• Journal of the Korean Society of Marine Environment & Safety
• /
• v.5 no.1
• /
• pp.9-18
• /
• 1999

To predict the oil spill dispersion phenomena in the ocean, the oil spill response model, which can be used for strategic purpose on the oil spill site, based on Lagrangian particle-tracking method was formulated and applied to the neighboring area with Pusan port where the oil spill incident occurred when the tanker ship No.1 Youil struck on a small rock near the Namhyungjeto on September 21, 1995. The real-time tidal currents to be required as input data of the oil spill model were obtained by the two-dimensional hydrodynamic model and the tide prediction model. Evaluation of tidal currents using observation data was successful. For wind data, other input data of oil spill model, observed data on the spot were used. To verify the oil spill model, the oil spill modelling results were compared with the field data obtained from the spill site. Compared the modelling results with the observation data, there exist some discrepancies but the general pattern of modelling results was similar to that of field observation. The modelling results on 7 days after spill occurred showed that the 40% of spilled oil is in floating, 36% in evaporated, 23% at shore, and 1% in out of boundary, respectively. According to the evaluation of weighting curves of effective components to the dispersion of oil, the winds make a 37% of contribution to the dispersion of oil, turbulent diffusion 39.5%, and tidal currents 23.5%, respectively. Provided the more accurate wind data are supported, more favorable results might be obtained.

• Journal of the Korean Society of Safety
• /
• v.21 no.1 s.73
• /
• pp.86-91
• /
• 2006

Oil spills caused by the accidents have been occurred from house and factory waste, grounded tanker, the rupture of storage tank and oil pipelines, the deterioration of various industrial facilities, etc. Many oil spills result in contamination of shorelines and workplace. Fire and explosion may happen from these spills. There are several technologies used for clean-up application, which include use of oil dispersing agents, absorbents, solidifiers, booms and skimmers by physical, chemical, and biological methods. Methods for oil spill clean-up operation are classified into the absorption type, gel type and self-swelling type. Porous materials with oil absorptive properties are classified into micropore, mesopore, and macropore depending on their pore sizes. Recently, new porous materials with smaller size have been developed, but the selective oil absorption in water-in-oil interface demonstrates the macro pore size. In this study oil absorption effects were evaluated using the organic porous materials with a complex function of gel type and swelling type. Samples were subjected to analysis by FT-IR spectroscopy and were characterized in terms of gel formation and morphologies. Oil sorption capacity, pressure retention force and gel strength were also measured. From these results, the physicochemical reactivity before and after gelation was verified and the industrial applications of clean-up operation were suggested.

• Journal of Navigation and Port Research
• /
• v.26 no.4
• /
• pp.373-381
• /
• 2002

There has been an interesting trend showing that the number of tankers owned by major oil company has been decreasing since the 1980s, while the number of tankers chartered by them is increasing. So do Korea oil refineries in the period 1990s. Therefore, the following question is raised： Why have oil refinery companies, national and international, been much more dependent upon chartered ships than their owned ships since 1980s\ulcorner This paper tried to answer the above question. In so, doing ten decision-making factors for fleet composition of oil tankers are drawn through literature survey on the research topic with questionnaires and interviews to the four big Korean oil refineries.

• Proceedings of KOSOMES biannual meeting
• /
• 2007.05a
• /
• pp.187-194
• /
• 2007

In order to control and manage oil-tanker scrapped materials and wastes properly, the actual conditions and global trends of the treatment and the management of ship scrapped wastes were surveyed and some amendments to marine pollution prevention law of Korea were proposed. Global annual volume of scrapped ships was estimated to be about 22 million DWT and most of them were scrapped in 4 major ship scrap countries such as Bangladesh, China. India and Pakistan and in minor ship scrap countries such as Turkey, the Philippines, Indonesia and Vietnam. The industry of ship scrap has been mainly developed in developing countries or undeveloped countries rather than in advanced countries. Most of scrapped ships were found to be small or medium size below 1,000 GRT In Jellanam-Do and Jeju-Do of Korea. Most of ship scrap enterprise and all enterprises of collection, transfer, treatment and disposal for ship scrapped materials and wastes were shown to be small sized in Korea. The regulations and/or rules which shall prohibit or limit trans-boundary movement of overage oil-tankers for scrap from Korea to developing or undeveloped countries, and vice versa should be Included in marine pollution prevention law of Korea. the criteria of manpower and facilities for enterprise of ship scrap, and for enterprises of collection, transfer, treatment and disposal of ship scrapped materials and wastes should be stipulated in marine pollution prevention law of Korea. It is desirable to introduce the system or concept of recycle or reuse of ship scrapped materials and wastes on producer's responsibility into marine pollution prevention law of Korea.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.5 no.2
• /
• pp.99-111
• /
• 1999

The object of this study is to get the superior double hull structure to its crashworthiness against collision comparing absorbed energy capacities of its various types with each other, varying material properties, collision positions and velocities, and structural arrangements such as double hull width, web and stringer spaces, etc. Local absorbed energy capacities, failure behaviors and damage extents of their members are also considered during collision in addition to the estimations of their global ones. This paper describes a series of numerical simulations of collisions between DWT 45,000 oil tanker(struck ship) and DWT 10,500 rigid one(striking ships) using Hydrocode LS/DYNA3D. Collisions are assumed to occur at the middle of struck ship with striking one moving at right angle to its centerline. The following remarks were obtained through this study: More flexible the double hull structure is, much superior its crashworthiness against collision is. The increment of double hull width does not give much influence than other factors do. The exact use of material property such as failure strain is also important on the numerical simulation of collision.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 1995.11a
• /
• pp.73-88
• /
• 1995

I. Introduction II. State of vessel-source marine pollution 1. Pollution by tanker accidents 2. Pollution by tanker operations 3. Pollution by chemicals 4. Pollution by garbage and sewage III. Regulatory regime for ship safety and vessel-source 1. Regime for ship safety 2. Regime for vessel-source marine pollution prevention IV. Cause analysis of Contemporary vessel-source marine pollution. 1. Diversity of interested parties of shipping 2. Fierce international competition of shipping 3. Wide variagions in ship safety indicators by natons 4. Limitation of enforcing oil spill activities 5. Limitation of international countermeasures V. Summary conclusions and suggestions Note and References

• Journal of Navigation and Port Research
• /
• v.38 no.4
• /
• pp.379-384
• /
• 2014

In case of sunken tankers, remaining-oil recovery operation should be conducted due to possible oil spill accident. However, the deep sea operation make difficulties in checking the completion of remaining oil recovery process, therefore the work termination procedure is very important. In this paper, a reasonable work termination procedure through the comparison and analysis of two cases(Youil No.1 and Osung No.3, Kyung-Shin) which were performed in different method, using disparate equipment. By investigating previously applied methods and techniques, work speed, safety and expenses were compared. The proposed ending procedure of the remaining-oil recovery project is to recover the remaining oil from each cargo tanks and to clean up such tanks whilst an independent surveyor proceeds to a confirmation procedure whereby said surveyor checks out whether any remaining oil exists by putting a stick in each cleaned up tanks and opening up the hatch cover of the tanks or the top place of the tanks to confirm the cleanness of oil. Such procedure shall be done through discussion by the ordering party, contractor and the independent surveyor all together with a flexible application.

• Journal of the Society of Naval Architects of Korea
• /
• v.43 no.5 s.149
• /
• pp.560-567
• /
• 2006

FPSO and shuttle tanker are connected to each other by a mooring hawser and a loading hose through which cargo oil is off-loaded. Even in mild sea-state. environmental loads can cause unstable large drift motions between two vessels in tandem off-loading operations, which may result in collision incidents. Accordingly. the analysis on the relative motion between two vessels due to the environmental loads should be investigated in initial design stage. In this study, the low speed maneuvering equation is employed to simulate nonlinear motions of FPSO and shuttle tanker. Low frequency wave drift forces including hydrodynamic interactions between two vessels are evaluated by near field approaches. Current loads are determined by mathematical model of MMG and wind loads are calculated by employing the wind spectrum according to the guidelines of API-RP2A. Mooring forces produced by turret mooring lines and a flexible hawser are modeled quasi-statically by catenary equations. The effect of environmental loads that affect nonlinear motion is investigated through variation in their magnitudes and the nonlinear motions between FPSO and shuttle tanker are simulated under wave, current and wind in time domain.

• Proceedings of the KSRS Conference
• /
• v.2
• /
• pp.977-980
• /
• 2006

Ships and industries damage the delicate coastal ecosystem in many parts of the world by releasing oil or pollutants into rivers, coastal and offshore waters. After a tanker accident the biggest problem is to get a clear idea of the extent of the oil slick and predict the way it will move. For natural and man-made oil spills it is necessary to operate a regular and operational monitoring. In the Mediterranean, North and Baltic seas aircrafts or ships normally carry it out. This is expensive and is constrained by the limited availability of these resources, borders between countries, daylight hours, good weather conditions, etc. Satellite imagery can help greatly identifying probable spills over large areas and then guiding aerial surveys for precise observation of specific locations. The Synthetic Aperture Radar (SAR) instrument, which can collect data almost independently of weather and light conditions, is an excellent tool to monitor and detect oil on water surfaces. SAR is currently on board the ENVISAT, ERS-2 and RADARSAT satellites. The application of this technology to the investigation of oil pollution in the Caspian, Black, Mediterranean, North and Baltic seas is shown.

• Journal of Ocean Engineering and Technology
• /
• v.26 no.1
• /
• pp.60-63
• /
• 2012

The accident risks in the marine environment are increasing because of the tendency to build faster and larger ships. To secure ship safety, risk-based ship design (RBSD) was recently suggested based on a formal safety assessment (FSA). In the process of RBSD, a ship designer decides which risk reduction option is most cost-effective in the design stage using a cost-benefit analysis (CBA). There are three dimensions of risk in this CBA: fatality, environment, and asset. In this paper, we present an approach to estimate the environmental costs based on the size of an oil tanker involved in an accident using a neural network. An appropriate neural network model is suggested for the estimation,and the neural network is trained using IOPCF data. Finally,the learned neural network is compared with the cost regression equation by IMO MEPC 62/WP.13 (2011).