• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.1
• /
• pp.165-170
• /
• 2006

In the Civil Aviation field, the international trend (through ICAO, EUROCONTROL) is to adopt one positioning system that allows to follow more flight phases. This will allow to release themselves by ground installations and optimize the traffic flows following the aRea Navigation (RNAV) concept. In order to realize this goal the European Scientific Community are focusing on Augmentation Systems based on Satellite infrastructure (SBAS - Satellite Based Augmentation System) and on Ground based ones (GBAS - Ground Based Augmentation System). The goal of this work is to present some results on SBAS and GBAS performances. Regarding SBAS, the Department of Applied Sciences of Parthenope University, after the acquisition of a Novatel OEM4 SBAS receiver has created a monitoring station that reflect as much as possible a standardized measure environment for EGNOS Data Collection Network (EDCN), established by Eurocontrol. The Department of Applied Science has decided to carry out a own monitoring survey to verify the performance of EGNOS that can be achieved in South Europe region, a zone not very covered by official (EDCN) monitoring network. Regarding GBAS, we started from a data set of measurements carried out at the GBAS of Milan-Linate airport where we work on a ground installation (GMS - Ground Monitoring Station) that supervises the GBAS signal and that represent, for our purposes, the Aircraft subsystem. So the set of data collected is to be considered in RTK mode and after the measures session we processed them with the software PEGASUS v 4.11. Both experiences give us the possibility to evaluate the GNSS1 performance that can be achieved.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.17 no.4
• /
• pp.567-572
• /
• 2016

Many studies have been performed since the introduction of GPS in Korea. As a result, positioning using GNSS was fully proposed. On the other hand, most of these studies focused on accuracy but analytical studies on the GNSS status and the national GNSS infrastructure of Korea are lacking. In this study, the status of multi-constellation GNSS and National Geographic Information Institute's CORS (Continuous Operating Reference Station) were identified for the benefit and direction of GNSS infrastructure enhancement. As a result, it has been operating Multi-constellation GNSS, such as GPS, GLONASS, Galileo, COMPASS, and QZSS for surveying. In addition, improvement was presented by the number of satellites, precision, PDOP, etc. through the experiment about VRS and RTK using Multi-constellation GNSS. Upgrading the infrastructure for satellite surveying was identified as a priority consideration. In the future, if a Multi-constellation GNSS service is possible in VRS service, the satisfaction of public administration service will improve, which will contribute greatly to the advancement of a surveying infrastructure.

• Journal of The Geomorphological Association of Korea
• /
• v.25 no.4
• /
• pp.37-47
• /
• 2018

Coastal sand dunes have been regarded as natural defenses to protect hinterland from disasters such as storm surge and typhoons. However, many dunes are not well-deserved in South Korea because of imprudent land development or inappropriate measures after coastal erosion. Lately, beach nourishment and dune reinforcement are emphasized as the effective and environmentally sustainable solution for the coastal protection. They are regarded good strategies to keep landscapes for a time, with little side effects. However, there is little knowledge on the construction methods including proper design and time plans for the best results.In addition, the effects of dune reinforcement in the field should be tested.In thisstudy, we performed sand filling in an eroded dune scarp and surveyed topographic changes in the beach-dune system, which is located along Dasa-ri coast, Chungnam Province, South Korea. Using a network RTK-GPS and drone-based aerial photographs, we analyzed the temporal and spatial changes in the area, before and after the reinforcement. As a result, the dune reinforcement seems to be helpful to mitigates the coastal erosion and to prevent the coastline retreat at least for one year.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.14 no.3
• /
• pp.78-95
• /
• 2011

This study has developed various DEMs with different spatial resolutions using many different interpolation methods with the aid of a 1:5,000 digital map. In addition, this study has evaluated the vertical accuracy of various DEMs constructed by check point data obtained from the network RTK GPS survey. The obtained results suggest that a DEM developed from the TIN-based Terrain method performs well in evaluating height restriction of buildings in a flying safety area considering general RMSE values, land-type RMSE values and profile evaluation results, etc. And, it has been found that three meters is the right spatial resolution for a DEM in evaluating height restriction of buildings in a flying safety area. Meanwhile, elevation values obtained by the DEM are not point estimation values but interval estimation values. This can be used to check whether the height of buildings in the vicinity of an airfield violates height limitation values of the area. To check whether the height of buildings measured in interval estimation values violates height limitation values of the area, this study has adopted three steps: 1) high probability of violation, 2) low probability of violation, 3) inconclusiveness about the violation. The obtained results will provide an important basis for developing a GIS related to the evaluation of height restriction of buildings in the vicinity of an airfield. Furthermore, although results are limited to the study area, the vertical accuracy values of the DEM constructed from a two-dimensional digital map may provide useful information to researchers who try to use DEMs.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.34 no.3
• /
• pp.283-290
• /
• 2016

Even though existing methods for orthophoto production in traditional photogrammetry are effective in large areas, they are inefficient when dealing with change detection of geometric features and image production for short time periods in small areas. In recent years, the UAV (Unmanned Aerial Vehicle), equipped with various sensors, is rapidly developing and has been implemented in various ways throughout the geospatial information field. The data and imagery of specific areas can be quickly acquired by UAVs at low costs and with frequent updates. Furthermore, the redundancy of geospatial information data can be minimized in the UAV-based orthophoto generation. In this paper, the orthophoto and DEM (Digital Elevation Model) are generated using a standard low-end UAV in small sloped areas which have a rather low accuracy compared to flat areas. The RMSE of the check points is σ_H = ±0.12 m on a horizontal plane and σ_V = ±0.09 m on a vertical plane. As a result, the maximum and mean RMSE are in accordance with the working rule agreement for the airborne laser scanning surveying of the NGII (National Geographic Information Institute) on a 1/500 scale digital map. Through this study, we verify the possibilities of the orthophoto generation in small slope areas using general-purpose low specification UAV rather than a high cost surveying UAV.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.36 no.6
• /
• pp.457-467
• /
• 2018

Currently, the regulation and rules for public surveying and the UCPs (Unified Control Points) adapts those of the triangulated traverse surveying. In addition, such regulations do not take account of the unique characteristics of GNSS (Global Navigation Satellite System) surveying, thus there are difficulties in field work and data processing afterwards. A detailed procesure of GNSS processing has not yet been described either, and the verification of accuracy does not follow the generic standards. In order to propose an appropriate procedure for field surveys, we processed a short session (30 minutes) based on the scenarios similar to actual situations. The reference network in Seoul was used to process the same data span for 3 days. The temporal variation during the day was evaluated as well. We analyzed the accuracy of the estimated coordinates depending on the parameterization of tropospheric delay, which was compared with the 24-hr static processing results. Estimating the tropospheric delay is advantageous for the accuracy and stability of the coordinates, resulting in about 5 mm and 10 mm of RMSE (Root Mean Squared Error) for horizontal and vertical components, respectively. Based on the test results, we propose a procedure to estimate the daily solution and then combine them to estimate the final solution by applying the minimum constraints (no-net-translation condition). It is necessary to develop a web-based processing system using a high-end softwares. Additionally, it is also required to standardize the ID of the public control points and the UCPs for the automatic GNSS processing.

• Journal of Advanced Navigation Technology
• /
• v.22 no.6
• /
• pp.591-601
• /
• 2018

This paper discusses methods to effectively operates and evaluates an infrastructure system for lane-level positioning based on satellite navigation. The lane-level positioning infrastructure provides correction information on range measurements with integrity information on the correction to a user with a single frequency (cheap) satellite navigation receiver in order to perform lane-level positioning and integrity monitoring on the position estimate. The architecture and configuration of the lane-level positioning system are described from the systematic level in order to provide a comprehensive insight of the system. The operation/evaluation system for the integrated infrastructure is then presented. The evaluation results of the real implemented system are provided. Based on the results, we discuss requirements to increase the system stability from the operation perspective.