• Advances in environmental research
• /
• v.6 no.2
• /
• pp.113-125
• /
• 2017

Santa Barbara Amorphous-15(SBA-15) nanoparticles were utilized as the inexpensive and effective adsorbents to remove methylene blue dye from the aqueous solution.SBA-15 was created by Zhao et al method. Infrared spectroscopy, X-ray diffraction and scanning electron microscopy (SEM) were used for the evaluated physical properties of SBA-15. The results of diffraction X-ray indicated that was the crystalline structure for it. Also IR spectroscopy indicated was a silica the whole structure of the groups and SEM image verify the structure of relatively identical particles size of SBA-15. Factors affecting adsorption including the amounts of adsorbent, pH and contact time were investigated by a SBA-15 nanomaterial design. The extent of dye removal enhanced with increasing initial dye concentration and pH from 4 to 10. The higher percentage adsorption were obtained under optimum conditions of variables (sorbent dose of 200 mg/liter, initial MB concentration 10 mg/liter, initial pH of 10 and temperature of $25^{\circ}C$). Maximum adsorption happened after the 2 hour and the kinetic processes of the dyes adsorption were described by applying the pseudo-first-order and the pseudo-second-order and the relatively High correlation with the kinetic Ellovich models. It was found that the pseudo-second-order models kinetic equation described the data of dye adsorption with a good correlation (R2>0.999) which indicated chemisorption mechanism. Freundlich and Langmuir adsorption models were investigated in conditions of variables (adsorbent dose 0.01 gr/liter, MB concentration 10, 20, 30 mg/liter, pH of 4, 7, 10, contact time 90 min and temperature of $27^{\circ}C$). The adsorption data were represented by Langmuir isotherm model. These values are higher than the adsorption capacities of some other adsorbents that have recently been published in the literature.

• Journal of Korean Society of Water and Wastewater
• /
• v.29 no.3
• /
• pp.407-414
• /
• 2015

The effect of activated carbon particle diameter (i.e. US sieve No. $8{\times}10$ ($d_p{\approx}2.19mm$), $18{\times}20$ ($d_p{\approx}0.92mm$), $50{\times}60$ ($d_p{\approx}0.27mm$) and $170{\times}200$ ($d_p{\approx}0.081mm$) on caffeine adsorption is investigated. BET surface area was increased with decreasing particle diameter ($d_p$), and caffeine adsorption rates increased with decreasing $d_p$. Moreover, pseudo-second order model is predicted the experimental data more accurately than pseudo-first order model, and the fastest rate constant ($k_2$) was $1.7g\;mg^{-1}min^{-1}$ when $d_p$ was 0.081 mm. Surface diffusion coefficient (Ds) was decreased with decreasing $d_p$ based on the minimum sum of square error (SSE). Practically, certain ranges of Ds are acceptable with high reliability ($R^2$) and it is determined that the effect of $d_p$ on Ds is unclear. The effect of pH on caffeine adsorption indicated the dependency of m/L ratio (mass liquid ratio) and $pH_{pzc}$. The $pH_{pzc}$ (i.e. $7.9{\pm}0.2$) was not affected by $d_p$. The higher caffeine adsorption at pH 4 and pH 7 than at pH 10 is due to $pH_{pzc}$, not $pk_a$ of caffeine.

• Korean Chemical Engineering Research
• /
• v.53 no.3
• /
• pp.309-314
• /
• 2015

Adsorption of brilliant blue FCF dye from aqueous solution using coconut shell based activated carbon was investigated. Batch experiments were carried out as function of adsorbent dose, initial concentration, contact time and temperature. The equilibrium adsorption data were analyzed by Langmuir and Freundlich model. The results indicate that Freundlich model provides the best correlation of the experimental data. Base on the estimated Freundlich constant (1/n=0.129~0.212), this process could be employed as effective treatment method. Adsorption kinetics experimental data were modeled using the pseudo-first-order and pseudo-second-order kinetic equation. It was shown that pseudo-second-order kinetic equation could best describe the adsorption kinetics. Base on the negative Gibbs free energy value (-4.81~-10.33 kJ/mol) and positive enthalpy value (+78.59 kJ/mol) indicate that the adsorption is spontaneous and endothermic process.

• Korean Chemical Engineering Research
• /
• v.54 no.2
• /
• pp.255-261
• /
• 2016

Adsorption experiments of Acid Yellow 14 dye using activated carbon were carried out as function of adsorbent dose, pH, initial concentration, contact time and temperature. The equilibrium adsorption data were analyzed by Langmuir, Freundlich and Temkin isotherm model. The experimental data were best represented by Freundlich isotherm model. Base on the estimated Freundlich constant (1/n=0.129~0.212) and Langmuir separation factor ($R_L=0.202{\sim}0.243$), this process could be employed as effective treatment method. The heat of adsorption of Temkin isotherm model was 5.101~9.164 J/mol indicated that the adsorption process followed a physical adsorption. Adsorption kinetics experimental data were modeled using the pseudo-first-order and pseudo-second-order kinetic equation. It was shown that pseudo-second-order kinetic equation could best describe the adsorption kinetics. Base on the negative Gibbs free energy (-4.81~-10.33 kJ/mol) and positive enthalpy (+78.59 kJ/mol) indicate that the adsorption is spontaneous and endothermic process.

• Korean Journal of Agricultural Science
• /
• v.2 no.2
• /
• pp.399-404
• /
• 1975

In order to study on the utility for feed of several leguminosae tree leaves, the leaves of Lespedeza spp., Amorpha fruticosa and Robinia pseudo acacia were collected from several places of Daejon city and Daeduck-Kun at the different growing seasons. The leaf productivities, the change of the contents of chemical components on the different growing seasons. and the palatability trial were determined. The results were summarized as follows: 1. Leaf productivities of Amorpha fruticosa and Robinia pseudo acacia were higher than that of Lespedeza spp., and the highest production of Amorpha' fruticosa was showed in august and that of Robinia pseudo acacia was showed in september. 2. Crude protein contents of Lespedeza spp., Amorpha fruticosa and Robinia pseudo acacia were determined to 12.6, 18.63 and 15.87% respectively and the protein contents of them showed gradual decrease as growing. 3. Crude fat contents of Lespedeza spp., Amorpha fruticosa and Robinia pseudo acacia were determined to 9.00, 5.85 and 4.70% respectively, and they displayed gradual increase as growing, 4. Crude fiber contents of Lespedeza spp., Amorpha fruticosa and Robinia pseudo acacia were determined to 14.97, 12.61 and 9.80% respectively, and they showed gradual increase as growing. 5. The content of nitrogen free extract of Robinia pseudo acacia showed higher than those of Lespedeza spp. and Amorpha fruticosa, and all of them displayed gradual decrease as growing. 6. Crude ash contents of Lespedeza spp., Amorpha fruticosa and Robinia pseudo acacia determined to 4.40, 4.98 and 5.27% respectively, and variable changes were appeared as growing. 7. The results of palatability trial for three leaves showed superior to the order of Lespedeza spp., Robinia pseudo acacia and Amorpha fruticosa, and the dried leaves were more favorable than green leaves.

• Korean Journal of Remote Sensing
• /
• v.17 no.1
• /
• pp.33-44
• /
• 2001

The paper presents several satellite models and satellite image decomposition methods for inaccessible area where ground control points can hardly acquired in conventional ways. First, 10 different satellite sensor models, which were extended from collinearity condition equations, were developed and then behavior of each sensor model was investigated. Secondly, satellite images were decomposed and also pseudo images were generated. The satellite sensor model extended from collinearity equations was represented by the six exterior orientation parameters in $1^{st}$, $2^{nd}$ and $3^{rd}$ order function of satellite image row. Among them, the rotational angle parameters such as $\omega$(omega) and $\Phi$(phi) correlated highly with positional parameters could be assigned to constant values. For inaccessible area, satellite images were decomposed, which means that two consecutive images were combined as one image, The combined image consists of one satellite image with ground control points and the other without ground control points. In addition, a pseudo image which is an imaginary image, was prepared from one satellite image with ground control points and the other without ground control points. In other words, the pseudo image is an arbitrary image bridging two consecutive images. For the experiments, SPOT satellite images exposed to the similar area in different pass were used. Conclusively, it was found that 10 different satellite sensor models and 5 different decomposed methods delivered different levels of accuracy. Among them, the satellite camera model with 1st order function of image row for positional orientation parameters and rotational angle parameter of kappa, and constant rotational angle parameter omega and phi provided the best 60m maximum error at check point with pseudo images arrangement.

• Journal of the Korean GEO-environmental Society
• /
• v.11 no.1
• /
• pp.45-51
• /
• 2010

Cadmium (Cd) adsorption by the activated carbon containing hydroxyapatite (HAP) was investigated. Cd adsorption with different HAP mass ranged from 10% to 30%. With more HAP, more Cd was adsorbed. These results suggest that the higher HAP dose causes an increase of the ion exchange potential in HAP sorbent. Kinetics and equilibrium studies were investigated in series of batch adsorption experiments. Langmuir and Freundlich isotherm models were fit to the equilibrium data and Cd adsorption on HAP sorbent were found to follow the Freundlich isotherm model well in the initial adsorbate concentration range. The simple kinetic model, the pseudo first order kinetic model and the pseudo second order kinetic model, were used to investigate the adsorption. The adsorption reaction of Cd followed the pseudo second order kinetic model, and the adsorption pseudo second order kinetic constants ($k_2$) increased with increasing initial HAP amounts onto activated carbon. Also, intraparticle diffusion model was used to investigate the adsorption mechanism between adsorbate and adsorbent in the aqueous phase. Surface adsorption reaction and intraparticle diffusion occur simultaneously Cd adsorption mechanism from aqueous phase in this study.

• Journal of the Korean Geotechnical Society
• /
• v.27 no.4
• /
• pp.43-50
• /
• 2011

Steel-making slag was investigated as reactive material for removal of cadmium in coastal area. Batch experiments of the sorption isotherm experiment and kinetic sorption experiment were performed. Result of sorption isotherm was more adequately described by Langmuir model than Freundlich model and theoretical maximum capacity (${\beta}$) of cadmium onto steel-making slag was found. Results of kinetic sorption experiments were evaluated by pseudo second order model to investigate sorption characteristics of cadmium onto steel-making slag. Results showed that the equilibrium sorption amount of cadmium (q$q_e$) increased and the rate constant ($k_2$) and initial sorption rate (h) decreased as the initial cadmium concentration increased. The $q_e$ with simulated sea water was similar to that with deionized water and $k_2$ and h with simulated sea water was lower than those with deionized water. Results of kinetic experiments could be used to predict the result from sorption isotherm, since equilibrium sorption amounts calculated by pseudo second order model generally agreed with those measured from sorption isotherm. The reaction time for the target removal rate could be calculated by the pseudo second order model using kinetic sorption tests results.

• Korean Chemical Engineering Research
• /
• v.59 no.1
• /
• pp.21-34
• /
• 2021

Chitosan nanoparticles (CNPs) and Lactococcus lactis (L. lac.) were used as adsorbents to evaluate the adsorption performance of endocrine hormones, which are phthalates, in the healthy food packages. CNPs were produced through the cross bond with tripolyphosphate (TPP), and L. lac.-CNPs were prepared through the introduction of L. lac. during the preparation. The various functional groups of all adsorbents were identified using Fourier transform infrared spectroscopy (FTIR). Adsorption isotherm and adsorption kinetic confirmed the adsorption behavior and mechanism of CNPs, L. lac. and L. lac.-CNPs. The adsorption behavior of DBP and DEP for all particles was more suitable for the Freundlich adsorption isotherm model than for the Langmuir adsorption isotherm model, which means that the surface of the particles is heterogeneous. The adsorption mechanism was more suitable for the Pseudo-2nd-order model than for the Pseudo-1st-order model. This means that due to the presence of various functional groups on the particle surface, the adsorption of DBP and DEP is dominated by chemical adsorption such as electrostatic attraction and hydrogen bonding rather than physical adsorption. Finally, it was confirmed that the preparation of CNPs and L. lac.-CNPs can be performed easily and quickly, and it could be used as a cheaper adsorbent that can effectively remove phthalates.

• Journal of Environmental Science International
• /
• v.22 no.9
• /
• pp.1161-1170
• /
• 2013

The efficiency of coal-based activated carbon in removing methylene blue (MB) and phenol from aqueous solution was investigated in batch experiments. The batch adsorption kinetics were described by applying pseudo-first-order, pseudo-second-order, and first order reversible reaction. The results showed that the adsorption of MB and phenol occurs complexed process including external mass transfer and intraparticle diffusion. The maximum adsorption capacity obtained from Langmuir isotherm was 461.0 mg/g for MB and 194.6 mg/g for phenol, respectively. The values of activation parameters such as free energy (${\Delta}G^0$), enthalpy (${\Delta}H^0$), and entropy (${\Delta}S^0$) were also determined as -19.0~-14.9 kJ/mol, 25.4 kJ/mol, and 135.2 J/mol K for MB and 51.8~54.1 kJ/mol, -29.0 kJ/mol, and -76.4 kJ/mol K for phenol, respectively. The MB adsorption was found to be endothermic and spontaneous process. However, the CV adsorption was found to be exothermic and non-spontaneous process.