• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.26 no.12
• /
• pp.68-73
• /
• 2012

In this paper, the fault current limiting characteristics of a flux-lock type superconducting fault current limiter (SFCL) with peak current limiting function were analyzed through its short-circuit tests. The setting condition for the peak current limiting operation was derived from its electrical equivalent circuit, which was dependent on the inductance ratio between the third coil and the first coil. Through the analysis on the short-circuit tests for the flux-lock type SFCLs with the different inductance ratio between the third coil and the first coil, the setting value for the peak current limiting operation of the flux-lock type SFCL with peak current limiting function could be confirmed to be adjusted with the variation of the inductance ratio between the third coil and the first coil.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.26 no.11
• /
• pp.75-80
• /
• 2012

In this paper, the operational characteristics due to the introduction of the superconducting fault current limiter(SFCL) with a peak current limiting function were analyzed in the power distribution system. The parallel structure of the superconducting element can operate the peak current limiting function depending on the transient amplitude of fault current. We studied the operating characteristics of the introduction of the SFCL with a peak current limiting function in the power distribution system. Furthermore, we were analyzed between the SFCL with a peak current limiting function and the protection devices in the power distribution system, through the short circuit experiments.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.13 no.4
• /
• pp.673-682
• /
• 2010

This paper describes and analyzes a various generation methods of the mutually orthogonal polyphase sequences with low cross-correlation peak sidelobe and low autocorrelation peak sidelobe levels. The mutual orthogonality is the key requirement of multi-static or MIMO(Multi-Input Multi-Output) radar systems which provides the good target detection and tracking performance. The polyphase sequences, which are generated by SA(Simulated Annealing) and GA(Genetic Algorithm), have been analyzed with ACF(Autocorrelation Function) PSL(Peak Sidelobe Level) and CCF(Crosscorrelation Function) level at the matched filter output. Also, the ambiguity function has been introduced and simulated for comparing Doppler properties of each sequence. We have suggested the phase selection rule for applying multi-static or MIMO systems.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.17 no.4
• /
• pp.38-44
• /
• 1980

We present a high speed pitch estimation algorithm that is based on peak detection and average magnitude difference function (AMDF). A few pitch candidates are first estimated from the low-pass filtered (800 Hz) speech by a peak detection algorithm. AMDF values of the pitch candidatestare then calculated, and the pitch candidate that yields the minimum AMDF value is chosen as the desired pitch period. The new method requires far less computation time than other pitch estimation algorithms, while it yields fairly accurate results.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.24 no.1
• /
• pp.47-51
• /
• 2011

The superconducting fault current limiter (SFCL) with a peak current limiting function according to the initial fault current with the different amplitudes was suggested. The proposed SFCL, which consists of two limiting components, causes only the first superconducting element among two limiting components to be quenched in case that the initial fault current with the lower peak amplitude happens. On the other hand, the initial fault current with the higher peak amplitude makes both the superconducting elements of two limiting components to be quenched, which contributes to the peak current limiting function of the SFCL. To confirm the fault current limiting operation of the proposed SFCL, the short-circuit tests of the SFCL according to the fault angle were carried out and its effective fault current limiting operations could be discussed.

• Journal of the Korean Mathematical Society
• /
• v.33 no.2
• /
• pp.399-411
• /
• 1996

Let $\Omega$ be a smoothly bounded pseudoconvex domain in $C^n$ and let $A(\Omega)$ denote the functions holomorphic on $\Omega$ and continuous on $\bar{\Omega}$. A point $p \in b\Omega$ is a peak point if there is a function $f \in A(\Omega)$ such that $f(p) = 1, and $\mid$f(z)$\mid$ < 1 for z \in \bar{\Omega} - {p}$.

• Bulletin of the Korean Chemical Society
• /
• v.33 no.10
• /
• pp.3391-3396
• /
• 2012

Two-dimensional infrared (2D-IR) spectroscopy can probe the fast structural evolution of molecules under thermal equilibrium. Vibrational frequency fluctuation caused by structural evolution produced the time-dependent line shape change in 2D-IR spectrum. A variety of methods has been used to connect the evolution of 2D-IR spectrum with Frequency-Frequency Correlation Function (FFCF), which connects the experimental observables to a molecular level description. Here, a new method to extract FFCF from 2D-IR spectra is described. The experimental observable is the time-dependent frequency shift of maximum peak position in the slice spectrum of 2D-IR, which is taken along the excitation frequency axis. The direct relation between the 2D-IR peak shift and FFCF is proved analytically. Observing the 2D-IR peak shift does not need the full 2D-IR spectrum which covers 0-1 and 1-2 bands. Thus data collection time to determine FFCF can be reduced significantly, which helps the detection of transient species.

• Journal of Institute of Control, Robotics and Systems
• /
• v.15 no.11
• /
• pp.1071-1075
• /
• 2009

This article describes a robust control method by using peak control of a sensitivity function in the state-feedback control systems. This method apparently reduces the peak, and as a result makes closed loop systems more stable. The designed closed loop systems also make the response to an external step disturbance more fast with a lower undershoot. At the conclusion, it is verified that the proposed method enhances robust stability and robust performance to parametric uncertainties through $\mu$-plot.

• PNF and Movement
• /
• v.8 no.3
• /
• pp.9-16
• /
• 2010

Purpose : The purpose of this study was to investigate effects of kinesio taping of thigh muscle on isokinetic muscular function during closed kinetic chain exercise of lower extremity. Methods : Twenty healthy males were participated in this study. The isokinetic muscular function of closed kinetic chain were measured for peak torque, peak torque % body weight, average power, max rep tot work before and after application of kinesio taping on thigh muscles. Results : At $60^{\circ}/s$ peak force and peak force % body weight were significant increased in both extension(p<0.01) and flexion(p<0.001) after applying kinesio taping. At $180^{\circ}/s$ average power was significant increased in both extension and flexion after applying taping(p<0.001). At $240^{\circ}/s$ max rep tot work was significant increased in both extension(p<0.001) and flexion(p<0.05). Conclusion : This study suggests that application of kinesio taping on thigh muscle was more effective to improve isokinetic muscular function in closed kinetic chain exercise of lower extremity.

• Journal of Korean Academy of Nursing
• /
• v.39 no.4
• /
• pp.584-593
• /
• 2009

Purpose: The purpose of this study was to investigate the effect of stretching, muscle strengthening, and walking exercise on the cardiopulmonary function and health-related quality of life in hemodialysis patients. Methods: Twenty-one patients in the intervention and the control group participated in the exercise respectively on maintenance hemodialysis at four university hospitals. The exercise was composed of 20 to 60 min per session, 3 sessions a week for 12 weeks. The effect of exercise was assessed by cardiopulmonary function (peak oxygen uptake, peak ventilation, peak respiration rate, maximal heart rate, and exercise duration) using a cycle ergometer. Grip strength was measured by dynamometer, and flexibility was measured by sit and reach measuring instrument. Health-related quality of life was measured using Medical Outcomes Study Short Form-36. Results: Peak oxygen uptake, peak ventilation, peak respiration rate, exercise duration, grip strength, flexibility, and physical component scale were significantly improved in the intervention group after 12 week's exercise compared to the control group. Conclusion: These findings indicate the exercise can improve cardiopulmonary function, grip strength, flexibility, and physical component scale of health-related quality of life in hemodialysis patients.