• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.8
• /
• pp.878-887
• /
• 2012

Aeronautical frequency band is to be internationally protected for aviation safety. Recently, with a rapid growth of an international air traffic, aeronautical frequency band is getting saturated, and thus may causes the interference in the congested frequency band. In this paper, an efficient aeronautical frequency allotment and management policies are proposed for resolving the existing problems in the aeronautical frequency band. The key activities include the review of the aeronautical frequency management and interference mitigation policies in a few important foreign countries such as United States and Japan. This policy study will be contributed for the future air safety in the aeronautical frequency management point of view.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• v.9 no.2
• /
• pp.200-203
• /
• 2005

Most of electrical fires are caused by short circuits, overheating of wires, deterioration and incomplete connection of wiring devices. The last two cases are predictable before the occurrence of fire because of its slow progress. In this paper, we have simulated the discharge signals caused by the deterioration and incomplete connection of wiring devices using an aged concent to provide information on the characteristics of discharge signals. From the experimental data, we could characterize the frequency spectrums of the discharge signals depending on the cases. The higher frequency components of the signal are attenuated by the capacitance and inductance of power lines as the measuring point is getting away from the discharges. Main frequency components of the discharge signal are existent at 600 kHz - 1.5 MHz in incomplete connections and at 210 kHz - 8 Mhz in deteriorations of the concent.

• Archives of design research
• /
• v.12 no.4
• /
• pp.139-147
• /
• 1999

There are numerous possible approaches to an investigation of the evolution of modern design. the intent of this study is to inquire into the history of 20th-century design as modern project. The French Revolution and the Industrial revolution at the end of 18th century brought about a wide spectrum of social and economic changes in Europe. The bourgeoisie took the leading part in these reforms and they attempted to establish the new aesthetic value of items of everyday use. The turning point in history led to the advent of modern design. This study attempts to provide a conceptual overview of significant stags in modern design's development this paper, it is hoped, will provide an opportunity to place modern design in a social and aesthetic context.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.11a
• /
• pp.120-123
• /
• 2003

The ZnSe epilayers were grown on the GaAs substrate by hot wall epitaxy. After the ZnSe epilayers treated in the vacuum-, Zn-, and Se-atmosphere, respectively, the defects of the epilayer were investigated by means of the low-temperature photoluminescence measurement. The dominant peaks at 2.7988 eV and 2.7937 eV obtained from the PL spectrum of the as-grown ZnSe epilayer were found to be consistent with the upper and the lower polariton peak of the exciton, $I_2$ ($D^{\circ}$, X), bounded to the neutral donor associated with the Se-vacancy. This donor-impurity binding energy was calculated to be 25.3 meV. The exciton peak, $I_1^d$, at 2.7812 eV was confirmed to be bound to the neutral acceptor corresponded with the Zn-vacancy. The $I_1^d$ peak was dominantly observed in the ZnSe/GaAs:Se epilayer treated in the Se-atmosphere. This Se-atmosphere treatment may convert the ZnSe/GaAs:Se epilayer into the p-type. The SA peak was found to be related to a complex donor like a $(V_{Se}-V_{Zn})-V_{Zn}$.

• Proceedings of the KIEE Conference
• /
• 2003.11c
• /
• pp.878-881
• /
• 2003

To acquire an appointed speaker's clear voice signal from inspect-camera, picture-conference or hands free microphone eliminating interference noises needs to be preceded speaker's position automatically. Presumption of sound source position's basic algorithm is about measuring TDOA(Time Difference Of Arrival) from reaching same signals between two microphones. This main project uses ADF(Adaptive Delay Filter) [4] and CPS(Cross Power Spectrum) [5] which are one of the most important analysis of TDOA. From these analysis this project proposes presumption of real time sound source position and improved model NI-ADF which makes possible to presume both directions of sound source position. NI-ADF noticed that if auditory sense of humankind reaches above to some specified level in specified frequency, it will accept sound through activated nerve. NI-ADF also proposes practicable algorithm, the presumption of real time sound source position including both directions, that when microphone loads to some specified system, it will use sounds level difference from external system related to sounds of diffraction phenomenon. In accordance with the project, when existing both direction adaptation filter's algorithm measures sound source, it increases more than twice number by measuring one way. Preserving this weak point, this project proposes improved algorithm to presume real time in both directions.

• Nuclear Engineering and Technology
• /
• v.50 no.3
• /
• pp.462-469
• /
• 2018

The background spectrum of a $3^{{\prime}{\prime}}{\times}3^{{\prime}{\prime}}$ NaI(Tl) well-type scintillation SILENA detector was measured without shielding, in 6 cm thick lead shielding, and with 2 mm thick electrolytic copper covering the detector inside the lead shielding. The relative remaining background of the lead shield lined with copper was found to be ideal for low-level environmental radioactive spectroscopy. The background total count rate in the (20-2160 KeV) was reduced 28.7 times by the lead and 29 times by the Cu + Pb shielding. The effective reduction of background (1.04) by the copper mainly appeared in the energy range from X-ray up to 500 KeV, while for the total energy range the ratio is 1.01 relative to the lead only. In addition, a strong relation between the full-energy peak absolute efficiency and the detector well height was found using gamma-ray isotropic radiation point sources placed inside the detector well. The full-energy peak efficiency at a midpoint of the well (at 2.5 cm) is three times greater than that on the detector surface. The energy calibrations and the resolution of any single energy line are independent of the locations of the gamma source inside or outside of the well.

• Applied Chemistry for Engineering
• /
• v.16 no.6
• /
• pp.755-759
• /
• 2005

This study was based on organic electroluminescence display. Especially, DPAVBi, AVBi and DPVBi for the emitting materials were synthesized by Wittig, Wittig-Horner reaction. This reaction was conducted between phosphorous ylide and 4-(diphenylamino)benzaldehyde, 9-anthraldehyde and benzophenone. The structural property of reaction products were analyzed by FT-IR, $^1H-NMR$ spectroscopy and thermal stability, reactivity and PL property were analyzed by melting point, yield and emission spectrum, respectvely. The photoluminescence spectra of a pure DPAVBi, AVBi and DPVBi were observed at approximately 445nm, 484nm and 450nm, respectively. In this study, it was known that DPAVBi, AVBi, DPVBi had a different reaction properties according to stability of ${\alpha}$-position carbonyl group of the aldehyde, ketone.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.16 no.1
• /
• pp.85-100
• /
• 1991

In the discussion of digital mobile communication systems the speech coder based on the high quality low bit rate is an essential part of topics to overcome the limited availability of radio spectrum, which will enhance the communication services. In this paper we present the implementation and performance evaluation of 13kbps RPE LTP speech coder. An implementation of a real time full duplex coder with 75% of DSP loading rate using a single DSP chip has been shown, and also the fixed point simulations for H/W implementation has been performed. Finally, analysis result for relative bit importance of each transmitting parameter has been shown for channel coding.

• Advances in concrete construction
• /
• v.10 no.3
• /
• pp.271-278
• /
• 2020

Quantifying the amount of damage of structures under earthquakes is an interesting issue that researchers have attended on and have presented some damage indices. Whereas a lot of damage indices have been introduced based on nonlinear dynamic analysis, computational effort, the calculus complicacy and time-consuming of this analysis are the main drawbacks to widespread use of these indices. The objective of this study is to quantify the damage of Shear Wall Reinforced Concrete Frames (SWRCFs) based on pushover analysis as a procedure that can reflect the behavior of structures from elastic to collapse. For this purpose, firstly, several SWRCFs are designed and the capacity spectrum of each one is achieved via pushover analysis. After that, the static damage indices of the designed frames are obtained. Then, nonlinear dynamic analyses are performed on these frames and the Park and Ang damage index as the basis damage criterion is achieved. Afterward, some relations are presented to predict the dynamic damage of these frames via pushover analysis. Eventually, to confirm the validity of the proposed relations, the values of Park and Ang damage index of three new SWRCFs are acquired once utilizing nonlinear dynamic analysis and again applying the introduced relations. Outcomes prove the validity of some presented damage indices.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.11 no.5
• /
• pp.921-925
• /
• 2007

This paper investigates the information related to the radiated sounds during treatment using the extracorporeal shock wave lothotriptor(ESWL). First, we observe the vibration of the objects from the radiated sounds and extract the information about the change of the peak frequency from the relation between the vibration and the radiated sounds. Next, we observe the change of the peak frequency according to the position of the focus and demonstrate that it is more difficult to vibrate objects exactly at the focal point than above or below the focus of the ESWL device. Lastly, we analyze the relation between the cavitation and the radiated sounds and examine the benefiting condition for the object fragmentation.