• Journal of Electrical Engineering and Technology
• /
• v.11 no.1
• /
• pp.241-246
• /
• 2016

This paper presents a method that can improve the performance of permanent magnet synchronous motor current control by minimizing the measured current phase delay caused by the Low Pass Filter(LPF) used to cut off the noises that flowed in when feedback currents are measured. Although existing methods that change the Cutoff Frequency of the LPF can minimize phase delays during high speed rotations, their noise cutoff effects are much lower and this may lead to the decline of control performance. Therefore, in this study, an algorithm that can compensate current phase delays through relatively simple calculations from the synchronous motor d-q axis coordinate transformation matrix and the inverse transformation matrix is proposed and the validity of the proposed method is verified by comparing the waveform of the calculated current with the waveform of actual currents through simulations and experiments.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.60 no.5
• /
• pp.993-998
• /
• 2011

In this paper we suggest new criteria for the classification of the electrode gap between common and scan electrodes. The electrode gap is categorized as a short, middle, and long gap according to the criteria. Among these structures, we focus on the erase waveform of a mid-gap structure. we report an unstable discharge arising from the erase ramp period in a mid-gap structure. Based on the Vt close curve, we analyze the unstable discharge at various conditions. Our analysis reveals that the unstable discharge is ignited between surface electrodes and caused by un-erased wall charges accumulated on the outer edges of electrodes. By reducing the voltage level of the last sustain pulse, the problem is solved.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.58 no.4
• /
• pp.483-489
• /
• 2009

Electrolytic capacitors are used in variety of equipments as smoothening element of the power converters because it has high capacitance for its size and low price. Electrolytic capacitors, which is most of the time affected by aging effect, plays a very important role for the power electronics system quality and reliability. Therefore it is important to estimate the parameter of an electrolytic capacitor to predict the failure. This objective of this paper is to propose a new method to detect the rise of equivalent series resistor(ESR) in order to realize the online failure prediction of electrolytic capacitor for DC output filter of power converter. The ESR of electrolytic capacitor estimated from RMS result of filtered waveform(BPF) of the ripple capacitor voltage/current. Therefore, the preposed online failure prediction method has the merits of easy ESR computation and circuit simplicity. Simulation and experimental results are shown to verify the performance of the proposed on-line method.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.17 no.5
• /
• pp.521-528
• /
• 1992

this paper a new PAM-PWM Inverter using IGBT Is described. The output waveforms in the proposed PAM-PWM inverter are investigated both theoretiically and experimentally. The line-voltage waveform is composed of fundamental component and the sidebands of carrier frequency. The lower order harmonics are not included In the output waveform. As each inverter arm does not operate during two-thirds period, the heats, generated in the devices are reduced. That is the size of the inverter system can be minimized because of the reduction In the heat dissipating equipemnt.

• Phonetics and Speech Sciences
• /
• v.7 no.4
• /
• pp.35-40
• /
• 2015

We propose a speech waveform forgery detection algorithm based on the flatness of frequency distribution. We devise a new measure of flatness which emphasizes the local change of the frequency distribution. Our measure calculates the sum of the differences between the energies of neighboring frequency bands. We compare the proposed measure with conventional flatness measures using a set of a large amount of test sounds. We also compare- the proposed method with conventional detection algorithms based on spectral distances. The results show that the proposed method gives lower equal error rate for the test set compared to the conventional methods.

• Proceedings of the KIEE Conference
• /
• 1999.07f
• /
• pp.2662-2664
• /
• 1999

To improve the current waveform of diode rectifiers, we propose a new operating principle for the voltage diode rectifiers. In the conventional voltage rectifier circuit, relatively large capacitors are used to boost the output voltage, while the proposed circuit uses smaller ones and a small reactor not to boost the output voltage but improve the input current waveform. A circuit design method is shown and confirmed simulation. It explained that compared conventional SPWM inverter with HPWM(Half Pulse-width modulated)Inverter. Proposed HPWM inverter eliminated dead-time by lowering switching loss and holding over-shooting. Output voltage and current of this paper were applied for real air-conditioner.

• 제어로봇시스템학회:학술대회논문집
• /
• 1991.10a
• /
• pp.917-921
• /
• 1991

Hydraulic fitting impulse tester is equipment which produce impulse pressure waveform that specified foreign standard of SAE, JIS etc. Test conditions of SAE J1453 about waveform standard indicates frequency of 35-70 cycle/min, pressure of 560 bar, oil temperature of 93 .+-.3.deg. C etc. and required cycle is a million over. In additions, Test condition operated continuously equipment. This development item adopted new pattern method such as intensifier and rotary distributor is different from already established fitting impulse tester applied servo valve and high pressure direct directional control valve. Therefore, this development item which compares already established item is good reliability, low cost of manufacture and save of electric energy. especially, Domestic small and medium enterprise uses this tester because of economical cause. We develope appropriateness tester which conforms to demand of user.

• Proceedings of the IEEK Conference
• /
• 2002.07b
• /
• pp.1030-1033
• /
• 2002

This paper, a new simple controller operates in continuous conduction mode (CCM) for Boost power factor collection converter is introduced. The duty ratios are obtained by comparisons of a sensed signal from inductor current and a negative ramp carrier waveform in each switching period. By using the proposed controller, input voltage sensing, error amplifier in the current feedback loop, and analog multiplier／divider are not required, then, the control circuit implementation is very simple. To verify the proposed controller, the circuit simulation for Boost power factor correction converter was applied. For the results, the input current waveform was shaped to be closely sinusoidal, implying low THD.

• Proceedings of the Korean Society of Marine Engineers Conference
• /
• 2005.11a
• /
• pp.200-201
• /
• 2005

This paper is analyzed a new modulation method of OSW(Optimized Sine-Wave) modulation strategy for cascaded H-bridge multi-level inverter. The inverter structure was modified with the maximum output voltage level, and the switching angle was calculated easily to adjust the requested Vrms of the output. The suggested modulation method could make output waveform very close to the ideal sine wave, and the THD value was improved also remarkably.

• The Journal of the Acoustical Society of Korea
• /
• v.18 no.1E
• /
• pp.32-36
• /
• 1999

In the area of the speech synthesis techniques, the waveform coding methods maintain the intelligibility and naturalness of synthetic speech. In order to apply the waveform coding techniques to synthesis by rule, we must be able to alter the pitches of synthetic speech. In this paper, we propose a new pitch altering method that compensates phase distortion of the cepstral pitch alteration method with time scaling method in the time domain. This method can remove some spectrum distortion which is occurred in conjunction point between the waveforms. For performance test the spectrum distortion rate was used as objective criterion and the MOS(Mean Opinion Score) was used as subjective criterion. As a result, the spectrum distortion and MOS are obtained by 0.66% and 3.9, respectively.