• Journal of Convergence for Information Technology
• /
• v.7 no.2
• /
• pp.53-58
• /
• 2017

This paper describes the design of a simulator for analyzing the accuracy of a correlative interferometer(CI) direction finder. CI direction finder is robust to noise, so it is often used in aircraft or ships where complex antenna installation is required, and the direction finding accuracy is very high. When the radio wave is incident at a specific azimuth angle, the phase difference calculated in a noiseless environment and the phase difference measured in a real environment with noise are fused to estimate the largest correlation coefficient as the azimuth angle of the radio wave. The simulator receives RF frequency, the number of antennas, the antenna coordinates, the transmission signal intensity, the bandwidth of the receiver, the gain and the payload effect, and calculates the direction finding accuracy of 0-360 degrees azimuth and 0-60 degree elevation with 0.5 degree. accuracy.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.47 no.5
• /
• pp.388-396
• /
• 2019

This paper describes the RF(Radio Frequency) interference on the GNSS receiver due to the S-band signals transmitted from the transmitters in the Test Launch Vehicle, and analyzes the cause of the RF interference. Due to the S-band signals that have relatively high power levels compared with GNSS signals, an LNA(Low Noise Amplifier) in the active GNSS antenna was saturated, and the intermodulation signal within GNSS in-bands was produced in the LNA whenever two S-band signals were received from the GNSS antenna. For these reasons, the C/N0 of the satellite signals in the GNSS receiver was attenuated severely. The design of the LNA was changed in order to protect the RF interference due to the S-band signals and the suppression capability of the RF interference was confirmed in the new LNA through the comparison of the old LNA.

• Korean Journal of Audiology
• /
• v.18 no.3
• /
• pp.105-111
• /
• 2014

Assistive listening devices (ALDs) refer to various types of amplification equipment designed to improve the communication of individuals with hard of hearing to enhance the accessibility to speech signal when individual hearing instruments are not sufficient. There are many types of ALDs to overcome a triangle of speech to noise ratio (SNR) problems, noise, distance, and reverberation. ALDs vary in their internal electronic mechanisms ranging from simple hard-wire microphone-amplifier units to more sophisticated broadcasting systems. They usually use microphones to capture an audio source and broadcast it wirelessly over a frequency modulation (FM), infra-red, induction loop, or other transmission techniques. The seven types of ALDs are introduced including hardwire devices, FM sound system, infra-red sound system, induction loop system, telephone listening devices, television, and alert/alarm system. Further development of digital wireless technology in hearing instruments will make possible direct communication with ALDs without any accessories in the near future. There are two technology solutions for digital wireless hearing instruments improving SNR and convenience. One is near-field magnetic induction combined with Bluetooth radio frequency (RF) transmission or proprietary RF transmission and the other is proprietary RF transmission alone. Recently launched digital wireless hearing aid applying this new technology can communicate from the hearing instrument to personal computer, phones, Wi-Fi, alert systems, and ALDs via iPhone, iPad, and iPod. However, it comes with its own iOS application offering a range of features but there is no option for Android users as of this moment.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.26 no.3
• /
• pp.333-341
• /
• 2015

In this paper, a 0.5~4 GHz frequency synthesizer having good phase noise performance is proposed. Wideband output frequencies of the synthesizer were synthesized using DDS(Direct Digital Synthesizer) and analog direct frequency synthesis technology in order to obtain fast settling time. Also in order to get good phase noise performance, 2.4 GHz DDS clock was generated by VCO(Voltage Controlled Oscillator) which was locked by the 100 MHz reference oscillator using SPD(Sample Phase Detector). The phase noise performance of wideband frequency synthesizer was estimated and the results were compared with the measured ones. The measured phase noise of the frequency synthesizer was less then -121 dBc @ 100 kHz at 4 GHz.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.4
• /
• pp.28-39
• /
• 2007

This paper presents a programmable RF DFT (Radio Frequency Design-for-Testability) circuit for low noise amplifiers. We have developed a new on-chip RF DFT circuit that measures RF parameters of low noise amplifier (LNA) using only DC measurements [1, 2]. This circuit is extremely useful for today's RFIC devices in a complete RF transceiver environment. The DFT circuit contains test amplifier with programmable capacitor banks and RF peak detectors. The test circuit utilizes output DC voltage measurements and these measured values are translated into the LNA specifications such as input impedance and gain using the mathematical equations. Our on-chip DFT circuit can be self programmed for 1.8GHz, 2.4GHz and 5.25GHz low noise amplifiers for GSM, Bluetooth and IEEE802.11g standards. The circuit is simple and inexpensive.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.2
• /
• pp.208-216
• /
• 2014

Ground station in lunar mission is responsible to receive telemetry signal including sensor data from lunar orbiter and/or lander. At preliminary stage of developing this ground station, receiving performance such as antenna size and noise temperature should be designed on the basis of link budget analysis. When the antenna of ground station is pointing to the moon to communicate with lunar orbiter and/or lander, noise level is supposed to be increasing due to the lunar flux density. It means that the moon is working as a noise source to degrade receiving performance when antenna is pointing to the moon. Antenna noise temperature contributed by the moon was firstly calculated and secondary validated by using test configuration in this paper. Consequently, it was shown that antenna noise temperature caused by the moon was quietly matched with measured one and G/T degradation of receiving system in lunar mission can be calculated depending on antenna size and frequency.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.15 no.3
• /
• pp.632-638
• /
• 2011

This paper presents on-chip Design-for-Testability (DFT) circuit for radio frequency System-on-Chip (SoC) applications. The proposed circuit measures functional specifications of RF integrated circuits such as input impedance, gain, noise figure, input voltage standing wave ratio (VSWRin) and output signal-to-noise ratio (SNRout) without any expensive external equipment. The RF DFT scheme is based on developed theoretical expressions that produce the actual RF device specifications by output DC voltages from the DFT chip. The proposed DFT showed deviation of less than 2% as compared to expensive external equipment measurement. It is expected that this circuit can save marginally failing chips in the production testing as well as in the RF system; hence, saving tremendous amount of revenue for unnecessary device replacements.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.12
• /
• pp.1406-1411
• /
• 2012

An energy detection based spectrum sensing has been found to be vulnerable to the noise power uncertainty. A cooperative spectrum sensing with an energy detector has appeared as one of the solutions to alleviate this difficulty. However, its performance analysis in a fading environment has not been reported yet in the literature. Motivated by this, this paper presents the performance analysis of the scheme by extending our previous work on evaluating the performance of an energy detector in the presence of noise power uncertainty. The analysis shows that the false alarm probability and detection probability gets higher as the sensing time and/or the number of the secondary users in the OR based cooperative spectrum sensing scheme increase when the noise power uncertainty exists.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.10
• /
• pp.966-982
• /
• 2014

This paper presents recent trends in system-level EMC investigation and countermeasure technology for radio frequency interference (RFI) influenced by noise generated in high-speed digital system. Recently, as the only digital device can perform various roles, there are a variety of EMI/EMC problems between systems. Especially, RFI is now recognized as a major problem, which occurs by EMI caused by the digital system. Therefore, in this paper, recent trends of RFI investigation from component-level to system-level are introduced and analyzed. Furthermore, in order to solve the RFI problem, recent researches are presented and investigated for the occurrences and suppression methods of common-mode noise which is one of the major noise sources in high-speed digital system. Lastly, this paper suggested future research of system-level EMC analysis and countermeasure technology for RFI problems.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.18 no.1
• /
• pp.83-90
• /
• 2019

LED lighting is spreading on the strength of LED lighting, and various government policies are being implemented. VLC research which is a wireless communication technology using lighting has been actively conducted, and it has been proven through many studies that a general LED light source such as a high-speed data transmitter can be used. But from now on, one of the main problems is the noise from side lights, which can be compared to the noise of radio broadcasts. So in this paper, we proposed a noise canceling model to remove the interference of ambient light by using an optical filter for a detachable VLC channel. In order to verify the proposed model, various high brightness RGB LED modules were used for comparative analysis. In addition, the applicability was verified through experiments using High Luminance LED lighting which is applied in real life.