• 공업화학
• /
• 제29권3호
• /
• pp.258-263
• /
• 2018

본 연구에서는 전자산업폐수에 함유되어 있는 불소성분을 제거하기 위하여 미세 침강성 석회석을 적용해보고자 하였다. 석회석의 입자크기는 평균 $0.96{\mu}m$이었으며, 질량 기준으로 70%가 함유된 수용액상의 pH는 10이었다. 현탁액의 침강속도는 2 mL/hr로 나타났다. 본 연구의 시험용 석회석 수용액은 폐수 중화와 불소이온 제거능력 면에서 기존의 액상소석회와 동등 이상의 성능을 보여주었다. 추가적인 알칼리 증량제의 투입양에 따라 pH 7에 도달할 수 있는 시험용 칼슘원의 양은 기존의 석회수보다 적었다. 또한 불화수소로 고정시킬 수 있는 양도 미분말 석회석이 석회수보다 큰 것으로 나타났다. 또한, Minteq 평형모델링으로부터 다양한 불소와 칼슘화합물 형성이 예상되었다.

• Corrosion Science and Technology
• /
• 제8권3호
• /
• pp.110-115
• /
• 2009

At the onset of corrosion of steel in concrete, hydrogen ions usually evolve in the process of electrochemical reaction, thereby decreasing the pH of the pore solution, which can be buffered by cement hydration products, as being representatively illustrated by calcium hydroxide. Hence, a fall in the pH is dependent on properties of cement hydration (i.e. hydration products and degree of hydration). The present study tested acid neutralization capacity (ANC) of cementitious binders of OPC(Ordinary Portland Cement), 30% PFA(Pulverized Fuel Ash), 60% GGBS(Ground Granulated Blast Furnace Slag), 10% SF(Silica Fume) to quantify the resistance of cement matrix to a pH fall. Cement pastes were cast at 0.4 of a free W/C ratio with 1.5% chlorides by weight of binder in cast. Powder samples obtained crushed and ground specimen after 200 days of curing were diluted in still water combined with different levels of 1M nitric acid solution, ranging from 0.5 to 20 mol/kg. Then, the pH of diluted solution was monitored until any further change in the pH did not take place. It was seen that the pH of the diluted solution gradually decreased as the molar amount of nitric acid increased. At some particular values of the pH, however, a decrease in the pH was marginal, which can be expressed in the peak resistances to a pH fall in the ANC curve. The peaks occurred at the variations in the pH, depending on binder type, but commonly at about 12.5 in the pH, indicate a resistance of precipitated calcium hydroxide. The measurement of water soluble chloride at the end of test showed that the amount of free chloride was significantly increased at the pH corresponding to the peaks in the ANC curve, which may reflect the adsorption of hydration products to chlorides.

• 한국펄프종이공학회:학술대회논문집
• /
• 한국펄프종이공학회 2011년도 춘계학술발표회 논문집
• /
• pp.93-99
• /
• 2011

Proton-NMR spectroscopic method was applied to kinetics study of concentrated sulfuric acid hydrolysis reaction. Xylan was used as model compounds. Without neutralization steps in proton-NMR methods, this analysis method is valid for analysis of xylose, furfural and formic acid in acid hydrolyzates.

• Transactions on Control, Automation and Systems Engineering
• /
• 제2권2호
• /
• pp.130-135
• /
• 2000

A two parameter model of a single fictitious weak acid with unknown dissociation constant has been successfully applied to design a neutralization system for many multi-component acid streams. But there are some processes for which above two parameter model is not satisfactory due to poor approxmation of the nonlinearity of pH process. Here, for etter control of wide class of multi-component acid streams, a three parameter model of a strong acid and a weak acid with unknown dissociation constant is proposed. The model approximates effectively three types of largest gain variation nonlinearities. Based on this model a nonlinear pH control system is designed. Parameters can eeasily estimated since their combinations appear linearly in the model equations and nonlinear adaptive control system may also be constructed just as with the two parameter model.

• Korean Membrane Journal
• /
• 제2권1호
• /
• pp.1-8
• /
• 2000

In Kimchi (a salt-pickled and fermented food) manufacturing industry, the process of brining and rinsing the raw vegetable produces a vast amount of wastewater of high salinity. Instead of expensive and low-efficient conventional treatment system, brining wastewater reuse system was developed using hybrid chemical precipitation/microfiltration. In the microfiltration of chemically treated brining wastewater, comparison of flux, backwashing frequency and energy consumption was made between dead-end and crossflow filtration mode. The optimum location of neutralization step in this system was also discussed in connection with the microfiltration performance. The quality test of Kimchi prepared by the reuse system confirmed the new approach was successful in terms of water/raw material(salt) saving and wastewater reduction.

• 한국막학회:학술대회논문집
• /
• 한국막학회 1999년도 심포지움시리즈 Jan-99 막분리공정을 이용한 재활용 기술
• /
• pp.1-12
• /
• 1999

In Kimchi (a salt-pickled and fermented food) manufacturing industry, the process of brining and rinsing the raw vegetable produces a vast amount of wastewater of high salinity. Instead of expensive and low-efficient conventional treatment system, brining wastewater reuse system was developed using hybrid chemical precipitation / microfiltration. In the microfiltration of chemically treated brining wastewater, comparison of flux, backwashing frequency and energy consumption was made between dead-end and crossflow filtration mode. The optimum location of neutralization step in this system was also discussed in connection with the micro filtration performance. The quality test of Kimchi prepared by the reuse system conformed the new approach was successful in terms of water/raw material (salt) savings and wastewater reduction.

• 제어로봇시스템학회논문지
• /
• 제19권10호
• /
• pp.891-895
• /
• 2013

This paper proposes the development of a new method for online analysis which measured acid concentration in a pickling line. Pickling is the most important step to remove surface scale layers and is strongly depending on the exactly controlled pickling liquor composition. Today, there is no feasible system available for the online control of pickling lines. Within this paper, new methods for online analysis of pickling liquors have been tested and implemented into an overall pickling process control tool. This method measured simultaneously the hydrochloric acid and iron ion concentration in a solution of hydrochloric acid by measuring the ultrasonic speed, the solution temperature, and the electrical conductivity. Experimental results showed excellent precision and the measurement error was ${\pm}2g/l$ compared with the neutralization titration measurement.

• 음성과학
• /
• 제13권3호
• /
• pp.19-33
• /
• 2006

This study explores whether Russian, known to have a process of syllable-final devoicing, reveals differences in vowel duration as a function of the underlying voicing of the coda stop. This paper also examines whether non-native speakers of Russian and English learn typical L2 values in vowel duration. The results indicate that vowels in Russian have a slightly longer mean duration before a voiced stop than before a voiceless stop (a mean difference of 9.52 ms), but in most cases the differences did not exhibit statistical significance. In English the mean difference was 60.05 ms, and the differences were in most cases statistically significant. All native Russian speakers of English produced larger absolute differences in vowel duration for English than for Russian, and all native English speakers of Russian produced smaller absolute differences for Russian than for English. More experienced learners seemed to achieve more native-like values of vowel duration than less experienced learners did, suggesting that learning occurs gradually as the learners gain more experience with the L2.

• 공업화학
• /
• 제32권6호
• /
• pp.659-663
• /
• 2021

반도체 제조공정에서 발생하는 미세먼지와 질소산화물 동시처리를 위하여 오존산화, 습식중화 및 습식전기집진 기술들을 직접화한 10 CMM급 복합오염물질 제거시스템을 개발하였으며, NOx 제거효율 증대를 위한 공정변수 제어 및 최적화를 진행하였다. 특히, 전원공급장치를 포함한 습식전기집진장치 핵심부품 안정성 평가를 위해 30일 동안의 장기운전도 병행하였다. 오존산화 기반 DeNOx 공정에서 가장 중요한 운전변수인 O₃/NO 비율은 1.5 부근에서 최적화하였으며, 습식중화 공정의 운전변수를 최적화하여 중화반응에 의한 제거효율 기여도를 확인하였다.

• 한국재료학회지
• /
• 제24권11호
• /
• pp.578-584
• /
• 2014

To synthesize Sn nanoparticles (NPs) less than 30 nm in diameter, a modified polyol process was conducted at room temperature using a reducing agent, and the effects of different pH values of the initial solutions on the morphology and size of the synthesized Sn NPs were analyzed. tin(II) 2-ethylhexanoate, diethylene glycol, sodium borohydride, polyvinyl pyrrolidone (PVP), and sodium hydroxide were used as a precursor, reaction medium, reducing agent, capping agent, and pH adjusting agent, respectively. It was found by transmission electron microscopy that the morphology of the synthesized Sn NPs varied according to the pH of the initial solution. Moreover, while the size decreased to 11.32 nm with an increase up to 11.66 of the pH value, the size increased rapidly to 39.25 nm with an increase to 12.69. The pH increase up to 11.66 dominantly promoted generation of electrons and increased the amount of initial nucleation in the solution, finally inducing the reduced-size of the Sn particles. However, the additional increase of pH dominantly induced a decrease of PVP by neutralization, which resulted in acceleration of the agglomeration by collisions between particles.