• 한국대기환경학회지
• /
• 제21권3호
• /
• pp.277-284
• /
• 2005

Catalytic oxidation of toluene in low concentrations was investigated over various supports. As the manganese oxides loading was increased, the conversion of toluene increased at a lower temperature. The 18.2 $wt\%$ $Mn/\gamma-Al_2O_3$ appeared to be the most active catalyst. Among the supports, $\gamma-Al_2O_3$ was more active than $TiO_2$ and $SiO_2$. Manganese oxide catalysts prepared from manganese nitrate precursor were better for complete oxidation of toluene than those prepared from manganese sulfate and chloride precursor because sulfate from manganese sulfate and chloride from chloride manganese remained even after the calcination by XRD (X-Ray Diffraction) analyses.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2012년도 제42회 동계 정기 학술대회 초록집
• /
• pp.266-266
• /
• 2012

Ni films with a thickness of 700-800 nm were deposited on carbon fiber layers using electroless deposition, and surface structures and chemical properties of these films with various annealing temperatures (300, 600 and $900^{\circ}C$) were studied. $600^{\circ}C$-annealing under atmospheric conditions resulted in formation of porous surface structures with a mean pore size of ~100 nm, whereas the other samples showed non-porous surface structures. $600^{\circ}C$-annealed Ni film showed much higher reactivities for toluene adsorption and CO oxidation comparing to other non-porous surfaces.

• 한국자동차공학회논문집
• /
• 제11권2호
• /
• pp.134-139
• /
• 2003

This study was carried out to investigate the aging and conversion characteristics of oxidation catalysts for a natural gas vehicle with lean-bum system. The conversion of $CH_4$ was observed over the various composition ratio of PMs(Precious metals) and washcoating methods. On the fresh catalysts, Pd affected on the activity of $CH_4$ at low temperature more than other PMs in Pd-only and Rh/Pd/Pt catalysts. The activity at low temperature increased as a mount of Pd increases. On the aged catalysts, the $CH_4$ conversion efficiency of Pd-only catalyst with mono-layer washcoat decreased more than that of the other catalysts of $CH_4$ conversion. It was observed that the thermal durability of Rh/Pd/Pt catalysts with double-layer washcoat was better than the single washcoat catalyst.

• Bulletin of the Korean Chemical Society
• /
• 제28권4호
• /
• pp.543-546
• /
• 2007

Herein, a new electrochemical method was described for the determination of ciprofloxacin based on the enhancement effect of an anionic surfactant: sodium dodecyl benzene sulfonate (SDBS). In pH 4.0 phosphate buffer and in the presence of 1.0 × 10-4 mol/L SDBS, ciprofloxacin yields a well-defined and sensitive oxidation peak at the carbon paste electrode (CPE). Compared with that in the absence of SDBS, the oxidation peak current of ciprofloxacin remarkably increases in the presence of SDBS. The experimental parameters, such as supporting electrolyte, concentration of SDBS, and accumulation time, were optimized for ciprofloxacin determination. The oxidation peak current is proportional to the concentration of ciprofloxacin over the range from 8.0 × 10-8 to 5.0 × 10-6 mol L-1. The detection limit is 2.0 × 10-8 mol L-1 after 2 min of accumulation. This new voltammetric method was successfully used to detect ciprofloxacin in drugs.

• Bulletin of the Korean Chemical Society
• /
• 제29권5호
• /
• pp.1033-1037
• /
• 2008

A copper cyclam-type complex was successfully immobilized onto mesoporous silica SBA-16. Characterization by NIR spectroscopy and TGA analysis confirmed that copper cyclam complex is immobilized onto mesoporous SBA-16. The Cu(II)-Cyclam-SBA-16 was proven to be a good catalyst for oxidation reaction of cyclohexene with conversion up to 77.8% after 13 h reaction and providing a high selectivity to cyclohexenol and 3-hydroperoxycyclohex-1-ene. The results suggest that the copper species play a major role as catalyst via reversible redox cycles as proven by cyclic voltammetry analysis.

• Bulletin of the Korean Chemical Society
• /
• 제9권2호
• /
• pp.81-84
• /
• 1988

The CO oxidation was performed on $H_2$-reduced NiO-${\alpha}-Fe_2O_3$ in the temperature range 150-$250^{\circ}C$. The kinetic study and the conductivity measurements indicate the oxidation reaction follows Langmuir-Rideal type process that is uncommon in heterogeneous catalyst$^1$. No active site is found on the catalyst surface for CO adsorption, but an oxygen vacancy adsorbs an oxygen, and this step is rate initiation. The partial orders are half for $O_2$ and first for CO, respectively. Apparent activation energy for over-all reaction is 9.05 kcal/mol.

• Journal of Industrial and Engineering Chemistry
• /
• 제67권
• /
• pp.448-460
• /
• 2018

Copper nanoparticle-doped and graphitic carbon nanofibers-covered porous carbon beads were used as an efficient catalyst for treating synthetic phenolic water by catalytic wet air oxidation (CWAO) in a packed bed reactor over 10-30 bar and $180-230^{\circ}C$, with air and water flowing co-currently. A mathematical model based on reaction kinetics assuming degradation in both heterogeneous and homogeneous phases was developed to predict reduction in chemical oxygen demand (COD) under a continuous operation with recycle. The catalyst and process also showed complete COD reduction (>99%) without leaching of Cu against a high COD (~120,000 mg/L) containing industrial wastewater.

• E2M - 전기 전자와 첨단 소재
• /
• 제7권2호
• /
• pp.145-151
• /
• 1994

The multi-dielectric layer SiOz/Si3N4/SiO2(ONO) is used to scale down the memory device. In this paper, the change of composition in ONO layer due to the process condition and the conduction mechanism are observed. The composition of the oxide film grown through the oxidation of nitride film is analyzed using auger electron spectroscopy(AES). AES results show that oxygen concentration increases at the interface between oxide and nitride layers as the thickness -of the top oxide layer increases. Results of I-V measurement show that the insulating properties improve as the thickness of the top oxide layer increases. But when the thickness of the nitride layer decreases below 63.angs, insulating peoperties of film 28.angs. of top oxide and film 35.angs. turn over showing that insulating property of film 28.angs. of top oxide is better than that of film 35.angs. of top oxide. This phenomenon of turn over is thought as the result of generation of surface state due to oxygen flow into nitride during oxidation process. As the thickness of the top oxide and nitride increases, the electrical breakdown field increases, but when the thickness of top oxide reaches 35.angs, the same phenomenon of turn over occurs. Optimum film thickness for scaled multi-layer dielectric of memory device SONOS is estimated to be 63.angs. of nitride layer and 28.angs. of top oxide layer. In this case, maximum electrical breakdown field and leakage current are 18.5[MV/cm] and $8{\times}{10^-12}$[A], respectively.

• Bulletin of the Korean Chemical Society
• /
• 제34권7호
• /
• pp.2105-2110
• /
• 2013

Carbon-fiber-supported NiO catalytic filters for oxidation of volatile organic compounds were prepared by electroless Ni-P plating and subsequent annealing processes. Surface structure and crystallinity of NiO film on carbon fiber could be modified by post-annealing at different temperatures (500 and $650^{\circ}C$). Catalytic thermal decompositions of toluene over these catalytic filters were investigated. $500^{\circ}C$-annealed sample showed a higher catalytic reactivity toward toluene decomposition than $650^{\circ}C$-annealed one under same conditions, despite of its lower surface area and toluene adsorption capacity. X-ray diffraction and X-ray photoelectron spectroscopy studies suggest that amorphous structures of NiO on $500^{\circ}C$-annealed catalyst caused the higher reactivity for oxidation of toluene than that of $650^{\circ}C$-annealed sample with a higher crystallinity.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2013년도 제44회 동계 정기학술대회 초록집
• /
• pp.217-217
• /
• 2013

Carbon-fiber-supported NiO catalytic filters for oxidation of volatile organic compounds were prepared by electroless Ni-P plating and subsequent annealing processes. Surface structure and crystallinity of NiO film on carbon fiber could be modified by post-annealing at different temperatures (500 and $650^{\circ}C$. Catalytic thermal decompositions of toluene over these catalytic filters were investigated. $500^{\circ}C$ annealed sample showed a higher catalytic reactivity toward toluene decomposition than $650^{\circ}C$ annealed one under same conditions, despite of its lower surface area and toluene adsorption capacity. X-ray diffraction and X-ray photoelectron spectroscopy studies suggested that amorphous structures of NiO on $500^{\circ}C$ annealed catalyst caused the higher reactivity for oxidation of toluene than that of $650^{\circ}C$ annealed sample with a higher crystallinity.