• Journal of Powder Materials
• /
• v.14 no.4
• /
• pp.251-255
• /
• 2007

This work is to report not only the effect of rapid solidification of $MgZn_{4.3}Y_{0.7}$ alloys on the micro-structure, but also the extrusion behavior on the materials properties. The average grain size of the atomized powders was about $3-4{\mu}m$. The alloy powders of $Mg_{97}Zn_{4.3}Y_{0.7}$, consisted of I-Phase (Icosahedral, $Mg_{3}Zn_{6}Y_{1}$) as well as Cubic structured W-Phase ($Mg_{3}Zn_{3}Y_{2}$), which was finely distributed within ${\alpha}-Mg$ matrix. The oxide layer formed along the Mg surface was about 48 nm in thickness. In order to study the consolidation behavior of Mg alloy powders, extrusion was carried out with the area reduction ratio of 10:1 to 20:1. As the ratio increased, fully deformed and homogeneous microstructure could be obtained, and the mechanical properties such as tensile strength and elongation were simultaneously increased.

• Journal of Powder Materials
• /
• v.15 no.2
• /
• pp.107-113
• /
• 2008

Ultrafine TiC-5%Co powders were synthesized by spray drying of aqueous solution of TiO$(OH)_2$ slurry and cobalt nitrate, followed by calcination and carbothermal reaction. The oxide powders with carbon powder was reduced and carburized at $900^{\circ}C{\sim}1250^{\circ}C$ under hydrogen atmosphere. During reduction, CO gas was mainly evolved by reducing reaction of oxides. Ultrafine TiC-5%Co powders were easily formed by carbothermal reaction at $1250^{\circ}C$ due to using ultrafine powders as raw materials. The ultrafine WC-TiC-Co alloy prepared by sintering of mixed powder of ultrafine WC-13%Co powder and ultrafine TiC-5%Co powder has higher sintered density and mechanical properties than WC-TiC-Co alloy prepared by commercial WC, TiC and Co powders.

• Environmental Analysis Health and Toxicology
• /
• v.17 no.3
• /
• pp.219-224
• /
• 2002

This study was carried out to examine the effects of bis (tribytyltin)oxide (TBT), endocrine disrupting compounds (EDCs). on the changes of survival, growth and oxygen consumption rate in the oliver flounder, Paralichthys olivaceus. Oliver Flounders were exposed to sublethal concentration of TBT (0, 1.67, 3.20, 6.30 and 12.50 $\mu\textrm{g}$/L) during 6 weeks. Survival rate was decreased in a concentration and exposure period-dependent way and suddenly the reduction of more than 20% occurred at TBT concentration greater than 3.20 $\mu\textrm{g}$/L. after exposure 6 weeks. Growth rate and feed efficiency significantly decreased at concentration greater than 3.20 $\mu\textrm{g}$/L. Oxygen consumption rate was also decreased in a concentration-dependent way and significantly decreased to 17,48 and 67％ than that of the control at the TBT concentration of 3.20, 6.32 and 12.50 $\mu\textrm{g}$/L, respectively. This study revealed that high TBT concentration ($\geq$3.20 $\mu\textrm{g}$/L) reduced growth and oxygen consumption rates of the juvenile oliver flounder suggesting potential influence on the natural mortality of Paralichthys olivaceus in the coastal areas.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.11a
• /
• pp.75-76
• /
• 2007

Poly-Si Schottky barrier Thin Film Transistor (SB-TFT) is manufactured with erbium silicided source/drain. High quality poly-Si film was obtained by crystallizing the amorphous Si film with Excimer laser annealing (ELA) method. The fabricated poly-Si SB-TFT devices showed low leakage current and large on/off current ratio. Moreover, the electrical characteristics were considerably improved by 3% $H_2/N_2$ gas annealing, which is attributed to the reduction of trap states at the grain boundaries and interface trap states at gate oxide/poly-si channel.

• Nuclear Engineering and Technology
• /
• v.32 no.5
• /
• pp.514-520
• /
• 2000

The mechanism of corrosion behavior has to be understood clearly to select an optimum material for handling molten salts to be used in the oxide reduction process of PWR spent fuel. In this study, the oxidation states of corrosion products on the surface of Inconel 600 and 800H as well as their chemical compositions and structural informations were determined by using XPS, ICP-AES, AAS, EPMA and XRD after the corrosion experiment with lithium molten salts at 75$0^{\circ}C$ for 25 hours. Nickel and oxygen were detected from the corrosion products on the surface of Inconel plates and chromium was found to be dissolved out into lithium molten salts leaving cracks on the surface. The corrosion products were identified as metal oxides such as Fe$_2$O$_3$, Cr$_2$O$_3$, NiO, NiFe$_2$O$_4$and MnO by using XPS and XRD.

• Journal of Life Science
• /
• v.10 no.2
• /
• pp.55-60
• /
• 2000

We examined the effects of Kamgil-Tang on the process of lipopolysaccharide (LPS)-induced unclear factor (NF)-${\kappa}$ Bp65 and inhibitory (I)-${\kappa}$ B${\alpha}$ alteration in RAW 264.7 cell and acute lung injury in rats. Immunoblot analysis showed that LPS-induced degradation of I-${\kappa}$ B${\alpha}$ in RAW 264.7 was inhibited by pretreatment of Kamgil-Tang. The total cells of bronchoalveolar lavage fluid by LPS challenge markedly decreased in the Kamgil-Tang pretreatment rats. Kamgil-Tang pretreatment caused also a decline in neutrophils infiltration into interstitium of the lung. In the alveolar macrophages and neutrophils, decreased NF-${\kappa}$ Bp65 and inducible nitric oxide synthase and increased I-${\kappa}$ B${\alpha}$ immunoreaction were detected in Kamgil-Tang pretreated rats compared with LPS alone treated ones. It may be concluded that Kamgil-Tang attenuates the development of LPS-induced inflammation by reduction of NF-${\kappa}$ Bp65 activation and neutrophil-mediated acute lung injury. Kamgil-Tang would be useful as a therapeutic agent for endotoxin-induced lung disease.

• Journal of the Korean institute of surface engineering
• /
• v.27 no.5
• /
• pp.261-272
• /
• 1994

Both Cu-Cr and Cu-Ti alloy films with different composition were prepared by dc magnetron sputtering onto polyimide substrate and their adhesion and microstructure were observed. In addition, the effect of heat treatment at $400^{\circ}C$ for 2 hours on the variation of adhesion properties and on the changess of microstructure were investigated. Cu-Cr alloy films have crystalline structure of either for or bcc phase depending on the composition of the film. However, the Cu-Ti alloy film forms fcc phase at low Ti concentration while it forms an amorphous phase as the Ti concentration in the films is increased to more than 25at.%. TEM analysis reveal that the microstructure of Cu-Cr and Cu-Ti films forms an open structure with vacant spaces. The adhesion between Cu-Cr, Cu-Ti alloy films and polyimide substrate is relatively good before the heat treatment, but is noticeably reduced after the heat treatment. In particular, the adhesion strength is significantly reduced in the Cu-Ti alloy films after the heat treatment. The reduction of adhesion strength after the heat treatment is identified to relate with the formation of oxide phases at the metal/polyimide interface by AES(Auger Electron Spectroscopy).

• Journal of the Korean Applied Science and Technology
• /
• v.27 no.3
• /
• pp.378-384
• /
• 2010

Regenerated cellulose was prepared from Buckeye wood pulp V60 via dissolution in N-methylmorpholin N-oxide (NMMO) solvent system. The effect of antioxidants such as, n-propylgallate (PG), tris(nonylphenyl) phosphite (TRIS), ethylenediamine tetraacetic acid disodium salt (EDTA), and magnesium sulfate on the properties of regenerated cellulose was studied using X-ray diffraction, copper index calculation, and viscometry. Only addition of more than 0.01% of PG into NMMO solvent was effective to avoid the reduction of the degree of polymerization(DP) of regenerated cellulose during dissolution at $110^{\circ}C$. However, the early stage(within 0.5h of dissolution process) degradation of cellulose was not prevented eventhough up to 0.5% PG was appled to hot NMMO system. In addition, to recover the expensive NMMO after cellulose regenerating process, the washing filtrate was studied using simple techniques, such as refractive index, pH, and conductivity measurements. Through conductivity measurement result, 4-time of washing was enough to remove the NMMO completely from regenerated cellulose.

• Journal of Industrial and Engineering Chemistry
• /
• v.68
• /
• pp.173-179
• /
• 2018

Electrochemical characterization was conducted on poly(vinyl alcohol) (PVA)-ceramic composite (PVA-CC) separators for supercapacitor applications. The PVA-CC separators were fabricated by mixing various ceramic particles including aluminum oxide ($Al_2O_3$), silicon dioxide ($SiO_2$), and titanium dioxide ($TiO_2$) into a PVA aqueous solution. These ceramic particles help to create amorphous regions in the crystalline structure of the polymer matrix to increase the ionic conductivity of PVA. Supercapacitors were assembled using PVA-CC separators with symmetric activated carbon electrodes and electrochemical characterization showed enhanced specific capacitance, rate capability, cycle life, and ionic conductivity. Supercapacitors using the $PVA-TiO_2$ composite separator showed particularly good electrochemical performance with a 14.4% specific capacitance increase over supercapacitors using the bare PVA separator after 1000 cycles. With regards to safety, PVA becomes plasticized when immersed in 6 M KOH aqueous solution, thus there was no appreciable loss in tear resistance when the ceramic particles were added to PVA. Thus, the enhanced electrochemical properties can be attained without reduction in safety making the addition of ceramic nanoparticles to PVA separators a cost-effective strategy for increasing the ionic conductivity of separator materials for supercapacitor applications.

• Journal of Ginseng Research
• /
• v.20 no.2
• /
• pp.133-138
• /
• 1996

Rabbit corpus cavernosal smooth muscle strips submaximally precontracted with phenylephrine (5$\times$$10^6$ M) and treated with increasing concentrations of Korean ginseng (1, 5, 10, 20, 30, 40 mg/ml) showed tension decrease concentration-dependently (1 mg/ml: 1.7%, 5 mg/ml: 10.2%, 10 mg/ml: 22.7%, 20 mg/ml: 44.0%, 30 mg/ml: 65.2%, 40 mg/ml: 95.6%). Relaxations to Korean ginseng were inhibited significantly by endothelial disruption, by pretreatment with methylene blue, pyrogallol, L-NNA and atropine. Pretreatment of the muscle strips with ginseng caused concentration-related inhibition of a phenylephrine induced contraction, and in calcium-free high potassium depolarizing solution, decreased basal tension as well as inhibited contraction induced by Caclr. Korean ginseng also produced the reduction of responses to depolarizing medium(50, 40, 60 mM KCI). With these results we can confirm the relaxation effect of ginseng at a dose dependent on the cavernosal smooth muscle and suggest that its action is mediated by multiple action mechanisms that include increasing the release of nitric oxide from the corporal sinusoids. Increasing intracellular calcium sequestration, and a hyperpolarizating action.