• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.11C
• /
• pp.1076-1084
• /
• 2009

We propose an ATI (Adaptive Tone Injection) scheme based on clipping noise for PAPR (Peak-to-Average Power Ratio) reduction of OFDM (Orthogonal Frequency Division Multiplexing) signals. The proposed scheme is composed of three steps: clipping, tone selection, and TI procedures. In the first step, the peak samples in the IFFT (Inverse Fast Fourier Transform) outputs are scaled down by clipping. In the second step, the sub-carrier position where the power of the clipping noise is the maximum, is selected. Finally, the generic TI procedure is performed. Simulation results show that the proposed scheme does not require all the possible combinations of the original TI procedures, while maintaining the PAPR reduction performance.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2013.10a
• /
• pp.343-345
• /
• 2013

This paper describes a phase-locked loop (PLL) that generates a 51-phase clock with the operating frequency of 125MHz. To generate 51-phase clock with a frequency of 125 MHz, the proposed PLL uses three voltage controlled oscillators (VCOs) which are connected by resistors. Each VCO consists of 17 delay-cells. An resistor averaging scheme, which makes three VCOs to connect with each other, makes it possible to generates 51-phase clock of the same phase difference. The proposed PLL is designed by using 65 nm CMOS process with a 1.0 V supply. At the operating frequency of 125 MHz, the simulated DNL and peak-to-peak jitter are +0.0016/-0.0020 LSB and 1.07 ps, respectively. The area and power consumption of the implemented PLL are $290{\times}260{\mu}m^2$ and 2.5 mW, respectively.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.4
• /
• pp.379-386
• /
• 2004

OFDM(orthogonal frequency division multiplexing) communications system is very attractive for the high data rate transmissionin the frequency selective fading channel. Since OFDM has high PAPR(peak-to-average power ratio), OFDM signal may be distorted by the nonlinear HPA(high power amplifier). In this paper, we propose an improved dummy sequence scheme for reducing the PAPR in OFDM communication system. This method inserts each different dummy sequence at the predefined sub-carriers fur PAPR reduction. After IFFT, the OFDM data signal with the lowest PAPR is selected to transmit. The complementary sequence is used as dummy sequence. So, it can cut down the computation time and quantity because it dose not require the peak value optimization for finding the phase rotation factor and the transmission of the side information about the rotation factor unlike the PTS method.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.14 no.5
• /
• pp.817-824
• /
• 2019

We propose an ATR (Adaptive Tone Reservation) scheme based on clipping noise for PAPR (Peak-to-Average Power Ratio) reduction of OFDM (Orthogonal Frequency Division Multiplexing) signals. The proposed scheme is composed of three steps: clipping, tone selection, and TR procedures. In the first step, the peak samples in the IFFT (Inverse Fast Fourier Transform) outputs are scaled down by clipping. In the second step, the sub-carrier position where the power of the clipping noise is the maximum, is selected. Finally, the generic TR procedure is performed. Simulation results show that the proposed scheme does not require all the possible combinations for the original TR procedures, while maintaining the PAPR reduction performance.

• Proceedings of the IEEK Conference
• /
• 2005.11a
• /
• pp.185-188
• /
• 2005

This paper proposes a new peak-windowing algorithm with window-length adaptation for peak-to-average power reduction (PAPR) of orthogonal frequency division multiplexing (OFDM) systems. Conventional peak windowing algorithm has advantages, such as moderate system complexity with good spectral shape. However, adjacent peak signals within the length of window functions produce the distortion of signal amplitude since window functions might overap with each other. These undesired characteristics of conventional peak windowing algorithm result in the degradation of BER performance. The proposed algorithm outperforms the conventional one with the aid of window-length adaptation. Simulation results show the efficiency of the proposed algorithm under the environments of WiBro downlink systems.

• Journal of Environmental Science International
• /
• v.11 no.10
• /
• pp.1081-1087
• /
• 2002

This study was performed to research the characteristics of suspended particulate for Yellow Sand of January, 1999 in Busan. Yellow Sand frequency during 13 years(1988~2000) in Busan showed maximum in April(57%), next to March(21%), May(16%). According to result of 850hPa weather map and backward isentropic trajectory, this event originated from the Gobi Desert and the Loess Plateau of China. And three mode was found in time series of TSP and PM10 concentration, primary peak showed the maximum hourly concentration at ali station. Gamjeondong as industrial site showed the highest TSP concentration and also had the longest high concentration($geq700\mu\textrm{g}/m^3$). In PM10, concentration of primary peak showed maximum value at Yeonsandong, maximum concentration of secondary and third peak was Deokcheondong. Lasted time from primary peak to secondary peak was about 30 hours, between secondary peak and third peak was 18 hours in Busan, The traveling time between occurrence of Yellow Sand the finding of it was 8~9 hours in Busan and 4~5 hours in central area.

• Journal of Korean Society of Transportation
• /
• v.21 no.6
• /
• pp.27-42
• /
• 2003

The basis for planning airport development is the specific demand at peak hour among various aviation demands. The demand at peak hour is regarded to be the source which enables us to estimate the size requirement and capacity of an airport facility. The distribution type of peak hour-operation depends on the difference of aircraft route, geographical location of airport, passengers and cargo. The demand at peak hour is calculated with peak hour factor. So far, the features of peak hour adopted for domestic airport construction plan have been based on the foreign research results. However, it is officially unconfirmed whether the various peak hour characteristics or peak hour factor suggested from foreign studies can be compatible with Korean state or not. In this study, the aircraft operation pattern and the peak hour characteristics are analyzed with hourly data using the operation schedule of an airport for the last 5 years and the actual result statistics of Korean air transportation by airport through the recent 10 Years. After the peak hour factor of the airports is calculated and compared with existing research results, peak hour factor by annual operation frequency is suggested for Korean airports.

• Journal of Korea Water Resources Association
• /
• v.42 no.9
• /
• pp.725-736
• /
• 2009

A flood event can be defined by three characteristics; peak discharge, total flood volume, and flood duration, which are correlated each other. However, a conventional flood frequency analysis for the hydrological plan, design, and operation has focused on evaluating only the amount of peak discharge. The interpretation of this univariate flood frequency analysis has a limitation in describing the complex probability behavior of flood events. This study proposed a bivariate flood frequency analysis using a Gumbel mixed model for the flood evaluation. A time series of annual flood events was extracted from observations of inflow to the Soyang River Dam and the Daechung Dam, respectively. The joint probability distribution and return period were derived from the relationship between the amount of peak discharge and the total volume of flood runoff. The applicability of the Gumbel mixed model was tested by comparing the return periods acquired from the proposed bivariate analysis and the conventional univariate analysis.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.2C
• /
• pp.203-209
• /
• 2010

In this paper, we propose a new selected mapping (SLM) scheme for reducing peak to average power ratio (PAPR) of orthogonal frequency division multiplexing (OFDM) signals modulated with quadrature amplitude modulation (QAM), called amplitude and phase variant SLM (APSLM). Contrary to the conventional SLM which rotates the phases of QAM symbols in the frequency domain, the proposed scheme changes the magnitudes as well as the phases of QAM symbols by applying binary sequences to the binary data sequence before mapped to QAM symbols. Simulation results show that the proposed scheme has better PAPR reduction performance than the conventional SLM scheme for the QAM modulated OFDM signals, especially for the small number of subcarriers.

• Journal of Advanced Navigation Technology
• /
• v.25 no.1
• /
• pp.90-95
• /
• 2021

In this paper, the design method for a high-sensitivity compact resonator for chipless RFID tags is proposed. Proposed high-sensitivity compact resonator uses an interdigital-capacitor structure instead of a capacitor-shaped strip structure in a conventional ELC resonator. The length of the electrode plate of the IDC structure is longer than that of the conventional capacitor-shaped structure, resulting in a larger equivalent capacitance of the resonator. This can lower the resonant peak frequency of the RCS characteristic. Two resonators with the same length of the square loop and the width of the strip are fabricated on an RF-301 substrate with a thickness of 0.8 mm. The experiment results show that the resonant peak frequency and value of the bistatic RCS for the ELC resonator were 4.305 GHz and -30.39 dBsm, whereas those of the proposed IDC resonator were 3.295 GHz and -36.91 dBsm. Therefore, the size of the resonator is reduced by 23.5% based on the measured resonant peak frequency of the RCS characteristic.