• Bulletin of the Korean Chemical Society
• /
• v.24 no.11
• /
• pp.1609-1612
• /
• 2003

The electrooxidation of 8-(3-acetylimino-6-methyl 2,4-dioxopyran)-1-aminonaphthaline (AMDAN) in aqueous and non aqueous media led to the formation of polymeric films, poly (AMDAN). The monomer, undergo anodic oxidation through the formation of a monocation radical irrespective of the nature of the medium. In aqueous medium, the monocation radical undergoes, through its resonance structures, dimerisation involving tail-to-tail, head-to-tail and even head-to-head coupling. The products formed, being more easily oxidisable than the parent substance, undergo further oxidation at the same potential so that the overall oxidation involves a one-step (i.e., a single wave), two-electron process. In non-aqueous medium, the monocation radical does not undergo dimerisation through coupling reactions. Retaining its identity, monomer oxidise in two steps involving one electron in each step. The fact that the cathodic peaks corresponding to these anodic peaks are rarely observed indicates fast consumption of the electrogenerated monocation radicals and dications by follow-up chemical reactions to produce polymeric products (poly AMDAN). The electrochemical behavior of the formed polymer films was investigated in both non aqueous and aqueous media. The films prepared in non aqueous medium were found to be more electroactive than that the films prepared in aqueous medium. This is confirmed with the results in litreature which illustrate that the film prepared in aqueous solution hold water in its structure via hydrogen bonding, which causes decomposition reactions.

• Journal of Technologic Dentistry
• /
• v.29 no.1
• /
• pp.121-131
• /
• 2007

A preparation process's conditions of aqueous sol which contains anatase-type nano titania particles with photocatalyic properties was established by using Yoldas process, so called, DCS(Destabilization of Colloidal Solution) process in this study. And crystal size change and phase transformation of titania particles in aqueous titania sol depending on reaction conditions was investigated by a light scattering method and XRD analysis of frozen dried powders, respectively. This sol with photo catalytic nano titania particles was used to the following hydrophilic hybrid coating film's fabrication and its properties was evaluated. Subsequently, for coating film using the above mentioned aqueous titania sol, non-aqueous titania sol was prepared without any chemical additives and its time stability according to aging time was investigate. By using the above mentioned aqueous titania sol and non-aqueous sol, a complex oxide coating sol for metal and ceramic substrate and a organic-inorganic hybrid coating sol for polymer substrate was prepared and it's hydrophilicity depending on UV irradiation conditions was evaluated. As a conclusions, the following results were obtained. (1)Aqueous titania sol The average particle size of titania in formed aqueous titania sol was distributed between 20$\sim$90nm range depending on reaction conditions. And the crystal phase of titania powders obtained by frozen drying method was changed from amorphous state to anatase and subsequently transformed to rutile crystal phase and it is attributed to concentration gradient in aqueous sol. (2)Non-aqueous titania sol Non-aqueous titania sol was prepared using methanol as a solvent and a little distilled water for hydrolysis and nitric acid as a catalyst were used. The obtained non-aqueous titania sol was stable at room temperature for 20 days. Additionally, non-aqueous titania sol with addition of chealating reagent such as acethylaceton and ethylene glycol prolonged the stability of sol by six months. (3)Complex sol and hybrid sol with super hydrophilicity The above mentioned aqueous titania sol as a main photocataylic component and non-aqueous titania sol as a binder for coating process was used to prepare a complex sol used for metal, ceramic and wood material substrate and also to prepare the organic-inorganic hybrid sol for polymer substrate such as polycarbonate and polyethylene, in which process APMS(3-Aminopropyltrimethoxysilane), GPTS(3-Glycidoxypropyl-trimethoxysilane) as a hydrophilic silane compound and HEMA(2-Hydroxyethyl methacrylate) as a forming network in hybrid coating film were used. The hybrid coating film such as prepared through this process showed a superhydrophilicity below 1$10^{\circ}$ depending on processing conditions and a pencil's hardness over 6 H.

• Korean Chemical Engineering Research
• /
• v.51 no.5
• /
• pp.615-621
• /
• 2013

Membrane characterization methods for aqueous redox flow batteries aqueous RFBs were modified for non-aqueous RFBs. The modified characterization methods, such as ion exchange capacity, transport number, permeability and single cell test, were carried out to evaluate commercial membranes in non-aqueous electrolyte. It was found that columbic efficiency and energy efficiency in a single cell test were dependent on the ion selectivity of commercial anion exchange membranes. Neosepta AHA anion exchange membrane showed the anion transport number of 0.81, which is a relatively low ion selectivity in non-aqueous electrolyte, however, exhibited 92% of coulombic efficiency and 86% of energy efficiency in a single cell test. It was also found that a porous membrane without ion selectivity is suitable for a non-aqueous redox flow battery at a high current density.

• Journal of Surface Science and Engineering
• /
• v.24 no.3
• /
• pp.169-176
• /
• 1991

The pros and cons of deposition metals, alloys and compounds from organic, inorganic and molten salt non-aqueous plating baths are discussed. Although some metals, alloys and compounds not obtainable otherwise can be deposited, few commercial processes exist. Widespread use is limited by the cost, complexity, and hazards associated with non-aqueous electrolytes, coupled with the relatively small markets for many of these coatings.

• Journal of Pharmaceutical Investigation
• /
• v.30 no.2
• /
• pp.119-125
• /
• 2000

In an attempt to develop a non-aqueous liquid formulation of practically insoluble biphenyl dimethyl dicarboxylate (DDB), dissolution and permeation studies were performed. Various non-aqueous DDB solutions were formulated and filled into empty hard capsules. Dissolution rates of a new formulation were compared with those of commercially available DDB preparations using one and eight dose units. Dissolution rates after 2 hr of DDB tablets (DDB 25 mg), hard capsules (DDB 7.5 mg) and soft capsules (DDB 7.5 mg) on market and new formulation (DDB 7.5 mg) were 6.3, 15.0, 84.5 and 98.0%, respectively. Higher doses (8 units) resulted in a supersaturation within one hr of dissolution, and dissolved amounts were reduced markedly. Due to the saturation and precipitation, a directly proportional dose-dissolution relationship was not observed. The addition of copolyvidone and/or glycyrrhizic acid ammonium salt to DDB solution in polyethylene glycol 300 and 400 inhibited the formation of precipitates during dissolution and markedly enhanced the rabbit duodenal permeation of DDB. From the site-specific gastrointestinal permeation studies, it was found that permeation rates of DDB after mixing of non-aqueous DDB solutions with aqueous buffered solutions were faster in the order of $rectal\;<\;colonic\;{\risingdotseq}\;ileal\;{\risingdotseq}\;duodenal\;<\;jejunal\;<\;gastric$.

• Natural Product Sciences
• /
• v.11 no.3
• /
• pp.155-159
• /
• 2005

The aqueous extract of Coscinium fenestratum was studied for its antioxidant status in STZ-nicotinamide induced type 2 diabetic rats at two dose levels of 250 mg/kg and 500 mg/kg. At the end of the experimental period, diabetic rats treated with aqueous extract at both dose levels showed a significant increase in the levels of enzymatic antioxidants such as glutathione peroxidase, glutathione synthetase, peroxidase, superoxide dismutase and catalase as compared to the untreated control. Similarly, a significant increase was also observed in the levels of the non enzymatic antioxidants ceruloplasmin, ascorbic acid and tocopherol. The results suggest that the aqueous stem extract of C. fenestratum prevents type 2 diabetes mellitus induced oxidative stress.

• Journal of Surface Science and Engineering
• /
• v.43 no.4
• /
• pp.180-186
• /
• 2010

$TiO_2$ nanotubes were formed on Ti by anodizing in 1 M $H_3PO_4$ + 0.3 M HF and 0.1 M $NH_4F$ + 2% $H_2O$ in ethylene glycol, and their surface and cross-sectional morphologies were observed using FE-SEM as a function of anodizing time and applied voltage. The cross-section of the $TiO_2$ nanotubes was readily observed from the small pieces of nanotubes remaining near the scratch lines after scratching of the anodized surface. $TiO_2$ nanotubes was observed to grow faster and thicker in non-aqueous solution than in aqueous solution. Diameter of $TiO_2$ nanotubes was proportional to the applied voltage, irrespective of the type of the electrolyte, and it is recommended to use non-aqueous solutions for the preparation of larger diameter of $TiO_2$ nanotubes.

• Journal of Pharmaceutical Investigation
• /
• v.34 no.1
• /
• pp.29-34
• /
• 2004

The solubility and stability of quercetin in various vehicles were determined. The solubility of quercetin at $28^{\circ}C$ increased in the rank order of isopropyl myristate < oleyl alcohol < propylene glycol monolaurate < oleoyl macrogol­6 glycerides < linoleoyl macrogol-6 glycerides < propylene glycol laurate (PGL) < propylene glycol monocaprylate (PGMC) < polyethylene glycol-8 glyceryl linoleate < caprylocaproyl macrogol-6 glycerides < diethylene glycol mono ethyl ether (DGME). The addition of DGME to non-aqueous vehicles such as PGL ad PGMC markedly increased the solubility of quercetin. From the stability studies, it was found that quercetin was unstable due to rapid oxidation by dissoved oxygen. The addition of a combination of ascorbic acid and edetic acid (EDTA) at 0.1 % markedly decreased the degradation rates of quercetin in 40% polyethylene glycol 400 in saline. Quercetin was relatively unstable in non-aqueous vehicles such as PGL and PGMC alone, and PGL-PGMC co-solvent The degradation of quercetin in such non-aqueous vehicles was fast, depending on temperature. The addition of butylated, hydroxytoluene, butylated hydroxyanisole, citric acid and/or EDTA at 0.1 % was effective in retarding the degradation of quercetin.

• Advances in Traditional Medicine
• /
• v.3 no.2
• /
• pp.84-89
• /
• 2003

The antidiabetic efficacy of Enicostemma littorale Blume (chhota chirayata) aqueous extract was examined in newly diagnosed non-insulin-dependent diabetes mellitus (NIDDM) patients taking only the extract and was administered as two divided doses, half an hour before meal as 5g of aqueous extract per single dose. Out of the 20 patients volunteered, 11 successfully completed the 2 month trial and a significant decrease in fasting & postprandial blood glucose and glycosylated haemoglobin levels were observed along with a significant improvement in the antioxidant parameters of the patients. There was also a significant increase in serum insulin levels in 7 patients after extract treatment as compared to levels before treatment. Serum total cholesterol and serum triglyceride levels were decreased significantly with a significant increase in serum HDLCholesterol levels. Other vital parameters remained stable and no side effects were observed. This is the first report showing the hypoglycemic, antioxidant and hypolipidemic properties of the aqueous extract of E. littorale Blume in non-insulin dependent diabetes mellitus patients.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.19 no.12
• /
• pp.850-856
• /
• 2007

In a supercooled or capsule type ice storage system, aqueous solution (or water) may have trouble with non-uniform dissolution though the system contributes to the simplicity of system and ecological improvement. The non-uniform dissolution increases the instability of the system because it may cause an ice blockage in pipe or cooling part. In order to observe the supercooled state, a cooling experiment was performed with pressurization to an ethylene glycol(EG) 3 mass% solution in stationary state. Also, the effect of the pressurization from 101 to 505 kPa to the dissolution of supercooled aqueous solution was measured with the dissolution time of the supercooled aqueous solution at a fixed cooling rate of brine. At results, the dissolution of supercooled point decreased as the pressure of the aqueous solution in the vessel increased. Moreover, the dissolution point increased as the heat flux for cooling increased.