance of the proposed system is compared with three other hardware systems, all of which are end products. The experimental results confirm the performance using the measured minimum required carrier-to-noise ratio and threshold of visibility signal for each system. In addition, a graphic user interface (GUI) and electronic program guide (EPG) are developed for the digital television user.

• Journal of Satellite, Information and Communications
• /
• v.4 no.1
• /
• pp.36-44
• /
• 2009

The key technologies of GNSS receiver for GNSS sensor station are under development as a part of a GNSS ground station in ETRI. This paper presents the GNSS receiver implementation and signal processing result which is implemented based on FPGA to process the Galileo E1 and E5 signal. To verify the working and performance for GNSS receiver which is implemented based on FPGA, live signal received from GIOVE-B which is second test satellite is used. We gather GIOVE-B signal by using prototyping antenna and RF/IF units including IF-component. To verify Galileo E1 and E5 signal processing function from GIOVE-B, FPGA based signal processing module is implemented as a prototyping hardware board.

• Proceedings of the Acoustical Society of Korea Conference
• /
• 1994.06a
• /
• pp.1064-1069
• /
• 1994

In order to realize the function of human interface of telecommunications whose objective is to interchange useful information among persons, we developed a bone conduction telephone with which hearing impaired persons with conductive or noise-induced hearing loss and presbycusis can communicate with each other without any other additional devices such as hearing aids. The bone conduction telephone we developed has chatacteristics as follows : (i) a hearing impaired person and a normal hearing person can communicate by bone and air conduction hearings, respectively, using only this telephone set because, as its receiver, it uses a bone conduction vibrator with which we can realize such function with the voice coil and damper of a small speaker unit, the vibrating plate, etc., (ii) it has tone control function compensating hearing losses of hearing impaired persons according to their hearing loss/frequency chatacteristics. Using the tone control function together with a received volume control, it has the received volume range of 20dB in loudness rating; and (iii) it has the function of three emergency calls and a bell lamp as the visual display of a received call.

• Journal of Satellite, Information and Communications
• /
• v.5 no.1
• /
• pp.58-62
• /
• 2010

This paper presents the effects of RF performance parameters on the Galileo receiver design via simulation after reviewing the requirements of the Galileo receiver structure. At first, we considered the general requirements, structure and characteristics of the Galileo system. Then we designed the Galileo receiver focused on performance requirement of 16 dB C/N which is equal to 15 % Error Vector Magnitude(EVM) by using Advanced Design System(ADS) simulation program. In order to verify the function of Automatic Gain Control(AGC)), we measured the IF output power level by changing the input power level at the front - end of the receiver. We analyzed the performance degradation due to phase noise variations of Local Oscillator(LO) in the Galileo receiver through EVM when the minimum sensitivity level of -127 dBm is applied at the receiver. We also analyzed the performance degradation according to variable Analog-to-Digital Converter(ADC) bits within the Dynamic range, -92 ~ -139 dBm, which has been defined by gain range (-2.5 ~ +42.5 dB) in the AGC operation. The results clearly show that the performance of the Galileo receiver can be improved by increasing ADC bits and reducing Phase Noise of LO.