• Journal of IKEEE
• /
• v.25 no.1
• /
• pp.32-36
• /
• 2021

This paper presents a novel collided tag signals's periodic characteristic based radio frequency identification (RFID) tag collision detection method for the ultra high frequency (UHF) RFID. The proposed method utilizes that periodicity of tag signals is maintained even under tag collision. In the proposed method, the correlation between received signal and reference edge signal is used. Simulation result shows that the detection performance using the proposed method is about 10 dB better than that of existing method. In addition, the detection performances with different magnitude difference, phase difference, delay, number of tags are analyzed.

• Proceedings of the KIEE Conference
• /
• 1995.07b
• /
• pp.817-819
• /
• 1995

Applied by periodic Stimulating Currents in Bonhoeffer-Van der Pol(BVP) model, chaotic and periodic phenomena occured at specific conditions. The conditions of the chaotic motion in BVP comprised 0.7182< $A_{1}$ <0.792 and 1.09< $A_{1}$ <1.302 proved by the analysis of phase plane, bifurcation diagram, and lyapunov exponent. To control the chaotic motion, two methods were suggested by the first used the amplitude parameter $A_{1}$,$A_{1}={\varepsilon}((x-x_{s})-(y-y_{s}))$ and the second used the temperature parameter c, c=c$(1+ {\eta}cos{\Omega}t)$ which the values of $\eta$, ${\Omega}$ varied respectlvly, and $x_{s}$, $y_{s}$ are the periodic signal. As a result of simulating these methods, the chaotic phenomena was controlled with the periodic motion of periodisity. The feasibilities of the chaotic and the periodic phenomena were analysed by phase plane and lyapunov exponent.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2002.11b
• /
• pp.623-629
• /
• 2002

The spectrum of impulse response signal from an impulse hammer testing is widely used to obtain frequency response function(FRF) of the structure. However the FRFs obtained from impact hammer testing have not only leakage errors but also finite record length errors when the record length for the signal processing is not sufficiently long. The errors cannot be removed with the conventional signal analyzer which treats the signals as if they are always steady and periodic. Since the response signals generated by the impact hammer are transient and have damping, they are undoubtedly non-periodic. It is inevitable that the signals be acquired for limited recording time, which causes the finite record length error and the leakage error. In this paper, the errors in the frequency response function of multi degree of freedom system are formulated theoretically. And the method to remove these errors is also suggested. This method is based on the optimization technique. A numerical example of 3-dof model shows the validity of the proposed method.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.12 no.10
• /
• pp.792-798
• /
• 2002

The spectrum of impulse response signal from an impulse hammer testing is widely used to obtain frequency response function (FRF) of the structure. However the FRFs obtained from impact hammer testing have not only leakage errors but also finite record length errors when the record length for the signal processing is not sufficiently long. The errors cannot be removed with the conventional signal analyzer which treats the signals as if they are always steady and periodic. Since the response signals generated by the impact hammer are transient and have damping, they are undoubtedly non-periodic. It is inevitable that the signals be acquired for limited recording time, which causes the finite record length error and the leakage error. In this paper, the errors in the frequency response function of multi degree of freedom system are formulated theoretically. And the method to remove these errors is also suggested. This method is based on the optimization technique. A numerical example of 3-dof model shows the validity of the proposed method.

• Journal of Institute of Control, Robotics and Systems
• /
• v.12 no.2
• /
• pp.101-105
• /
• 2006

Disk radial runout creates a periodic relative motion between the laser beam spot and tracks formed on an optical disk. While only focus control is activated, the periodic relative motion yields sinusoid-like waves in the tracking error signal, where one cycle of the sinusoid-like waves corresponds to one track. The frequency of the sinusoid-like waves varies depending on the disk rotational speed and the amount of the disk radial runout. If the frequency of the tracking error signal in the off-track state is too high due to large radial runout of the disk, it is not a simple matter to begin track-following control stably. It might take a long time to reach a steady state or tracking control might fail to reach a stable steady state in the worst case. This article proposes a simple method for reducing the relative motion caused by the disk radial runout in the off-track state. The relative motion in the off-track state is effectively reduced by a drive input obtained through measurements of the tracking error signal and simple calculations based on the measurements, which helps reduce the transient response time of the track-following control. The validity of the proposed method is verified through an experiment using an optical disk drive.

• 제어로봇시스템학회:학술대회논문집
• /
• 2003.10a
• /
• pp.1648-1653
• /
• 2003

The paper studies effect of quasi-periodic or airplane flutter phenomenon on television broadcasting signal. Airplane flutter is a very important problem. It causes the receiving antenna to receive both direct signal by the Tx (Transmitter antenna) and reflected signal scattered by the airplane with phase delay. The sum of two signals results in fading, sometime collapse and distortion of picture on TV screen. We performed measurement and modeling this phenomenon on TV signal when the airplane flew across and range Tx and Rx (Receiver antenna). The frequency 60.75MHz (Aural frequency of CH3) is used under tests. A single scatter multipath model is introduced. It is used to duplicate some of the measured data and show the dependence of power variation on the airplane fluttering. The fluctuation of the airplane flutter phenomenon was calculated to be around 2-4dB. The Yaki antenna is used for improving airplane flutter problem because it can make high gain and high directivity.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.4 no.5
• /
• pp.963-969
• /
• 2000

In this paper, we define two input-output gains of linear periodic time-varying systems. One is the ratio of output with worst-case l2-norm over all inputs with unit 12-norm. It denotes G($\iota_2,\iota_2$.The other is the ratio of output with worst-case RMS value over all inputs with unit RMS value. It denotes G(RMS, RMS) .It is fact that these two gains are equivalent for linear time-invariant system. In this paper, we prove these two gains are also equivalent for linear periodic time-varying system. In addition, the relationship between two method of obtaining the generalized frequency responses for linear periodic time-varying system is derived. Finally, we apply the defined input-output gains to M-channel filter-bank which is multi-rate signal Processing system, used to speech coding. In the filter-bank, generally, aliasing distortion, magnitude distortion, and phase distortion are present. It is shown that these are kept small if the filter-bank is designed by a method that optimizes the gain G($\iota_2,\iota_2$ of an error system.

• Journal of the Institute of Convergence Signal Processing
• /
• v.5 no.1
• /
• pp.73-78
• /
• 2004

There are random, continuous, and periodic allocation methods in the time slot sequence integrity for the multi-slot call. In the T-S-T switch, there are 2 time switch and the 2*2 space switch. Three time-slot allocation methods are suggested for the simulation. In the simulation, the searching times for time-slots on a multi-slot call is chosen to 32, and the simulation time is chosen to 100,000 seconds. Three kinds of calls are supposed for a multi-slot call : one time-slot call, two time-slot call, and 6 time-slot call. In the simulation, the carried traffic and the blocking probability are calculated on the 3 different traffic cases of 8:1:1, 6:2:2, 4:3:3(one time-slot : two time-slot : 6 time-slot) multi slot calls. It is shown that the blocking probability for the periodic time slot allocation method is best. As a result, the periodic time-slot allocation method is the proper one for the multi-slot ATM switch.

• Journal of the Institute of Convergence Signal Processing
• /
• v.9 no.1
• /
• pp.82-88
• /
• 2008

In this paper, Runge-Kutta (RK)-Butcher algorithm is proposed to study the periodic and oscillatory problems. Simulation results obtained using RK-Butcher algorithms and the classical fourth order Runge-Kutta (RK(4)) methods are compared with the exact solutions of a few periodic and oscillatory problems to confirm the performance of the proposed algorithm. The simulation results from RK-Butcher algorithms are always found to be very close to the exact solutions of these problems. Further, it is found that the RK-Butcher algorithm is superior when compared to RK(4) methods in terms of accuracy. The RK-Butcher algorithm can be easily implemented in a programming language and a more accurate solution may be obtained for any length of time. RK-Butcher algorithm is applicable as a good numerical algorithm for studying the problems of orbit and two body as it gives the nearly identical solutions.

• Journal of Advanced Navigation Technology
• /
• v.26 no.6
• /
• pp.474-480
• /
• 2022

Optical phase conjugation is one of techniques capable of compensating for distortion due to chromatic dispersion and nonlinearity, which are essential for long-distance transmission of wavelength division multiplexed (WDM) signal. We proposed and analyzed a way to solve the limitations of this technology through dispersion map with periodic dispersion profile. In the proposed system, optical phase conjugator (OPC) is placed at the position of 1:2 or 2:1 of the entire link, and the dispersion profile of dispersion map has periodic shape in the form of a sine wave or an inverse-sine wave. It was confirmed that the effective compensation of the distorted 960 Gb/s WDM signal was further improved through the proposed periodic dispersion map when the OPC was located at the 1:2 point instead of the 2:1 point of the entire link. In addition, it was found that the maximum RDPS allocated to fiber span should be 1,800 ps/nm or more in order to increase the design flexibility of dispersion-managed link with the proposed periodic dispersion map.