• 전기전자학회논문지
• /
• 제15권3호
• /
• pp.198-204
• /
• 2011

본 논문에서는 선택적 증폭후 전달(Opportunistic Amplify-and-Forward: OAF) 릴레이 시스템에 대한 새로운 성능 분석 기법을 레일리 페이딩 채널에 대하여 제안하였다. 제안된 분석 기법에서는 집합 연산(set-operation)을 기반으로 각 릴레이가 최적의 릴레이로 선택될 확률을 유도한다. 그리고 수신된 순시 신호 대 잡음비의 확률 밀도 함수를 기존의 분석 기법보다 일반적인 (확률밀도함수 표현에서 합 기호의 개수 및 그 영역이 구체화된)형태로 제시한다. 그리고 이를 이용하여 평균 오류율, 누락 확률 및 평균 채널 용량을 근사화된 닫혀진 형태로 유도한다. 제안된 성능분석 기법의 정확성은 모의실험을 통하여 검증한다. 성능분석 및 모의실험 결과 비교를 통하여 OAF 기법이 평균 오류 확률, 누락 확률 및 평균 채널 용량 측면에서 비선택적 기법에 비해 성능 향상 정도가 우수함을 확인한다.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제8권11호
• /
• pp.3967-3983
• /
• 2014

The performance of an partial relay selection on the decode-and-forward (DF) mode cognitive radio (CR) relay networks is studied, with some important factors, including the outage probability, the bit error ratio (BER), and the average channel capacity being analyzed. Different from the conventional relay selection schemes, the impact of spectrum sensing process as well as the spectrum utilization efficiency of primary users on the performance of DF-based CR relaying networks has been taken into consideration. In particular, the exact closed-form expressions for the figures of merit such as outage probability, BER, and average channel capacity over independent and identically distributed (i.i.d.) Rayleigh fading channels, have been derived in this paper. The validity of the proposed analysis is proven by simulation, which showed that the numerical results are consistent with the theoretical analysis in terms of the outage probability, the BER and the average channel capacity. It is also shown that the full spatial diversity order can always be obtained at the signal-to-noise ratio (SNR) range of [0dB, 15dB] in the presence of multiple potential relays.

• Journal of information and communication convergence engineering
• /
• 제14권3호
• /
• pp.171-176
• /
• 2016

In this study, we investigate the physical layer secrecy performance of RF energy harvesting (EH) networks over Rayleigh fading channels. The RF-EH system considered here consists of one power transfer station, one source, one destination, and multiple passive eavesdroppers. The source harvests energy from the power transfer station and transmits the information to the destination by using a time switching-based relaying protocol. The eavesdroppers try to extract the transmitted information without an active attack. By using the statistical characteristics of the signal-to-noise ratio (SNR), the exact closed-form expressions of the existence probability of the secrecy capacity and the secrecy outage probability are derived. Further, we analyze the secrecy performance of the system with respect to various system parameters, such as the location of the system elements and the number of eavesdroppers. Finally, the equivalent Monte Carlo simulation results are provided to confirm the correctness of our calculations.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2002년도 하계종합학술대회 논문집(1)
• /
• pp.41-44
• /
• 2002

Alamouti proposes a two branch transmit diver-sity scheme that provides the same diversity order as maximal ratio combining at the receiver. It has many advantages of no bandwidth expansion, not requiring channel information at the transmitter and simple maximum likelihood decoding at the receiver. Papadias and Foschini extend this sch-eme to four transmit antennas and suggest several schemes to decrease the interference component and allow the attainment of the open-loop capacity. This paper shows the performance of ZF and MM-SE schemes comparing with ideal case on 4xl sy-stem over BER and 10% outage capacity.

• 한국인터넷방송통신학회논문지
• /
• 제18권3호
• /
• pp.71-75
• /
• 2018

본 논문에서는 복호 후 재전송 기반의 중계기 시스템에서 재머를 사용했을 때의 보안 불능 확률을 연구한다. 물리 계층에서 보안 용량을 증가시키기 위해서 선택되지 않은 중계기들 중에서 재머를 선택하여 의도적인 잡음을 발생시키도록 할 수 있다. 재머에 의한 잡음은 수신자와 도청자에서 동일하게 간섭으로 작용하지만 송신자-도청자 링크 간의 채널 품질을 송시자-수신자 링크의 채널보다 더 악화 시키는 최적의 재머를 선택하여 물리 계층 보안을 강화할 수 있다. 본 논문에서는 재머의 유무에 따른 보안 불능 확률의 이론적인 식을 계산하고, 그 식이 타당한지 증명하기 위하여 이론값과 모의실험을 통한 실험값을 비교해 본다.

• 대한전기학회논문지:전력기술부문A
• /
• 제51권5호
• /
• pp.238-246
• /
• 2002

Utilities are trying to install the equipment of high quality to avoid deterioration of supply reliability. In addition, many sectionalizing switches which can decrease the total outage value for a fault are installed for the same reason. Therefore, utilities are interested in stun dards and criteria for installing switches to optimize the total cost on distribution systems. The affect of sectionalizing switches installed on distribution feeder is gradually decreased because the failure rate on distribution feeder is decreased. Also the automation for distribution systems is widely applied for the efficient operation. Therefore, the renewal for installation standards of sectionalizing switches Is required to reflect the current operation situation. The variable data is used to consider the KEPCO's real situation of distribution feeder as follows; the feeder capacity, connecting rate, feeder length, failure rate of distribution feeder, the failure rate of switches, perception time of feeder fault, the restoration time for a faulted section, the transfer time to other feeders, and the switching time. In this study, We propose equations which can determine the number of sectionalizing switches for minimizing the outage and switch installation cost.

• 조명전기설비학회논문지
• /
• 제18권1호
• /
• pp.98-104
• /
• 2004

본 논문에서는 사고나 계획정전 등으로 인한 건전 정전구간에 신속하게 전원을 공급하는 방안을 제시하였다. 제시한 부하복구방안은 연계개폐기로부터 공급피더 방향으로 계통을 역방향으로 탐색하고 탐색시 저장된 경로와의 조합을 이용하여 구해짐으로써 계통의 탐색공간이 대폭 줄어들게 되어 신속한 복구방안의 제시가 가능하다. 또한 공급 여유량을 미리 확보하는 2단계의 부하복구, 모든 구간에 대한 복구가 불가능한 경우 부하를 차단하는 방안 등이 포함되어 있으므로 광역정전이나 다중사고 및 중요수용가를 고려한 부하복구, 배전자동화시스템과 연계된 부하 복구에도 이용할 수 있다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2002년도 하계학술대회 논문집 A
• /
• pp.70-73
• /
• 2002

Utilities are trying to install the equipment of high quality to avoid deterioration of supply reliability. In addition, many sectionalizing switches which can decrease the total outage value for a fault are installed for the same reason. Therefore, utilities are interested in standards and criteria for installing switches to optimize the total cost on distribution systems. The affect of sectionalizing switches installed on distribution feeder is gradually decreased because the failure rate on distribution feeder is decreased. Also the automation for distribution systems is widely applied for the efficient operation. Therefore, the renewal for installation standards of sectionalizing switches is required to reflect the current operation situation. The variable data is used to consider the KEPCO's real situation of distribution feeder as follows; the feeder capacity, connecting rate, feeder length, failure rate of distribution feeder, the failure rate of switches, perception time of feeder fault, the restoration time for a faulted section, the transfer time to other feeders, and the switching time. In this study, We propose equations which can determine the number of sectionalizing switches for minimizing the outage and switch installation cost.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 하계학술대회 논문집 C
• /
• pp.1416-1418
• /
• 1999

This paper presents a restoration method by using Dijkstra algorithm for outage restoration problems in distribution system that considering load capacity constraints and operation constraints. Restoration problem in distribution system is difficult to solve problem in a short times, because of a distribution system that supplies power for customers combined with many tie-line switches and sectionalizing switches and have to satisfy plenty of operation conditions. Therefore, this paper applied Dijkstra algorithm which is satisfy radial operation conditions in distribution system. This proposed method used Kruskal algorithm include to Dijkstra algorithm Therefore, proposed method is restored to a outage sections in a short times and just then to satisfied with a operation conditions in distribution system. A 26-bus, 31-branch model system is used to demonstrate the effectiveness of the proposed method.

• 한국인터넷방송통신학회논문지
• /
• 제18권2호
• /
• pp.49-54
• /
• 2018

본 논문에서는 복호 후 재전송 기반의 중계기 시스템에서 협력 다이버시티와 재머를 사용했을 때의 보안 불능 확률을 연구한다. 협력 다이버시티를 얻기 위해서 수신자와 도청자에서 MRC 기법을 사용한다. MRC 기법을 사용하기 위해서 송신자와 수신자, 송신자와 도청자 사이의 직접 링크를 사용한다. 보안용량을 증가시키기 위해서 의도적인 잡음 신호를 발생 시키는 재머를 사용한다. 재머는 의도적인 잡음을 발생시켜 도청자의 채널 품질을 떨어뜨리고 물리 계층 보안이 실현될 수 있도록 돕는다. 보안 성능을 평가하기 위해서 보안 불능 확률이 사용된다. 시스템은 레일리 페이딩 채널 하에 있다고 가정한다.