• Water for future
• /
• v.22 no.2
• /
• pp.223-231
• /
• 1989

A dynamic levee breach model is demonstrated which can be applied to various types of breach such as overtopping, breaking, and piping. Through a hypothetical simulation the sensitivity of brach width and duration in the result are discussed. the breach width has more important effect than the failure duration upon a side discharge owing to levee breach.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.21 no.8
• /
• pp.27-33
• /
• 2007

A novel priming discharge technique in which the ramp shaped priming pulse is superposed on the sustain period so that the entire plasma display panel (PDP) is discharged at the same time with a single drive circuit is proposed. From the experimental results, it is ascertained that the priming discharge is ignited only in a pixel in which sustain discharge does not occur and it has been understood that the priming pulse hardly influences the sustain discharge. Moreover, high-speed driving with address pulse widths of 0.7[${\mu}s$] was achieved and a wide address voltage margin of 40[V] was obtained by using the drive method applied the proposed priming discharge technique. In these results, full-HDTV PDP with 1080 horizontal scanning lines can be driven without decreasing the brightness and the possibility of the commercializing is also high because this technology is designed for using the commercialized driver IC.

• Journal of Korea Water Resources Association
• /
• v.34 no.2
• /
• pp.141-154
• /
• 2001

An experimental study was performed to investigate the effects of levee crest width and the slope steepness on levee break due to overtopping flow. The phenomenon of bank failure can be described in 4 stages. In this study, the magnitudes of breach width, breach depth peak discharge, and scouring shape at the break site were measured, and the result shows that peak discharge will be reduced and breach duration extended by widening the crown width and lessening the levee slope steepness. The breach width was narrower and the breach depth deeper, as the levee crest width become wider or the slope steeper. And, the bed scour depth was deeper and steeper, as the levee crest crest width become narrower or the slope milder.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.12
• /
• pp.712-721
• /
• 2017

Recently, the intensity and frequency of floods has increasing worldwide, and flood disasters have become a big problem. Flood disasters, which account for the largest portion of disasters, are floods accompanied by typhoons and localized heavy rainfall. As a result, they cause damage of levee overtopping, in which the water level of a river rises to the levee crown. Therefore, countermeasures are essential and necessary because of the damage to the facility itself as well as to life and other property. The damage magnitude depends on the collapse of the levee. A levee that is difficult to collapse will reduce the discharge inland significantly. Accordingly, the protection of the inland slope, where the collapse of the levee is initiated, is one of the most important countermeasures In this study, revetments with various porosity and forms were suggested and hydraulic experiments were carried out for each type. The hydraulic experiments showed that the stability of a revetment in an inland slope is strongly correlated with the weight per unit area of the revetment. The relationship between the critical velocity, which is the velocity at the moment of leaving the revetment, and the weight per unit area was derived. Through this study, by applying the nature friendly revetment, which has not yet been applied to Korea, it is expected that life and property damage caused by levee overtopping during flooding can be reduced, and a nature friendly river space can be constructed.

• Journal of Korean Society of Disaster and Security
• /
• v.17 no.2
• /
• pp.1-11
• /
• 2024

Most reservoirs in South Korea are earthen dams, mainly because they are cost-effective and easy to construct. However, earthen dams are highly vulnerable to seepage and overtopping, making them prone to sudden failure during excessive flooding. Such sudden failures can lead to a rapid increase in flood discharge, causing significant damage to downstream rivers and inhabited areas. This study investigates the effect of riprap placement on the slopes of earthen dams in delaying dam failure. Delaying the failure time is crucial as it allows more time for evacuation, significantly reducing potential casualties, which is essential from a disaster response perspective. Hydraulic experiments were conducted in a straight channel, using two different sizes of riprap for protection. Unlike previous studies, these experiments were performed under unsteady flow conditions to reflect the impact of rising water levels inside the dam. The target dam for the study was a cofferdam installed in a diversion tunnel. Experimental results indicated that the presence of riprap protection effectively prevented slope failure under the tested conditions. Without riprap protection, increasing the size of the riprap delayed the failure time. This delay can reduce peak discharge, mitigating damage downstream of the dam. Furthermore, these findings can serve as critical reference material for establishing emergency action plans (EAP) for reservoir failure.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.18 no.4
• /
• pp.329-337
• /
• 2006

A small hydro-power plant operated by cooling water discharged from the power plant is under construction. In this study, the flow characteristics of the effluent channel and the outfall coastal zone in which the facilities are constructed have been measured and analysed. The flow pattern is highly dependent on the effluent discharge and clearly classified as these typical areas; the upstream and downstream areas of the weir, and the outfall coastal zone. The discharge and the width of the channel in the upstream area of the weir are increased step by step, so the water level fluctuation is small. The flow overtopping the weir is rapidly changing and has highly vertical fluctuation patterns after hydraulic jump just below the weir. The flow pattern in the outfall zone is directed toward the seaward direction and the velocity is dominated by the tidal level fluctuation. The mean tidal range in this area is about 10% greater than that of the Tongyeong tidal gauging station and the wave effects are negligible because of the sheltering effects of this area.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.33 no.6
• /
• pp.321-332
• /
• 2021

The crown wall with parapet on top of the rubble mound breakwater represents a relatively economic and efficient solution to reduce the wave overtopping discharge. However, the inclusion of parapet leads to increased wave pressure on the crown wall. The wave pressure on the crown wall is investigated by physical model test. To design the crown wall the wave loads should be available, and the horizontal wave pressure is still unclear. Regarding to the horizontal wave pressure on the crown wall, a series of experiments were conducted by changing the rubble mound type structure and the wave conditions. Based on these results, pressure modification factors of Goda's (1974, 2010) formula have been suggested, which can be applicable for the practical design of the crown wall of the rubble-mound breakwater covered by tetrapods.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.29 no.6
• /
• pp.410-418
• /
• 2017

The stability of low-crested structure (LCS) and overtopping discharge over a seawall behind the LCS are influenced by the water level behind the structure. Hence, the experimental results can be distorted unless the increase of water level is known when two-dimensional experiment is carried out. In order to estimate increase of the mean water level behind the low-crested structure, this study applied a hybrid technique that combined results of two-dimensional model test and hydrodynamic numerical modeling based on the relationship between the water level and discharge. By using this technique, the mean water level increase and flow field can be obtained almost at the same time, which resolved the above problem considerably. In addition, this method can provide an approximate information about the outflow velocity from the openings of the structure, which is helpful for selecting appropriate planar configuration of the low-crested structure.

• Journal of Korean Society of Disaster and Security
• /
• v.14 no.2
• /
• pp.61-75
• /
• 2021

Recently, as the occurrence frequency of sudden floods due to climate change increased and the aging of the existing spillway, it is necessary to establish a plan to utilize an auxiliary spillway to minimize the flood damage of downstream rivers. Most studies have been conducted on the review of flow characteristics according to the operation of auxiliary spillway through the hydraulic experiments and numerical modeling. However, the studies on examination of flood damage in the downstream rivers and the stability of the revetment according to the operation of the auxiliary spillway were relatively insufficient in the literature. In this study, the stability of the revetment on the downstream river according to the outflow conditions of the existing and auxiliary spillway was examined by using 3D numerical model, FLOW-3D. The velocity, water surface elevation and shear stress results of FLOW-3D were compared with the permissible velocity and shear stress of design criteria. It was assumed the sluice gate was fully opened. As a result of numerical simulations of various auxiliary spillway operations during flood season, the single operation of the auxiliary spillway showed the reduction effect of maximum velocity and the water surface elevation compared with the single operation of the existing spillway. The stability of the revetment on downstream was satisfied under the condition of outflow less than 45% of the design flood discharge. However, the potential overtopping damage was confirmed in the case of exceeding the 45% of the design flood discharge. Therefore, the simultaneous operation with the existing spillway was important to ensure the stability on design flood discharge condition. As a result of examining the allocation ratio and the total allowable outflow, the reduction effect of maximum velocity was confirmed on the condition, where the amount of outflow on auxiliary spillway was more than that on existing spillway. It is because the flow of downstream rivers was concentrated in the center due to the outflow of existing spillway. The permissible velocity and shear stress were satisfied under the condition of less than 77% of the design flood discharge with simultaneous operation. It was found that the flood damage of downstream rivers can be minimized by setting the amount allocated to the auxiliary spillway to be larger than the amount allocated to the existing spillway for the total outflow with simultaneous operation condition. However, this study only reviewed the flow characteristics around the revetment according to the outflow of spillway under the full opening of the sluice gate condition. Therefore, the various sluice opening conditions and outflow scenarios will be asked to derive more efficient utilization of the auxiliary spillway in th future.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2011.05a
• /
• pp.442-442
• /
• 2011

우리나라는 홍수조절이나 통제를 목적으로 10개의 다목적댐을 통한 홍수방재시스템을 운영하고 있다. 다목적댐 또한 방류능력과 저류능력에 한계가 있기 때문에 안정적인 홍수조절을 위해서는 유입량과 유출량을 미리 예측할 수 있어야 한다. 하지만, 강수량은 그 변동이 심하여 정확한 예측이 어렵기 때문에 합리적인 하천 구조물의 설계와 홍수예측기술의 발전을 위해서는 강우-유출 해석뿐만 아니라 과거의 수문자료를 사용한 통계적인 분석이 요구된다. 최근 기후변화로 인해 과거에 겪지 않았던 이상 기후현상이 빈번하게 나타나고 있다. 기상청발표에 따르면 최근 10년간(1996~2005) 15개 지점의 평균 연강수량은 1,458.7 m로 약 10 �時貂� 하였고, 특히 여름철은 18 %로 증가폭이 가장 크며 호우일수는 30년 평균이 2일인데 비하여 2.8일로 0.8일 증가하였다. 이러한 강수량 및 호우일수 증가는 여름철 심각한 수해를 초래할 수 있다. 본 연구는 기후변화로 인한 수해를 대비하여 홍수기중 저수지 제한수위운영의 안정성을 검토하였다. 연구 대상 지역은 광교저수지로 수원천 상류부인 경기도 수원시 장안구 연무동에 위치한다. 유역면적은 10.98 km, 유효저수량은 250.0 만$m3$이며, 현재 예비취수원으로 사용되고 있다. 기후변화에 따른 하류지역의 예상치 못한 홍수피해를 사전에 예방하기 위해 광교저수지 유역의 설계 강수량과 설계 홍수량을 산정하였다. 제한수위의 시나리오는 현재 시행중인 제한수위와 만수위를 포함하여 5개로 설정하였다. 설계 홍수량이 광교저수지로 유입될 때 시나리오에 따른 월류량은 웨어공식을 이용하여 산정하였으며 결론은 다음과 같다. 1. 39년간의 최다 일 강수량 자료를 사용하여 100년 빈도의 설계 강수량을 Gumbel 분포법으로 산정한 결과 344.4 mm임을 알 수 있었다. 2. 광교저수지 유역의 설계 홍수량을 SCS 방법을 이용하여 산정한 결과 $216.2\;m^3/s$/s로 나타났으며, 총 유입량은 $301.0\;m^3$/day로 파악되었다. 3. 광교저수지로 설계홍수량이 유입될 때 제한수위 시나리오에 따른 최대 방류량은 EL. 87 m의 경우 $23.1\;m^3/s$, EL. 89 m의 경우$27.5\;m^3/s$ EL. 91.36 m의 경우 $79.6\;m^3/s$, EL. 93 m의 경우 $121.1\;m^3/s$ EL. 95.2 m의 경우 $137.`\;m^3/s$이다. 광교저수지 하류부분의 하천정비기본계획상의 설계 홍수량은 $114\;m^3/s$로 홍수기중 저수지의 제한수위는 EL. 91.36 m이하로 설정하는 것이 바람직한 것으로 판단된다.