• Proceedings of the Earthquake Engineering Society of Korea Conference
• /
• 1999.04a
• /
• pp.17-24
• /
• 1999

The porvision against earthquakes and aseismic design of nuclear power plants (NPPs) in Korea are composed of four stages: site-selection, design, construction, and operation stages, Since regulatory criteria are strictly applied in each stage, the NPPs in Korea are believed to have a sufficient safety against maximum potential earthquakes. However, it has been recognized that those regulatory criteria borrowed from U.S. should be replace by Korea-specific ones by using earthquake data obtained from earthquake observation at and around NPP sites. Also, the government made a plan after the Yongwol and th Kyongju earthquakes that the regulatory body operates an independent earthquake network in order to reinforce the earthquake preparedness of NPPs. In compliance with the government's plan, this project is aiming at deployment of an earthquake motoring network composed of four seismic stations at NPP sites to record earthquake ground motions at NPP sites, to derive attenuation formulas of various ground motions and site-specific response spectra, and to develop structural intergrity assesment program.

• Journal of the Korean Magnetics Society
• /
• v.7 no.5
• /
• pp.232-236
• /
• 1997

We have gone into details about the velocity calibration of sinusoidal mode for Mossbauer spectrometer. Since sinusoidal Mossbauer spectrometer has a ${\gamma}$-ray source that oscillates at the end of loudspeaker with the natural frequency. Doppler velocity is accurate and stable. From the analyzing Mossbauer spectra of $Fe_3O_4$ and U $Fe_3O_4$ (unbalanced $Fe_3O_4$), we have shown the power of correct velocity for sinusoidal mode.

• Korean Journal of Optics and Photonics
• /
• v.10 no.3
• /
• pp.254-258
• /
• 1999

We propose a simple technique to obtain field-induced absorption changes of an electroabsorption waveguide by using photocurrent generated inside a waveguide. Photocurrent proportional to the absorbed power and displaying Fabry-Perot interference fringes were observed and the field-induced absorption changes were derived from the ratio of resonant and anti resonant currents in the photocurrent spectra. The field-induced absorption change of InGaAsP waveguide for 1.5V reverse bias voltage at 1.55 $\mu\textrm{m}$ was determined to be $~157\cm^{-1}$.

• Applied Science and Convergence Technology
• /
• v.23 no.1
• /
• pp.44-47
• /
• 2014

In this study, we investigated the basic properties of N-doped ethylcyclohexene plasma polymer thin films that deposited by radio frequency (13.56 MHz) plasma-enhanced chemical vapor deposition (PECVD) method with controlled ammonia flow rate. Ethylcyclohexene was used as organic precursor with hydrogen gas as the precursor bubbler gas. Additionally, ammonia ($NH_3$) gas was used as nitrogen dopant. The as-grown polymerized thin films were analyzed using ellipsometry, Fourier-transform infrared [FT-IR] spectroscopy, UV-Visible spectroscopy, and water contact angle measurement. We found that with increasing plasma power, film thickness is gradually increased while optical transmittance is drastically decreased. However, under the same plasma condition, water contact angle is decreased with increasing $NH_3$ flow rate. The FT-IR spectra showed that the N-doped ethylcyclohexene plasma polymer films were completely fragmented and polymerized from ethylcyclohexane.

• The Transactions of the Korean Institute of Electrical Engineers
• /
• v.38 no.2
• /
• pp.127-136
• /
• 1989

This paper describes the parameter convergence properties of an adaptive system to identify a single-input single-output plant model. It is demonstrated that, by using power spectrum analysis, the persistency of excitation (PE) condition in order to guarantee the exponential stability of the adaptive control system can be transformed into the positive definite behavior for the auto-correlation function matrix of adaptive signal. The existence of parameter nominal values can be analyzed by this condition and the convergence rates of parameter are determined by examining the auto-correlation function. We may use the sufficient richness (SR) of input spectrum instead of the PE condition to analyze the parameter boundedness. It can be shown that the eigen values of the auto-correlation function are always related with adaptive gain, input amplitude and positions or numbers of input spectra. In each case, the variation of parameter convergence rate can be also verified.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2000.11a
• /
• pp.539-542
• /
• 2000

ZnO thin films for light emission device have been deposited on sapphire and silicon substrates by pulsed laser deposition technique(PLD). A Nd:YAG laser was used with the wavelength of 355 nm. In order to investigate the emission properties of ZnO thin films, PL measurements with an Ar ion laser as a light source using an excitation wavelength of 351 nm and a power of 100 mW are used. All spectra were taken at room temperature by using a grating spectrometer and a photomultiplier detector. ZnO exhibited PL bands centered around 390, 510 and 640 nm, labeled near ultra-violet (UV), green and orange bands. Structural properties of ZnO thin films are analized with X-ray diffraction (XRD).

• Proceedings of the KIEE Conference
• /
• 2001.10a
• /
• pp.150-156
• /
• 2001

This paper describes an implementation of the DSP(Digital Signal Processor) based triangular carrier frequency modulated RPWM inverter drive system. The power spectrum of the noise emitted from the induction motor was measured in the anechoic chamber. The analysis of the sources for the acoustic noise and the effects of the noise reduction are confirmed by the measured spectra of the noise. Real-time RPWM along with the speed control was achieved by high speed DSP. By changing the center frequency and the bandwidth of the carrier, the proposed real-time RPWM scheme can be used as an efficient switching frequency band acoustic noise reduction method for the inverter drive system with variant load conditions.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2000.07a
• /
• pp.316-319
• /
• 2000

By RF magnetron sputtering ZnGa$_2$O$_4$thin films were prepared on Si(100) wafer in terms of RF power, substrate temperatures and Ar/O$_2$flow rate. Crystallographic orientation was characterized by x-ray diffraction(XRD). Surface morphology and microstructure were observed by scanning electron microscope(SEM). Photoluminescence(PL) measurement was employed to observe the emission spectra of ZnGa$_2$O$_4$films. The influences of various deposition parameters on the properties of grown films were studied. PL spectrum of ZnGa$_2$O$_4$thin films showed broad band luminescence spectrum.

• Journal of the Optical Society of Korea
• /
• v.8 no.4
• /
• pp.156-162
• /
• 2004

The spectroscopic model is proposed to analyze the gain bandwidth of a fiber Raman amplifier (FRA) with a multiple wavelength pumping scheme based on Raman gain theory. The oscillatory lineshape, which is the analytic function to analyze Raman gain spectra, allows us to estimate the gain bandwidth of the FRA. Based on the proposed theoretical modeling, we design and analyze the characteristics of the FRA using the combined multiwavelength pumping sources. We achieved the extended gain bandwidth of the FRA over 80 nm with the small gain ripple less than 0.5 dB. Threshold pumping power and effective noise figure for the FRA can be also analyzed by using the proposed model, which is also applicable for versatile fibers with other doping materials. The proposed analysis method can be useful for the design of FRA with the multiwavelength pumping scheme.

• Korean Journal of Microbiology
• /
• v.23 no.4
• /
• pp.241-247
• /
• 1985

The objectives of this study were to isolate and identify ninhydrin positive substande(s) produced in the culture broth of Pseudomonas fluorescens. It was found that the NPS could stimulate bioconversion of furfural into furoic acid. In order to isolate the NPS from the culture broth, cell free filtrate was subjected to ion-exchange chromatography, gel-permeation and finally to cellulose column chromatography. The purified NPS was white amorphous power and very soluble in water, slightly soluble in methanol and very insoluble in organic solvents. UV, and IR absorption spectra. $^H$ and $^{13}C-NMR$ were measured in order to identify the chemical structure of the NPS.