• Journal of the Korean Association of Oral and Maxillofacial Surgeons
• /
• v.26 no.2
• /
• pp.146-153
• /
• 2000

The purpose of present study is comparing the effect of Teflon Membrane and Nylon Membrane on bone regeneration in rabbit tibia. The 6 defects of $8{\times}8{\times}5mm$ size were drilled with dental handpiece in rabbit tibia, which on left side as an order of Control group(no coverage), Group 1(Nylon $5{\mu}m$ size), Group 3(Nylon $10{\mu}m$ size), and on right side Control group, Group 2($5{\mu}m$ Teflon), Group 4($10{\mu}m$ Teflon). Animals were killed at 7, 10, 14, 42 days to make specimens and observed the difference of healing potentials with light microscopy. The results were as follows ; 1. New bone formation has taken place at 14 days in Guided Bone Regeneration (GBR) group comparing to the Control group of massive inflammatory status. 2. Larger pore membrane allows more favorable healing potentials. Bone formation started earlier in larger membrane pore groups than smaller groups, until 14 days. 3. Bone forming potentials of Teflon membrane group was higher than Nylon membrane groups, Control group has the lowest bone forming potentials. 4. New bone formation was almost ended in 42 days, and there was no difference of bone formation between Nylon and Teflon membrane group of different size. There was no difference of bone formation at final stage(42 days) between Nylon membrane and Teflon membrane of same pore size. So nylon membrane may be clinically usable in guided bone regeneration case with further studies.

• Textile Coloration and Finishing
• /
• v.14 no.4
• /
• pp.197-207
• /
• 2002

The physical properties and dyeability of the nylon 6 fibers prepared by high speed spinning at take-up speed of 4,100~5,600m/min were investigated. The strain decreased as the take-up speed was raised from 4,100m/min to 4,400m/min, but further increase of take-up speed could not decrease the strain. The stresses of the fibers spinned at various take-up speed did not make any noticeable differences. Birefringences, densities and crystallinities of the fibers increased with the take-up speed and then reached to a nearly maximum value at 5,300m/min. In DSC diagrams, the $\gamma$ form of crystal became dominant at higher take-up speed. The dye uptakes of C. I. Acid Blue 113 on the fibers decreased a little with the increase of take-up speed.

• Elastomers and Composites
• /
• v.49 no.4
• /
• pp.293-304
• /
• 2014

Rubber air spring (RAS) is a special suspension device for the industries of automobile, railroad car and other transportation. A RAS serves as a spring component with the elastic effect of compression and expansion of air in a composite rubber bag. The main component of RAS is the rubber sleeve. Rubber sleeve is the composite which is made up of combination of chloroprene rubber (CR) and nylon 6 cord, and the adhesive strength between CR and nylon 6 cord is very important. In this study, considering the effects of additives in rubber sleeve, various physical properties were tested to find the optimal combination of composition and conditions. Further, in order to select the optimum orientation of the reinforcing fibers, numerical analysis was performed using the finite elements method. After assembling all components of RAS, it was mounted on an actual vehicle, and then it was tested air leakage, fatigue life and fundamental properties.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.20 no.6
• /
• pp.1138-1150
• /
• 1996

This study was carried out to investigate the effects of dyeing on the mechanical properties, primary hand, total hand value (THV), and total appearance value (TAV) of woven fabrics. Cotton, PET, nylon, cotton/PET, and cotton/nylon woven fabrics were used as test specimens. Each of fabric was dyed under the same conditions as the fabrics for sportswear which consumers have selected as best. Mechanical properties of specimens were measured by KES-FB system and primary hand and THV were calculated by equation KN -201-MDY and KN-301-WINTER respectively. TAV was calculated by KN (eq. 10). The results were as follows: 1. In mechanical properties. tensile energy increased when cotton and two cotton mixture fabrics were dyed and decreased when polyester and nylon fabrics were dyed. Bending rigidity and shear rigidity decreased after all fabrics were dyed except nylon and cotton/ nylon mixture fabrics showing higher rigidities. Cotton fabrics showed higher surface roughness while other fabrics did lower values after dyeing. 2. In evaluation of primary hand and total hand , four primary hands of cotton fabrics so decreased after dyeing that THV were lowered. Numeri, Fukurami, and Sofutosa in primary hand of polyester, cotton/polyester, and cotton/nylon fabrics and Koshi and Numeri of nylon fabrics increased after dyeing and therefore THV of four fabrics were improved. 3. Cotton and polyester fabrics showed higher TAV due to their lower bending and shear rigidity, while nylon and cotton/nylon fabrics did lower values due to their higher shear rigidity. 4. It was proposed that the method of dyeing or treatment for minimizing the decrease of THV of cotton fabrics and TAV of nylon fabrics should be developed.

• Korean Journal of Food Science and Technology
• /
• v.21 no.2
• /
• pp.252-257
• /
• 1989

Nylon laminated low density polyethylene(LDPE) film is mostly used for package of Vienna sausage in Korea. The water vapor permeability and gas transmission rate of Nylon laminated LDPE film is higher than that of Oriented polypropylene/polyvinylidene chloride coated LDPE film. Comparision of shelf-life of Vienna sausage packed with both film was as follows. The water vapor permeability and gas transmission rate of PVDC coated film were 2.5 times lower and 20.7 to 30 times lower than those of Nylon laminated film, respectively. Shelf-lives of Vienna sausage packed with Nylon laminated film and PVDC coated films were 25 days and 31 days at $15^{\circ}C$, 32 days and 41 days at $5^{\circ}C$, respectively.

• Asian-Australasian Journal of Animal Sciences
• /
• v.9 no.6
• /
• pp.637-642
• /
• 1996

This experiment was conducted to determine RDP values of locally available feedstuffs that are commonly used in ruminant rations in Bangladesh. Four cattle were fistulated in the rumen for the in situ nylon bag studies. Seventeen different feedstuff sample (9 roughages and 8 concentrates) were evaluated in $4{\times}14cm$ nylon bags and incubated in the rumen for different periods of time (2, 6, 12, 24, 48 and 72 h). The variation in crude protein (CP) contents reflected on the average CP disappearance value throughout the rumen incubation. Soluble fraction (a), insoluble but degradable fraction (b) along with the rate of degradation also varied widely among the various feedstuffs. Under 2% of rumen outflow rate, the percentages of the calculated protein degradabilities of roughages were rice straw, 16.7; maize grass, 70.6; oat grass, 70.8; dhal grass, 71.1; sunhemp, 78.4; napier grass, 62.4; matikalai grass, 72.1; khesarikalai grass, 76.9 and daincha browse, 78.4, respectively. The results in the protein degradabilities (%) in 8% ruminal outflow rate of concentrates were wheat bran, 61.6; rice polish (red), 61.3; rice polish (auto), 30.9; mustard oil cake, 71.8; sesame oil cake, 74.2; coconut oil cake, 57.9; soybean meal, 49.2 and fish meal, 37.9, respectively.

• KOREAN JOURNAL OF PACKAGING SCIENCE & TECHNOLOGY
• /
• v.4 no.1
• /
• pp.11-16
• /
• 1997

Sorption studies involving the sorption of n-propanol by an Amorphous Nylon(Nylon 6I/6T) were carried out as a function of sorbate vapor activity at $23^{\circ}C$. Vapor activity levels from 0.035 to 0.91 were investigated to evaluate the concentration dependency of sorption mechanism. Sorption behavior of propanol by Nylon 6I/6T showed distinctive two mode sorption phenomena as a function of Vapor activity. At Vapor activity levels below a=0.11, equilibrium sorption was achieved within a short period of time(less than 20hrs), which can be interpreted as following a Fickian diffusion model. A Langmuir-Flory-Muggins Dual Mode Sorption model can also be applied at these concentration levels. However, for Vapor activities above a=0.11, the sorption process appeared to be non-Fickian and resulted in a lack of equilibrium being attained.

• Korean journal of applied entomology
• /
• v.43 no.4 s.137
• /
• pp.275-279
• /
• 2004

This study compared the biological characteristics, nymphal development, adult longevity, and oviposition of the bean bug, Riptortus clavatus Thunberg, in fibrous nylon and glass-tube in the insectary at $28{\pm}2^{\circ}C$ and 16L:8D of photoperiod. Nymphal duration in the fibrous nylon-tube was 1 day longer than in the glass tube; the difference was attributed to the developmental duration of the fifth instar. Percent emergence in the fibrous nylon-tube was $64\%,\;8\%$ higher than in the glass tube ($56\%$). In the fibrous nylon-tube, adult longevities for female and male were 4.1 times and 6.0 times higher than those in the glass tube. Preoviposition period was 1 day longer in the fibrous nylon-tube than that in the glass tube. The total number of eggs laid was 3.5 times more in the fibrous nylon-tube than in the glass tube. The oviposition duration lasted about 30 days for the bean bug in the fibrous nylon-tube and about 8 days for those in the glass. Accordingly, the fibrous nylon-tube was found more conducive than the glass tube for determining the biology of bean bug.

• Textile Coloration and Finishing
• /
• v.26 no.4
• /
• pp.311-321
• /
• 2014

In this study, Aftertreatment properties of PCM/Nylon sheath/core fabrics have been determined. Especially, the relationship between finishing property and content including of PCM ratio. Samples of PCM/Nylon fabrics were monitored, separately, with 2% o.w.f solutions of each of the berberine chloride, cetylpyridinium chloride(CPC), benzyldimethylhexadecyl ammonium chloride(BDHAC) and dodecyltrimetyl ammonium bromide(DTAB). Various temperatures and liquor ratio and pH conditions were also studied to optimize aftertreatment properties. Berberine chloride finished sample showed the good color fastness. Cetylpyridinium chloride(CPC) finished sample showed very effective antibacterial properties against Staphylococcus aureus and Klebsiella pneumoniae.

• Journal of Korean Society for Atmospheric Environment
• /
• v.18 no.4
• /
• pp.297-303
• /
• 2002

Fine particles (d$_{p}$ < 2.5 $\mu$m) were measured using an annular denuder system (ADS) in Chongju. The data set was collected on fifty-eight different days with a 24-hr sampling period from October 27, 1995 through August 25, 1996. Particulate nitrate in the ADS was also measured on teflon and nylon filters in series behind denuders to collect HNO$_3$, HNO$_2$, SO$_2$and NH$_3$. From this study. the mean concentration of particulate nitrate of PM$_{2.5}$ in the ADS were seen with the following order: winter (5.05) ＞fall (4.36) ＞spring (3.92) > summer (1.10 $\mu\textrm{g}$/㎥). Nitrate losses, which calculated from the ratio of nylon filter nitrate to the sum of teflon and nylon filter nitrates, varied in the following manner summer (72.2%) > spring (42.6%) > fall (23.5%)> winter (0.4%). Especially, gaseous nitric acid was dominant at temperature higher than 8$^{\circ}C$ while particulate nitrate was major species in total nitrate below that temperature. This indicates the particulate nitrate loss is strongly correlated rather with ambient temperature.e.e.