• Journal of electromagnetic engineering and science
• /
• 제6권3호
• /
• pp.189-195
• /
• 2006

In this paper, the derivation of the protection ratio for the digital microwave system with diversity is newly suggested for a basic guidance of initial planning for frequency coordination, and computational results are presented for an actual radio frequency band. The net filter discrimination has been also examined to see the effect of the adjacent channel protection ratio caused by adjacent channel interference. In addition, the protection ratios for the space or frequency diversity system are analyzed in terms of diversity improvement factors to find out an equivalent allowable noise-to-interference ratio (N/I) from degraded fade margin. According to results for 6.2 GHz system, with the space diversity of 25 m distance between antennas or the frequency diversity of ${\Delta}f/f=0.05$, under 64-QAM and 60 km at BER $10^{-6}$, the protection ratio can be greatly reduced in comparison to the non-diversity system. So, assuming that only the same protection ratio as the non-diversity system is kept, it is shown that the system with diversity may get more interference level of N/I allowing from 9.0 to - 5.9 dB or from 6.0 to - 4.3 dB for the space or frequency diversity. In consequence, it is concluded that the diversity system is more robust or tolerable for interferences or fades, which may play an important role in overcoming N/I to some extent.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제4권2호
• /
• pp.83-87
• /
• 2004

Phase noise performance and current consumption of Radio Frequency (RF) Voltage-Controlled Oscillator (VCO) are largely dependent on the Quality (Q) factor of inductor-capacitor (LC) tank. Because the Q-factor of LC tank is determined by on-chip spiral inductor, we designed, analyzed, and modeled on-chip differential inductor to enhance differential Q-factor, reduce current consumption and save silicon area. The simulated inductance is 3.3 nH and Q-factor is 15 at 2 GHz. Self-resonance frequency is as high as 13 GHz. To verify its use to RF applications, we designed 2 GHz differential LC VCO. The measurement result of phase noise is -112 dBc/Hz at an offset frequency of 100 kHz from a 2GHz carrier frequency. Tuning range is about 500 MHz (25%), and current consumption varies from 5mA to 8.4 mA using bias control technique. Implemented in $0.35-{\mu}m$ SiGe BiCMOS technology, the VCO occupies $400\;um{\times}800\;um$ of silicon area.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제11권4호
• /
• pp.295-301
• /
• 2011

A triple-band transceiver module for 2.3/2.5/3.5 GHz mobile WiMAX, IEEE 802.16e, applications is introduced. The suggested transceiver module consists of RFIC, reconfigurable/multi-resonance MIMO antenna, embedded PCB, mobile WiMAX base band, memory and channel selection front-end module. The RFIC is fabricated in $0.13{\mu}m$ RF CMOS process and has 3.5 dB noise figure(NF) of receiver and 1 dBm maximum power of transmitter with 68-pin QFN package, $8{\times}8\;mm^2$ area. The area reduction of transceiver module is achieved by using embedded PCB which decreases area by 9% of the area of transceiver module with normal PCB. The developed triple-band mobile WiMAX transceiver module is tested by performing radio conformance test(RCT) and measuring carrier to interference plus noise ratio (CINR) and received signal strength indication (RSSI) in each 2.3/2.5/3.5 GHz frequency.

• Journal of electromagnetic engineering and science
• /
• 제14권2호
• /
• pp.47-53
• /
• 2014

This paper presents a high gain and high harmonic rejection low-noise amplifier (LNA) for software-defined radio receiver. This LNA exploits the high quality factor (Q) series resonance technique. High Q series resonance can amplify the in-band signal voltage and attenuate the out-band signals. This is achieved by a source impedance transformation. This technique does not consume power and can easily support multiband operation. The chip is fabricated in a $0.13-{\mu}m$ CMOS. It supports four bands (640, 710, 830, and 1,070MHz). The measured forward gain ($S_{21}$) is between 12.1 and 17.4 dB and the noise figure is between 2.7 and 3.3 dB. The IIP3 measures between -5.7 and -10.8 dBm, and the third harmonic rejection ratios are more than 30 dB. The LNA consumes 9.6 mW from a 1.2-V supply.

• 한국통신학회논문지
• /
• 제27권1A호
• /
• pp.1-12
• /
• 2002

초광대역 통신은 전 주파수 대역에 걸쳐 스펙트럼이 마치 기저 대역 잡음과 유사한 형태로 존재하여 타 통신시스템에 간섭을 주지 않고 고속의 통신이 가능하며, 반송파를 사용하지 않기 때문에 송${\cdot}$수신기의 소비 전력과 그 구조를 간략화 시킬 수 있다. 본 논문에서는 평균값이 0이고 대칭성을 갖는 레일리 모노펄스 Antipodal 방식을 처음으로 적용하여 초광대역 신호를 구성하고 시간 도약 부호를 적용하여 다중접속 시스템을 제안하였다. AWGA에서 레일리 모노펄스에 대한 오류확률, 다중접속시 사용자의 수, 전송속도에 대해 수치해석을 통해 시스템의 성능을 비교, 분석하였다. 그 결과 제안한 Antipodal 방식은 기존의 펄스 위치 변조 방식보다 오류확률, 사용자의 수 및 전송속도 면에서도 유리함을 보였다.

• Journal of Electrical Engineering and information Science
• /
• 제2권6호
• /
• pp.202-207
• /
• 1997

Design and fabrication issues for an L-band GaAs Monolithic Microwave Integrated Circuit(MMIC) Voltage Controlled Oscillator(VCO) as a component of Personal Communications Systems(PCS) Radio Frequency(RF) transceiver are discussed. An ion-implanted GaAs MESFET tailored toward low current and low noise with 0.5mm gate length and 300mm gate width has been used as an active device, while an FET with the drain shorted to the source has been used as the voltage variable capacitor. The principal design was based on a self-biased FET with capacitive feedback. A tuning range of 140MHz and 58MHz has been obtained by 3V change for a 600mm and a 300mm devices, respectively. The oscillator output power was 6.5dBm wth 14mA DC current supply at 3.6V. The phase noise without any buffer or PLL was 93dB/1Hz at 100KHz offset. Harmonic balance analysis was used for the non-linear simulation after a linear simulation. All layout induced parasitics were incorporated into the simulation with EEFET2 non-linear FET model. The fabricated circuits were measured using a coplanar-type probe for bare chips and test jigs with ceramic packages.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2000년도 하계학술대회 논문집 C
• /
• pp.1924-1926
• /
• 2000

This paper deals with the multiresolution analysis of wavelet transform for partial discharge(PD).PD is an electrical discharge that only partically bridges the insulation performance of electrical equipment in high voltage. PD signal is very sensitive and difficult to suppress strong noises such as narrow-band radio frequency noise and random noise. In recently, wavelet transform has become a powerful tool to analysis and process signals in various science and technology fields. In this paper, daubechies family is adopted for the research of the characteristics of PD signals. The results show that the kurtosis is increased with discharge process and skewness is decreased with discharge process, but when PD occured positive range then skewness is increased. Segment 7, 8, 9, 10, 11 values is increased with discharge process, so phase distribution is characterized by 210$\sim$330 ranges.

• 한국음향학회지
• /
• 제36권1호
• /
• pp.64-69
• /
• 2017

본 논문에서는 PTT(Push-To-Talk) 기반의 무선 통신을 위한 진폭 및 위상 복원 기반의 단일 채널 음성 향상 방식을 제안한다. 제안한 방식은 신호의 진폭만을 대상으로 음성 향상을 진행했던 기존의 방식들과 달리, 음성 신호의 진폭과 위상을 분리하여 각각 향상시켜 다시 결합함으로써 더욱 양질의 음성을 제공한다. 본 논문에서 제안하는 방식의 성능을 평가하기 위해 동적 잡음 환경에서의 단계별 비교 실험을 실시하였으며, 실험 결과를 통해 제안한 방식이 다양한 잡음 환경에서 양질의 음성을 제공하는 것을 확인할 수 있다.

• 한국해양공학회:학술대회논문집
• /
• 한국해양공학회 2003년도 춘계학술대회 논문집
• /
• pp.168-171
• /
• 2003

We introduced a small-sized automatic model helicopter for using in the remote sensing. The feature of our helicopter system is that the helicopter system is realized using commercialized radio-controlled model helicopter, whose payload is 1.5 kg. Therefore, our system has may benefits when apply our system to practical tasks. The compactness and light-weight of our system is realized by the introduction of our original technique to suppress the vibration noise using a slimy material as well as the introduction of latest sensors and semiconductor products. Submerging the acceleration sensor into a slimy material, moise ratio is highly improved. In this paper, we show an experimental results for the effect of our orignal technique to remove the vibration noise of helicopter. The result of hovering flying test shows the effectiveness of our system.

• Journal of Communications and Networks
• /
• 제14권5호
• /
• pp.471-480
• /
• 2012

Reliable detection of primary user activity increases the opportunity to access temporarily unused bands and prevents harmful interference to the primary system. By extracting a global decision from local sensing results, cooperative sensing achieves high reliability against multipath fading. For the effective combining of sensing results, which is generalized by a likelihood ratio test, the fusion center should learn some parameters, such as the probabilities of primary transmission, false alarm, and detection at the local sensors. During the training period in supervised learning, the on/off log of primary transmission serves as the output label of decision statistics from the local sensor. In this paper, we extend unsupervised learning techniques with an expectation maximization algorithm for cooperative spectrum sensing, which does not require an external primary transmission log. Local sensors report binary hard decisions to the fusion center and adjust their operating points to enhance learning performance. Increasing the number of sensors, the joint-expectation step makes a confident classification on the primary transmission as in the supervised learning. Thereby, the proposed scheme provides accurate parameter estimates and a fast convergence rate even in low signal-to-noise ratio regimes, where the primary signal is dominated by the noise at the local sensors.