• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.29 no.9 s.240
• /
• pp.997-1005
• /
• 2005

The extinction characteristics of low strain rate normal gravity (1-g) nonpremixed methane-air flames were studied numerically and experimentally. A time-dependent axisymmetric two-dimensional (2D) model considering buoyancy effects and radiative heat transfer was developed to capture the structure and extinction limits of 1-g flames. One-dimensional (1D) computations were also conducted to provide information on 0-g flames. A 3-step global reaction mechanism was used in both the 1D and 2D computations to predict the measured extinction limit and flame temperature. A specific maximum heat release rate was introduced to quantify the local flame strength and to elucidate the extinction mechanism. Overall fractional contribution by each term in the energy equation to the heat release was evaluated to investigate the multi-dimensional structure and radiative extinction of 1-g flames. Images of flames were taken for comparison with the model calculation undergoing extinction. The two-dimensional numerical model was validated by comparing flame temperature profiles and extinction limits with experiments and ID computation results. The 2D computations yielded insight into the extinction mode and flame structure of 1-g flames. Two combustion regimes depending on the extinction mode were identified. Lateral heat loss effects and multi-dimensional flame structure were also found. At low strain rates of 1-g flame ('Regime A'), the flame is extinguished from the weak outer flame edge, which is attributed to multi-dimensional flame structure and flow field. At high strain rates, ('Regime B'), the flame extinction initiates near the flame centerline due to an increased diluent concentration in reaction zone, which is the same as the extinction mode of 1D flame. These two extinction modes could be clearly explained with the specific maximum heat release rate.

• Toxicological Research
• /
• v.24 no.3
• /
• pp.183-188
• /
• 2008

The behavioral phenotypes of out-bred ICR mice were compared with those of in-bred C57BL/6 and BALB/c mice. In particular, this study examined the locomotor activity and two forms of hippocampus-dependent learning paradigms, passive avoidance and object recognition memory. The basal open-field activity of the ICR strain was greater than that of the C57BL/6 and BALB/c strains. In the passive avoidance task, all the mice showed a significant increase in the cross-over latency when tested 24 hours after training. The strength of memory retention in the ICR mice was relatively weak and measurable, as indicated by the shorter cross-over latency than the C57BL/6 and BALB/c mice. In the object recognition memory test, all strains had a significant preference for the novel object during testing. The index for the preference of a novel object was lower for the ICR and BALB/c mice. Nevertheless, the variance and the standard deviation in these strains were comparable. Overall, these results confirm the strain differences on locomotor activity and hippocampus-dependent learning and memory in mice.

• Ocean and Polar Research
• /
• v.25 no.4
• /
• pp.625-631
• /
• 2003

While phytoplankton diversity and productivity in the Southern Ocean has been widely studied in recent years, most attention has been given to elucidating environmental factors that affect the dynamics of micro-plankton (mainly diatoms) and nano-plankton (mainly Phaeocystis antarctica). Only limited effects have been given to studying the occurrence and the potential risks associated with the blooming of dinoflagellates in the relevant waters. This study focused on the appearance and toxicological characteristics of a toxic dinoflagellate, Alexandrium tamarense, identified and isolated from the Drake Passage in a research cruise from November to December 2001 The appearance of A. tamarense in the Southern Ocean indicates the risk of a paralytic shellfish poisoning (PSP) outbreak there and is therefore of scientific concern. Results showed that while the overall quantity of A. tamarense in water samples from 30meters below the sea surface often comprised less than 0.1% of the total population of phytoplankton, the highest concentration of A. tamarense (20 cells $L^{-1}$) was recorded in the portion of the Southern Ocean between the southern end of South America and the Falkland Islands. Waters near the Polar Front contained the second highest concentrations of 10-15 cells $L^{-1}$. A. tamarense was however rarely found in waters near the southern side of the Polar Front, indicating that cold sea temperatures near the Antarctic ice does not favor the growth of this dinoflagellate. One strain of A. tamarense from this cruise was isolated and cultured for further study in the laboratory. Experiments showed that this strain of A. tamarense has a high tolerance to temperature variations and could survive at temperatures ranging from $5-26^{\circ}C$. This shows the cosmopolitan nature off. tamarense. With regard to the algal toxins produced, this strain of A. tamarense produced mainly C-2 toxins but very little saxitoxin and gonyailtoxin. The toxicological property of this A. tamarense strain coincided with a massive death of penguins in the Falkland Islands in December 2002 to January 2003.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.41 no.3
• /
• pp.193-198
• /
• 2017

Alloy 617 is one of the primary candidate materials to be used in a very high temperature reactor (VHTR) system as an intermediate heat exchanger (IHX). To investigate the low cycle fatigue behavior of Alloy 617 weldments at a high temperature of $850^{\circ}C$, fully reversed strain-controlled fatigue tests were conducted with the total strain values ranging from 0.6~1.5％. The weldment specimens were machined using the weld pads fabricated with a single V-grove configuration by gas tungsten arc welding (GTAW) process. The fatigue life is reduced as the total strain range increases. For all testing conditions, the cyclic stress response behavior of the Alloy 617 weldments exhibited the initial cyclic strain hardening phenomenon during the initial small number of cycles. Furthermore, the overall fatigue cracking and the propagation or cracks showed a transgranular failure mode.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.25 no.3
• /
• pp.211-217
• /
• 2012

In this paper, experimental tests and theoretical studies were carried out to evaluate the tensile behavior of the sprayed FRP composite with chopped glass fiber. For this, a series of tensile strength tests with various strain rates were conducted on the specimens of the matrix and sprayed FRP composite. Sprayed FRP composite contained chopped glass fibers with fiber length of 15mm and a specific volume fraction of fibers of 25 %. An inverse simulation was conducted to simulate the strain rate sensitivity based on the present experimental data of the epoxy resin. The simulated viscosity value is adapted to the micromechanics-based viscoelastic damage model(Yang et al., 2012), and the overall tensile behavior of sprayed FRP composites is predicted. It was seen from the comparative study between present experimental data and predication results that the proposed methodology can be used to predict the viscoelastic behavior of the sprayed FRP composite.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.04a
• /
• pp.913-916
• /
• 2008

Direct tensile response of strain hardening cement composites(SHCC) depends primarily on the material's tensile response, which is a water cement ratio, direct function of fiber and matrix characteristics, the bond between them, and the fiber volume fraction. This paper discusses effect of aspect ratio of the direct tensile response of SHCC with PET and PVA fibers. The main variables considered include the aspect ratio of PET fibers(Aspect ratio, ${\ell}/d_f$ : 150, 300, 600). For the same mixture proportion, PET1.5+PVA0.5-300 and PET1.5+PVA 0.5-600(Aspect ratio 300, 600) showed better overall behavior(Pseudo strain-hardening, Multiple cracking) than specimens with PET1.5+PVA0.5-150(Aspect ratio 150). Tensile strain of PET1.5+PVA0.5-300 and PET1.5+PVA 0.5-600 at ultimate tensile stress were 0.5, 2.0% respectively.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.58 no.2
• /
• pp.31-44
• /
• 2016

This study analyzed pore water pressure, earth pressure and settlement through field monitoring on the project site in which raising embankments are being built through backside extension, and compared the behaviors of seepage analysis, slope stability analysis and stress-strain during flood water levels and rapid drawdown under steady state and transient condition. The variation of pore water pressure showed an increase during the later period in both upstream and downstream slope, with downstream slope more largely increased than upstream slope overall. The variation of earth pressure increased according to the increase of embankment heights, while the change largely showed in the upstream slope, it was slowly increased in the downstream slope. The settlements largely increased until 23 m as embankment heights increased, and showed very little settlement overall. Under a steady state and transient conditions, the seepage quantity per day and leakage quantity per 100 m of embankment against total storage were shown to be stable for piping. The hydraulic gradient at the core before and after raising embankments was greater than the limit hydraulic gradient, showing instability for piping. The safety factor of upstream and downstream slopes were shown to be very large at a steady state, while the upstream slopes greatly decreased at a transit conditions, downstream slopes did not show any significant changes. The horizontal settlements, the maximum shear strain and stress are especially distributed at the connecting portion of the existing reservoir and the new extension of backside. Accordingly, the backside extension method should be designed and reinforced differently from the cases of other types reservoirs.

• Korean Journal of Poultry Science
• /
• v.36 no.2
• /
• pp.133-137
• /
• 2009

This study was conducted to evaluate the performance of Cherry Valley and Grimaud strain. A total of two hundred eighty eight, one day old duck breeders (Cherry Valley and Grimaud strain) were randomly divided into two groups with 4 replicates of 36 birds each and fed a commercially available diet for 24 weeks. Overall body weight gain was significantly higher in Cherry Valley (3,064 g) than in Grimaud strain (2,851 g). Feed intake was significantly increased in Grimaud strain compared with Cherry Valley strain (p<0.05). Viability of Grimaud strain showed 100.0% and was higher than that of Cherry Valley strain. Uniformity was not statistically different between Cherry Valley and Grimaud strains.

• Food Science and Preservation
• /
• v.17 no.2
• /
• pp.174-181
• /
• 2010

The yeast strains used for fermentation are known to influence the qualities of wine. We investigated the effects of fermentation using different yeast strains on the properties of wine produced from 'Hayward' kiwifruit (Actinidia deliciosa). The physicochemical characteristics of wine produced using various yeast strains for fermentation were also analyzed. Saccharomyces cerevisiae Gervin No.5 strain (GVN), S. bayanus Lavin strain EC1118 (EC1118), and S. cerevisiae Red star Davis No. 796 (No.796) are commercial dry yeast strains selected for optimization of fermentation. Although the soluble solid contents of samples fermented by all three yeast strains decreased by a similar extent, the levels of alcohol production differed, particularly during the first week of fermentation. Use of the GVN strain resulted in the highest alcohol concentration (13.8%, v/v), whereas fermentation with No.796 and EC1118 strains yielded alcohol contents of 13.0% and 12.5% (both v/v), respectively. Upon sensory evaluation, GVN-fermented wine had a strong taste and bitterness, with high acid and alcohol contents. Wine fermented using No.796 had a chemical profile similar to that of GVN-fermented product, but the taste remained sweet, consistent with the lower alcohol content. EC1118-fermented wine was soft and sweet in taste, high in flavor, and had a low alcohol content. Total phenolic levels and antioxidant activities in wine fermented by EC1118 were significantly higher than in wines prepared using No.796 or GVN. When previously described characteristics were additionally considered, EC1118 was selected as an optimum strain for further study. In conclusion, fermentation of kiwifruit using different yeast strains yielded wines with distinct characteristics. The yeast strain EC1118 had the most desirable properties, and is considered suitable for kiwifruit fermentation. Valuable attributes of wine fermented by this yeast include overall sensory acceptance, an appropriate level of total phenolics, and good antioxidant activity.

• Journal of Korean Society of Environmental Engineers
• /
• v.30 no.1
• /
• pp.79-84
• /
• 2008

This paper describes the application of bioluminescence stimulating agents on a genetically engineered microorganism, Pseudomonas putida mt-2 KG1206, to monitor toluene analogs using in groundwater samples from petroleum hydrocarbon contaminated sites. The maximum bioluminescent response with pure chemicals followed in the order: m-methyl benzyl alchohol > m-toluate > toluene > m-xylene > benzoate > p-xylene > o-xylene. Generally, the bioluminescence production of strain mixed with groundwater samples was dependent on the contaminated total inducer concentrations. However, few samples showed opposite results, where these phenomena may be caused by the complexicity of environmental samples. Two chemicals, SL(sodium lactate) and KNO$_3$, were tested to determine a better bioluminescence stimulant. Both chemicals stimulate the bioluminescence activity of strain KG1206, however, a slightly high bioluminescence was observed with nitrogen chemical. This selected stimulant was then tested on samples collected from contaminated groundwater samples. The bioluminescence activity of all samples mixed with the strain was stimulated with KNO$_3$ amendment. This suggests that the low bioluminescence activity exhibited by the environmental groundwater samples can be stimulated by amending the culture with a proper agent, such as nitrogen compound. These findings would be useful, especially, when strain was used to monitor the groundwater samples contaminated with low inducer contaminants. Overall, the results of this study found the ability of bioluminescence producing bacteria to biosensor a specific group of environmental contaminants, and suggest the potential for more efficient preliminary application of this engineered strain in a field-ready bioassay.