• Journal of the Korean Society for Aviation and Aeronautics
• /
• v.22 no.1
• /
• pp.7-14
• /
• 2014

This paper deals with recent research cases and directions of Fly-By-Wireless (FBWLS) flight control technology. FBWLS is a new type of flight control system technology with the aim of solving the problems mainly caused by the increasing amount of wires in aircraft to which Fly-By-Wire (FBW) technology applies. Therefore, in FBWLS flight control system the wired communication system is replaced with a wireless communication system. Currently the FBWLS flight control technology is at an initial development stage and thus this paper surveys deals with the cases in the viewpoint of technology feasibility. In this context, this paper analyzes technology that needs further studies to secure the reliability, stability and accuracy to the similar level of the corresponding FBW system. Since the major problems of FBWLS technology are packet losses and time delays so that this paper suggests the research direction of wireless communication protocol selection, optimization of wireless communication network and controller design considered communication environment.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.7 no.5
• /
• pp.983-989
• /
• 2012

IEEE 802.3az LPI mechanism allows an Ethernet link to reduce power consumption by entering a low-power sleeping mode and letting some components being powered off when there is no data to be transmitted through the link. However, if small amount of packets are being sent periodically, such a mechanism can not obtain energy efficiency due to a high overhead caused by excessive mode transitions. In this paper, we propose an enhanced LPI mechanism which can perform state transition adaptively based on the traffic characteristics on transport layer and network status. This simulation result shows that proposed mechanism improves energy efficiency than LPI mechanism with respect to energy consumption rate for various traffic loads.

• The Journal of the Korea Contents Association
• /
• v.5 no.1
• /
• pp.73-79
• /
• 2005

Recent advances on wireless technology are enabling the design and deployment of real-time traffic in wireless LAN. Point Coordination Function (PCF) mode of Wireless LAN is defined to provide QoS of real time traffic, such as voice, video in wireless LANs. The service polling scheduling plays an important role in real-time traffic services of wireless LAN. This paper proposes a multicast polling scheme to increase the maximum number of conversations by reducing the amount of empty polls in IEEE 802.11 PCF mode. Our simulation studies show that our scheme may improve performance of the PCF in terms of the average transfer delay and packet discard ratio.

• Journal of the Korean Professional Engineers Association
• /
• v.34 no.4
• /
• pp.41-47
• /
• 2001

The paper describes SR3 (Synchronous Round Robin with Reservations), a collision-free medium access control protocol for all-optical slotted packet networks based on WDM multi-channel ring topologies where nodes are equipped with one fixed-wavelength receiver and one wavelength-tunable transmitter SR3 is derived from the SRR and MMR protocols previously proposed by the same authors for the same class of all-optical networks. SRR and MMR already achieve an efficient exploitation of the available bandwidth, while guaranteeing a throughput-fair access to each node. SR3, In addition, allows nodes to reserve slots. thereby achieving a stronger control on access delays; it is thus well suited to meet tight delay requirements, as it is the case for multimedia applications. Simulation results show that SR3 provides very good performance to guaranteed qualify traffic, but also brings signigicant performance improvements for best-effort traffic. Energy effciency is an important issue for optical network since they must rely on their batteries. We present a novel MAC protocol that achieves a good energy efficiency of optical interface of the network and provides support for diverse traffic types and QoS. The scheduler of the base station is responsible to provide the required QoS to connections on the optical link and to minimise the amount of energy spend by the High speed Network. The main principles of the MaC protocol are to avoid unsuccessful actions, minimise the number of transitions , and synchronise the mobile and the base-station. We will show that considerable amounts of energy can be saved using these principles.

• Journal of KIISE:Information Networking
• /
• v.28 no.2
• /
• pp.236-241
• /
• 2001

A new scheme is proposed to speed up a known bandwidth measuring method which employs potential bandwidth for filtering out noiscs (in cstirna60nl from time compression caused by a packet queueing ahead of two probe packets. Instead of inerementing the potential bandwidth by a fixed amount as in the original method we increase the potential bandwidth exponentially for faster convergence. To retain its filtering capability as well as its agility to adapt to new bottleneck bandwidth, each trial potential bandwidth(PB) is adjusted using MAX and MIN as upper bound and lower bound. An experiment using known bandwidths shows 45~g9% improvement in conVergence time.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.2
• /
• pp.127-137
• /
• 2015

Various services such as IPTV(Internet Protocol TV), Internet Telephony are provided through multiple ISPs(Internet Service Providers) as ICT technologies are evolving. This paper suggests that the end-to-end Internet service quality evaluation method, which is optimized for domestic environment based on international standards. The end-to-end service quality determines the quality of IPTV and Internet Telephony services and is critical factor for subjective quality as well. As a result, time delay, jitter and packet loss rate are three elements for the quality evaluation. It is also shown that these factors can be predicted with traditional statistical method by sharing minimum amount of information between ISPs.

• Journal of Communications and Networks
• /
• v.7 no.4
• /
• pp.489-498
• /
• 2005

For better performance over a noisy channel, mobile wireless networks transmit packets with forward error correction (FEC) code to recover corrupt bits without retransmission. The static determination of the FEC code size, however, degrades their performance since the evaluation of the underlying channel state is hardly accurate and even widely varied. Our measurements over a wireless sensor network, for example, show that the average bit error rate (BER) per second or per minute continuously changes from 0 up to $10^{-3}$. Under this environment, wireless networks waste their bandwidth since they can't deterministically select the appropriate size of FEC code matching to the fluctuating channel BER. This paper proposes an adaptive FEC technique called adaptive FEC code control (AFECCC), which dynamically tunes the amount of FEC code per packet based on the arrival of acknowl­edgement packets without any specific information such as signal to noise ratio (SNR) or BER from receivers. Our simulation experiments indicate that AFECCC performs better than any static FEC algorithm and some conventional dynamic hybrid FEC/ARQ algorithms when wireless channels are modeled with two-state Markov chain, chaotic map, and traces collected from real sensor networks. Finally, AFECCC implemented in sensor motes achieves better performance than any static FEC algorithm.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.9B
• /
• pp.604-611
• /
• 2007

In this paper, we present an analysis of the throughput when there are multiple piconets and WLAN sharing the ISM bands. The analysis takes channel propagation characteristics and the capture effect. We also propose an algorithm which can be used to reduce the amount of channel scanning. By using traffic prediction of the interfering WLAN, we are able to maintain a reasonable performance in terms of fraction of time channel is wasted due to collisions or unused channel. Through computer simulation, we demonstrate that the proposed algorithm achieves reduced scanning frequency.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.20 no.2
• /
• pp.29-37
• /
• 2020

Conventional firewalls cannot cope with attacks immediately. It is because security professionals or administrators need to analyze them and enter relevant policies to the firewalls. In addition, those policies may often block even normal accesses. Even though the packet themselves are normal, there exist many attacks that cause denial of service due to the inflow of a large amount of those packets. In this paper, we propose a method to block attacks such as Flooding, Spoofing and Scanning while allowing normal accesses based on whitelist policies which are automatedly generated by learning normal access patterns.

• Journal of KIISE
• /
• v.45 no.3
• /
• pp.195-199
• /
• 2018

Recently, with increasing scale of internet of Things (IoT), a large amount of data are generated and various services using such data are emerging. Therefore, a protocol suitable for IoT environment that can efficiently process / transmit big data is needed. MQTT is a lightweight messaging protocol for IoT environment. Although MQTT protocol can use TLS to provide security, it has a problem in that handshake and packet overhead will increase when TLS is used. Therefore, this paper proposed as Secure_MQTT protocol. It can provide stronger security by using lightweight encryption algorithm for MQTT protocol.